Having problems with your 2006 Scion xA ?

Water in getting in floor behind driver seat

\015 Water in getting in floorboard behind driver seat\015 Posted / edited by AnonymousUser on : 16-10-2017

Answers :

Remove the Cowl vent panel under the wipers. Each corner in the basin has a square drainage hole. Make sure they are clear with a blower or long wire. They get clogged with leaves and debris. Test it by pouring water and see if it drains under the fender. Drill additional drain holes if you want, at the bottom of this metal basin. On the back of this basin you will see a large rectangular hole where the air is sucked in for the heater. That is where the water gets into if the drainage is clogged. It then shoots through the vent under the drivers seat, aiming to the rear. that is why you get a wet rear floor.
Check your door and window seals on the driver side

Repair Help & Product Troubleshooting for 2006 Scion xA

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0118 seconds