Having problems with your 2006 Hyundai Sonata ?

2006 hyundai obd ii scanner wont connect - 2006 Hyundai Sonata

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2006 Hyundai Sonata

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2006 hyundai obd ii scanner wont connect - 2006 Hyundai Sonata


... 2006 Hyundai Sonata

My onboard computer wont connect to the OBD scanner. How can I get it to read it?


... 2000 Hyundai Elantra GLS

2003 Hyundai sante FE drive cycle " comp component " is incomplete and affecting my obd ready status for smog , we have driven it close to 300 miles on and off the freeway all other monitors have reset. What sensors is this checking and how long till reset, I'm using an Actron scanner with code connect. Could it be my scanner is not supporting this model ?


... Cars & Trucks

Obd diagnostic hi, i have a 1999 hyundai coupe f2 evo (tiburon in usa) and i bought a obd diagnostic kit (elm327 obd2-eobd) but it wont connect to my ecu ive tried everything i can think of....any help would be great .. thanks phil


Look under the hood in the engine compartment.The emissions sticker will tell you if it is obd compliant...If it is manufactured in the u.s. since 1996 , federal laws require it to be obd compliant..I would give the manufacturer of the scanner a cal ... Hyundai Motor 1999 Tiburon

No crank 2001 hyundai elantra gls, we were driving, car died, now wont crank. new batt, cables look good with new ends, nothing, just a click, have power to all accessories and lights. hooked up ODBII scanner, cannot connect to ecm, please help


First, has the timing belt been replaced? breaks after 60,000 miles and engine locks up.will not crank. .need to take a 22 millimeter socket and see if the engine will turn over by hand. if not remove the timing cover and inspect the timing belt for ... 2001 Hyundai Elantra

98 hyundai sonata obd II port has no power or comunication with my scaner


If you connect a scanner to the OBD2 port and the vehicle then runs fine? Then you have a problem with a ground. Top of the DLC is pin 4 and 5 that is the ECM body ground. pin 16 is battery volts 12vlts. ... Hyundai Sonata

2009 Hyundai Sonata has a connection problem with cell phone and GPS car chargers. I have had problems charging my cell phone and GPS in my 2009 Hyundai Sonata from the first time I used the cigarette


... 2009 Hyundai Sonata

Hyundai sonata wont start - 2007 Hyundai Sonata Limited Sedan


... 2007 Hyundai Sonata Limited Sedan

Hyundai sonata 2006 obd port - 2006 Hyundai Sonata


... 2006 Hyundai Sonata

2006 F350 Power stroke truck OBD Scanner Will NOT Communicat When Pluged IN, and 'read codes' is pressed it read out must connect to VEH TO RUN THIS TEST Checked pins they are good and tested OBD auto scanner on another TK Works OK HOW Can YOU CHECK DLC or What Might Cause This


... Cars & Trucks

Obd location on hyundai sonata 2006 - 2006 Hyundai Sonata


... 2006 Hyundai Sonata

2006 F350 Power stroke truck OBD Scanner Will NOT Communicat When Pluged IN, and 'read codes' is pressed it read out must connect to VEH TO RUN THIS TEST Checked pins they are good and tested OBD auto scanner on another TK Works OK


... Cars & Trucks

Trunk on 2003 hyundai sonata wont shut - 2006 Hyundai Sonata


... 2006 Hyundai Sonata

My 1999 hyundai sonata wont change gears - 1999 Hyundai Sonata


Hi there:We are assuming that you are talking about Automatic car, then we can't just say to you the park neutral position switch needs to be replaced without checking all the parts and pieces. There are several different components to the shif ... 1999 Hyundai Sonata

My OBDII scanner will not read any info,how can I check proper connection to OBD plug in my Ford Explorer 2000?, 'check engin' light at start-up, never comes 'ON'-I tried to read through the OBD but the scanner does not read anything at all.


The bulb may have gone out and check the back of the obd plug to make sure no one pulled the diag wire from the plug assembly. ... 1999 Ford Explorer

I went to connect my obd auto scanner to a 2004 aveo and could not locate the obd port to connect it to? Where is it? Usually its under the dash board...I thought


It is regulation/law that it is accessable under the steering wheel side of the car try looking for a cover to the side panel or just behind the trim above the pedal its quite small it will be in that location ... 2005 Chevrolet Aveo

Hyundai sonata 1997 wont start - 1997 Hyundai Sonata


... 1997 Hyundai Sonata

Obd connection Help... my new INNOVA 3120 obd1/obd11 scan tool cannot connect to my right hand drive 1995 Hyundai Accent obd 12 pin connector, is there an universal connector?.


... Hyundai Motor 1995 Accent

Hyundai sonata 2000 gls. v6. HAs no EGR. Emission test, first try, HC(0) CO (0) nox 1033 mechanic said my engine seems hot (there was also heat out of vents blowing out. I cleaned my maf sensor and put on high octane gas and fuel cleaner drove for a week and retested. ssecond try HC(0) CO (0) nox 1250. failed agian. I changed my mass airflow from anotehr car and change my 3 front spark plugs myself not the three at back. Car seemed to be running better and engine definitely cooler no mor


... 2000 Hyundai Sonata

When I plug my scanner in to the dlc the scanner turns on with the key off but when i turn the key on the scanner has no power and won't communicate i had a blown fuse and replaced it but still nothing trying to program a new key and it wont allow me to connect through the data link connector


All diagnostic link connectors with 16 terminals the the 16th terminal bottom far right the OBD 2 DLC IS THE 12 VOLTS POWER SOURCE TO POWER UP SCANNER.IF YOU NOT GETTINNG 12 VOLTS AT 16TH TERMINAL YOU HAVE PCM PROBLEMS. ... 2002 Ford Taurus

Esc off light wont go off period in my 06 Hyundai Sonata


... 2006 Hyundai Sonata

My 2001 kia magentis v6 (same as hyundai sonata) sometimes get stuck at 3000 rpms and wont shift unless i put it in manual shift mode. i can get it to shift then but it still wont rev past 3000rpms. i brought it to a shop and they said it was going into safe mode due to high transmission tempature. although when this problem occurs i checked the trans fluid it was hot but i could still touch the dip stick with out being burned. whenever i disconect the battery for about 5 minutes and reconnect


Dear friend-when your vehicle wont rev it means that it went into limp mode and by disconnecting the battery you reset the ecu and will appear ok till the faulty sensor comes up again,have a dianostic test carried out to sole,previble when in limp mo ... 2001 Hyundai Sonata

Handle on door wont open on 99 sonata. - 1999 Hyundai Sonata


... 1999 Hyundai Sonata

Sonata 2010, break lights wont switch off? - 2006 Hyundai Sonata


Try the switch at top of pedal ... 2006 Hyundai Sonata

2006 sonata hood wont close - 2006 Hyundai Sonata


... 2006 Hyundai Sonata
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.8870 seconds