Having problems with your 2006 Ford Explorer ?

06 ford explorer,awd,5spd auto trans,6 CYl x

\015 06 ford explorer,awd,5spd auto trans, rsc,6cyl.:Pblm C-1175 Error.Lt whl sensor issue.repl sensor,Then Irepl abs Cntlr w new ford pone, Had ford initialize it, But they were unable to communicate with the new one,they repl it agin & still could not communicate with module.I pickedup the car ,the harnness had been cut,spliced and looked like a rat had lunch. I purchased and installed a New harness which took me a week to iron out why now I can shart the car,( NO starter action) I bypassed thestarter solenoid w/key on to start car and now saw I had no alternator output.Found harness inproperly wired at C175B pin 2 & pin 22 had been reversed wired. Swapping these pins allowed me to start and charge. But I still had my original C1175 pblm.Found Rear harness had been compressed between floor pan & top of gas tank. causingstray voltages onto the lt whl senser. I was utilizing the ford servicemanuel for C1175 testing proceedure and found both pins of the senser had two different voltages on ea one. I ran New twisted wiring to both rear senser fearing that I may have blown out the output stage of the controller crkt.After rewiring I tested both crkts (lt/rt) senser in accordance with service manuel.chking ea line cntl to senser for continuity/opens & shorts. CHdC-155 36/37 with senser inst, got 10.4 M ohms.with shorted senser plug got 0 ohmss, Both wires to ground were open. Installed c-155 onto cntlr and got 12 V accross senser plug pins.these tests tell me i Have a complete circuit from cntlr to senser back to controller.placed two(2) new contollers onto c-155 and still get c_1175. This is with scanner installed key ON ron OFF , and a abs erase done. IT will lower the counter(# of error to 1). I can ont figure what I am not adding to this eqcazion. i Was a diesel truck mech in my younger years and just retired as aaircraft computer & guidance sys techfo UAL.so wiring & logic are not my pblms, If I am overlooking som small fact please let me know. ps; toner ring and axle okay, thanks Jack SIMOES\015 Posted / edited by AnonymousUser on : 20-11-2017

Answers :

Hello! Let me digest this problem and I'll do my level best to provide the correct solution...

Guru................Saailer
Repair Help & Product Troubleshooting for 2006 Ford Explorer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0061 seconds