Having problems with your 2006 Chrysler Sebring ?

Before I start tearing apart my dashboard, can anyone tell me where the OBD II terminal is on my 2006 Sebring?

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Take it to Autozone and ask them to read check engine codes. Watch where they attach.
Repair Help & Product Troubleshooting for 2006 Chrysler Sebring

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Before I start tearing apart my dashboard, can anyone tell me where the OBD II terminal is on my 2006 Sebring?


Take it to Autozone and ask them to read check engine codes. Watch where they attach. ... 2006 Chrysler Sebring

Won't start Worked fine last night, didn't start this morning. Battery level fine. Lights, radio, dashboard indicator lights, all work fine. Blower fan for heater doesn't work, and turning the ignition gets me silence. 12.3 volts to starter, multimeter registers 0 on other solenoid terminal when key is turned into start position. Seems like the restart relay is the common element between fan and starter, as I look closely at chassis wiring diagram. Probably have no A/C, but can't tell with engin


A friend here solved it. It was a bad connection of the ground wire, with the paddle-shaped connector loose. He cleaned it a bit, slid it back on, and crimped it a little (not easy to do in that tight space). Solved both problems. ... 1993 Isuzu Trooper

I have a 1995 geo prism 1.6 lsi Put new pluggs and a cap and roater wires double checked everythings tight started out was hard to get it started then once u started it it would idle fine tell u put it in gear then it dies evrytime or if u let of the gas when u go around the corner now it has no spark at all plz if anyone has any information as to what could be the problem plz ... not sure how to pull coil only wires comming off cap are the 4 plug wires if anyone has any insight plz a little he


Well, first of all, you have a coil-in-cap design. So, my best thought would be to make sure all wires going to the distributor are in tight, and that you've got the cap on tight, and work from there. ... 1995 Geo Prizm

Help please @ first 2 weeks ago drove it 3miles and it quit tryed starting it and every time i put it in a gear it would just quit then next thing you know it wont start at all then we put throttle body ? on it then fuel pump, fuel filter, practically everything new and we have had mechanics look at it and no one can tell us what it is can anyone please give me something else to tell someone to look at since im a woman i dont know much but my boyfriend has tryed everything and my ex husband is a


Try checking the crank sensor, (for sludge, and wiring connection) and having someone check the timing. It may have jumped a tooth. (so the engine isnt firing the sparkplugs at the right time) Also try drilling a 1/4" to 1/2" hole in the exhaust ... 1992 Chevrolet Corsica

1996 audi a4 no spark. car wont start now was running fine earlier and when i came back out to go somewhere the car will not start. i checked for spark and found no spark. was wondering if anyone knew what the problem was. or can anyone tell me witch relay switch to check under the dash?


SOUND LIKE FAULTY IGNITION MODULE. ... 1996 Audi A4

I HAVE A 1988 CHEVY VAN G20 5.7 I CHECKED TIMEING CHAIN NEW PLUGS,PLUG WIRES,DIST CAP, ROTOR,COIL,FLUSHED FUEL TANK,NEW FUEL PUMP AND FILTER I HAVE GOOD FUEL PRESSURE,GOOD COMPRESSION,THE PROBLEM IS SPARK, I TAKE THE COIL WIRE OFF DIST CAP AND HOLD IT CLOSE TO THE TERMINAL AND IT STARTS DOESNT RUN WELL BUT RUNS IF I PLUG IT INTO THE TERMINAL IT WONT START AT ALL. ITS A RESISTANCE PROBLEM BUT WHERE DOES ANYONE KNOW WHAT COULD CAUSE IT


... 1988 Chevrolet G20

Can anyone tell me what these engine fault codes refer to on a 1998 mercedes c180 auto,1.8 petrol. I suspect it may be releated to tempeture sensor. Total of 6 codes 065 (2,2,0,41) resistance too high 104 (2,2,0,68) resistance too low 122 (2,2,0,7a) resistance too low 126 (2,2,0,7e) resistance too low 129 (2,2,0,81) resistance too low thanks jim 161 (2,2,0,a1) resistance too high


Most common is o2 sensor ... 2002 Mercedes-Benz C-Class

My 2000 Pontiac Grand Prix just started acting up. It started with the RPM gauge going to 0 while driving, then the "off Trac" light comes on. Now it sometimes won't start, it will crank, but not turn over. last night it wouldn't start right away, then it did, but as I got almost home, it just shut off on me while driving. Has anyone ever exerienced this before. Now it doesnt start like it used to. It will start right up but then turn off again.


... 2000 Pontiac Grand Prix

I have a 1989 ford f150 that cuts out/pops when the motor warms up. Its fine for about 2 or 3 minutes when i start driving it and then it starts acting up. It doesnt seem to lose power though? This all started after we put a new alternator in. Can anyone tell me what's going on?


You need to pull the fault codes and see what is going on based on those. Go here to learn how to retrieve ... Cars & Trucks

My '94 Olds Cutlass Ciera won't start. The first problem I noticed was when the auto locks wouldn't work after driving it. Then it got to the point where the car would just shut off while driving down the road. My wife noted problems with lights although I didn't notice anything. The car would always start back up when it died while driving. However, one day it got to the point where it just wouldn't start anymore. I'm guessing that it is some kind of electrical problem. Can anyone tell me what


That year of car , it maybe something simple such as ground faults . Have you clean any ground points on the car ? Starting with the battery posts and alternator , starter? work your way from there that is were I would start, Doesn't cost anything. H ... 1994 Oldsmobile Cutlass Ciera

I have 2011 dodge 3500 cummins smokes when cold started? when started first thing in morning only around 0 blows lots of white smoke smell like unburnt diesel and shakes a bit for 10 to 15 min has had piston rings, injectors, head, a few head gasket all replaced already still does not start right after sitting overnight seems like cylinder six is missfiring when capped of does not smoke. does anyone have anyother ideas of the cause of all the smoke thanks


... Dodge Cars & Trucks

Won't Start I have a 1995 Intrepid 3.3L V6 that i recently purchased for $300. it ran fine for a day or two, then i went to leave for work the next morning and got about 5 minutes down the road, it died. started again, died again, finally made it back home, and now it won't start at all. I have changed the plugs, plug wires, ignition coil, cam sensor, crank sensor, and it's still not firing to the plugs. it is flashing codes 1277, and 5455. Can anyone tell me what those codes mean? Any help is g


My daughters car did the exact same thing. Lights and all. I replaced the pump twice and both relays (auto shut down and fuel pump relay). Very frustrating indeed.The 1994 recall (see below) is right on! Right behind the engine block inta ... 1995 Dodge Intrepid

My 03 denali's battery dies in the morning after sitting in the garage over night. the car starts fine after a jump start and allowing the battery to charge. I can let the car sit for 3 hours and it will start fine. I made sure no inter lights or running lights were on. can anyone tell me what else to check?


Have some one do a load test on battery,Sounds like it has a bad cell in it and will need replaced ... 2003 GMC Yukon Denali

I have a 1995 ford contour with a 2.5l i am having a problem in the morning when the car is cold it takes 5 to 6 different times of cranking to get it to start after it starts it runs and drives fine but if it sits for a while or overnight its long cranking before it starts can anyone tell me what is causing this


... 1995 Ford Contour

Hi my name is Andy I have a 2005 daromax 6.6 I started it and then it turned off. When I tried to start it now it won't start can anyone tell me what I can check.


Check the fuel filer if have not replaced in the past 60000 get one , it also has a water separator and a sensor that may be keeping it from starting.Th filter sits on top of the engine no special tools needed. ... 2005 Chevrolet Silverado 2500HD 2WD

1970 Oldsmobile Cutlass Supreme won't start. It does try to start but stops immediatly. I have replaced the sparkplug wires and the fuel filter but still wont start. When turning it over most of the time it cranks smooth and other times its like a plug wire in the firing order is off one but nothing has been changed around. I believe it is a 5.7L 350 2bl. if anyone could tell me way to find out exactly what motor it has, I would greatly appreciate it. I heard there was a way to find out with the


A 2-letter code on the oil filler tube identified the engine. If its a 455 there will be Oldsmobile W-455, on the intake manifold, if not it is most likely the 350. Sounds like you might have a bad timing chain. To check for excessive play in the tim ... 1970 Oldsmobile 442

I turned my car off to go into the store when I came back out it wouldn't start. acted like it wasn't getting fuel put more gas in it still wouldn't start. someone said it was probably fuel pump so I put a fuel pump on it then a fuel filter, then a crank shaft censor, still won't start, someone then told me it was the theft system so I tried two different methods that two different shops told me to try neither of the two worked, now someone says it could be the timing, can anyone tell me how to


Again i say do not replace parts until you know why, too many people have done this. get a spark tester(in line works best) injector tester(noid light) and fuel pressure guage, and a volt ohm meter, the run basic tests, spark, fuel , injector signal, ... 1999 Chevrolet Cavalier

Cold start problem,engine took a while to start,cranked over fine but felt like it was missing or starving for fuel.once warmed up seemed fine but chick engine light was on,after driving awhile light went off.did this for two days,i changed the fuel filters but still wont start,acts like its starving for fuel.the dealership said it could be many problems ,i dont half to tell you how much they want just to hook this thing up to a computer to find out.if anyone could possibly help i would be very


... 2006 Ford F-250 Super Duty

This morning i went to start up my sebring and it wouldnt start. the electronic throttle control light came on so i kept trying to start it but nothing happened . it was just fine the other day .can you tell me what is going on


I could be that the sensor could be dirty. They sell a spray at your local auto parts store specificly for the throttle body. It's should be connected to your air filter housing. Just try to clean the sensors and use the spray for the throttle bod ... 2007 Chrysler Sebring Sedan

2000 nissan frontier 6cyl 3.3l will not start. pretty sure it is either the crankshaft position sensor or camshaft position sensor. since the truck wont start and I dont have an obd scanner I can't narrow it down between those two parts. I bought a CKPS since it was only 20$ but I can not locate where the sensor is.... does anyone know where it is? Also, is it true if its the CMPS, i would need to replace the whole distributor? Which sensor is more likely to fail and cause it not to start?


... 2000 Nissan Frontier

Hey, I have a 2001 nissan sentra that will not start. The negative terminal had corroded to the point the clamp was loose, I replaced it. When the key is turned to start, the battery voltage stays around 12v, fan radio, etc all work fine. My wife said the last two times it started it sounded like it had rocks in it if that makes sense. I am fairly certai the starter is bad. Can anyone confirm that or give me another idea?


Indeed, a bad starter can sound like a bunch of rocks, but it also could be a weak battery. Even though it shows 12 volts, it may not have enough reserve capacity. Step 1 is to take the battery to Pep Boys (or whatever) and have it tested. ... 2001 Nissan Sentra

My 1996 Jeep Grang Cherokee just started acting up, first the battery gauge kept dropping to 0 about a minute after starting, now it will not start without a boost and the second I unplug the battery it shuts off; I had the battery checked @ Autozone and it is good. Can anyone help please?


Check the alternator output, with engine running and a volt meter check voltage at battery that be alternator out put voltage for the alternator, should not have less then 13.5 volt's with engine running, if less bad alternator, replace it ... 1996 Jeep Grand Cherokee

I have suzuki alto vxr 2007. the vehicle is giving problem in starting when cold on cng. if i park the car during day for more than half an hour and start it back on, it wont start on first self or will take long self.. have got tappet adjusted recently and tunning of cng and petrol but problem persists.. can anyone tell wot can be the reason


... 2007 Chevrolet Aveo Sedan

What could be the problem with my car, premio 1998 d4 engine, i have to start for several times(3) for the car to start.(hard start) it has engine check code 12,which has failed to clear up even after replacing crank and oxygen sensor and also clearing the computer memory by removing battery terminal and wait for 20 min. i recently purchase Eobd/obd2 code scanner could not link with ECM, what could be the possible DTL connector, pin layout are 4,6,7,9,13,14,16. Anyone with an idea?


DTL connector is the plug is under the hood on that car i think by the driver side ... Cars & Trucks

Can anyone tell me what Diagnostic OBD Code P2238 meens for a 2004 Toyota Camry?


Most of the codes for those readers are not in the book/manual. Only the common ones are. You can search online at the readers website or just enter the ... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 6.0133 seconds