Having problems with your 2006 Chevrolet Impala ?

Idle air control valve - 2006 Chevrolet Impala

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2006 Chevrolet Impala

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Idle air control valve - 2006 Chevrolet Impala


... 2006 Chevrolet Impala

Pops back through the intake when it is cold runs better when warm replaced complete distribitor,cap rotor,plugs,wires,ign coil, ign control module,throttle position sensor,idle air control valve, egr valve,oxygen sensor,fuel pressure regulator kit,fuel injectors,don;t know what else to do 1992 k 1500 chevrolet tbi 5.7 with 5 speed


This problem can be caused by defective spark plug wires that are cross firing due to voltage leaking to a nearby plug wire as well as a flat camshaft lobe. ... 1992 Chevrolet K1500

Idle air control valve 2005 Chevrolet Equinox


... 2005 Chevrolet Equinox

My 1997 honda cr-v has had a problem with idle air control valve for a long time.the code is 14-1 idle air control valve-circuit failure.i replaced the idle switch yet the the light still comes on and the vehicle stalls in the morning before it behaves normally.two auto electricians have suggested replacing the ics in the computer since its not sending the correct voltage to the idle air control valve.is this helpful or just another non-working theory?


Check your mas air flow sensor. if that don't work check your throttle position sensor.hope that helps.. ... 1995 Volkswagen Jetta

WE HAVE A 2000 GLE IN OUR SHOP A/T 3.0 , IT CAME IN WITH A STALLING PROBLEM AFTER WARM UP WOULD HAVE TO DOUBL FOOT IT JUST TO GET INTO SHOP, IT HAD CODES 505 , 400. 325, 135,WE REPLACED THE AIR CONTROL VALVE AS IT SHOWED OHMS READINGS OUT OF SPECS, WE CLEANED EGR VALVE AS IT WAS CLOGGED AND RAN IT THROUGH THE IDLE VOLUME PROCEDURE. NOW YOU NO LONGER HAVE TO DOUBLE FOOT IT BUT IT STILL STALLS ON DECELERATION AND CAN JUST BE SITTING AND IDLING AND STALL. INJECTOR PULSE AND IDLE AIR CONTROL SEEM TO


Check the fuel pressure as it can be the problem of fuel not reaching the engine properly may be clogged up fuel pressure.as you have ruled out all the possibilities for this problem.so all parts needs to be checked with meter for proper voltage.fro ... Nissan Maxima

My 1990 Honda Prelude idle goes up and down,I replaced the idle air control valve with a new one my cooling system is full and it is still going up and down I'm stumped,everyone said idle air control valve it has to be something else,anyone have an idea. By the way it is a 2.0 si mpfi double overhead cam thanks Mike Smith


... Honda Prelude

In my 2000 Saturn SL1 I am experiencing very high idle (2000 rpm warm - higher cold). I have cleaned the throttle body and the idle air control valve with no improvement. What next, replace the idle air control valve? Any other suggestions? Thanks, Sandy R


You could try replacing the idle air control valve but I would obtain one from a local salvage yard, its cheaper and you are not certain if thats the problem, another thing i would check is your intake manifold gasket where it meets the cylinder head ... 2000 Saturn SL

Had a rough idle and the engine dies while driving. Got a code P0505 Idle air control system malfunction. Replaced the pcv valve and the idle air control valve but it is still doing the same thing, check engine light is also back on.


Does yurs have the idle air control motor if so look into that ... 1999 Dodge Durango

I have a 98 dodge Dakota 4x4 auto 5.2. Air idle controle valve was loud all the time and wound load up on fuel n die and also rpms wont go past 2000. So I changed both o2 sensors. Now air valve is not loud at idle most of the time. But still won't rev up. When I try to rev it up it bogs down n smokes alittle n some soot sometimes comes out. Fuel presser is 45 psi @idal new o2s new air temp water temp new tps used map used air valve. Please help


Here's a link on what may be wrong.Here's how to ... Cars & Trucks

2000 Chevy Impala 3.8L any idea if I can prelace the idle air control valve o-ring?


... 2000 Chevrolet Impala

My 2000 Chevy Impala 3.4 shuts down when I take my foot off of the gas peddle completely. At a light I must have a foot on the brake while the other foot is on the gas and I must give it gas to start it. I.v changed the master air flow, The Idle control sensor, the throttle position sensor and the pcv valve connections. What else could the problem be? (oh yeah, there is no check engine light with all of this)


Vacuum lines are broken, cracked, or removed? I had the same thing in my Lincoln, ended up being 2 cracked vacuum lines and the Mass air flow. ... 2000 Chevrolet Impala

Hi i have a problem with my idle air control valve i replaced it and i'm still getting the engine check light even if i reset it. i still get the same code telling me the my idle air control valve? what should i do. THANK YOU


If it is idling good, then have the light turned off with a scanner, to see if it stays out. auto zone will do this for free! ... 1998 Toyota RAV4

Idle Air Control Valve equinox 2005 - 2005 Chevrolet Equinox


... 2005 Chevrolet Equinox

IDLE AIR CONTROL VALVE - 2009 Chevrolet HHR


... 2009 Chevrolet HHR

Replace idle air control valve - Corvette Chevrolet Cars & Trucks


... Chevrolet Corvette

I have a 89 chevrolet K2500, it runs fine when cool but after warming up it runs rough and will cut off. i have already changed the fuel filter, pump, sending unit, plugs, wires, cap, rotor, idle air control valve, and o2 sensor. Have any other ideas on what else could be causing the problem.


... 1989 Chevrolet Silverado 2500

INSTALL IDLE AIR CONTROL VALVE HOW TO - 1992 Chevrolet Cavalier


... 1992 Chevrolet Cavalier

I have a 94 Jeep Grand Cherokee Laredo that stalls when slowing down, turning slowly or stopped at a light. Just before it stalls I notice the battery meter drops significantly. The battery is good and the cables are tight. I have had it tested for vacuum leaks. I have replaced the distributor cap and rotor (the contact points were black), the catalytic converter (was busted up inside), and the Idle air control valve. After replacing the Idle air control valve it stalls less often, but still sta


Are you able to pull a trouble code from this vehicle by cycling the key on-off-on-off, then leasve it on and count the flashes given by the engine light in the dash??? ... 1994 Jeep Grand Cherokee

Where is the idle air control valve location on a chevrolet uplander 05


... 2005 Chevrolet Uplander

What are the steps to replacing the idle air control valve? i have the idle air control valve and the gasket.dont want to pay a mechanic an hours worth of labor if i am able to do it myself.thanks


I'm already faced this problem and got my solution from here. Hope it \012will help you to solve yours too. Here is the link for your Solution " bit.ly/fixyablog-post17762 " (Copy this link on your browser and read the instructi ... 2000 Mazda Protege

2002 chevy tracker idle air control valve - 2002 Chevrolet Tracker


... 2002 Chevrolet Tracker

97 Chrysler Concorde high idle speed A 1997 Chrysler Concorde starts fine, but idles at 2000 rpm. The idle increases to 2500 as it warms up. Vacuum is at spec, and no signs of intake leak. We have replaced the coolant temp sensor (previous code), idle air control motor (previous code), one front O2 sensor, EGR valve and control, and MAP sensor (previous code). The previous owner had the PCM replaced with a used unit, with no luck. We have not yet replaced the intake air temp sensor,


Couple things to check out. what is the throttle position sensor readings fully closed (should be .5volts). if it's above the pcm may think the car is not at idle. did you spray sections of vacuum lines and manifold gaskets with brake clean to check ... Chrysler Concorde

Can an Idle Air Control Valve for a 1989 Mustang 2.3 litre be cleaned? Because I can't get the idle any lower than 900 rpm and the idle adjustment screw is as far as it can go. I've cleaned the throttle body, but did nothing, I'm assuming that it's the Idle Air Control?


Yes,wire brush. try checking throttle position sensor is in the right voltage range with a multimeter should be between3.2 and 3.5 volts depnds on motor check manual. ... 1989 Ford Mustang

I have a chevy silverado - 5.7 engine. It runs rough, wont idle and most time dies unless i pop it in neutral, shakes and sputters when i accelerate and not much power. I have replaced the air filter, gas filter, ERG valve, ERG relay, spark plugs, wires, rotor, cap, PCV valve and hose going from PCV to intake and vacuum hoses on intake. I have tested the throttle position sensor and idle air control valve and appear good according to the service manual. Any other ideas?


Fuel Pressure/Pump?Injectors?Fuel Pressure Regulator?Are there any codes/check engine light?Ignition coil? Just off the top of my head. ... 1995 Chevrolet K1500

I have a 1992 Pontiac Sunbird SE with 3.1 V6, automatic transmission and air conditioning. When the engine is started, the idle speed immediately revs to 2900 rpm. When I put it into gear, the rpm drops to normal. This extra high idle speed only occurs when it is in park or neutral. The check engine light has not come on but I've checked for codes and there are none. I've checked the EGR valve passages and the Idle Air Control Valve passages and there were no blockages. There was just a sm


You may still have some gunk in the IAC that is preventing the plunger from functioning properly and shutting the airflow. Also check the wiring at the connector to the IAC. The fact that it operated as it was supposed to once after the cleaning sugg ... Pontiac Sunbird
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.5579 seconds