Having problems with your 2006 Chevrolet Aveo ?

Vibration front right wheel when driving and braking 2006 aveo

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2006 Chevrolet Aveo

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vibration front right wheel when driving and braking 2006 aveo


... 2006 Chevrolet Aveo

Front brakes drag (more on left than right) while driving in rush hour stop-and-go traffic. Both rims get hot the left more than the right. Also have some steering wheel vibration and brake pedal pulsing. Everything clears up after a few minutes of driving at a steady speed or just stopping and waiting. read something in the Drivers Handbook about this but no permanent fix is offered. Plan right now is to replace stock brake pads with ceramic ones and put on new discs. what's your opinion o


Sounds like the pads are completely worn or either crystallized. The crystallized happens when the brakes get hot and cool water hits them, this will also warp the rotors. With the brakes pulsating, it may be the rotors are warped and have worn the ... 2003 Chrysler Town & Country

2004 Kia spectra, driving down highway, heard loud bang on right front side, as though I ran over something, (nothing in road that I hit). Since then, when applying brakes, the front right wheel vibrates sporadically In addition, the brake pedal requires significantly more pressure to brake, vs before.


Have you jacked up vehicle and checked front suspension/steering for looseness?remove rf wheel and also see if a brake pad lining has come off..check caliper bracket mounting bolts and caliper for broken/loose bolts..this is where i would start ... Kia Spectra

I have front end vibration that is not caused by alignment. New tires on all four wheels but still have alot of front end vibration. Car is a 2004 Hyundai Tiburon. this information is helpful but not exactly. i also have vibration while driving at 60-70 mph. tires were just rotated. no shimmy in the steering wheel or looseness. the car does not pull to the left or right when braking and it is serviced on a regular basis (2005 ford focus). i'm apprehensive about taking it to the garage as i fee


I would suggest going to a local shop and asking that they balance your wheels. It should take about half an hour and should cost less than $30.It is possible that one of your wheels has lost a weight that had been\015\012installed when y ... 2005 Ford Focus

Suspension Had struts put in [front and rear] few month ago. Shruts were shot. Now when I'm driving over any bumps there is alot of rattling and vibration in the front. Very noisy. On the highway its worse. The sterring wheel vibrates and the car pulls to the right when I drive over any bumps. Scary and dangerous. Have two new front tires and 4 wheel aligment done. The noise in the front has getting worse each day since the struts were put on. I can feel the vibration on the gas pedal when drivi


The struts and shocks where not tightened properly take it back and have then tighten everything down to correct specs. But before you leave your hosue check your tire lug nuts and make sure they are tight so you can drive over there and like i said ... 1999 Chrysler Concorde

1997 intrepid vibration right front tire feels like it fibrates between 46 to 55 mph and front ends sounds limke it s grinding not real bad but you can hear it while driving i pulled the wheels off and the brakes are good and the cv jounts are great none of the bushings look wore at all the car has 96000 miles on it


97 Intrepid, 3.5L, 220,000 miles, nasty vibration from passenger side front wheel under heavy acceleration between 50 and 60 MPH. Replaced what remained of cradle bushings. Dooo-Waah and off we go again! Wow, what a difference. ... 1997 Dodge Intrepid

I have a 2000 Toyota Tundra V8 4 wheel drive. I just replace new rotor,caliper(old and rusted), and brake pads( front left/right wheel). 1) My friend and I bleed the brake line. I pumped the brake pedal 3 to 4 times till hard. We started from the driver side first, rear passenger side, rear passenger side, and than front passenger side. We did this process twice. The brake is still spongy? 2) When we drive the Tundra and press on the brake we feel a little vibration on the driver side brake?


... 2000 Toyota Tundra

High speed vibration 100 km and above (60 mph +) can feel the vibration in seat, steering wheel, gas pedal, brake pedal, dash, floor. feels like driving over rubble strips, without the noise at times. -new u joints front to back, new wheel bearings, tune up done, new shocks, leaf spring re arched, transmission fluid and filter changed, 4 new tires, wheel allignemnt and new rack new brakes front and back, has all been done. yet I still have a significant vibration 100km plus.


... 2005 Chevrolet Silverado

Sounds like a wheel barring but it started when i would drive down. whenever i turn the wheel to the right, there will be a vibration in the front. Now, it happens all the time when i drive but its a constant humming noise and when i turn to the right, it makes the humming and the vibrating humming noise together


Probably a wheel bearing ... 2003 Chevrolet Malibu

The ABS light is illuminated. The Word Brake is flashing. There is a Indicator light that is a Circle with a triangle inside lit but not flashing. I drive around for my job and these usually come on later in the day. Could be on the highway or a secondary road. I don't think speed is an issue. The right front wheel lost a balance weight which has had minimal effect on the ride, very slight vibration. I don't know if this could have caused the indicator lights or not. Any insight I could get woul


... Volkswagen GTI

While driving when you turn the wheel slightly to the right you hear a noise with some vibration. front tires and brakes are new. could this be cv joints or struts?


Need more info but sounds like power steering gearbox or cv joints. What happens when you turn all the way left or right? Is it worst or better and what do the noises sound like? Whining or grinding? ... 2002 Saturn L-Series

Have a ford galaxy 1.9tdi. 03 plate; 80,000miles. Has slowly developed a low rumble in front wheels. Also a slight vibration in steering wheel. There is a significant vibration when braking between 70 - 60 and 60 - 50. Have changed tyres, wheels brake pads and discs. Although low level, the noise is constant. Greater intensity when cornering; but again, not hugely loud. Just this rumble. Good garage; do not want to change parts unless sure. Not pleasant to drive now on long journeys. Please help


Wheel bearings. ... 2003 Ford Ranger Regular Cab

2001 Monte Carlo SS. Can feel a slight vibration and high and low speeds, hit the brakes and it's a bit stronger. Hard right turns it feels like the right front wheel is wobbling. I changed BOTH front hub assemblies, had the front end aligned(they said everything looked good), and bought new tires. Still got the vibration. Don't mind spending cash to fix it but don't want to just keep throwin parts at it. Any ideas????


Have you changed the rotors? or at least have them machined. This sounds like you have heat warpage on the rotors. ... Chevrolet Monte Carlo

2003 suzuki aerio passenger front brake keeps locking up. i have replaced the pads, disc and the caliper,??????? drive about 5 mins and they get tight, then when used they lock up, right front only this is Not all wheel drive and doesnt look like it has and wires down there for anti lock brakes. someone said to remove the abs fuse and i did a test drive and it hasnt happend yet. so would it be the abs? and what would it be?


This problem is only caused by one thing on this late model car, that is a leaking hydraulic control valve in the ABS unit, this allows brake pressure to be applied to the caliper pistons without any input from the driver. ... Suzuki Aerio

2003 Cavalier - are both front wheels drive wheels. I have the car up on jack stands to service the rear brakes and when done had the vehicle put in drive while still up and onyl the right front was turning.


They are both drive wheels, but on these type of vehicles it is like a limited slip differential. When you give it gas and it gets in a bind it will lock in the other. ... 2003 Chevrolet Cavalier

I have a 2000 Model 2.0D toyota Corolla which is in excellent condition with no problems except when i press the brake at medium and above speed, the car swings , front portion left and rear portion right. have got all brakes checked. The brake pads and rear brake shoes are new and everything is in order, wheel alignment and balancing of the wheels has also been done which is perfect but the problem remains which is a risk in driving. Pl help !


Hi Hassan,Seems the most likely cause of your problem is the adjustment of the rear brakes. There are automatic adjusters which sometimes become seized with rust or dirt build up. Jack up thr rear of the vehicle, and place the vehicle on chassi ... Toyota Corolla

1990 chev 1/2 ton two wheel drive, left front brake sticking, sometimes, now pulls to right when brakes applied. took off left caliber and sprayed with brake cleaner and that seemed to help. but still not right, what should i do now?


What i would do from experience is to take the caliper off and clean up the sliders really well even with a light sand paper then lube up with silicone lube, this should help but like the other guy said it may just be worn so youll need to replace it ... 1990 Chevrolet K1500

Screeching noise While driving my front right tire/wheel area starting screeching loudly, the noise would only happen while I was moving and was unchanged whether I had the brakes applied or not, or had the clutch engaged or not. When I turned the steering wheel all the way one direction something thumped softly, and now it's not making the noise. I took off my wheel and can't find any signs of grinding or scoring anywhere on the suspension or brake rotor. I'm inexperienced and have suspicion


If your C/V joint is going bad it will make a nasty clicking sound and get louder the longer you leave it unattended.If this noise went away it could have been something stuck it the moving area of your wheel and just worked itself out.Keep an ear ou ... 1996 Honda Civic

With the 1994 Pontiac Grand Prix Has trouble taking off. low fuel mileage.. Car acts like the left front wheel dragging. I've ruled out brakes, wheel bearing/hub. With frontend jackedup in the air, trans in neutral, the right tire spins freely, the left turns but not as easy. In drive, same thing, right spins faster than the left. Doesn't seem to be as noticeable in reverse


Is it's CV joints in good condition? Might be an axle issue. ... 1994 Pontiac Grand Prix

I have 1998 Mercury Sable DOC. I have some vibrating in the front end, I have had bearings, ball joints, brake pads, rotors, calipers, tie rod ends replaced and the vehicle still shakes. I notice it more when I am going right around a corner, the left front wheel shakes and can be felt in my steering wheel. Please help running out of solutions and feel like the mechanics are taking me for a ride!


This is something that,after all youve done will really **** you off if it works.........try changeing wheels/tyres front to rear.OR as the car leans over to the left when turning right,you put pressure on the left side,could it be the right shocker ... 1998 Mercury Sable

Changed front left hub assembly on a Mercury Mountaineer 97 and now there is a loud noise when we drive forward but no noise when you back up. The noise was not there till the hub assem was changed also there is no noise when you turn the wheel to the right I think... One way or the other, there is no noise. When you drive faster the noise goes faster like something is not on right and hitting as you go.There seems to be nothing wrong with the axle. Brake light comes on.It is a loud noise like i


When i hit a curb with my 97 cavileier and bent the center hub its made a noise something like the one you are describing i changed it to a new one and there was still a slight noise i took it back of and took a closer look and the new hub had a slig ... 2003 Ford Focus

Occasionally after driving and stopping my right front brake caliper is slow to release,a few times it actually stayed applied and become extreamely hot. When this happen I opened the bleeder screw relieved the built up pressure and the caliper released the brake pads and the wheel was able to turn free. This is the only wheel that is sticking, and I thought if the caliper was sticking, opening the bleeder wouldn't have any effect, what say you?


Replace the rubber brake hose on that side....they are prone to rotting on the inside and letting fluid pass through it ,but not letting it back out,causing caliper to stay hung up and making you believe caliper is sticking,and opening the bleeder le ... 2000 Chevrolet Venture

Constant Vibration My brother has a 2006 Buick Rendezvous, 2 wheel drive. He recently had a half shaft installed on the right front side as it was bent; he also has two brand new tires on right side, but he still has a very noticable vibration anywhere from 20 mph and up. Very unfortable ride. Could this possibly be a hub bearing? Or any other suggestions?


Well, you may need a front end alignment for one. Two, who replaced the halfshaft? ... 2006 Buick Rendezvous

Brake problems We have a problem with our 1984 240 GL Volvo. The brake pedal went to the floor while driving, after pumping it the pedal came back. I took it to the shop and they said I needed a master cylinder. They put a new master cylinder in and when I drove it away from the shop the brakes began making a horrible noise and felt like they were dragging badly, something clearly was not right, I took it back to the shop and they pulled the front wheels off and told me I needed brake pads but t


I had a somewhat similar problem, brake failure. Had them bled 3 times by the same place (a Mavis dealer - it was the closest place to me). Turns out the cause was that (and I honestly forget which brands have how many bleeder valves in the front), b ... 1984 Volvo 240 Series

Brakes We have a problem with our 1984 240 GL Volvo. The brake pedal went to the floor while driving, after pumping it the pedal came back. I took it to the shop and they said I needed a master cylinder. They put a new master cylinder in and when I drove it away from the shop the brakes began making a horrible noise and felt like they were dragging badly, something clearly was not right, I took it back to the shop and they pulled the front wheels off and told me I needed brake pads but they coul


There is a sertain way to bleed some lr/rf/rr/rf check autozone for repair book it gives way for diff.systems but you got air or master cylnder ailed when went to floor may have to bench bleed also ... 1984 Volvo 240 Series
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.3262 seconds