Having problems with your 2006 Cadillac CTS ?

Need instructions on putting back the air intake manifold. do i need new screws? what's the right torque to apply? whats the pattern I should follow? and what are the increments of torque pressure I should apply to the screws? 06 cadillac cts 3.6

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

To install:
\015\012
    \015\012
  1. \015\012 If necessary, assembly the intake manifold:
    \015\012 \015\012
      \015\012
    • \015\012 Install the upper manifold to the lower manifold using a new \015\012gasket.
      \015\012
    • \015\012
    • \015\012 Install the fuel injector wiring harness bracket bolt. \015\012Tighten to 89 inch lbs. (10 Nm).
      \015\012
    • \015\012
    • \015\012 Tighten the upper-to-lower intake manifold bolts to 17 ft. \015\012lbs. (23 Nm).
      \015\012
    \015\012
  2. \015\012
  3. \015\012 Install the intake manifold with a new gasket. Tighten the bolts\015\012 to 17 ft. lbs. (23 Nm).
    \015\012
  4. \015\012
  5. \015\012 Install or connect the following:
    \015\012 \015\012
      \015\012
    • \015\012 Fuel injector harness bracket. Tighten bolt to 89 inch lbs. \015\012(10 Nm).
      \015\012
    • \015\012
    • \015\012 Left bank ignition coil harness
      \015\012
    • \015\012
    • \015\012 BARO sensor electrical connector
      \015\012
    • \015\012
    • \015\012 Intake manifold runner control solenoid electrical connector
      \015\012
    • \015\012
    • \015\012 PCV hose to the camshaft cover
      \015\012
    • \015\012
    • \015\012 Upper intake manifold brace. Tighten bolts to 48 ft. lbs. \015\012(65 Nm).
      \015\012
    • \015\012
    • \015\012 Throttle body electrical connector
      \015\012
    • \015\012
    • \015\012 Purge solenoid valve electrical connector
      \015\012
    • \015\012
    • \015\012 Brake booster vacuum hose to the manifold
      \015\012
    • \015\012
    • \015\012 Air intake assembly
      \015\012
    • \015\012
    • \015\012 Engine shroud
      \015\012
    \015\012
  6. \015\012
  7. \015\012 Start the engine and check for leaks.
    \015\012

Actually there are TWO intake manifolds on your vehicle
\015\012
    \015\012
  • upper
  • \015\012
  • lower
here's the upper
8b19814.gif

here's the lower
285c9ca.gif

here's your specs
9b057a5.jpg



Repair Help & Product Troubleshooting for 2006 Cadillac CTS

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need instructions on putting back the air intake manifold. do i need new screws? what's the right torque to apply? whats the pattern I should follow? and what are the increments of torque pressure I should apply to the screws? 06 cadillac cts 3.6


To install:\015\012\015\012\015\012 If necessary, assembly the intake manifold:\015\012 \015\012\015\012\015\012 Install the upper manifold to the lower man ... 2006 Cadillac CTS

Installing Manifold of a 06 Cadillac CTS. I need the pattern that I should follow when Tightening the bolts to the upper Manifold. I replace my spark plugs. I Tighten the bolts to 17 ft. lbs. Started the car and after a few seconds the car will start ticking, and the ticking keeps getting faster. I'm assuming it's an air leak for not Tightening the bolts in the right order. but if you have any ideas please let me know


The ticking noise is most likley you didnt get the coil wire on the plug. If it were a vacuum leak if you sprayed water you would hear it **** in. Also if you spray brake cleaner the RPM's would go up when it got sucked in. As long as you started in ... Cadillac CTS

Need to know torque specs on front bearings of my 2003 cadillac cts


... Cars & Trucks

Need to know what the torque specs for a 2005 cadillac cts 3.6 liter are


... Cadillac Cars & Trucks

Whats steps do i need to follow on replacing a fuel pump on a 2003 cadillac cts


The fuel pump is probably in the gas tank. You can check if the pump works by turning the key to on without starting the engine. Open the fuel door and remove the gas cap. Put your ear up against the gas filler tube and listen for the fuel pump ru ... Cadillac CTS

I need the head bolt torque sequence for a 1996 honda accord 2.2? I also need to know the pounds of pressure and how many passes needed to torque. Thanks


Install the cylinder, then tighten the cylinder head bolts sequentially in 3 steps. step 1. 29 ft. lbs. step 2. 51 ft. lbs. step 3. 72 ft. lbs. ... 1996 Honda Accord

What tools do i need to replace starter on 2003 cadillac cts?


... 2003 Cadillac CTS

I need to know the torque specs for an 02 lancer oz ralley pressure plate. Also need the drive housing nut torque spec.


... Mitsubishi Lancer

Need to replace ect on 2003 cadillac cts - CTS Cadillac Cars & Trucks


... Cadillac CTS

I have a 2000 buick century,the trans. is acting up,on a hard pull it don't want to shift right.Had a code read out and was told the torque converter sensor was bad and need to pull the trans.Where is the torque sensor located and do I have to pull the trans.I ask if it could be the govner solnoid and pressure switch and they said no-------need help Thanks Larry


I would also check the detent cable as well just for safe measures might throw off the sensor giving bad code ... Buick Century

I have a 2003 ford f350 6.0 turbo diesel, automatic the truck has no power!!! I have did the following: NEW- turbo NEW- injector NEW- fuel pressure regulator NEW- high pressure oil sensor NEW- injector control pressure sensor NEW- accelator pedal I have checked all the volums, powers & grounds in this vehicle and compared the infomation. PLEASE I need help!!!! thank you for any help you can provide me!!!!


The only help,I can provide is,if you have tried supreme additives for the fuel,and changed the fuel filters afterwards,then the injection pump,is either clogged,or needs replacing,That is about all that is left ,except for the chip in the computer,b ... Ford F-350

I can not locate the low pressure vavle to add the 134a freon to recharge the system, one article said it is located on the drivers side near the firewall, also the cap would have an L on it. im pretty sure the vavle i found on the passenger side is the high pressure valve. I need a picture diagram for a 1995 jeep grand cherokee!!! i followed all the lines out and can not locate the low pressure vavle


Go here. \015\012http://i5.photobucket.com/albums/y192/fonzz300/P1000436.jpg\015\012that should be it ... 1995 Jeep Grand Cherokee

I need the diagram, how much torque (if need) the bolts and nuts need in the clutch and pressure plate in 2004 rx8 manual transmission


... 2004 Mazda RX-8

Need Cadillac CTS 2006 remote programming info


I went to keylessride.com and looked up your vehicle and the remotes need to be programmed by a locksmith or dealer and being a locksmith myself I know that my prices are generally lower than dealers ... 2006 Cadillac CTS

Need to replace water pump on a 03 Cadillac cts I


10 4 you have 2 remov rad power steer ac cond big job ... 2003 Cadillac CTS

I need to find a vacuum schematic for a 2003 Cadillac CTS


... 2003 Cadillac CTS

Need repair manuel for 2004 Cadillac CTS


Similar to obtaining an owner's manual, you can obtain a repair manual from the same sources identified in this handy, diagnostic article:\015\012 ... 2004 Cadillac CTS

Need wiring diagram for outside air temp sensor 2004 cadillac cts


The wires have no polarity, so no mater how you connect it should work. ... Cars & Trucks

Need to replace a purge vent valve on 2006 cts cadillac where is it located and what does it look like


If you buy one from the dealership you will know what it looks like !Replacing it , , , it can be located in a few locations but it is usually on the bulkhead under the hood. ... 2006 Cadillac CTS 3.6

Truck will start to shake. this happens around 70-80k when under pressure. trans says its not the trans. torque converter seems to be suggested. read a bulletin on 94 1500 that said its got to do with elec. problems. mentioned the exact problem but refered to it as torque converter shake or roll or somthing along that line. showed diagram of elec. wiring that need rearanging the circuts and resistors. if i could remember the bullentin problem would be solved. oh,started the truck this morn and t


Also check the Ujoints on the driveshaft and wheel balance for the shake. ... 1994 Dodge Ram

I own Cadillac '95--A cadillac dealer put my car on the scanner and found that I needed the following: 2 Rear Hubs, Rear ABS Harness, And Re- Diagnose the driving ability capability. What is your opinion about me keeping or selling the car?


I know from experience, this is a big price tag. It just depends on your situation. If this is all that is wrong, it is probably worth getting fix. Don't just get one price quote though. Call around and see what other people charge for labor. Changin ... 1995 Cadillac DeVille

What transmision fluid need 2005 cts - 2005 Cadillac CTS


Normal ATF any colour will do ... 2005 Cadillac CTS

I have a 2003 Cadillac cts and there is a message on the information center that says "msg tp" and I can't find anywhere what the tp stands for. I thought it was tire pressure but I checked the tire pressure and the message is still there. What doess "msg tp" mean?


Eon=enhanced other networks..means a stonger signal/ same station is being recieved. \015\012ta/tp=traffic info from stations tuned into (if applicable)they send out traffic info like bad weather/jams,so you have a stored message..... \01 ... 2003 Cadillac CTS

Service engine light comes on often/ something with the torque converter / Does this mean that I need to get a new transmission? Do I need to take it to a cadillac dealer ?


These cars had torque converter clutch solenoid failures any transmission shop should be able to diag and repair. ... 1999 Cadillac DeVille

What type of oil do i need fot cts 2003 - 2003 Cadillac CTS


Regular 5W30 oil will work just fine in the '03 CTS. Your owners manual\015\012will tell you to stay away from any other viscosity (5W20, 10W30, etc)\015\012because they will be either too thick or too thin. It does not require\015\012synthetic as it ... 2003 Cadillac CTS
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.3451 seconds