Having problems with your 2005 Peugeot 407 2.0 ?

Peugeot 407

\015 Electronic anti-theft faulty i am unable to start the car so help me thanks\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2005 Peugeot 407 2.0

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a peugeot 306 hdi 2 0 starts but spluttering and only reving up properly at 3000 revs ive had a diagnostics on it and it says the injector system is jamed . any help please .


... Cars & Trucks

307 hdi peugeot .will turn over.but struggles to start.when temp falls below 0 degrees.


... Peugeot 405

Peugeot 406 98model has S and star lights blinking on dash board, diagnosis says: '[Ie,94,0,30] please refer too relevant manual intermittent fault'


... Peugeot Cars & Trucks

Peugeot 406 speedometer sometimes drops to 0 mph


... 2005 Peugeot 405

Can anyone tell me what these engine fault codes refer to on a 1998 mercedes c180 auto,1.8 petrol. I suspect it may be releated to tempeture sensor. Total of 6 codes 065 (2,2,0,41) resistance too high 104 (2,2,0,68) resistance too low 122 (2,2,0,7a) resistance too low 126 (2,2,0,7e) resistance too low 129 (2,2,0,81) resistance too low thanks jim 161 (2,2,0,a1) resistance too high


Most common is o2 sensor ... 2002 Mercedes-Benz C-Class

03 gmc envoy with 5.3 140000 miles. Oil pressure reading fluxuates between 0 and 40. When problem first started pressure read 80. When vehicle was new it stayed at midpoint (40) vehicle has plenty of oil. if you rev engine or increase rpms it goes to 0 and stayes there. let off and it jumps around like it did when started (0 to 40). No engine pecks while running. Display indicates low oil pressure and stop engine. orange light (check gages) comes on when at 0. any ideas. Service engine has not c


There may be a loose wire or the gauge or sending unit may be going bad. The first thing I would do is to hook up a temporary oil pressure gauge, not using the old one at all. With this watch gauge while driving and see what readings you get. If the ... 2003 GMC Envoy Xl

Hyundai sonata 2000 gls. v6. HAs no EGR. Emission test, first try, HC(0) CO (0) nox 1033 mechanic said my engine seems hot (there was also heat out of vents blowing out. I cleaned my maf sensor and put on high octane gas and fuel cleaner drove for a week and retested. ssecond try HC(0) CO (0) nox 1250. failed agian. I changed my mass airflow from anotehr car and change my 3 front spark plugs myself not the three at back. Car seemed to be running better and engine definitely cooler no mor


... 2000 Hyundai Sonata

I have just purchased an Antler cabin bag with a TSA lock, should be preset to 0 0 0 as per factory setting & I should be able to open it, unfortunately this is not the case, any suggestions????


... Cars & Trucks

How do i get my keys out of my locked boot on the peugeot 307cc?


... Peugeot Watches Cars & Trucks

Peugeot 406 break rear seat belt in the midle are stuck. How can I repair or replace mechanism?


... Peugeot 406

Fitting a radiator on a Peugeot Expert van - Peugeot Peugeot Cars & Trucks


... Peugeot Peugeot

Peugeot Instructions How can I jump a 308 Peugeot from a 3008 Peugeot when I cant reach the neg on the battery


You don't necessarily have to attach your ground to the ground on the battery. You can ground to the engine block and it will do the same job. Yuo may have to scratch it a few times to get good contact. Hope this helps. ... Cars & Trucks

Clutch adjustment on peugeot expert 2004 van - Peugeot Peugeot Cars & Trucks


... Peugeot Peugeot

Loss of power peugeot 4007 - Peugeot Peugeot Cars & Trucks


... Peugeot Peugeot

Peugeot expert door locks - Peugeot Peugeot Cars & Trucks


... Peugeot Peugeot

Need Peugeot e7 motion locks wiring diagram - 2002 Peugeot Peugeot 307


... 2002 Peugeot Peugeot 307

R reg peugeot expert clutch cable adjustment - Peugeot Peugeot Cars & Trucks


... Peugeot Peugeot

97 gmc suburban, no start, has spark and fuel. no codes. scanner shows no problem, except cam ******=0 knock ******=0 and spark ******=0 doesnt show inj. pw. leaning towards pcm??any help would be great


... 1997 GMC Suburban

The oil pressure gauge is going directly from 0-80.....as soon as you crank up the vehicle....Its running fine, no lights have come on, running smooth like normal, its just that the gauge in the dashboard is going from 0-80....what could this be ....this is the gauge that has 0-40-80 and the picture of the little oil container


It sounds like there is a problem with the oil pressure sending circuit. The oil pressure sender changes voltage according to the differences in oil pressure. If it is pegged all the way to the max, there may be a short (or open, depending on the w ... 2003 Chevrolet Tahoe

Peugeot boxer lx920 drum brake diagram - Peugeot Peugeot Cars & Trucks


... Peugeot Peugeot

Peugeot boxer wiring for towbar - Peugeot Peugeot Cars & Trucks


... Peugeot Peugeot

1990 corvette tachometer problem, when the key is turned on the tach needle moves from slightly below 0 up to 0 but does nothing more when the engine is started and revved up


... 1990 Chevrolet Corvette

Peugeot 406 loses power -1991 PEUGEOT 406 executive; 1997cc


Yes i think that i can help you.Please just send me yuor car chassis number and mor details about the symptom ... 1991 Peugeot 405

1990 toyota 4 runner Gun timing mark?? 0 or degrees after 0??


... Toyota 4Runner

Frieghtliner m2 fault codes eng 0, 4376, fail 5 and eng 0, 3361, fail 05


... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0632 seconds