Having problems with your 2005 Ford F-150 ?
Clunking noise in back of truck\015 From a stop when I begin to slowly take off there is two clunks coming from the rear of the truck and it only does it when its under a load.\015
Repair Help & Product Troubleshooting for 2005 Ford F-150
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
I get a clunking noise from the front of my truck when I cold start it and only for a few min as is warms up then it goes away. This started in cold weather 35-60F. I have a chevy silverado 2001 1500 4.8L. only mods I made before the noise was a ram air intake, cat back flowmaster ehaust and put synthetic blend 5w-30 motor oil rather then the basic 10w-30 the used to be in there. The noise didn't start right after all these things about 2-3 weeks later it did. Not sure where the noise is co
This engine has forged pistons whitch expand more than hyper-u-tec-tic pistons when heated . this is normal for this engine . my brother has a chevy silverado 2001 1500 4.8Lwith 650,000 kms and he said his made that noise when it was brand new and ... 2001 Chevrolet Silverado 2500
Clunking noise in back of truck
... 2005 Ford F-150
Backing up made clunk noise and when dry sterring it makes a clunk noise when turning wheels left and right
You're probably going to need a shop to look at the front suspension.With extra weight in the back, the front could have been up enough to cause something to come loose such as a strut mount. And that could happen just from old age without the ... Cars & Trucks
My truck make noise, a clunking sound when I back up and cut the wheel to the left or right. The tires skip also.
... 2003 Mercury Mountaineer
Clunking noise back end of car - Toyota Cars & Trucks
... Toyota Cars & Trucks
I have a 2004 f150 5.4 v8. i had very loud noise at start up and intermittently at idle even after being at operating temp. I took the truck to local shop and they changed two cam phasers sending me on my way, truck ran fine for one day... second day same problem came back (loud noise occasionally even at higher rpms) vey intermittent... took truck back to shop where they refunded charge for cam phasers and advised i take the truck to dealership... the dealership told me i need a new timing chai
I would bite the bullet and trade it off on the other hand try another shop and get a second opion. ... 2004 Ford F150
I put my 2004 ford ranger in 4wd and it made a horrible grinding noise when i moved forward and the truck moved very slowly. i stopped, put the trans back to neutral and shifted bacck to 2wd but the truck stayed in 4wd. after about a minute, the truck slammed back into 2wd and im afraid to go back to 4wd for fear i wont be able to go back to 2wd again . what should i do?
Have your transfer box fixed,,,its busted? ... Ford Ranger
I own a 2003 lincoln navigator. I have a problem sometimes where I go to start my truck and all I hear is a buzzing noise coming from my fuse box on the passenger side of the truck by the passengers feet. When I hear the buzzing noise the truck will not start. I walk around to the passengers side door and open it and turn my key and I observe the fuse box and a loud buzzing noise continues to come out. When i start pulling out some of the fuses and put them back in the truck will start up. I hav
Its the relay in the fuse box by the passenger side floor board. Remove the kick plate and its either white relay on the top (one is mounted horizontal on the right or rear position and vertical on the front or left. Its $6 bucks at Auto zone. You ca ... 2003 Lincoln Navigator
My truck is running bad. it started when my truck was under pressure like going up a hill ther would be a noise like the timimg chain making a clinging noise then my check engine light would come on . iwould then lose power but i could put it in nutural while driving turn it off then back on and it would be fine. but it got worse over time . then it started cutting out like i turned the key off and then back on .this kept getting worse now it is real bad you cant even drive . i gave it a tune up
The possibilities are endless. do a compression check on the cylinders and see if your dropping a cylinder. If so this could be a valve sticking, bad head gasket, cracked cylinder wall (Where I would really start looking). Your symptom, by your de ... 1988 Chevrolet Silverado 2500
This evening my 2001 GMC Sonoma was in 4-wheel drive. As I was backing out of a parking spot, I heard a clunk and had no brakes. I continued to back up with no brakes and then finally felt my brakes coming to. I again proceeded forward and noticed I had no brakes again, so, I placed the truck in reverse and put truck in 2-wheel drive and got my brakes back again. Is the truck just not engaging in 4-wheel driver properly?
I would not drive that truck 1 more foot until that brake situation is rectified! No the 4 wheel drive cannnot make the brakes go out, they are 2 seperate systems entirely and have aero to do with the other as far as operation. This is a very dange ... 2001 GMC Sonoma Extended Cab
My yukon is making a funny noise every now and again it kinda sounds like it mite be the rear end but not sure but it is a clunking noise definitely coming from the bottom of the vehicle but when i exceeded to a speed of 55mph or greater it stopped and didnt start back until 2hrs later and 30-40 mph, it doest make a consistant noise it will just go clunk and then clunk again
Dear,\012\012Next time buy a Honda, you won't have trouble like this.\012\012\012Allah Akbar! ... 1993 GMC Yukon
I just started having problems today. 2001 ford f150 . It felt like tranny was slipping. Checked fluid, a little low, topped it off. truck goes into reverse but wont move backwards. truck moves forward but makes a funny noise. truck will now backup but makes noise that sounds like it is coming from the back wheels or the rear
Sounds like the rear end differential is going out. I had a similar problem on a customer's truck, and it was the differential in the rearend. Replaced the rearend, and the noise was gone. ... 2001 Ford F150 Styleside SuperCrew
I have a 1996 Dodge Ram 1500 5.9L V8. 4x4. I have a constant Rattle noise under my feet when im driving, it gets worse when at idle. truck runs fine, but the noise is always there. the noise seems to be coming from the center to the back under my truck(sounds like marbles in a tin can or better yet a loose spinning bike chain hitting metal). Any one who knows what they are talking about on vehicles have any suggestions?
It could be a loose heat shield on the exhaust. How ever I have seen the inspection plate loosen at the torque convertor housing. There may even be a loose bolt on the flywheel. ... 1996 Dodge Ram 1500 Club Cab
I have a 1996 chevy 1500 4 wheel drive truck. I'm getting a noise from the back of the truck when I push the gas pedal down while driving . it stops when i let the gas pedal off going over 45 mph. The noise also doesn't happen when going into reverse only in forward at low speeds. it sounds like a whirr noise. thanks for any help.
A good thing to check is the universal joints on your rear drive shaft. When they get worn, one of the first symptoms is a noise/ vibration that only occurs at certain speeds. Sometimes you can visually inspect them, and see signs of rusty powder co ... 1996 Chevrolet C1500
I have a grinding noise sounds like its from rear but had takin to shop several times and they rebuilt transfercase rear and checked cv / u joints and everything is ok but noise still accures when going over bumps after truck is warm and sometime when cold plz help cuz all in all trucks been in shop for a month and a half just got it back and was told to drive it till noise gets bad again
... 2004 Chevrolet Chevrolet Silverado 1500 SS
I have a 2004 cts 3.6L and as I'm parked, I switch to reverse, I hear a clunk.. back to drive.. clunk.. and as i am going down the road, I hear a whirring howling noise from my rear.. Is it the
I seen this before and is the upper rear axle support, or the engine support just open your hood and see if the motor move to much, or get on the back the car and look under to see it the axle move to much wile some one is shifting. MAKE SURE TO APPL ... 2007 Cadillac CTS 3.6L
Clunking noise from under the truck. The truck
Hi: Sounds Like you could have a Clogged Fuel Filter, Which you can Locate under your Truck on the Right Hand Side. Along the Trucks Drivers Side Frame. Thats the 1st Thing I'd Replace.Its not Very Expensive. If you can Get your Truck to say a Autozo ... 2001 Chevrolet Silverado 1500
Wind Noise I just bought a new 2010 camry a day ago and I have been driving it with no problem until I was cruising on the highway when I decided to do away with air conditioning and lower the back windows. I almost had a heart attack. The car vibrated with the worst noise, lost power which I needed to pass a huge truck. This is the worst idea Toyota has ever come up with. I'm pretty sure they will have to change. I immediately took it back to the dealer when they informed me not to worry that a
I ahve a 1997 stratus it does it as well what happens is they are right about being air tight it essentialy creates a vacuum and when you lower the front windows then there is a path for the air to flow so the vibration is normal and yes it is annoyi ... 2006 Toyota Highlander
Clunking noise when shifting, but not always. It happens on hard acceleration AND low acceleration. I have had the rear end completely gone through. Replaced rear differential. Mechanic said it was sloppy. Some of the clunking noise is gone now, but I still have some. Seems to be coming from front end. Also when coming to a stop the truck seems to rock forward after a complete stop (nose dip)more than usual. I dont think it's the supension. It almost feels as something is loose. After I
May seem to be unrelated but, I had a similar problem with my last truck and it wound up being ball joints. It sounds similar, (especially the rocking forward after stop), might be something to check. If you're talking about a 4WD, it could be your t ... 1999 Chevrolet Silverado 1500
I have a 2000 Frontier V6 Auto Crew 4x4 with an odd 4x4 issue. When using reverse, the transmission makes a quiet popping noise both when turning or going straight back. When I put it into drive, add accelerate above 25mph, there is a gear grinding noise that worsens when speed increases. If I place the truck into 4x4 while driving, it will make a large thunk, the grinding will stop, and I can put it back into 2wd and no grinding till I put in in park or reverse. Any ideas?
... Cars & Trucks
I have a 96 nissan 200sx se-r, 2.0 litre, 5 speed. I have had it for 243 miles and it was makin a tick tick tick noise when i drove then 2 days ago when i started it, it squealed (like a belt) until almost 3rd gear then it stopped squealing of course only til I was back in 1st or 2nd. Then today only 5 miles from leaving work the tick tick turned into a few seconds of clunk clunk then THUD and it stopped running so i pulled over went and got a trailer to tow it and when i got back there was oil
... Nissan 200SX
I have a 2004 GMC Envoy and I am having some major issues. First my transmission started slipping and then one night driving the Check Engine light popped on and it cut off on me. I was able to crank back up and go home. Also when driving over ten miles or so there is a loud scrubbing noise coming from the back of my truck it almost sounds as if the axle is scrubbing. Could this be the problem? Also could the scrubbing have something to do with the transmission. I have taken my truck to the Chev
If the dealer said your trans is close to a rebuild,\015\012you should do that,now, and not at a dealer,a trans\015\012shop\015\012\015\012Then work on any other issues if they still exist ... 2004 GMC Envoy
Vehicle trouble 2000 jimmy gmc while driving home the 2 back wheels seized up and would not move. Had to get towed. Just prior to this happening noise from back end,it would go into gear but would not move due to wheels seized.No warning prior other than noise moments before . When unloading from the tow truck brakes felt down. Any idea as to what could be wrong?
I think you may have a blown Rear Drive Axle due to lack of lubrication. It will be hit or miss if the housing is still usable. I would be against the problem being brakes as the likely hood of both wheels failing at once is extremely unlikely. ... 2000 GMC Jimmy
Daughter-in-laws 2003 Jeep Liberty with 118000 miles has a clunk every once in a while when you back up. She said while she was driving it made noises like a tire was going flat. I had her back up while I was walking next to the vehicle and there was a distinct clunk from the right rear wheel. It doesn't happen all the time only once in awhile. I checked the brake caliper and its okay, I'm thinking rear wheel bearing.
Might be a worn drive shaft linkage at the rear axle (differential). Could certainly be a worn wheel bearing. ... 2003 Jeep Liberty
Clunk noise i have a 1994 chevy silverado truck. it makes clunking noise when i take off. any ideas what could be causing it? thanks, george
Tranny, drive shaft, rear end, ... 1994 Chevrolet Silverado 2500