Having problems with your 2005 Chrysler Town & Country ?

What tool do I need to remove the caliper guide pin bolt on a 2004 town and country?

Posted / edited by AnonymousUser on : 20-11-2017

Answers :

I just finished doing the rears on my 2005 T&C. The caliper pins need to be removed with a 7mm allen wrench. I used an allen socket for a 3/8" ratchet, which was much easier than using my wrenches. These pins are threaded and cannot be "tapped" out as said by someone else.
\015\012
\015\012When you replace them, make sure you have some high temp grease to put on them and check the pin rubber boots to make sure that they are not cracked or damaged. Good luck!.
I have a 98 Grand Voyager, it doesn't have 4 wheel disc brakes as the T+C does,but I believe I used a torx bit to remove the guide pin bolts on the front. That said, In '01 they started making two different caliper assemblies one for the T+C and all 4 wheel disc and a 2nd type for front disc only, which no parts are interchangeable. So they may have changed from torx to something else, but probably not. Hope this is of some help! If not, repost question. Good luck!
Repair Help & Product Troubleshooting for 2005 Chrysler Town & Country

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0069 seconds