Having problems with your 2005 Chevrolet Suburban ?

Replace flex fuel sensor

\015 How do i replace flex fuel sensor on 2005 suburban\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2005 Chevrolet Suburban

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2006 chevrolet suburban 5.3 SFI flex fuel OBD II trouble codes 172 and 175. I have replaced MAF sensor 2 times, New spark plugs, fuel injector cleaner in fuel tank multiple times, replaced drivers side O2 sensor ahead of converter just to see if something would change. I have a scan tool and have reset the computer each time. The service light usually seems to come on with engine warm and during a coasting situation (IE: down hill or during stopping. could this be fuel pressure regulator? Does

... Chevrolet Suburban 1500

2000 Ranger 3.0 Flex Fuel with no start condition. Have good fuel pressure, have replaced crank sensor, have replaced cam sensor, have replaced coil pack, have checked for camshaft turning,have noid tested injector harness, originally started to act up a year ago. Developed to needing to hold throttle wide open and crank to get it to start. Got progressivly more frequent. Now won't start at all. While cranking now, it cranks and sounds more like it wants to start with throttle wide open. Help Pl

U may have an intake manifold leak or low cylynder pressure ... 2000 Ford Ranger SuperCab

I have a 99 Plymouth voyager 3.3 flex fuel which stalls constantly on initial take off only. had the crank sensor replaced twice. was previously getting po140 code which is o2 sensor which i havent replaced but every mechanic i talk to says o2 sensor wont cause it to stall like that now i don't have check engine light even the dealership cant find the problem. another mechanic told me its not fuel system problem because it has good pressure for some reason he thinks it could be something in igni

Check your TPS (throttle position sensor) ... 1998 Plymouth Voyager

Flex fuel sensor on 2003 yukon Replaced it with a flex fuel sensor replicator and the car still does not start. Event eh DLC connector will not send information to the code reader so that I can figure out what is going on. Any hints?

DO NOT USE THIS COMPANY http://www.pointaengineering.com/main.sc Because they are a fraudulent company! The sensor they provide does absolutly nothing. I tried it and nothing changed in the way my vehicle ran.Read more: ... 2003 GMC Yukon XL

2003 Tahoe, 5.3 liter vortec flex fuel. Engine replaced at 60k miles due to low end knock (typical late model GM). Scanner shows mutiple misfires on all 8 cylinders and erratic timing. Rough idle. Everything replaced, knock sensors, ckp sensor, even the computer. Everything else tested, checks out fine, fuel pressure, oil pressure, compression all good, even the Chevy house can't figure it out. Any suggestions?

This is a comon problem on chevy 00-06 models a computer ground ,it seems ok at sight but inside it's just holding a few wires ,get under the car on the driver side passenger there you should find a two ground wire goin to the block a big, and a smal ... 2003 Chevrolet Tahoe

1999 dodge grand caravan 3.3L flex. Stopped while traveling down highway. Towed to house. Replaced fuel filter,ignition coil,crankshaft sensor, camshaft sensor and finally computer. Then I replaced ignition switch. Still will not crank.

Car Engine Will Not Crank Over\015\012The electrical system of your car has several different voltage \015\012and amperage demand systems. Th ... 1999 Dodge Grand Caravan

When starting truck it spins over like it out of fuel and when it starts it skips for about 1 to 2 min. then it runs great it just when starting. fuel pump,oil sensor and fuel filter has been replaced. A mechanic had it fixed one time before and it was the oil pressure switch and it said that it was an electrical problem but he has since sold out and moved. The truck has 2.2 litter engine and is flex fuel.


Replace flex fuel sensor

... 2005 Chevrolet Suburban

Mine is doing this what is it? have a 2002 dodge caravan with a flex fuel 3.3l. When it is first started it floods out so badly that it almost will not run. you have to hold the rpms at about 3000 just to keep it running. According to a matco determinator scanner it is stuck on 85% ethanol. I have never used ethanol. So far i have replaced the plugs and wires, coolant temp sensor, cam sensor, crank sensor, ignition coils/module, pcm, and tcm. I have even pulled the tranny to inspect the flexpl

... 2002 Dodge Caravan

I purchased a 1994 Cherokee Larado with a 4.0 6 in it that had been sitting for about two years un started. Animals had nibbled on wiring in various places including fuel lines, crank position sensor and cam position sensor. I replaced those and dropped the fuel tank and repaired the fuel lines and replaced the fuel filter. I have also replaced the throttle position sensor, and the other sensor on the body of the choke. I also replaced at the suggestion of the parts counter guy the air temperatu

Unless you are really lucky I don't think you will meet your deadline. One wire out of place or dis-connected can cause all kinds of problems. I'd begin by checking every fuse in the vehicle, especially those in the power distribution center. Often i ... 1994 Jeep Grand Cherokee

P0112 Code(surging) p0112 code came up, replaced intake air sensor, still coming up. I am also experiencing surging at low rpms. flex fuels sensor is disabled as well.

... GMC Sonoma

Need to replace flex fuel sensor on a 99 ford ranger is there another part that can replace this part?

... Ford Cars & Trucks

Hesitation in acceleration, I've taken to dealer 3 times, they said it was mass air flow sensor, replaced it, then throtel possition sensor, replaced it, then fuel pump, replaced it, then fuel pump computer, replaced it, then front o2 sensors, replaced them still no help. DOES ANYONE KNOW WHAT TO DO?? Dealer is stumped, they've checked timing, vacume leaks, ecu and wiring for damage none found, fuel injectors grounds, air flow meter, egr for sticking, ALL NO PROBLEMS,, PLEASE PLEASE HELP!! Thank

... 1995 Lexus Sc 400

1986 ford ranger 2.9 v6 40 min warm-up Cuts out and Stalls Replaced booster fuel pump ,fuel tank pump, fuel filter,fuel pressure regulator Cleaned injectors replaced fuel cut-out switch replaced fuel relay,Oxygen Sensor ,Oxygen Control valve ,MAP Sensor and Computer Replaced Distributer,Ignition control module,Pick-up coil Cap n rotor Spark plugs and wires

... 1986 Ford Ranger 2WD

1987 gmc sierra 305 tbi. Rough erratic idle. Started after buying gas other day. half way home started losing power, then started missing. Replaced fuel filter and fuel pump. Then map sensor code 33 came up. Replaced map sensor. Same running condition. Also replaced coil. Remove vacuum line from map sensor or pvc. Idle picks up with only slight miss. Remove wires from tps or coolant sensor, same happens. Took 2 days of working on for code to show. Stayed for a while, then went away. No new co

... Cars & Trucks

Before we replaced the transmission we didn't have this problem. We replaced the tranny with a used and that's when it began. I knew that we needed to do some things to the jeep so I did the following, replaced: Crank shaft sensor,fuel pump, distributor, cap, button, wires, plugs, fuel filter, air filter, vacuum hoses, cleaned the intake and throttle body, replaced with used the speed sensor, (did not change out any of the other sensors from the old tranny).Had 2 different computers(diagnostic)

I am sorry,you did not say what the problem was. ... 1992 Jeep Cherokee Briarwood

1987 gmc sierra 305 tbi. Rough erratic idle. Started after buying gas other day. half way home started losing power, then started missing. Replaced fuel filter and fuel pump. Then map sensor code 33 came up. Replaced map sensor. Same running condition. Also replaced coil. Remove vacuum line from map sensor or pvc. Idle picks up with only slight miss. Remove wires from tps or coolant sensor, same happens. Took 2 days of working on for code to show. Stayed for a while, then went away. No new co

... Cars & Trucks

The engine light is staying on.I had a Domestic done on it at autozone--troubleshooting report PO193.Definition:Fuel rail pressure sensor condition--Explanation:The powertrain control module monitors the fuel system pressure---Ptobable cause:Fuel pressure low-fuel pump defective;Fuel pressure regulator defective:Replace fuel filter:Replace Fuel Rail Pressure sensor--can you give me any information about this

Try changing your fuel filter it may solve your problem. after changeing fuel filter disconnect battery for 30 minutes if your light stays off problem solved.if this was helpful please leave me good feedback ... 2004 Ford Freestar

I am working on a 2001 Chrylser Town and Country 3.3 Flex Fuel. I have replaced the ECM, Crankshaft and Camshaft Sensors and the Front Module (on the fuse box under the hood). I still not getting a ground oulse from the ECM to the coil. Any Suggestions?

... 2001 Chrysler Town & Country

Radiator fan will not kick on 1999 voyager flex fuel ,i already replaced coolant sensor

Check you replaced the correct fan control sensor switch (not the temperature gauge sender),\015\012Check fan fuse,\015\012Check fan control relay operation,\015\012Check fan will run if power applied directly to it. ... 1999 Plymouth Voyager

I am getting the P0332 code which is the rear sensor under the intake manifold.Would it damage the engine if I didn't replace it for a few weeks?I have 5.3 flex fuel engine.It runs very good with no knocks with 127,000 miles.thanks

Typically (although all computers may have slightly different logic), if the computer knows there is a problem with the sensor, it will use a retarded default ignition timing that is less fuel efficient but is safe for operation without damaging the ... Chevrolet Tahoe


... 2005 Chevrolet Suburban

Fuel guage reading was erratic. Replaced fuel pump and sensor..fuel guage then read a constant 1/4 tank lower than it actually was. Mechanic checked and said it was wired wrong...fuel guage then read Empty..constantly. Already replaced fuel pump and sensor, fuel filter, and ECM, and it still reads a constant empty. What now?

Thanks for choosing FixYa and welcome. You may have a bad sending unit. It could also be a defective dash voltage regulator, lost ground at sending unit, break in the wire at the dash harness too. It can be anyone of these to be honest. ... 2001 Isuzu Rodeo

Cannot find sensor that energizes/controls the fuel injectors, they cant open, replaced the MAP sensor with a new oe, old one had about 440 ohms new 180, fuel pressure ok, fuel regulator ok, proper injector resistance and volts/ground, replaced Cam shift sensor,

There is no sensors which control the fuel injestors.There are relays which control the fuel flow through them and they are located on fuse panel block under the hood. It sits right in front of\015\012the driver, you have a single wheel- ... 2004 Chevrolet Malibu

My van dies it does start back up. I have had several things checked Like the intake manifold. Replaced the fuel filter, replaced coil ignition, replaced crankshaft sensor, camshaft sensor and distributor rotor. Fuel pump is working, fuel pressur was all good over 50psi constant 52 when running 60....... just will not stay running and i even blew out lines used starter fluid to start it before it went out,then it just stopped from running,but when i let it sit for about 20min,it started right u

Usually its a pickup coil when it just quits but that's my best guess~ ... 2000 Chevrolet Astro
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.8411 seconds