Having problems with your 2005 Chevrolet Impala ?

How to bleed coolant lines on 2006 impala - 2005 Chevrolet Impala

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2005 Chevrolet Impala

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to bleed coolant lines on 2006 impala - 2005 Chevrolet Impala


... 2005 Chevrolet Impala

Had coolant Bypass line break on the road just got it home had 0 oil Pressure fixed the hoses the next day started it noticed the coolant being pushed out of radiator im guessing a Blown head gasket eventhough the temp didnt reach Critical Temp but being it has Aluminum Head and cast Block that has to be it as the bypass lines were for the Oil cooler what do u guys think ? 89 ford probe GT turbo 2.2 litre and 1 more thing the oil was HOT !! :P


Sorry for the delay. if it is like that than your head gasket is bad. that is the only two common points other than the head and cylinder wall! if you do the head gasket make sure to take it to the machine shop to be pressure checked and resurfaced j ... 1989 Ford Probe

Trans coolant lines on 2007 impala - 2007 Chevrolet Impala LS Sedan New Cars


... 2007 Chevrolet Impala LS Sedan New Cars

Bleeding coolant system on a 2004 impala - 2005 Chevrolet Impala


... 2005 Chevrolet Impala

I changed the thermostat in my 02 cavalier, when turning the hex screw on the coolant lines to bleed an air pocket out the top of the bolt broke off, the rest is still in the coolant line, is there another way to bleed the air out of the thermostat housing?


... 2002 Chevrolet Cavalier

I have A 2005 chevrolet impala with just 60000. Miles ihave the coolant system flushed the oil cange and have it checked but the heat gauge on the dashboard keep going into the dameage zone the min I trun the car on I was told this is happen to A lot of chevrolet impala and other chevrolet cars there is get to be A recall on this system please help


Try changing the tempature coolent sensor first it may have got gunk on it when you got the system flushed and if that dont work you should take the radiator out and have it profesionally cleaned to take all the gunk that could be clogging up the bla ... 2005 Chevrolet Impala

O2 sensor bank 1 sensor 1 chevy impala 2007 - 2007 Chevrolet Impala LS Sedan New Cars


... 2007 Chevrolet Impala LS Sedan New Cars

I Hanve 1996 GMC 1500 brake pedal goes to floor. New brakes & Calipers in front, 1 new wheel cylinder. 3 New master cylinders,1 new brake booster, Brake line in rear rusted out & replaced. Have checked rubber lines for collasping or bubbling, When Bleeding all wheels lock, Have vacum bled and manual bled. Tried different ideas, do not touch brake until bleeder is open and depress and close bleeder. Tried just about everything, Have adjusted rear brakes out. When truck not running you can


Did you try a brake booster ? ... 1996 GMC Sierra

2002 chevrolet impala coolant problems - 2002 Chevrolet Impala


... 2002 Chevrolet Impala

Coolant sensor I have a 1986 camry. I am looking for the part number for a cooling system sensor that is on the upper radiator hose housing. There are 4 sensors, 2 with vacuum lines and 2 without, 1 of each is closer to the block and 1 of each is farther from the block. I need the one that does not have any vacuum lines attached, and is farther away from the engine block.


Hi there \015\012 you can go on line and go to the autozone web site and there is a do it yourself section there that you can look up parts and it gives you prices it has been a real big help for me \015\012best regards mike ... 1986 Toyota Camry

2003 chevrolet impala power steering lines - Impala Chevrolet Cars & Trucks


... Chevrolet Impala

How do you bleed the rear brakes on a 1999 chevrolet van express 1500 ? I replaced the front to rear brake line while I have the fuel tank out because it was very rusty, but not leaking yet. while my son pumped up the pedal, i opened the r.r. bleeder, but no air or fluid came out and the reservoir did not go down. the line is two 8' lines coupled together, so i opened the coupler between the lines and still no fluid. what the heck?


Sometimes it may take a while.Make sure he is keeping pressure on the pedal while u are loosining the bleeder screw.U can loosen all and let gravity take over for a while but it takes some time. ... 1999 Chevrolet Express

2003 Chevrolet 3.4L IMPALA engine block coolant drain plug location


... Chevrolet Cars & Trucks

1997 pontiac sunfire, i just change coolant temperature sensor, coolant hoses, reconnected low coolant sensor, now i have a drip under the car, maybe in the vancinity of water pump.... not sure if it was there before, but could anything i have done be causing the drip? also, i forgot to bleed the line at first, but i did before i drove it, maybe i didnt get all the air out? sort of new at this, trying to save my daughter some money


Did you have a leak before? If so and thats the reason you replaced those parts, it could be leaking from another spot in the coolant system sometimes the system with leak from the weakest points then when you fix them the system will leak from the n ... 2004 Mazda 3

(#1) MY 1998 VOLVO V70 GLT, HAS OIL LEAK, IT FLOWS DOWN FRONT OF 'TRANSMISSION OVER A SENSOR WITH 2 WIRES, LOTS OF OIL, ABOUT ONE QUART PER 50-80 MILES. MOBILE 1 10W-30W. (#2) RADIATOR LEAK AT TOP LEFT SIDE , WERE PLASTIC AND METAL JOIN, AREA ABOUT 1-3 INCHES DOWN THE SIDE, USED GREEN DYE TO TRACE, SEEMS NO MORE LEAKES,GREEN ALL TH WAY DOWN AND AROUND THE OIL LINE CONNECTION, WHICH ASSUME IS FROM THE ABOVE LEAK. COOLANT ONLY LEAK THERE. READING FIX-IT WITH ZIP TIE AND SOLDER IRON USING NYLON 6


... 1998 Volvo V70

Added coolant and tank is full. Ran it a couple times and added more coolant. 1 1/2 gallons altogether. Coolant light goes out then comes back on in a few seconds. Do these systems need bled. Has a bleed tube coming off thermostat housing.


This engine is leeking coolant,has this engine got work done latly,has anyone been working with the heating system??????,if not you have a leek in the system.adrian,,,,,,,,, ... 1997 Oldsmobile Achieva

The engine light is comming on. Took it to Autozone - giving a code "P0126 - Coolant thermostat condition; Low operating temprature, Probable cause - Low coolant level; Open or short circuit condition; or Faulty ECT Sensor". I can see an extremely corroded sensor on the side of the engine block, but I was told by the dealer that there are 2 temprature sensors. I need to determine which one to replace. All I can find on line and at all the parts stores is 1 type of sensor. Are there 2 coolant tem


The "probable cause" is the "thermostat" is stuck open, not allowing the engine to reach operating temp (190-195f) . As for the sensors, obviously its working, but if its corroded, its leaking and needs to be replaced. Better hope the pl ... 2004 Mazda MPV

How to bleed coolant system by the bleeding screws 2001 impala


... 2001 Chevrolet Impala

How to bleed coolant system by the bleeding screws 2001 impala


... 2001 Chevrolet Impala

I have a chevrolet impala 2002, my air conditioning slowly quit working. first speeds 1-2 quit and i could only use speeds 3-4-5. then a couple days later speeds 3-4 quit working and i could only use speed 5. now speed 5 has quit, so i thought it must have been a relay. when i looked at the fuse panel under the hood i seen three different relays that said "air cont #1", "air cont. #2" and "air cont. #3" could this be the problem? thanks


No. Most likely it is the blower module. It is on the passenger's side lower part of the dash panel.\015\012\015\012 ... 2003 Chevrolet Impala

Hi i have a 2006 chevy impala ss 5.3 liter and i just changed the following things on my car water pump radiator condensor and fan i had a mechanic bleed the system but for some odd reason it seems to me every time i use the a/c for a while my gauge starts to rise for the hot red line and car gets real hot im trying to find out how to bleed the system if anyone has instructions on how to do it and also what might be cause the car to overheat need help asap please


Any cooling system can bled of trapped air by using the method outlined below.\015\012\015\012The generic method of bleeding air from the cooling system is to use a floor jack and raise the front of the car as high as poss, th ... Chevrolet Impala

The checj engine light on my 99 pontiac sunfire came on last week and stayed on when i drove only a few short distances. it sat for 4 days and was on again when i drove under 8 miles then finally turned off-the fluids were checked and all ok-coolant wasn't to full mark but wasn't low-today i drove my furthest trip-apprx 30 miles and coolant light came on-stopped and filled to full line then drove my remaining 10 miles all uphill mountain road-light again came on about 1 minute b4 i reached hotel


First of all, was the water on the passenger side from the air conditioner or a leak (what color was the fluid?)-the cap has to be tight, otherwise it will not hold pressure, so that has to be checked before you set off again-push down as you turn th ... 1999 Pontiac Sunfire

Fuel line size for a 2002 impala - 2002 Chevrolet Impala


5/16 inch ... 2002 Chevrolet Impala

Propercrankpositionfor correctbelttiming is there a timing mark onthe crank pulley for refrence to line up with a notch on the engine ,besides the flyweel mark? i am puzzled because i have already bent some valves & dont want to repeat my mistake. i have put the #1 piston at TDC, flat with deck ''0'' deck is this right or should it be slightly below ''0'' deck hight and or should the key way be at 12:00 position. please help me P.S, this a 89 honda accord 2.0 carb.3V A20A1 engine


Send me your email address and I will send you the proper timing positions. I can copy them from mitchel and email it.... ... 1989 Honda Accord 4 Door

Complicated problem here. 2003 Chevrolet Impala had a bad fan. Replaced the fan unit with new. Now, the fans do not come on unless a/c on or coolant temp sensor unplugged. I have replaced coolant temp sensor, all 3 relays, checked fluid level. Ideas?


A few different things have happened here, either you have a bad ground circuit, you have a brand new bum sensor, or quite possibly the pcm has an issue. If this was aftermarket sensor (Auto Zone or other), it could be faulty. Take it back and have t ... Chevrolet Impala
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.2447 seconds