Having problems with your 2005 Chevrolet Impala ?

How to replace blend door actuator on 2009 chevrolet impala

\015 Heater/ac blend door actuator making a knocking noise,\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2005 Chevrolet Impala

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to replace blend door actuator on 2009 chevrolet impala


... 2005 Chevrolet Impala

Instructions replace blend door actuator 2003 chevrolet suburban


... 2004 Chevrolet Suburban

How to replace blend door actuator on 2009 impala


... 2005 Chevrolet Impala

How to replace tahoe blend door actuator - 2004 Chevrolet Tahoe


... 2004 Chevrolet Tahoe

How to replace air blend door actuator on 2004 impala


... 2004 Chevrolet Impala

Replace blend door actuator - 2001 Chevrolet Tahoe


... 2001 Chevrolet Tahoe

Can I replace a fresh air door actuator on a 2008 Chevrolet Impala


... Cars & Trucks

My AC is blowing out hot air. It has been happening on and off again for a couple of years. Turning it off and back on again has always worked before but this time nothing helps. It finally seems to be stuck for good. How do I replace the air blend door actuator on my 2005 chevrolet silverado 1500?


This problem is caused by either a sticking air temperature control blend door or a defective electric blend door actuator, u must pull the dash to replace either part, a factory repair manual and a high level of repair skill is required, the job wil ... 2005 Chevrolet Silverado

Where is the blend door actuator located on driver side on a 2005 chev impala and instrutions for replacement thanks


... 2005 Chevrolet Impala

How to replace blend door actuator on 1999 chevrolet silverado


... Chevrolet Silverado 1500

How to replace blend door actuator - 2000 Chevrolet Blazer


On a 2000 blazer you have to remove the dash to get to it ... 2000 Chevrolet Blazer

Blend door actuator 2005 kia sedona - 2005 Chevrolet Impala


... 2005 Chevrolet Impala

1999 town car cartier blend door actuator is not properly clocked to fit in blend door tip. i had to replace blend door box assembly , how do i clock blend door motor?


... 1997 Lincoln Town Car

How to replace door lock actuator on 2008 chev impala


... 2008 Chevrolet Impala

2002 Ford Crown Vic 4.6L. EATCM A/C, Heating system. Replaced the blend door actuator due to stripped gear inside it. Before replacement could hear clicking noise coming from dash during temperature changes but nothing happened. Only hot air came out all positions. A/C is engaged and working at this time. Could switch from defrost to floor to panel to defrost/floor with no problem. Red and blue buttons showed temperature change but blend door did not move only clicked. After awhile the clicki


That clicking noise you hear is likely a relay in the fuse panel that needs to be replaced. the easiest way to find out which relay it is would be to put you finger on each relay as you actuate the device not working. once you locate the clicking r ... 2004 Ford Crown Victoria

I have a 1993 Jeep Cherokee Larado. I just paid $1200.00 to have the dash pulled and the evaportor replaced. Now I get zero heat. They replaced the thermostat (didn't solve problem) and say the actuator blend door is stuck. They will have to pull the dash again and it will cost me almost $600.00. What does the blend door do? Could my heat problem be associated with the air condition fix?


If it got stuck when they took it apart.yes. It may also be coincedence.the heat worked before they did the evap I beleive I would be more than a little angry.it should of been noticed when they had it apart. Sorry but this is not something I can be ... 1998 Jeep Cherokee

Found solution below but cannot find the motor for the blend door acturator the problem is the blend door actuator. Its is located behind hte glove box. (as far up and to the left as you get get with your hand). The gear inside the motor will crack if it is overdriven. As far as the re calibration, pull the rdo fuse(s). wait about 30 sec. replace fuse(s) turn car to run wait for 40 sec or so. you should be able to get a flashlight and watch the motor turn back and forth. turn key off. you shoul


... 1998 Chevrolet Blazer

2001 FORD EXPEDITION XLT 4.6L V8 BLOWING MILD WARM BUT NOT WARMING THOROUGHLY. HAVE FLUSHED COOLING SYSTEM THREE TIMES, AND CHANGED THERMOSTAT. HAVE ALSO REMOVED DASH AND REPLACED "BLEND DOOR" AND BLEND DOOR ACTUATOR IN HEATER CORE HOUSING. HOW CAN I GET TO BLOW HOTTER.


You hot air comes from the water circulated through the heater core. It is like a miniture radiator with water flowing thru it constantly. So by opening the "Blend Door" you are permitting so much of this hot air to pass thru.Seems like ... 2000 Ford Expedition

Replace door lock on 2005 Chevrolet Impala - 2005 Chevrolet Impala


... 2005 Chevrolet Impala

I have a 2003 Chevrolet Suburban with automatic dual vent A/C-Heater control where the vent actuator does not appear to be working to direct air from one vent to another or from defrost to floor. The fan is blowing but the vent door does not change the air flow from one vent to another. Where is the vent door actuator located and how do I replace? Do you have a diagram or instructions?


... Chevrolet Suburban 1500

REPLACED BLEND DOOR ACTUATOR COLD AIR STILL BLOWS IN FLOOR


... 2000 Dodge Durango

Need to replace a blend door actuator in a


... 2005 Ford Expedition

HOW TO REPLACE THE BLEND DOOR ACTUATOR


I've done this and i'm sorry you have to - it's not quick and easy. the dash must be removed. the module sits on top of the heater box. i found a Lincoln shop manual for the 97 town car on ebay that was very helpful with step by step disassembly and ... 1997 Lincoln Town Car

1995 mercury sable blend door actuator replacement


... 1995 Mercury Sable

Blend door actuator possibly bad how hard is it to fix or replace?


Usually it is in the dash and the glove box needs to be removed to get to the actuator. ... 2004 Kia Sedona
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.2618 seconds