Having problems with your 2004 Mazda 3 ?

Full headlight assembly removal

\015 I am having great trouble removing the assembly on my car, I broke off the spring that holds in the headlight and I need to get it replaced, is there any easy fix. very difficult to get at.\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2004 Mazda 3

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Full headlight assembly removal


... 2004 Mazda 3

Removal of headlight assembly to change headlight bulb on 2007 gmc yukon xl. I see the two screws above but can't tell if there is more to removing assembly. seemed easy initialy, but can't figure it out. It looks impossible to change bulb without removing the headlight housing. Thanks


... 2007 GMC Yukon

2001 Buick LeSabre. How to remove headlight assembly... Just need to remove and replace the headlight assembly on my 2001 LeSabre Custom. I think it's just a matter of removing a couple of bolts, but would like to make sure before I start.. Thanks


The bolts you are looking to remove are located on the top of the light housing. It only takes 2 of them to remove the housing. One is about 6 to 8 inches long, and the other one is much shorter than that. Just unscrew and remove them, and pull the h ... 2001 Buick LeSabre

How to remove the fog light assembly on a 2006 Monte Carlo. After the headlight removal and the bulb removal from the fog light assemby... How does the assembly come off of the body, properly? When taking a closer look, there are 2, possibly 3 clips that the assembly is attached to. I am not sure how to get the assembly apart from those properly. Any help would be greatly appreciated. Thanks.


You must access the fog light from under the car. ... 2006 Chevrolet Monte Carlo

2005 buick Terazza. How to replace passenger side low beam halogen bulb? Apparently the headlamp assembly needs to be removed to get access to the socket in the rear but I don't see how it's attached. The right side headlights on my 2006 Terraza are dim. How do you remove the headlight to check the contacts? If I raise the little cips on top will the complete assembly come out? [email protected]


... 2006 Buick Terraza

Can the factory headlight lens covers on a 2001 Mercury Cougar be removed and cleaned ? I can remove the entire healight assembly and change the bulbs, but the inside of the healight cover is dirty and needs to be cleaned, I can't figure out how to take the clear plastic cover off the headlight assembly. Thanks for an input.


The lincoln LS had the same problems, and the lens was held to the headlight assembly with a sticky glue.\012To remove them, some guys were successful by warming the headlight assembly in the oven untill the glue softened up enough to be pulled ... 2002 Mercury Cougar

Removal and replacement for a 1997 ford F350 headlight assembly I need to remove and replace the headlight assembly in a 1997 Ford F350


... 1997 Ford F350 Crew Cab

I would like to replace the headlight assembly of a 2008 Silverado. I've located 3 bolts and removed them but am unable to remove assembly. Is it possible to replace the head light assembly without removing other parts?


There is a little aluminum stick in the assembly holding it in. On the top of the headlight twist the stick and remove it. It will look like a tent stake. Remove this stick and then the head light assembly will almost fall out. ... 2007 Chevrolet Silverado 2500HD

Headlight assembly The headlights on my '95 Eclipse are in need of replacement. I have replacement headlights but have ran into a snag with a single bolt that holds the light in place. I am able to remove all bolts with the exception of the lower most bolt that seats under the headlight. The area is very difficult to get to. Is there an easy or routine way to get to the bolt for removal and intallation. Any advise would be helpful. I am unable to get any direction from a HANES manual and have no


A swivel for the socket may be necessary, sometimes it may take more than one swivel. ... 1995 Mitsubishi Eclipse

I can not remove the headlight assembly by removing the 4 bolts.


Those should have 2 rods to hold in the light. then it just almost falls out. ... 2007 Cadillac Escalade Two-Wheel Drive

Headlight bulb I have a 2008 2500 hd sierra slt Duramax I was looking how to change headlight bulbs.Booklet says to change remove air cleaner and reach in and change them from the back. That won't work no room to even see the back of headlight. Looks like there is 2 bolts holding the assembly in and it should swing out like a 2001 gmc with there pins. the assemblys come out just dont know where to push thanks


You have to remove the air intake filter and then kind of reach around up in there to change it. It can be done, but is a lot of work. On the duramax, it is even harder to do the driver side because of the dual batteries. You have to remove the batte ... 2008 GMC Sierra 2500HD 2WD

I have removed the old headlight assembly from my 2002 Chrysler Sebring but I cannot seperate the signal lamp apparatus so that the 3 prongs connected to the wires in the harness assembly can be plugged into the new headlight assembly.


If you are careful with the wire configuration (mark everything) you can cut them loose and relug them with spade lugs(female) that you can slip on the male prongs on the light. Use a crimper. ... Chrysler Sebring

I can't find directions on line to change the driver's side headlight out of the headlight assembly. I took the assembly out of the car, not a simple task, you have to remove the bumper, but I can't figure out how to remove/reinstall the headlight itself


If I can remember, there should be two small screws on the bottom left of the headlight. This is the spring load. remove the screws and also remove the two small screws on the upper right. this will help remove the adjusting screw. the installation i ... 1990 Honda Accord

I have to replace the ballast for the HID headlights on my 2004 XC70 volvo and it is under the headlight assembly. I just need assistance on how to remove the passenger side headlight assembly


You need to remove the front bumper. Five push clips along the hood line, remove the headlight wipers (if equipped), one T25 screw in the front of each fender well, then two 12mm bolts under the headlights (1 each side). Then there are 4 10mm bolts ... 2004 Volvo XC70

I've researched the Ford Owners Manual and Chilton's but the manuals don't explain how to take out the headlight assembly on the XLS model. For example, there are no headlight housing retaining clips on this model. There is a vertical bolt, which I loosen. There are two two bolts securing the top of the headlight housing, which I have removed. However, there is an additional fastener which continues to hold the assembly in place. I sought help from our local Ford dealer but the s


Hello, I know it can be tricky, but there are only those 3 bolts holding the headlight assembly in. Once you have removed the two on top and loosened, ( but not removed) the vertical bolt, the entire assembly slides forward. There are 2 guide rails u ... 2004 Ford Expedition

I am attempting to replace the low beam headlight bulb on a 2005 Buick Allure. I have managed to raise the plastic clip holding the assembly in place. I have removed the screw and raised the metal clip also holding the assembly in place. I have removed the plastic pin and pulled out the coloured plastic strip between the high and low beams, but I do not seem to have enough room to move the assembly forward to get at the bulb for replacement. Any suggestions?


... 2005 Buick LaCrosse

I need to replace headlights on my 2005 baja. How do I remove the existing bulb assembly once the assembly is removed from the lens assembly itself?


... 2005 Subaru Baja

2004 Chevy Classic / How to replace head light bulb? Using my Chiltons repair manual it says to remove 2 screws on the headlight assembly and pull the assembly out the front. I removed screws but doesn't release the light assembly. What now ?


... 2004 Chevrolet Malibu

Headlight removal - how to remove bolts holding headlight assembly - they look like wingnuts but they are not - the star nut on the bottom is no problem it is the other 2


... 1995 Plymouth Voyager

Headlight removal? how do i remove the headlight assembly on a 2007 commander


... 2007 Jeep Commander Rocky Mountain

Headlight assembly how do I remove the headlight assembly in a 2007 new body style Silverado?


Hello streets54, my name is JShreader. Thank you for choosing fixya.com.First, you have to remove the Upper Radiator Grille. Behind the Headlamp at the top of the Front Bumper, access the lower inside hidden Headlamp Bolt. Only loosen the ... 2008 Chevrolet Silverado 1500

My headlight bulb won't fit into the headlight assembly on my 1994 jeep grand cherokee laredo, i can see some melted plastic inside the asssembly. How do I remove the assembly to repair the melted plastic issue?


It is to melted?change the headliht,try it whit a file to remake the housing. ... Jeep Grand Cherokee

How do you completely remove the passenger side headlight assembly to replace the headlight on a 2005 vw touareg? where is the clip or button that finally dislodges the assembly? brian in tx


Go here for pic by pic instructionshttp://forums.vwvortex.com/zerothread?id=1251418 ... 2005 Volkswagen Touareg

Headlight assembly how do i remove the passenger headlight assembly?


Pull upward on black cover above headlamp assy. (marked pull here for headlamp service) you will then see on the front side a large bolt above the lamp assembly that holds it to the front of the car. it is a 10MM socket you will then nee ... 2001 Cadillac DeVille

How do I remove the headlight assembly from my 2008 Saturn Outlook. I have a melted headlight plug. I will need to replace my harness and I am not sure the best way to remove it.


If you have the regular headlights(not the HID) there is a TSB for that at the dealer and they will fix it for free as long as you are under the 36000 miles,,anyhow to get the headlight out you need to remove the front bumper cover,,pop the hood, rem ... 2008 Saturn Outlook
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.3591 seconds