Having problems with your 2004 Kia Rio ?

I have a code on my 2004 KIA that reads po113 that says its a intake air temp cicuit ware is that on my car

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

The Intake Air Temperature sensor sends a reading to the main engine computer as to what temp the incoming air going into the engine is, for maximum engine fuel efficiency. On rio's, they often go bad due to their location in the intake manifold.. They are a bit tricky to get to, so take your time and use a 10mm socket with a 12-16" extension. They are located just to the right of the throttle body in the back area of the engine. Otherwise have a pro fix it.
If you look around the air filter or in the air filter ducting there is a sensor in there to sence air temp. a lot of people get this code when they change an air filter and forget to plug this back in sometimes..lol good luck
Repair Help & Product Troubleshooting for 2004 Kia Rio

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a code on my 2004 KIA that reads po113 that says its a intake air temp cicuit ware is that on my car


The Intake Air Temperature sensor sends a reading to the main engine computer as to what temp the incoming air going into the engine is, for maximum engine fuel efficiency. On rio's, they often go bad due to their location in the intake manifold.. Th ... 2004 Kia Rio

I have a 1999 saturn sl it has 130000 miles it runs good the check engine light came on with code po113 had it check at auto zone it says air intake temp circut it runs good but when i reach 50 on the highway the steering wheel just shakes a little nothing major when i turn on the car in the moring the sterring wheel shakes a little it says sensor open or shorted replace sensor i cant find that sensor can you please tell me where it is in a pitcher where its located and if i can replace it mysel


1st the sensor is part of the sensor array for the engine's fuel injection system and has nothing to do with the front end, that sounds like u have worn front end parts like tie rod ends or worn Constant ... Saturn SL

99 Grand am 3.4 i have a code po113 and replaced the intake air temp sensor and a friend told me it might be the air charge temp sensor bought it and now i can't find it on the car


I only show an air charge temp sensor which goes in the hose between the air cleaner and the throttle body. ... Cars & Trucks

Hello, I have a 96 Chevy Cavalier that misfires under a load. there were 2 codes, an IAT circuit high and misfire cylinder 2, i used my scanner at my work but i work at a Toyota dealership so i don't know if i could see all the codes or not. i have already replaced the fuel pump, fuel filter, spark plugs, plug wires , intake air temp so that codes gone and I cleaned out my EGR. the car has not changed and is only getting worse... I asked techs in my shop if they had any ideas and they all had t


Is the exhaust converter original?Did you scope the O2 Sensors?Do a cylinder leak down testEGR Valve ? or just cleaned passages?Take your scanner for a ride on your lunch & havea buddy look at cylinder misfire ... Cars & Trucks

Pliz help after taking my car for engine wash they used water to wash the engine and engine Codes came up . 16502 P0118 Engine coolant temperature circuit-G62:high . 16497 P0113 Intake air temperature sensor 1 circuit-G42:high. 16486 P0102 Mass air flow circuit -G7 0:low input. 16622 P0238 Turbo super charger boost sensor (A) circuit : high. 16955 P0571 Brake switch sporadic (A) circuit : malfunction. 18000 P1592 Altitude sensor /boost pressure sensor :implausible ratio. 16706 Engine RPM sens


Not Good: The Expensive main computer brain sustained a short from either the heat of the solutions or leakage allowing fluids to enter the components. If after a drying period this still occurs; then the computer brain needs replacing. ... 2005 Volkswagen Touran 1.6

I have a 99 passat v6, my check engine light went on, and the scanner says code P0112- air intake temp circuit low input. I replaced the sensor and erased the code from the ecm, but the light comes back on again, what can I do to fix this???


Remove your battery head for 5 minutes while engine is off. This should put it in order.\015\012\015\012Rate this please. ... 1999 Volkswagen Passat

I bought the car 2 monthes ago and the check engine light came on. Some one had installed a Fujita Air intake f5 and the mass air flow sensor is causing the check engine light to go on. The shop where it is getting fixed said the code is saying the sensor is making the light come on under heavy excelleration. Is there a fix to this problem?


Use only factory units and no boy racer add ons as they will cause problems like this ,its not a mk1 cortina and you can put harry moss add on boy racer bits.want a fast car buy a jag end of story.also is this conversion legal?? is their a certificat ... Mazda MAZDA3

2003 Jetta Thank you for your answer I have cleared the code again replaced the ECT and checked the plug for it (clean) and so far the light hasn't come back on. But only has 30 miles on it after replacement. Also checked the AC fans both or should I say it is running with AC. Car only runs 190 with AC on out side temp at 95. I went to burger king left air on idling 10min and temp gauge still 190. Thanks again Kevin


I have a 03 jetta 2.0 what should i look out for in repaires it has 75.333 ? ... 2003 Volkswagen Jetta TDI

2008 equinox is throwing the p0118 code. The car says the engine is hot and turn a/c off. Although the temp gauge is all the way down at 0 temp. This problem is intermittent and will sometimes" fix" itself after minutes of driving or resetting the computer.


Replace engine coolant temperature sensor ... Chevrolet Equinox

97 Chrysler Concorde high idle speed A 1997 Chrysler Concorde starts fine, but idles at 2000 rpm. The idle increases to 2500 as it warms up. Vacuum is at spec, and no signs of intake leak. We have replaced the coolant temp sensor (previous code), idle air control motor (previous code), one front O2 sensor, EGR valve and control, and MAP sensor (previous code). The previous owner had the PCM replaced with a used unit, with no luck. We have not yet replaced the intake air temp sensor,


Couple things to check out. what is the throttle position sensor readings fully closed (should be .5volts). if it's above the pcm may think the car is not at idle. did you spray sections of vacuum lines and manifold gaskets with brake clean to check ... Chrysler Concorde

2000 taurus duratec has problems staying running when you first start it.the rpms drop and the car stalls out. i have to give it gas and keep giving gas to keep it running for about 5 min then it runs fine. its worse in the colder temp. code read give says to much air to fuel ( not enough gas) any ideas?


... 2000 Ford Taurus

CEL came on for the car, says it is idleing too high/low. After I just put on a cold air intake. Cleared code and the CEL came back on the next day. Anyway I can turn the idle down manually?


There is no way for you to turn the idle down manually, it is all computer controlled. Do not adjust any screws on the throttle body, they are set from the factory. The only way you may be able to fix your idle problem with out getting rid of your co ... 2006 Dodge Stratus

BAD RUNNER car runs great but after you drive it come back later it turns over rough but starts and service engine light comes on but no codes come up it acts like its getting way to much gas when hot. we replaced o2 sensorcoolant temp sensor throttle position sensor intake air sensor wires and more injectors test good what next this is 1993 pontiac grand prix 3.1 HELP


Check the fuel pressure regulator. Pull off the vac line to it and see if any gas is leaking out of the vacuum fitting. If you see any fuel replace the regulator. ... 1993 Pontiac Grand Prix

Car doesnt rev up when cold...it revs to 3000 rpm then spits and misses and carries on. it is showing a crank cam code on again off again...we changed crank sensor,cam sensor,pcm,wired cam and crank sensor direct to pcm,replaced coil, plugs and wiresand air intake temp sensor...also replaced plug ends to crank and cam sensors


Sounds ike it could be the Crank sensor, do you have the OBDII code off hand? ... 1999 Plymouth Neon

Car failed emission test intake air temp to high code PO113.


Change the intake iar temperature sensor to pass the test. ... Ford Escort

2000 taurus duratec has problems staying running when you first start it.the rpms drop and the car stalls out. i have to give it gas and keep giving gas to keep it running for about 5 min then it runs fine. its worse in the colder temp. code read give says to much air to fuel ( not enough gas) any ideas?


Sounds like you are running lean , i would start by changing the fuel filter and check for fuel pressure using a fuel pressure guage at the shrader vavle on your fuel rail, if your fuel pressure is not above 35psi when you cycle your key on and you h ... 2000 Ford Taurus

Fixya replaced catalytic converter, muffler, fuel pump, air temp sensor,o2sensor,map sensor, intake manifold gaskets, fuel filter ,computer,strainer in fuel tank,radiator ,water pump,ect. getting codes f49 and f48 ..car stalls and is also very hard to restart seems like is getting too much gas ..will check erg


Code F48 is for low freon in the ac, and code F49 is for the computer turning off the ac compressor because the pressure is too high or the engine temp is too high. So neither code would have a direct effect on the engine running.You may have to ... 1990 Cadillac Deville

Code po113 on 2000 mercury cougar 2.5l v6 it says intake air temp sensor 1 circuit high input what sensor is this


... Cars & Trucks

Merc c200 k 2001 code p200b replaced air maff sensor from mercs (ouch) but still got this code what do you recomend.mechanic tells me intake manifold air control actuator bank 2 performance problem. also code p2036 secondry air injection malfunction, please help i have been a mechanic for many years but when it comes to new stuff for once iam stumped . the car runs well but sometime seems sluggish and then other days it goes faster it almost seems like another car . tim


Do the radiator test and see if coolant backs out the radiator.. I am thinking u have a broken cylinder head gasket or a fractured cylinder both of which can account for the codes and problem you are having.. Also how does it run with a hot engine?? ... 2001 Mercedes-Benz C-Class

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil


Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

Hi, I've sent my toyota prado 1998 (RZJ 95, engine 3RZ, petrol) to diagnostic and it shows 3 error codes: 1. code 31: intake air pressure sensor vacuum sensor signal abnormal 2. code 14: IGT or IGF circuit of ignition system fault 3. code 24: intake air temperature sensor signal abnormal (open or short for more than 0.5 second) The only problem that I have with is car is that the RPM are not stable, when I start the engine, the RPM stays at 800 RPM than downs to 600 and go up to 900R


To have so many different codes at the same time indicates that the first place to start looking is the wiring harness itself. Locate the MAP (manifold air pressure sensor - code 31) and IAT (inlet air temperature sensor - code 24) connections. D ... 1996 Toyota Land Cruiser

I have a 2005 vw jetta 5cyl. It has multiple misfire codes and code 18711 , leak in air intake . I have replaced the air intake brand new plugs , and coils , all with oem parts , I even tried a new mass air flow sensor . i brought it to a dealer , they said it was something in the timing and would have to disassemble frt of engine to diagnose . by the way, the car has 62000 miles . Any suggestions


There are two sensors that directly related to the timing.\015\012 The cam sensor and the crank sensor. I don't know if they\015\012were tested or overlooked. Or in some of the codes you\015\012pulled. But I would check these before ... Volkswagen New Jetta

04 grand prix code po128 car runs great good heat, temp guage in car is normal reading a little below the half way mark. Checked antifreeze level and was low about 1/2 gal. Refilled a little below the fill here when cold mark. Erased code and in 2 days po128 poped up again? Should i add more coolant to the fill. Here when cold mark and try again? Like I say i have great heat blowing and doesn't overheat and temp gage inside reads normal. What next if i add more fluid to the cold mark and the p


Change thermostat could be stuck open. ... Cars & Trucks

I took my 2001 olds bravada to advance auto to have a service engine light checked they checked it and told me it was a secondary air intake malfunction code then they erased the code after that my car wouldn't start. you can hear the fuel pump working and if you spray break cleaner into the air intake it runs briefly and dies


Too much air is entering the inlet manifold making the air/fuel mix too lean to ignite. Can you hear any suspect whistling or hissing from any of the pipes etc whilst the engine is turning over. Check every junction in the air ducting from the air f ... 2001 Oldsmobile Bravada

I took my 2001 olds bravada to advance auto to have a service engine light checked they checked it and told me it was a secondary air intake malfunction code then they erased the code after that my car wouldn't start. you can hear the fuel pump working and if you spray break cleaner into the air intake it runs briefly and dies


Well, the secondary air intake malfunction has to do with the air pump I read. Water can get into the air pump in some models and the pump would have to be replaced. However, I have heard that some OEM pumps have a short hose that accumulates water s ... 2001 Oldsmobile Bravada
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.2855 seconds