Having problems with your 2004 Jeep Grand Cherokee ?

2004 jeep flasher

\015 Signals not working\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2004 Jeep Grand Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

88 Jeep Cherokee, left turn signals don't work. Right signals flash as they should. Emergency flashers work as well. When the left turn signal is activated, the dash arrow lights up, the front bulb lights up and the rear bulb lights up but the flasher doesn't click. The flasher was replaced to rule it out and because it is easy, the left rear turn signal bulb was replaced and the front bulb was checked. It seems to me then next item to replace would be the turn signal switch. Any thoughts?


... 1988 Jeep Cherokee

Tempermental Flashers 97 Jeep Wrangler All of a sudden my flashers and turn signals dont work then they work then hours later they wont checked fuses and had a garage check flashers. What else could the problem be ??????


Itsounds like they are shorting out . you will need to follow the wiring for your signals and look for a wire that is shorting out, and be sure to check the ground wires as well. ... 1997 Jeep Wrangler

My 2006 jeep wrangler was making a noise like a belt squeeling drove about 5 miles noise stopped engine light appeared and oil pressure went to 0 (Jeep only has 38,000 miles)I imediatly turned engine off i checked oil was perfect checked water level perfect no oil under jeep really confused any suggestions


Have truck scanned for code can be anything oil pump timing chain etc also check warranty before doing any work most drive trains 5yrs- 100,000 miles ... 2006 Jeep Wrangler

I have a 2000 jeep grand cherokee 4.7 liter 4x4. the problem i am having is that when i turn the jeep on and it is idling the oil pressure is at about 40 lbs. however as soon as i touch the accelerator the pressure will drop to 0 until i let off the accelerator and then it will return to normal. it only does this after the engine gets cold or the first start of the day. the outside temperature seems to affect this some what because i used to be able to let the jeep warm up for 10-15 minutes when


... 2000 Jeep Grand Cherokee

Help! Just purchased a used 2004 Jeep Grand Cherokee and the speedometer jumps from 0-70. Had it checked at 3 shops, 2 of which were Jeep dealers, and none of them can figure out what's wrong. I haven't had my Jeep for 34 days and I just want it back :( Any suggestions?


Did anyone check for a binding or defective drive cable? ... Cars & Trucks

My 1997 Jeep Larado had the distributor brake at the braket that holds it in place. The jeep stopped running of course. I went and got a new distributor and brought the number 1 cylender to TDC and put the timeing mark on 0. The jeep turns over smooth but will not fire, I have spark coming out of the distributor. What am I missing.


If the distrubutor is definatley installed correctly, as you have some one crank the engine turn the distributor sightly counert clock-wise and clock-wise until the engine fires up. Then set the timing with a light. Double check the wires are in the ... 1997 Jeep Grand Cherokee

Where is the turnsignal flasher & hazard flasher on this jeep


I believe both are located on the fuse block, driver side of steering column. ... 1997 Jeep Grand Cherokee

My 2001 Jeep Grand Cherokee Loredo, straight six, is having a problem that the oil pressure gauge goes to 0 and my check gauges light comes on but when i accelerate it goes back up and the light goes off. Is this a sensor issue? Nothing seems to be wrong w/ the jeep


Your problem could be the result of a bad pressure sending unit but I would take care of that immediately. If the pressure doesn't return to normal after installing the new unit, do not drive 'til you have a mechanical gauge installed and the actual ... 2001 Jeep Cherokee

My jeep starts up and runs then it dies out and i put a fuel pressure tester and when the jeep is dying the fuel pressure drops to 0


... 1991 Jeep Cherokee Limited

My flashers don't work any more on my 2000 jeep wrangler. I bought a book and followed the instructions but the schematics did not look like my jeep.


... 2000 Jeep Wrangler

Show me flasher for the 1999 jeep grand cherokee turn signal flasher relay


Here it is. ... 1999 Jeep Grand Cherokee

1999 jeep turn signal problem. we replaced the flasher twice with no results. when it does flash, it can flash with or without the flasher attached! help!


Most on Jeeps are located under the dash on the right side of the steering column. ... 1999 Jeep Cherokee

86 Jeep GC, while helping a friend pull his pick up out of a ditch, my oil pressure drop to 0. I added some oil and the pressur came back up for a little bit then drop to 0 again.


To check the level of oil in the oil bread if it is correct you can replace the oil filter and if this does not improve it has that remplazar the oil pump ... 1993 Jeep Grand Cherokee

Hi. I have a 99 jeep grand. oil pressure gage fluctuated between 0 and normal. when it goes to 0 the warning appear. .then as I drive for a while it show normal. what to do?


Change the oil pressure sender switch.check the wiring first,it may have oil in it. ... 2003 Toyota Sequoia

2001 JEEP CHEROKEE LIMITED -- TURN SIGNAL WON'T BLINK, BUT FLASHERS DO WORK. BULB IS FINE. THINK IT IS THE FLASHER RELAY UNIT, BUT CANT FIND THE LOCATION....ANY IDEAS?


... 2001 Jeep Cherokee

98 jeep cherokee flasher and hazards not working. Changed the flasher that was up under my steering console. still no luck am i missing a fuse or do i need to grab a whole new switch?


... 1998 Jeep Cherokee

Ok Mr & Ms's Experts, try this one. I have a 1990 Jeep Cherokee Limited, I6 4.0L and I have problems with my right turn signal. This I know... 1) The bulbs are good. 2) Left flashers work front and rear. 3) I can manually make the right flashers work (both) by moving the signal stick up and down when I turn - when the running lights are off. 4) When the running lights are on, this does not work. A mechanic said I had a ground fault. If this is true, how can I find it?


Agree with the ground fault. Look for one of the TS lamps to be slightly dimmer than the ones on the other side. This would indicate that it is finding its ground through the parking lamp filament. From there you will have to use meters to trace t ... 1990 Jeep Cherokee Limited

My directional signals on my 1999 jeep cherokee sport do not work though my emergency flashers do. I've replaced fuses. what could be the problem? also, does this model use a combination turn signal/hazardous light flasher relay or are each seperate? Where do I find each one?


Turn signal relay switch. $15 part. located under driver steering colum ... 1999 Jeep Cherokee

Turn signals hazards flasher don't work jeep cherokee replaced combination flasher relay, turn signal switch and still no signals


I NEED TO LOCATE THE SWITCH WHERE IS IT ?\015\012MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME \015\012SO THERE MUST BE A RELAY SWITCH SOMEWHER B ... 1999 Jeep Cherokee

Hesitates after driving for awhile. Acts like it isnt getting enough fuel. I cleaned the 0-2 sensor, replaced thermostate, map sensor and spark plugs. When I am at a stop sign it acts like it is going to die. When put on puter it reads high input 0-2 sensor. 2000 cherokee jeep


You cant clean oxygen sensors, they need to be replaced, Also, remove your IAC and clean it out. ... 2000 Jeep Cherokee

Overhaul of the top in of 2003 jeep 4.7. It had jumped time, broke a valve spring and bent a valve. After the overhaul oil pressure at idle drops to 0 after the engine warms up. No engine noise what so ever. pressure jumps up while driving, but at idle drops back to 0. Afraid to drive, what should I do?


First thing you need to do is put a mechanical gauge in place of oil sender and read actual oil pressure. If mechanical gauge shows same condition, take a look at the connecting rod bearing serving the cylinder where the valve bent. If the piston hit ... 2003 Jeep Grand Cherokee

I have a 95 Jeep Grand Cherokee that I traded in on the c4c deal. I have not yet taken delivery (they are waiting for the gov't $) and my Jeep died a couple of nights ago, it was running, I stopped, parked, ran into a store, came out to restart, it sputtered and choked then died. It tries to start but won't turn over. After a tow and many tests, my mechanic says it is the fuel pump - he's getting 0 pressure from it, although the wires show power. He tried banging on the tank to jolt it for "


I dont know why Chrysler did this,but yes you have to get the whole unit,it is called a fuel pump sending unit.Did you consider getting a used unit for a lot less,and if your lucky fewer miles on the part. ... 1995 Jeep Grand Cherokee

Turn signals/emergency flashers on 2001 jeep wrangler d/n come on. changed fuse and bulbs. Where is the flasher (resister canister) located? What else could could it be?The signal stat?


Seating area, driver side, to the upper steering column housing at the top of the steering column, behind the multi-function switch ... 2001 Jeep Wrangler

My signal lights in my 2001 jeep cherokee sport don't seem to function correctly. The thing of it is that whenever i use them to make a turn, they come on for a little while, start blinking almost for 10 seconds, and then they stop blinking with the signal light still on... I'm thinking it's the fuse or flasher but I'm not for sure and I don't know where they are located... that's only because i've look it up and they pop up (the fuse and flasher that is). Hopefully it's something simple.


Sounds like the flasher up under the dash ... Jeep Cherokee

2000 Jeep Grand Cherokee, I had blinkers and flashers no brake lights, and after checking the bulbs in the light itself I dont have blinkers or flashers at all


Just no turn signals in the back now? Maybe didn't install the bulbs tight back into the asm? No brake lights...do the lights work with headlights on and just no illumination with the brake pedal depressed? Could be brake light switch. ... 2000 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.6727 seconds