Having problems with your 2004 Ford F150 ?

2004 F150 low beams not working

\015 Hi beams work fine\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2004 Ford F150

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 04 f150 and the high beams are not working and the fog lights don't work. the dash bord lights say they are on but nothing, i check fuse and they are good. my low beams work fine so far. any ideas on how i can fix this ?


... 2004 Ford F150

Does a 1987 ford f150 have a low beam relay? neither of my low beams work and the bulbs look good


You can run a wire to head light from batt to check if blub is good , if good then dis connect batt and test wires for break, then switch. ... 1987 Ford F 150

Low beams don't work - both out at the same time. High beams do work fine. I swapped the low and high beam relays in the fusebox and there was no change...no low, high OK. I can feel the low beam relay click when turning on the low beams and then the high beam relay click when turning on the high beams. still no low beams. Fuses for each side low beam are good (tested with ohmmeter). When I turn on the lights, I get 12v at the low beam fuses. When I turn off the lights, I get 0v at the low beam


DID YOU CHECK THE BULBS? ... Chrysler Voyager

2000 Mazda MPV minivan: When the headlight switch is set at the center position to turn on the low beam headlights, the low beam headlights are not on, but the high beam headlights' blue indicator on the dashboard becomes on. The high beam headlights work fine. When the problem just started a few weeks ago, sometimes the low beam headlights came back working, and the high beam indicator disappeared, but after a few minutes both low beams stopped working at the same time and the high beam blue


... 2000 Mazda MPV

I have a 2008 f250. one headlight (driverside) low beam is not working. I have checked both fuses 10amp and they are good. The flash to pass works and both lights on bright, right and left come on. the high beams work also. The only problem is that the driver side low beam is not working. I know the bulb is good cause I put it in the right side and it works on dim and bright.on the bulb that does not work on dim(driver side) I am getting 8.6 volts on low beam ,but not the full 12v. does this lig


I am sure that a 12 Volt bulb means it needs 12 Volts. Since you changed the bulb to the other side, why not check the voltage in the working side and see what it reads?\015\012\015\012Sometimes the turnstalk can interfere with the light ... Ford F-250

Kenworth t800 right highbeam fault, low beam works fine. high beam does not work. replaced bulbs and checked connection. checked for voltage. have power with both high beam and low beam. plug it in and does not work. swithed low beam prong with high beam in the plug and both lights work fine. why does the wire have power with meter. and as soon as you plug it into the bulb it faults out?


... Cars & Trucks

Low beam lights will not work on my 2001 ford f150 replaced bulbs still not working


... 2001 Ford F150 Styleside SuperCrew

1998 Ford F150 XLT 4.6L All lights work including high beams exept the low beams and running lights. Please help, thanks.


... 1998 Ford F150 Regular Cab

My low beams won't work on my 2001 Mazda Miata. The High Beams work and the fog lights also work, just the low beams not working. I checked the relay under the hood on the passenger side and it looks ok. Also checked the fuse under steering wheel and it also looks fine. There are two wires going to the bulb housing, red / white & white. I have voltage to the bulb housing, 12v on the red / white wire, and 12v on the white wire when the switch is pointing to low beams. Also 12v on the red / whit


... 2001 Mazda MX-5 Miata

Audi A4 low beams not working, high beam works, dip lights work, i put new bulbs in. the low beams still don't work. i cant find the fuse box for the low beams.


... 2002 Audi A4

My 2002 Camry low beams aren't working. High beams only work when I pull the lever back. If I let it go or turn high beams on they don't work. Day running lights work, just not the low beams.


... 2002 Toyota Camry

2004 F150 low beams not working


... 2004 Ford F150

2004 F150 low beams not working


... 2004 Ford F150

Low beams My low beams do not work. I tried replacing the headlights, but nothing. I have to use high beams for them to work, and they will often shut off too. I think the high beam switch is bad, but that doesnt explain why my low beams dont work...


The low beams go threw the switch also and that side of the switch burns out ... 1987 Dodge D150

Low beams My low beams are not working, I checked all fuses and they are good, replaced headlights, still no low beams. The retractable lights don't even open when I turn on the lights, they only open if I switch to High. But when i switch on low beams, dash lights do go on. All other components in wiring diagram work except low beams.


Hello i no you said you checked your fuse box go under your hood drivers side near your strut tower their problay is a second fuse box its black some times fuses is on the cover you have to unlock the side of cover lift off on inside of cover will l ... 1989 Honda Accord 4 Door

2007 Honda accord 4 cyl. Low beam doesn't work. New bulbs on both sides. Both high beams work and both low beam bulbs work on Daytime Running Light mode. Just low beam on passenger side goes of


This is usually caused by a failed front control module as this unit controls the lighting on the vehicle!--------airbag reset tool ... Cars & Trucks

My low beams are not working but the bulbs and fuses are fine, i even switched the passenger side to the drivers side and it worked but there's no low beam on the passenger side at all... high beams work just not the low beams


Did you ck fuse F1.40? 20 amps. ... 2004 Lincoln Navigator

My 2001 Buick Regal GS low beam were going on when I switched from high to low, then they went out. High beams work. Now the low beams dont work at all even with the headlamp switch pulled out. I cant find any low beam fuse or relay. Where would i find them.to low


... 2001 Buick Regal

Mazda protege: both low beams quit at same time, high beams work, changed bulbs, still have same problem except now one high beam and one low beam works on the high beam setting.. help have tested all


That should be the problem.Check the voltage at the dimmer on each setting. ... 2000 Mazda Protege

The high beam headlights in my 2005 Nissan Altima have both stopped working at the same time. The low beams still work perfectly. I get indication on the dash that the high beams are working. I never use the high beams and have just found out that only one fuse controls both the high and low beams. I 'm thinking dimmer switch but would I still get indication on the dash that the high beams are on with a faulty dimmer switch?


... 2005 Nissan Altima

Low beams work intermitantly high beams work while holding lever only had wiring from remote starter checked and wiring is not connected to low beam wires while driving holding high beam in the on position, low beams came back on when I let go of high beam lever


Well it's hard to tell you anything as you did'nt call off the make year and model. the answer changes from one model year to another a 1935 model will be way different than a 1999. Most of the modern cheveys the combiantio switch is Bad 70's - 80' ... Chevrolet Monte Carlo

Driver side low beam stopped working last week.Had both bulbs replaced at Toyota Dealer.Today driver side low beam does not work, and neither high beam bulb works when stalk is in the normal (fully down) position, but both high beam bulbs will work when the stalk is pulled fully up.


... 2007 Toyota Corolla

Headlight problems 2007 Toyota Corolla Sport, 186 000 kilometers: Driver side low beam stopped working last week.Had both bulbs replaced at Toyota Dealer.Today driver side low beam does not work, and neither high beam bulb works when stalk is in the normal (fully down) position, but both high beam bulbs will work when the stalk is pulled fully up.


I would check for voltage at the dimmer switch first. ... 2007 Toyota Corolla

My RH low beam is out, I though it was the lightbulb so I bough an identical Phillis light bulb put it on and nothing. I checked the #15 fuses to the RH side lowbeam and its good. the headlamp relay fuse in the fuse box ( 4 prong) i believe works because if I remove it the LH low beam that works does go off, My question is what esle could it be? is the headlamp relay fuse a two part system that it could be partially out and make the LH side lowbeam work but the RH side low beam be out?


No, single relay for both low beam bulb. Check the wiring at the RH lb side - either a wire is broken (or the grounding is corroded) or the clamps in the bulb socket are deformed (or corroded).  ... Lexus ES 300

Low beams wont work on 1990 camry changed globes checked fuses, changed head lamp relay . switch seems fine , I was playing with the head lamp realy and it seemed they worked, and the next day they didnt so i have replaced relay still no go and i cant get high beam now unless i pull indicator back towards me to flash high beams , with indicator pushed forward in its traditional constant high beam this function will not work as i did previously either, so no high or low beams now can you help


... 1991 Toyota Camry
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.1496 seconds