Having problems with your 2004 Ford F150 ?

I need to wire a pigtail for a oxygen sensor for 2004 ford f-150

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2004 Ford F150

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Oxygen sensors I have a GMC sierra 1500 HD 2wd. I am try to wire in some EFIE's into my oxygen sensors to allow my hydrogen generator work on my truck. I need to know which of the four wires on my oxygen sensors is the "highside signal wire". Can you please help.


You have four on this truck. bank one sensor one is "black and white" b1 s2 "brown" b2s1 "light green" b2 s2 "red/white" good luck post as fixed thanks ... 2003 GMC Sierra 1500

I need to wire a pigtail for a oxygen sensor for 2004 ford f-150


... 2004 Ford F150

I have a 99 dodge ram 2500 with the 5.9 gas v8. I need to know what wires that go to the oxygen sensor are the signal wire, the 12v power wire, and the ground wire, or what all the wires are, there are 4, orange and black, blue and black, green and white, and I don't remember the other, really need a diagram but an explanation would be nice, its for the rear sensor the one used to determine catalytic converter efficiency, thanks


... Dodge Ram 2500

I need a diagram of the exhaust system on a 1992 toyota previa, showing the oxygen sensors, I have replaced the sensor with 4 wires, I was told that there was another sensor with two wires, however the two wire sensor only occurs on 1995 models and up, there is supposed to be a 3 wire sensor for the 1992, where is that sensor located and how many wires does it have.... I am going to go to a junk yard to find it and want to make sure that I get the right one....is there any way to test an O2 sens


... 1992 Toyota Previa

I need to replace the Oxygen sensor in my 2001 Passat 4 cyl 1.8T. How many wires are there needed on the sensor? I have seen 4 wire. 2 wire, and even a one wire.


... 2001 Volkswagen Passat

All the insulation on my map sensor pigtail wires has burned off. A friend of my cut the wires near the computer and I bought a new pigtail... but the wires on the new pigtail are all white and I need to connect them to the original wires by the computer. Can anyone tell me the order that the wires go in on the pigtail? It's a 1998 Olds Achieva with a 6cyl. engine.


Okay here we go, there are three wires from the map sensor, if you look at the sensor there are letters stamped on the plug area, theres an A,B,and C the wires start from the sensor as orange/blk to terminal A then lite green wire to terminal B and l ... 1998 Oldsmobile Achieva

EMMISSION REPLACE OXYGEN SENSOR - OLD WIRE BROKEN NEED DIAGRAM TO FINE HARNESS WIRE OXYGEN SENSOR


Here are some sensors.http://www.autozone.com/autozone/parts/1996-Subaru-Legacy/Oxygen-Sensor/_/N-j4zs5Z8gcvp ... 1996 Subaru Legacy

My 2000 mitsubishi eclipes v6 has had the wires cut to the oxygen sensors. the front one has a plug and was no problem. the rear 2 have had the wires cut and the plug removed. I can only see 3 wires for each of the 2 plugs. the new sensors which came from mitsubishi have a plug with 4 wires. The wires are 2 white, 1 black and 1 grey. could you tell me where the 4th wire connects. I need to get finished so the check engine light will go out to have the car inspected.


Hi,Look at the wiring diagram :-Look at the below wiring as well :- ... Mitsubishi Eclipse

Mine has 217,000 miles. Has run great up until some time ago, when it started driving roughly only in wet weather. Now in dry weather, it starts fine, but drives roughly after warmed up (15-20 min) and then stalls. Will restart, but dies again shortly. Codes said oxygen sensor, knock sensor & cylinder 3 malfunction. Was told knock sensor code could mean it needs a tuneup. Changed spark plugs, wires, distributor cap, rotor, air filter, gas filter, oxygen sensor, PCV valve, cleaned EGR valve, repl


The knock sensor NEVER causes a drivability problem. DO NOT change it. Instead, clean the MAF, Mass Air Flow sesnor that's on the air intake tube near air cleaner. It is coated with varnish. Spray with carb cleaner several times and gently, gently b ... 2000 Mercury Villager

O2 sensor There are four wires on my oxygen sensor. I need to know which wire sends the signal FROM the sensor TO the computer.


The return signal is pin A circuit number 413 which is a tan wire. ... 1998 Chevrolet Malibu

I have a dodge dakota 2002 sxt 3.9 4x4 ,it has 2 oxygen sensor passenger side need to change .i bought 2 denso sensor , need to make wire connection .sensor side blue (signal) , white (ground) , 2 black (heater)connector side : black , gray , 2 whitecan you help me to do the right connection ?


... 2002 Dodge Dakota Club Cab

I have to replace my O2 sensor on my 1996 Honda Accord LX...Problem is I don't know where it is. This the one I need to replace Oxygen Sensor - OE Type - Exact Fit - Downstream Sensor 4 Wire, Heated. I have the part already, I just need to know where it goes.


Hey\015\012\015\012The oxygen sensor should be in a black box on the intake pipe in the engine bay, its usually a case of just loosening two screws and removing the connection. hope this helps.\015\012\015\012Damien ... 1996 Honda Accord

Need to find wiring for my 94 Mazda B2600 oxygen sensor, as it has never had wiring since i have owned it


... Cars & Trucks

Need wiring diagram or detailed description for 2008 dodge charger 3.5L ambient temperature sensor. Previous owner accidently removed connector and wires I have new connector and pigtail wiring but dont know which cut wires to attach to.


... 2008 Dodge Charger

Need the wiring diagrams for oxygen sensor 2004 chevrolet SSR


... 2004 Chevrolet SSR

I have a 1997 Dodge Intrepid ES with the 3.5 motor. For the past 3 years, the check engine light has been on but has been running fine. I now want to sell it so I went down to the auto parts store and the codes said that the plugs, plug wires, crankshaft sensor and a oxygen sensor needed replacing. I replaced the plugs and crank sensor then drove it to town and it ran great. The Check engine light was still on so I stopped by the parts house and they cleared the codes for me. I went out the nex


You need to reset the ECM once you make any changes to the car.If you only change the sensor then it won't be picked up unless you reset the car using a proper diagnostic tool.Be careful to read all codes before you reset it. ... 1997 Dodge Intrepid

I have a 1997 Dodge Intrepid ES with the 3.5 motor. For the past 3 years, the check engine light has been on but has been running fine. I now want to sell it so I went down to the auto parts store and the codes said that the plugs, plug wires, crankshaft sensor and a oxygen sensor needed replacing. I replaced the plugs and crank sensor then drove it to town and it ran great. The Check engine light was still on so I stopped by the parts house and they cleared the codes for me. I went out th


Then I am guessing that the oxygen sensor really needs to be changed, as most of the time the oxygen sensors will have intermittent problems and will sometimes work fine for a while and then bug up again. In some cases they will only go into fault at ... 1997 Dodge Intrepid

Wiring diagram I have an oxygen sensor with a 4 hole coupling. Each hole in the coupling piece is numbered 1 -4. The wires are Black with red stripe, black with blue stripe, black with white stripe and a green with red stripe. I need to know which wire goes to which numbered hole in the coupling connector. Thank you [email protected]


There should have been an instruction sheet with the replacement sensor that tells you which wire goes to which.If there is no instruction sheet I would go back to the store and ask for a replacement.Each brand of replacement sensor has a dif ... 1996 Jeep Grand Cherokee

NEED WIRING DIAGRAM FOR 99 METRO OXYGEN SENSORS TO ECM


... Cars & Trucks

I need a wiring diagram for an o2 sensor on a mazda mx3 the front oxygen sensor it a 1.8l


See page two on this PDF file HERE\015\012\015\012 ... 1993 Mazda MX-3

I had my old catalytic converter turn red and was told by a work mechanic that I needed a new one. So I had a new one professionally installed. I have changed the spark plugs, spark plug wires. PCV valve, 2 02 oxygen sensors, and the converter is still turning red.Also I have had 2 dignostic test done on my 1991 cadillac eldorado, but even the new converter is still turning red. What can I do as I am spending money and no results. I need to know what I can do, to stop this. Thanks


Engine is running rich. Some reasons might be MAF sensor or computer. Is the engine light still on, or what are the codes you got from the previous scans? ... 1991 Cadillac Eldorado

Crank shaft sensor pigtail wire it has a piece of wire hangn does it need to b replace?also my belt torn


... Cars & Trucks

Front oxygen sensor circuit malfunction P1130 (open circuit) is this a wiring malfunction or a need to replace the sensor ?


... Cars & Trucks

2005 dodge grand caravan 3.8v6 check engine light came on 4 weeks ago went to local auto parts who checks for free was told oxygen sensors needed to be replaced so i replaced both sensors plugs and wires. everything was fine and today the check engine light came back on went back to parts store and was told powertrain control module relay or fuse now what?


... 2005 Dodge Grand Caravan

I need a wire diagram for a 2000 zr2 s10 chevy 4x4 4.3L engine for oxygen sensors to the computer it has 2 sensors


\015\012this should help. ... Chevrolet S 10
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.0034 seconds