Having problems with your 2004 Dodge Ram 3500 Truck ?

I have a loose vac line from the rear axle drivers side going to I have no idea where. Where should this line attach?2004 Dodge 3500 5.9.

\015 2004 ram 3500 5.9 diesel,\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

I've seen some 4-wheel drive vehicle have vent tubes coming from the axle housing. Are you sure it's a vacuum tube?
Repair Help & Product Troubleshooting for 2004 Dodge Ram 3500 Truck

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a loose vac line from the rear axle drivers side going to I have no idea where. Where should this line attach?2004 Dodge 3500 5.9.


I've seen some 4-wheel drive vehicle have vent tubes coming from the axle housing. Are you sure it's a vacuum tube? ... 2004 Dodge Ram 3500 Truck

1987 Dodge Raider started cutting out going up hill. At first it would just pull back and buck back and forth. It never had a problem on the flat. Now it has a problem on the flat too and completely stalls out going up a hill and now wont start. It acts as though it is out of gas going up hill. The fuel line has been flushed thru and it has a manual fuel pump. Any suggestions would be greatly appreciated I have the exact same problem as the one described above from August. Do you have an idea


Fuel pressure from the fuel pump needs to be checked,it needs to be 4 to 7 pounds psi,also check the fuel filter,and the carburetor.Has the engine been tuned up,new plugs and plug wires ,and cap,and rotor?Check the vacuum advance ,or spark advance if ... 1987 Dodge Raider

1998 Durango, replaced brake line that was rusted in two, (was long line under drivers side to rear) bled all four brakes, abs and brake light are now on and will not go off. Have read it could be rear sensor, but what are the odds the sensor suddenly goes out after replacing the brake lines? Any ideas on how to fix the problem or what it could be? Afraid to drive it to a repair shop if the brakes aren't good.


Dear Brake Line.... I read your paragraph and if this brake light was never on previously to the brake line repair....then all it sounds like to me is that you have air enclosed in the braking system still. I would strongly advise that you b ... 1998 Dodge Durango

I have a 99 dodge durango 5.2. I was told my fuel pump is on the drivers side of the truck near the second door. I was told it is too loud and is beginning to go out. When I drive the truck it does not "get up" the way it should and if I just get in the truck and go it will sometimes only go slowly until the truck catches up. I have already had the oxygen sensor replaced, so is it possible that I am loosing pressure because of the fuel pump? I also want to know if it is safe to reuse the fuel pu


Your problem could be your fuel filter, fuel pump or your fuel injectors OR TRANSMISSION FILTER. Before replacing the fuel pump, replace the fuel filter and have the injectors cleaned. You can use the fuel pump housing, but I would have the transmis ... 1999 Dodge Durango

1997 dodge caravan Check endine light keeps going on for gas vapor after tank was lowered to replace brake line by shop that does not know how to fix it.I paid alot of money for brake line as car would not pass inspection. Light was not on before job. They even charged another 50 when they clamed to smoke system and found boot they replaced. It did not work and I have had it there 2 more times and light still goes on. It goes on without getting gas. any ideas. steve


Sounds like the garage knocked a vacuum line loose .you will need the lower the tank and see if all is plugged in and if anything is broken ... 2007 Dodge Caliber SXT Sport Hatchback

I have a 1991 Mercury Capri with power window problem.Thereis a short in the feed to the control on drivers side control. Both windows do not go up or down using either switch,but I can apply power source to each window motor they work..I'm assuming the mice got into the feed line and shorted it. Can I run a new feed line as fix for this problem ? Any ideas? Thanks Dennis


Your solution is possible; €if you dont discover exactly the point where is the short, you need re-wire the system for each windows motor.The wiring diagrams will can find in autozone.com (free register).Hope help with th ... 1991 Mercury Capri

Hello, I have a 2002 Dodge caravan and I am having trouble with the driver side power window.The window will not go up or down until I bang on the door panel. It acts like a broken wire shorting out. Is this a common problem with Dodge Caravans? Any ideas how to Isolate the problem without replacing everything?


This problem is caused by a defective motor, the motor's brushes are sticking, so banging on the door jars them loose and it works again, this is a classic symptom of a defective window lift motor. ... 2002 Dodge Caravan

1988 Dodge caravan SE. Metal fuel line coming from gas tank to the drivers side rear. what does it connect to? Not talking about the fuel line going to the fuel filter. It fell of and cant find what it attached to? I blocked it off now van vapor locks and dies in warm weather


Sounds like you have a broken fuel return line. The high pressure line goes through the filter and to the injection system, and the unused fuel is returned through the pressure regulator back to the fuel tank. ... 1988 Dodge Caravan

200 dodge stratus. At the begining of this grip all of the windows did not work except the fron pass. I Checked for voltage going to the motor and it read 14v for both up and down, so i replaced the window motor and the window worked Great. So the two front wondows were working. about 2 weeks later, all of the sudden the Driver window(the one that i just worked on) stops working and now the two rear windows work...so now all windows work except the driver. ???? Any ideas?


Did you checked the the motor again.is it working fine.also check the fuses are they got blown out or any wire getting short.also is the motor connected with high guage or low guage wire then required its guage ... Dodge Stratus

Have a 04 dodge with a driver side grinding noise that comes and goes. It started after I got my truck stuck in the snow. I thawed out the front end last night, and now its worse. It comes and goes while going down the highway. Sounds like something loose and grinding on the hub. Also in 4x4 it makes a clicking noise like a CV joint. Would a CV joint make a grinding noise that comes and goes?


C V Joints can make a lot of noises. Sounds to me like you either bent the inner fender or if it is plastic you may have pulled it loose and it looks normal but it is just sitting in place with the push pins out of their intended holes. When you turn ... Dodge Ram 1500

2.0 CRD SXT 2008 Dodge Journey runs very well most of the time and then it seems to loose power so much so that if reversing or in forward drive it almost stalls when going up an incline slowly any ideas


... Cars & Trucks

Dodge Durango 2004, the volume on radio will not go further than 1 on the graph, and also no sound in speakers.... can adjust between 0 and 1 ?? Any idea what to do ?


... Dodge Durango

The power driver's seat in my 2003 Dodge Stratus is not working, and I need to find out how to fix it. It will move up and down, but only left side will go forward and back. Pretty sure nothing is under the seat, blocking the track. Felt what seemed to be a loose cable. I want to fix it myself and am looking for a detail pictorial of the "guts" of the seat and how it works.


... 2003 Dodge Stratus

Hi I have a dodge ram 1997. I have problems with getting my truck into Drive. Sometimes I have to drop down to first and then back up, still playing around with the slector to get to go. The gear indicator dial seems to be not lined up with the slector lever. The lever itself is not loose. Sometimes the Truck will not start in park. I have to put it in netural to start. But not all the time. Can any one offer any help on this matter?


Linkage adjustment on the transmission ... 2004 Chevrolet TrailBlazer

I have a 2000 Dodge Durango. My rear window on the drivers side has come loose and slid down inside the door. I took the door apart and found an unatached cable but I dont know where it snaps back on? Any idea?


Sounds like the window regulator broke,u will need to replace the whole assembly,sometimes u can get them without the motor and change over the motor from your old window regulator to save a little cash ... 2002 Dodge Dakota Club Cab

The back pasenger electric window of my 2006 dodge ram 3500 deisel wont go up.both the switch on the door and the switch on the driver control door dont work. checked the fuse box but found nothing labeled rear window. took the door panel off and checked the conections to see if they were loose and they wernt, unhooked them anyway and pluged them back in. still nothing.


Hi, there is a relay for the windows. in the fusebox (s) there should be a relay for each window. these relays do fail (open circuit on switch side). the feed POWER side may be shorted. these circuits are hard to find the fault, but check all the doo ... 2006 Dodge Ram 3500 Truck

My 99 dodge ram's clutch seems to be fairly loose. It didn't give me any idea of anything going out. Just occured a couple of days ago


Do you change clutch? you need pump clutch pedal for long time ... 1999 Dodge Ram

1994 ford e-150. Looks like this unit has a electric brake system. Has this unit mounted under drivers side door area.. All brake lines go to this box.. Has a electric motor attached to it as well... Any idea what this unit is called??? And any diagrams for servicing this assembly? Thanks for any info.. John


It could be for handicap assist braking. You might ask about that at dealer. ... 1994 Ford Econoline

My Chevy 5 cyl. Colorado stalls after going just a short distance. This happens after it sits over night. I tried turning the key to on for a few minutes before starting with some success. After it stalss a couple of times its ok for the day unless it sits awhile. Seems like the fuel line looses its fuel or something. Any ideas on what this could be?


... 2005 Chevrolet Colorado

My oil gauge keeps going to 0 and then it seems to come back when we hit bumps it doesnt feel like im loosing any power what could this be i have a 97 dodge dakota 3.9 l engine the oil gauge doent fluxualte its on or not


Try changing the oil sending unit, it's usually screwed into the side of the engine block, somewhere around the oil filter, or into the side of the oil filter housing.\015\012If it still does it after that, could be the gauge itself, or there i ... 1997 Dodge Dakota

I have a 1996 dodge ram 2500 4x4 with the v-10 and i just changed the hub bearing on the drivers side and now the axle seams really loose kinda like a ball joint but the ball joints are good any ideas on what it could be


Check torque on hub bearing nut sounds like bearing not seated all the way ... 1996 Dodge Ram 2500 Club Cab

Ford van 1988 E150 500 efi engine. two fuel tanks. no fuel to the fuel rails. I disconnected the fuel filter under the driver side, turned on the key, no fuel came out of the line from the tank. I disconnected the electric line at the fuel pump under the driver side and tested for juice. No juice going to the pump. I removed the change over switch at the dash and poped the quick connect and tested for juice out of 6 wires going to the switch only one was hot But the tester was blinking on and o


Check the fuel pump relay, it is most likely defective. It is located in the PDC box with other relay's. You can take a relay from another power source and use it in the fuel pump circuit to verify the fuel pump relay is defective. ... Ford F-150

Vacuum line loose on 1996 4x4 dodge pickup with


... 1998 Dodge Ram 1500 4WD

I have a 1984 Buick regal that need a fuel line from the gas tank to the middle of the driver side where the brake off is.. the problem is I cant followed the lines because it go into the frame of the car in the rear than two lines come out and go into the gas tank. Is there a of the fuel lines


The larger one is fuel supply the mid size one is the return ... Cars & Trucks

High side of four wheel drive will not go in gear. My 2000 Dodge 1500 four wheel drive pickup will not go into high four wheel drive. The transfer case shifter bolts were loose but I fixed that with new bolts It will go into low four wheel drive but not high. The shifter will not move. I was wondering if something fell out which the shifter was loose.


... 1995 Dodge Ram
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.8274 seconds