Having problems with your 2004 Chrysler Voyager ?

Rockers broken on 07 voyager any know issues why

\015 Rockers broken on 07 voyager any know issues why\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2004 Chrysler Voyager

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Rockers broken on 07 voyager any know issues why


... 2004 Chrysler Voyager

Chrysler grand voyager 2004 gone in to limp mode, gearbox repaired (told a broken tooth on one of the gears (auto box)). Car returned and gone back in to limp mode after fill up with fuel? Gearbox ''expert'' said it was not solenoid and must have been this broken part, obviously another problem,


Get diagnostic codes to get a starting point for repairs required ... Chrysler Voyager

99 plymouth voyager 3.0 rocker arm torque - 2000 Plymouth Voyager


... 2000 Plymouth Voyager

1998 voyager rocker arm ticking noise - Voyager Plymouth Cars & Trucks


... Plymouth Voyager

My landrover discovery series II has a timing belt problem. The teeth on the timing belt keep getting ripped off. This time the push rods & vlaves were ent, but there was no damage to the pistons nor any visable damage to the engine. One rocker arm on the rocker shaft is broken. This is the third time it has happened in under 1500km.


... 1997 Land Rover Discovery

1997 plymouth grand voyager v6 3.0L broken timing belt


HI... I HAVE A 1990 PLYMOUTH VOYAGER VAN 3.0 ENGINE..MY TIMING BELT WENT STANDING AND IDILING AT A TRAFFIC LIGHT..I WANTED TO KNOW COULD I HAVE BENT THE VALVES ON THE ENGINE,, IS THIS MOTOR A INTERFERENCE MOTOR,,I DONT WANT TO DO ALL THIS WORK IF TH ... 1997 Plymouth Grand Voyager

Installed new oil pump and now have broken rocker arms


THe rocker arms are broken because there was not enough downward movement in the valves to allow the cam to complete its turn. IT happens when the valve spring retainer either hits the top of the valve guide or the valve springs are fully compressed ... Ford F-150

1994 plymouth voyager hood release cable broken


Get a flash light and shine it under the hood and use a screw driver to pull the latch over to one side to pop the hood open. ... 1994 Plymouth Voyager

Broken rocker arm l200


... Cars & Trucks

Broken rocker arm


... 2004 Dodge Ram 1500

Broken bolt Holden barina rocker cover


... Cars & Trucks

2004 Cavalier broken rocker arms after head gasket repair.


... 2004 Chevrolet Cavalier

Broken rocker arm on a 2006 jeep liberty


... 2006 Jeep Liberty

Part that holds 2000 plymouth grand voyager window in track is broken can i purchase the part or do i have to buy new window


... 2000 Plymouth Grand Voyager

1991 voyager shift cable may be broken


... 1991 Plymouth Voyager

1997 Plymouth Voyager broken hood latch cable


First,\012try smacking the hood at one of the front corners while someone else\012pulls the release handle. or even after you've pulled on it. if that\012works, once open, adjust and lubricate the hood latch assembly. if it\012still won't open, ... 1997 Plymouth Voyager

I have a 91 Voyager with broken shift arm.


It sounds like he broke the gear selector cable, ... 1991 Plymouth Voyager

97 plymouth grand voyager 3.3 Engine rocker arm torque specs


... Cars & Trucks

1993 Hyundai Excel - Broken Intake Rocker Shaft. I cannot find any information on the part number. I have read that there are many other vehicles that I can source this part from (Mitsubishi and Dodge). Where should I start?


Contact a Hyundai Parts Department - BEST SOLUTION! ... Hyundai Motor 1993 Excel

Need to remove ignition cylinder from 97 plymouth voyager minivan. The key has broken off in the cylinder and the steering column is locked. Have taken off the shroud around the cylinder and now cannot seem to get the cylinder out without a torx screwdriver. Is there any other way and if not where do you find one of those torx drivers?


Torx drivers can b found at any hardware ,auto ,where most tools are sold but before u do all that pick up a set of small picks like used in removing o-rings u should b able to fit one of the angled ones in cylinder and remove broken piece ... 1997 Plymouth Voyager

My plymouth voyager 1997 van, the gas cap cover at the hinge part is broken.


... 1997 Plymouth Voyager

How to change radio antenna for Plymouth 1998 Voyager which was broken off at the base.


... 1998 Plymouth Voyager

Part of the plastic filler cap has broken off and fell into a 2.2 dti vauxhall movano engine.Whats the best thing to do? Drop the oil and inspect the filter and sump? Or is it a rocker cover off and how easy is this to do?


Of it has fallen into oil filler cap then ye rocker cover off first then if not there, then strip down from top to botom. Make life as easy for yourself as possible. ... 2004 Renault 181

93 plymouth voyager - radiator hose leaking, chirping sound from engine and hood release broken so hood won't stay closed. Is this something a 50 year old woman can fix by herself?


You can try an tighten clamp that holds hose onto rad, or if its hose, take it off an go to parts store an get same thing an put on same way took off......chirping could just be belt or pulley, ( cant really say what to do about that)....hood release ... 1993 Plymouth Voyager

Audi 1.9 tdi fuel leak from back end of engine just under neath rocker cover pipe work goes to the turbo there is one screw with a broken head on the cover what is this


... 2003 Audi A6
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.2047 seconds