Having problems with your 2004 Chrysler Pacifica ?

2004 chrysler pacifica failed egr pressure and position sensor

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2004 Chrysler Pacifica

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2004 chrysler pacifica failed egr pressure and position sensor


... 2004 Chrysler Pacifica

Engine light Is on.Troubleshooting P0406 Oem brand Domestic. 1 failed egr position sensor 2 open or short circuit condition 3 Failed egr valve 4 Failed egr pressure sensor where application This what the test read probable cause


To repair this code you must replace the EGR valve assmebly, do u know the location of the valve and what it looks like? if not, please telll me what engine u have. here is a picture of the EGR valve, it looks the same on all the engines.\015\ ... Dodge Magnum

Code#P0404 CAME UP EGR SYSTEM FAILED FAILED EGR POSITION SENSOR OPEN OR SHORT CIRCUIT CONDITION FAILED EGR VALVE FAILED EGR POSITION SENSOR APPLICABLE OK SO THIS IS WHAT CAME UP WHEN THEY READ THE CHECK ENGINE LIGHT SOOOO I HAVE CHANGED THE EGR VALVE AND STILL WONT GOT PASS 10MPH AND JUST STUMBLES ALL OVER ITS SELF SO I UNPLUGED THE SENSOR AND IT IS RUNNING GREAT BUT THE SENSOR IS NEW AND I CANT KEEP IT UNPLUGED SO DOES ANYONE THINK THAT THE EGR VALVE THEY SOLD ME IS FAULTY... PLEASE HELP


... 1998 Chevrolet Blazer

Failed EGR position sensor... Negative Back-pressure EGR valve: An exhaust-gas-recirculation valve having a normally closed bleed hole which opens when back pressure drops, reducing vacuum above the Diaphragm and cutting the recirculation flow. Where is this valve and how do I fix it?


... 2006 Chrysler Town & Country

Power loss i have a 2003 chevy monte carlo with 87,000 miles my car idles great but when i press the gas hard the engine revvs but there is power loss the tranny shifts fine (service eng soon) had it scanned trouble code (p0404)fault in egr position sensor (probable causes) 1failed egr position sensor 2open or short cirtuit condition 3failed egr valve 4failed egr position pressure sensor where applicable 5failed egr position sensor where applicable (question) can a catalytic converter


Can't answer your last question but catalytic convertors that are just not working anymore won't cause any loss of power.\015\012However, if they have shattered inside (they are kind of a ceramic honeycomb) they can dump junk into the exhaust system ... 2003 Chevrolet Monte Carlo

2007 pacific egr position sensor - 2007 Chrysler Pacifica FWD New Cars


... 2007 Chrysler Pacifica FWD New Cars

How much would it cost to fix a failed egr position sensor on a Chrysler 300


... 2005 Chrysler 300

I HAVE A P0300 OBD CODE I DID A COMPRESSION TEST TO ENGINE AND IT PASS THE TEST,I DID CHECK EGR VALVE,CHANGE SPARK PLUGS,IGNITION WIRES, CAP AND ROTOR, I DID CHECK TPS SENSOR MAF SENSOR,FUEL PRESSURE,AND OXIGEN SENSORSI I FOUND THAT ON BANK 1 BOTH SENSORS (UP STREAM & DOWN STREAM )WORKS NORMALY BUT ON BANK 2 THE SENSOR 1 CHANGE FROM 0 TO 600 MILIVOLTS BUT NO CHANGES FROM RICH TO LEAN &SENSOR 2 HAS 0 MILIVOLTS & NO CHANGES FROM RICH TO LEAN SO I SWICHT SENSOR TO TEST THEM FROM BANK 2 TO BANK 1 AN


... 1997 Nissan Pathfinder

Code p1406 valve pintle position open or short circuit condition poor electrical connection egr position sensor fault failed egr valve i replaced the valve and the check light is still on


Unless you use a scan tool to clear the fault, it will not go away by itself until 40 consecutive warm up cycles have been completed without a fault. You can go to Autozone and they will clear the alarm for you. You can also clear it by disconnecting ... Isuzu Trooper

Where is the egr sensor on 2006 2.7 chrysler 300 can it be changed by the owner getting code for failed egr sensor


... Chrysler 300

Hyundai sonata 2000 gls. v6. HAs no EGR. Emission test, first try, HC(0) CO (0) nox 1033 mechanic said my engine seems hot (there was also heat out of vents blowing out. I cleaned my maf sensor and put on high octane gas and fuel cleaner drove for a week and retested. ssecond try HC(0) CO (0) nox 1250. failed agian. I changed my mass airflow from anotehr car and change my 3 front spark plugs myself not the three at back. Car seemed to be running better and engine definitely cooler no mor


... 2000 Hyundai Sonata

Camshaft position sensor chrysler pacifica 2005


... Chrysler Pacifica

P0300 code on scanner showing random misfires on my 1996 GMC sierra, 5.7 liter motor, gas line pressure at 55 psi at idle. Replaced fuel pump and filter, MAF sensor, both post O2 sensors, EGR valve, crankshaft position sensor, timing gears and chain. Sometimes switches from P0300 code to P0305. The manifold gasket is showing a leak. Any ideas?


... 1996 GMC Sierra

I have a 1988 Dodge Dakota P/U.It stalls when decelerating or idling,simply cuts off.the check engine light is also on.I have replaced the follwing items on it.the 02 sensor,egr valve,idle speed control,throttle position sensor,plugs and wires and the fuel filter and it still stalls.any suggestions to what it may be?could it possibly be fuel pump or pressure regulator on throttle body or map sensor?


If the map sensor was giving a problem,there would be most likely black,rich exhaust given off,and more problems,the code would be helpful.Check the fuel pump pressure to see what it is,I would guess,if it is the problem,there would be about only 10 ... 1988 Dodge Dakota

Hi, i have a 2.3 l 1990 mustang it failed smog cause of instability. it at 2000 rpm it will raise and fall it wont stabilize. i cleaned the i.a.c throttle position sensor. egr throttle body map sensor. compression hot #1 160 #2 165 #3 150 #4 160 so compression is all good. o2 sensor also is good. so im at a loss has a complete tune up. timing set at 10 btdc help me plz.


Did you check fuel pressure? New fuel filter? Clean Air Filter? Do you have vacuum leaks? Sounds like a vacuum leak because the IAC won't hold the idle steady ,because it is being told not to. Have to find out why. Also how did you do the compressi ... 1989 Ford Mustang

I am at my wits end with this check engine po401 exhaust-gas recirculation and differential pressure. I have replaced the EGR valve and within a couple of miles it came back on. I have a OB2 reader and cleared it but failed the smog test in Ca because it didnt drive through a full cycle. I went to my mechanic and he suggested I replace the EGR selonoid which I did and then cleared the code. Again it came back on. I then read that the culprit could be the DPFE sensor that is part of the EGR famil


Okay...Ready? Remove the EGR valve and clean the throttle passages. They have to be relatively spotless. It's still reliable, just dirty. You're probably not going to believe how much carbon it can hold. All this carbon is restricting the passage ... 2000 Ford Expedition

FAILED DPFE SENSOR (EGR PRESSURE SENSOR ) AND OPENOR SHORTED CIRCUIT CONDITION


... 2002 Ford Explorer

Pops back through the intake when it is cold runs better when warm replaced complete distribitor,cap rotor,plugs,wires,ign coil, ign control module,throttle position sensor,idle air control valve, egr valve,oxygen sensor,fuel pressure regulator kit,fuel injectors,don;t know what else to do 1992 k 1500 chevrolet tbi 5.7 with 5 speed


This problem can be caused by defective spark plug wires that are cross firing due to voltage leaking to a nearby plug wire as well as a flat camshaft lobe. ... 1992 Chevrolet K1500

How do you check an EGR position sensor and a O2 sensor to see if they actually need to be replaced or not? I was advised by one of the experts to check them but was not told how to check them in this 2005 Chrysler 300 with 3.5 Liter engine. Lou


Hi,\015\012\015\012I think you mean a crankshaft or camshaft position sensor.\015\012\015\012Crankshaft position sensor can be checked with an ohmeter, check for these 3 things.\015\0121. 5 Volt supply to terminal 1 whic ... Chrysler 300

12 booster sensor 31 cam comm 41 thrttle valve sol 51 egr position sensor 52 vg conti pressure


... Mitsubishi Passenger

1999 chevy malibu 3.1 rough idle only win car is in park not as bad win its in drive did a full tune up no check engine light on 0 codes has lots of power I just don't it i check for vacun leaks none found at this time ran some fuel injector cleaner no luck still the same fuel pressure is fine map sensor and tbs are all working had all sensor tested cleaned out egr


Clean your iac (idle air control) and then replace ignition plug wires and clean off terminals on coils before putting new wires on, use scotch brite pad or equivelent. could also be intake gaskets leaking, did you notice 1 or more spark pl ... 1999 Chevrolet Malibu

2005 chrysler town country DTC PO406 EGR position sensor circuit to high.Where is sensor located On 3.8 engine


... 2005 Chrysler Town & Country

Por que la 1990 Ford F150 se acelera hasta 1500 rpm Y2000 ya le cambie la egr, throttle position sensor, fuel pressure regulador y varios sensores


... 1990 Ford F150

How to replace crankshaft position sensor on Chrysler Pacifica


... Chrysler Cars & Trucks

Failed egr position sensor,secondary air injection systen fault..


... 2004 Mazda RX-8
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.3477 seconds