Having problems with your 2004 Chrysler Pacifica ?

2004 chrysler pacifica failed egr vacuum solenoid

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2004 Chrysler Pacifica

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2004 chrysler pacifica failed egr vacuum solenoid


... 2004 Chrysler Pacifica

Hi, I have a Mitsubishi Diamante ES2004 love my car. My engine light came on so I took it in for Diagnosis test. The trouble code p0401, which means exhaust gas recirculation flow insufficient detected. Possible Causes: EGR- control vacuum is too low (source vacuum hose is loose) EGR- exhaust tube is clogged or restricted EGR- solenoid valve has sailed] EGR- valve connector is damaged (check pins for damage, and for moisture) EGR- valve does not open (the valve may be damaged or failed) EGR- MA


It doesn't work quit that simplyYou have all the items listed, that you need to befamilar with & know how to testOnly then-- if one of those items fails a test-- do you replace itSo you need a repair shopWay to ... 2004 Mitsubishi Diamante

Hello. I have an 1990 ford e350 with 5.8l o/d I am rebuilding it because its a great van. The engine, transmission, all components and electrical components have been rebuilt or are new. The engine starts perfect and runs smooth and there are no trouble codes or engine light. However, it failed the air test because one of the two readings where off. There is no voltage to the egr vacuum solenoid when the engine is idling and hot. All egr components are new. I would like to know when to test for


Take the sensor off frezz it then ose a om meter to read it if it dont read the sesor is bad as a machanic i've bought sensors new and they be bad to ... Ford E-350

2004 chrysler pacifica egr solenoid circuit failure


... 2004 Chrysler Pacifica

2004 chrysler pacifica failed egr pressure and position sensor


... 2004 Chrysler Pacifica

High nox on smog check low 1400 rpm 2300 nox high sppeed ok 2300 rpm 299 nox hc co o2 good. suspect cts not operating egr vacuum solenoid. when unplu egr solenoid egr works.


... 1989 Jeep Cherokee

EGR Vacuum Solenoid, cavalier 1998 standard 2.2 lts.


I believe it is on the pass side of the head.(EGR) exhaust gas recirculator .it alows the engine to re burn left over fuel in the exhaust.unfortunately the pasage way gets cloged with carbon buildup causing egr failure.this is very hard to clea ... 1998 Chevrolet Cavalier

2001 montero sport looking for egr solenoid vaccuum line diagram. suv code 403 keep coming back. egr solenoid voltage and resistance is good. just need the vacuum lines diagram. please help


Hi,The P0403 code represents a problem with the Exhaust Gas Recirculation Solenoid or circuit.Below is the chart that explains and directs us to where the problem may exist. ... Mitsubishi Montero Sport

Vacuum line missing from egr solenoid. where does this vaccume line connect to from egr solenoid to?


To the intake manifold. ... 1986 GMC Safari

2001 MONTERO SPORT 3.0L CEL IS ON. I OHMS THE EGR SOLENOID AND FOUND 33.4 OHMS. TURN ON IGN AND HAVE 12V GOING TO RED WIRE. WHY CEL KEEP COMING ON. IS THE RESISTANCE ON THIS SOLENOID IS NOT ENOUGH. WHAT IS THE RESISTANCE. CAN YOU SUPPLY ME A VACUUM DIAGRAM HOW EGR WORKS.


Hello! Average reading is 35 ohms...Solenoid is good...With engine at idle... pinch the vacuum line, on the top of the throttle body, with the yellow tracer...Engine should stumble...If not...Remove the intake hose and clean the ports on the top side ... Mitsubishi Montero Sport

Recently failed canadian emissions test- high HC allowable 90 mine was 78, low CO allowable .76 i got .30 and a fail in the NOx allowable was 1116 i scored 1487 these figures from the driving test passed easily on idle test car is a 1991 240 sx with 260 kms dosent burn excessive amount of oil but a little puff of white smoke when i start driving , checked Egr diaphram moves freely by hand , but no noticeable vacuum draw with line disconnected and i didnt find that the Egr moved when i revved t


... 1991 Nissan 240SX

Failing NJ State Inspection for Low Idle emissions. Have replaced, EGR Valve, EGR selonoid, O2 Sensor, Idle Air Control Valve, Spark Plugs, Plug Wires, distributor cap & rotor, all vacuum hoses (currently pulling a steady 20 inches of vacuum at idle and at higher RPM's), oil change. Installed a Sunpro - CP2800 air/fuel mixture gauge indicating toward the higer end of ideal, but not too rich. Completely lost for any other avenues to check for low idle emissions failure? Any suggestions would be g


Based on what your write up says it would have to be a timing issue or Mass Air flow Sensor (MAF) .If your getting 20 HG's at idle steady there can't be a vacuum leak.Your a little on the rich side so its probably a dirty MAF.Try cleaning it first a ... 1995 GMC Sierra

Hyundai sonata 2000 gls. v6. HAs no EGR. Emission test, first try, HC(0) CO (0) nox 1033 mechanic said my engine seems hot (there was also heat out of vents blowing out. I cleaned my maf sensor and put on high octane gas and fuel cleaner drove for a week and retested. ssecond try HC(0) CO (0) nox 1250. failed agian. I changed my mass airflow from anotehr car and change my 3 front spark plugs myself not the three at back. Car seemed to be running better and engine definitely cooler no mor


... 2000 Hyundai Sonata

What controls the vacuum solenoid for the EGR unit on a 1990 mercedes 190e 2.6


... Mercedes-Benz 190-Class

Egr vacuum solenoid


... Infiniti Cars & Trucks

EGR Solenoid creates no vacuum


The EGR solenoid is located towards the rear of the car from the EGR vavle and slightly towards the center. It kind of stands on end. There is a vacuum line coming out the top (port C) and a green 2 wire connector plugged into it. Hope this helps. ... 1996 Nissan Sentra

Why does the fuse keep blowing that is linked with the o2 censors,EGR vacuum regulator,evr solenoid, camshaft position sensor, canister vent solenoid. The com. said it was a short in the canister vent solenoid.


... 1998 Ford Explorer

TROUBLESHOOTING P1402. Failed EGR SOLENOID VALVE, EGR TEMPERATURE SENSOR FAULT, STUCK OPEN EGR VALVE


Replace your egr valve ... 2000 Hyundai Accent

Check engine code P1409, Electronic Vacuum Regulator Control Circuit Malf. What could this mean? I have replaced the EGR Valve, EGR Solenoid, and the other Sensor on the firewall to the right of the EGR Valve(forgot name) Also replaced all 4 O2 Sensors. Any help? THanks, Alec


Clean the egr valve port on intake use piece of clothes rack clean the built up carbon on inside of port. ... 1998 Ford Expedition

1988 GMC 4.3L eng EGR Vacuum Solenoid wiring


... Cars & Trucks

I have a 1995 chevy s10 2wd 2.2ltr and the emissions test fails with 957 ppm low speed test. Thought it might be a egr valve but noticed that the vacuum line going to it might be malfunctioning. Any


... Chevrolet S 10

Egr vacuum solenoid


Exhaust Gas Recirculation (EGR) System Monitor—Differential Pressure Feedback EGR \015\012The Differential Pressure Feedback EGR System Monitor is an on-board strategy designed to test the integrity and flow characteristics of the EGR system. T ... 2001 Ford Escort ZX2

Where is the location of the egr vacuum solenoid on a 2000 vw beetle 2.0 engine


... Volkswagen Cars & Trucks

How to adjust EGR vacuum solenoid so the EGR valve wont get to hot


... 2003 Ford Escape

Why do the hoses on EGR vacuum solenoid come off?


If they tight fit when mated, ck the motor mount, at shift motor moves execively if mount damaged causing seperation! ... 1995 Geo Prizm
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0745 seconds