Having problems with your 2003 Volkswagen Passat ?

2003 Passat idling too low, engine codes P0300, 0303, 0302, 0303, 0304, 0171

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2003 Volkswagen Passat

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2003 Passat idling too low, engine codes P0300, 0303, 0302, 0303, 0304, 0171


... 2003 Volkswagen Passat

1996 toyota corolla engine codes p0300,0301,0302,0303,0304 with ck eng lite on and at times flashing.new plugs/wires/cap and rotor done


... 1996 Toyota Corolla

I have a 2003 Expedition 5.4L Triton. Two days ago, with low gas (38 miles to empty), engine started running rough. Code read P0302, misfire cyl. 2. Since it had 113K miles, I figured its time to change the plugs. Did that, and then got 4 codes. 0300 (random misfire), 0302 (cyl 2), 0304(cyl 4), 0171(running lean, bank 1). Then I changed all the boots and springs, and checked that plugs were all secure. Same thing. Changed PCV valve, air filter, fuel filter, and put Lucas fuel injector tr


Most likely the coils. Easiest way to check is swap them with another cylinder, start it, pull the plug wire connecter and if it doesn't change the engine the coil is bad. If it is the injector, then you can check it with an ohm meter. Touch the lead ... 2003 Ford Expedition

0303 trouble code on my 2006 Nissan Altima. Leaving work I noticed a clicking noise coming from my engine and my service engine soon light come on. I had to make a stop on the way home and when I started my car again the click turned in to a load knock at first and silence down a bit 5 second later. I had a 5 minute drive home where I noticed the low knock got louder when idling at the lights. Once home I got the service engine soon code of 0303, which I looked up and found said it was a misfire


... 2006 Nissan Altima

2003 Volks passat 4 cyl.: I have engine light on and the codes are: misfire cylinders 1,2,3 and 4. It's very strange. The passat was driving great. and now I feel the engine hesitating when it's in idle. when I'm driving i don't feel the hesitating. which part should i replace first? also, i checked the spark plugs and it looks ok. thanks


Hmm then you need to check your high tension leads,, your coil ,, and your engine timing belt.. other than that it has to be an ECU issue.. In most cases replacing the plugs and wires fix this issue.. ... 2003 Volkswagen Passat

2007 Ford F-250, 5.4 Engine-Missing, running very rough at idle-very low idle. Engine codes P0011, P0022, P0171, P0300, P0305, P0307, P0316, P2198.


Hello, There is an extended Warranty for "Cam Phasers". I want to say 7 Years and 90,000 Miles. But some of the repairs are on a case by case basis. Years 2004-2008 were affected.\012\012I will tell you what your Codes mean.p0011 and p0 ... Ford F-250

2000 ford f150 160,000 miles. Had to replace fuel injector #2 cylinder 3 years ago. Recently, started getting rough idle and obvious misfire. Check engine light (cel) code 0302. Put in new plugs, wires and coil pack. CEL off and no misfire or rough idle. How do you know if this soved the problem or an injector is going bad. Too hard for a DIY to change fuel injector. #2 problem. Seat belt giving 27 code. Can't locate problem #3 problem! Odometer comes on and off at will. S


... Ford F-150

I have a 2001 Dodge Ram 1500 5.2L, 197000km/120000miles. The cat was plugged up with no engine power. It occasionally smoked upon ignition. It occasionally smoked out an oily soot from the exhaust. The cat was replaced with a new one. Idled roughly. Engine chugged at lower vehicle and engine speeds. Engine light came on solid. At 120km/hr, 70mph the engine light started flashing, also at high rpms low speed. Engine codes are P0300, P0303, P0306. Oil at air filter, replaced. Plugs were all change


The plenum problem should not affect compression tests. It allows oil to get sucked into the intake and will cause carbon buildup, plug fouling, and pinging. If you have zero compression on a cylinder, it is usually a valve problem. Even a burned pis ... 1999 Dodge Ram

Car had code p0300 and p0303 which i do believe are engine misfire codes according to my code reader i replaced plugs with platinum plugs, new wires and replaced all 3 coils. Now all i get is code p0303. The fireing order is correct. and now i'm at a loss for what i can do now if someone out there can give me any suggestions it would be much appreciated... the car run smooth at an idle but as soon as you start to accelerate it starts to shudder


303 IS CYLINDER #3 WITCH IS REAR BANK IN THE MIDDLE, TRY SWAPPING SPARK PLUG WIRES WITH ANOTHER CYLINDER AND SEE IF YOU GET ANOTHER CODE. MAKE SURE PLUGS ARE GAPPED CORRECTLY. IF IT IS NOT A SPARK PLUG OR WIRE, SUSPECT A BAD INJECTOR. 301-306 IS CYL ... 1999 Chevrolet Malibu

2004 suburban z motor engine light comes on only at idle, code 0171,0174 have rep,rlaced both o2 sensors and mass air flow sensors I am not leaking antifreeze and I cannot get to rev with ether shot o


... 2004 Chevrolet Suburban

My 2001 Corolla displays P0171 after it idles for a minute or two. If I drive it hesitates (especially under hard acceleration) and starts also displaying P0300, P0301, and P0302. If I clear the codes and again allow it to idle for 1-2 minutes it again displayes P0171. Idle is smooth the whole time (at least after it's warmed up). Lastly, it cranks too long when starting, especially when the engine is still cold.


... 2001 Toyota Corolla

The engine ramps up and down both at idle and when driving. I actually lose power and it almost feels like it is running on 3 cylinders, step on gas and it revs up but takes a few seconds to actually respond, you can actually feel when it "kicks in". Engine will stall at coast or at light when stopped and foot on brake, often even in neutral. Service engine light came on and i have codes 0134, 1133,0172, 0171. help?


Sounds like you have a couple of problems. I would start with checking all your vaccum lines with a fine tooth comb. I'd also replace your upstream 02 sensor (the one in the engine compartment, just below the windshield wiper fluid reservoir) senso ... 2004 Chevrolet TrailBlazer

I'm getting code P0300 and i changed my air idle control valve, ignition control coils, had an engine flush done and i'm still getting this code. what's wrong?


Code 300 is usually for multiple misfire. IF you DID NOT get the computer reset/code cleared you will keep getting it ... 2005 Ford Taurus

My Toyota Avalon 02 is experiencing problems with check engine light flashing when idling at a light and then goes solid when driving. The codes read p0300 Thru p0303. The car idles very rough and shakes while stopped at a light. When driving it jerks when accelerating and stops when I take my foot of the gas pedal. When car is cold and I start driving it doesnt seem to want to go when pressing the gas and the rpms don't move either. What's wrong with my car? Had a tune up 5months ago. Spark plu


... Cars & Trucks

My pathfinder 2001 cranks too long before it starts and when it starts sometimes it gives white smoke and the engine shakes,but when i increase the accelerator everything works perfect but the engine shakes at idle running and when i took it for computer scanning/check it gave so many error codes listed here : 1.P0100 2.P1320 3.P0300 4.P0420 5.P0430 6.P1110 7.P1135 8.P0140 Pls what do I do from here?


... 2001 Nissan Pathfinder

1999 Ford Taurus 3.0L V6 24V DOHC Duratec Engine Engine was misfiring, plugs replaced, KAM erased, Idles Slow and Rough. OBDII says misfire ocurring on cyl 4 & 5. Codes P0300, P0304 and P0305


I would check the plug wires and the coils you check the plug wires for bad spots at night start the motor up and look at the plugs if you see a spark arch out the wire and to a peace of metal then the plug wires need to be replace. ... 1999 Ford Taurus

I have a 2004 Spectra. Driving to work this morning, car stalled out twice. Cranked car later in the day and the engine sputtered and idling high to keep from dying. Engine smoothed out, but MIL came on with codes p0449(evap vent valve/solenoid circuit), p0303(cylinder 3 misfire), p0304(cylinder 4 misfire), p0300(random misfire), p1166(no description), p0140(O2 sensor no activity bank 1, sensor 2). Any ideas about a common problem?


Well, it is either a timing belt/chain going out or a bad crank position sensor most likely causing the other problems. The O2 sensor may be bad as well but that usually doesn't cause the Misfire. The vehicle on board computer is confused, that is ... 2004 Kia Spectra

I have a 2003 Saturn Vue w/3.0l engine. Had a coolant leak at the head gaskets. Had the heads checked for straight and cracks. Replaced the timing belt and water pump. Now while running I have a flashing check engine light, codes p0300,0301,0303,0305. replaced the coil, checked the timing marks 3 times, all is ok. Will pop through the intake on accel.


... 2003 Saturn VUE

When my 2001 passat 4motion, is turned on it idles back and forth between 500 and 1000 rpms and sometimes will just die. check engine is on, i had the codes read however the port that they plug into isnt readable for reason. with the idling though what do you think the problem is, and would this be an easy fix?


If you cant read codes ,check first for vacuum leaks.if everything is good try disconnecting the mass air flow meter. ... 2001 Volkswagen Passat

Changed the plugs in a 2.7l sebring (2004) and now getting the check engine light with error code p0300. Engine idle at start up also continues to accelerate.


HalloThere is something wrong with one of the spark plug or you did not put all the cables on the plugs to the end. Or one of cables or ignition coil(s) is damaged. P 0300 = missfire detectedbest regardsMarko ... 2004 Chrysler Sebring

Missing, running very rough at idle-very low idle. Engine codes P0011, P0022, P0171, P0300, P0305, P0307, P0316, P2198.


The P0011 and P0022 are the camshaft sensors (both sides) are over advanced--common problem on Fords, and is usually a defective VCT solenoid (variable cam timing solenoid)-it will cause your other codes (P0300 random misfire), P0305 (#5 cylinder), P ... 2004 Ford F150

Check engine light blinking & rough idle. Have P0300, 301 &302 codes


... Cars & Trucks

Check engine light blinking & rough idle. Have P0300, 301 &302 codes


... Kia Rio

1991 ford f-250 7.5 engine scanner gives code 63 signal voltage too low and code 81. Check engine light comes on while letting off the accelerator and sometimes while idleing. the light will always go off by accelerating. Sometimes while idleing the the the engine will cycle in and out of this condition as if a solinoid were kicking on and off. When the check engine light is on the idle increases to 1200 rpm and there is low bottom end power, sometimes the engine will stall when at low rpm and


... 1991 Ford F250

1999 ford ranger p/u with 4.0 litr engine with engine light on code po171 engine missfire #2 cyl and engine code po174 system too lean code [bank1 and bank 2] ran comp. test on #2 cylinder good comp. replaced plugs and wires [no change]replaced injector [no change] ran cylinder leak down test on cylinder less than 10% leak down. runs good off idle and good acceleration but idles rough. any recommendatoins?


Please re-post if you have further issues.Thank You ... Ford Ranger
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.5660 seconds