Having problems with your 2003 Renault Clio ?

Where is main earth point on 2003 clio

\015 My rh indicator comes on on its own, when i press the brake or put the car into reverse\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2003 Renault Clio

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where is main earth point on 2003 clio


... 2003 Renault Clio

Brake lights flash when i indicate light cluster fittings are all good megane scenic year 99 ,where will i find the main earthing point


The earth is under the trim below the lamp, otherwise It is probably a badly fitted or wrong bulb. ... 2000 Renault 181

1999 Clio headlights work okay on main beam but only one on dim


... 2006 Renault Le Car

Looking for exact location of indicators relay on my 2006 citroen relay van and also earthing points I have found one earthing point just below battery. I know there is 2 fuse boxes in dashboard and a


On this websie (link below) you finde fuse box diagram and description for your Citroen Relay \012 \012 http://www.autogenius.info/en/ci ... Cars & Trucks

Where are the earth points on my 1999 chrysler voyager.Have found one under battery tray.Are earth points just a multi-plug into a square block onside of body? New battery is ok. Sometimes starts with no effort then next time will struggle as if battery is nearly flat.


... 2000 Chrysler Grand Voyager

GOOD MORNING I HAVE A 1996 DIESEL GMC 3500HD P/U. MY PROBLEM IS THE TRUCK HAS DUAL FUEL TANKS AND THE WAY IT IS SETUP THE AUX TANK STARTS TO BE PUMPED INTO THE MAIN TANK ONCE THE MAIN TANK BECOMES HALF FULL. ONCE THE AUX TANK IS EMPTY THE MAIN TANK WILL CONTINUE TO GO EMPTY. THE PROBLEM IS THE MAIN TANK HAS STOPPED GOING EMPTY AND A HALF A TANK OF FUEL REMAINS IN THE TANK. AT THAT POINT THE ENGINE RUNS OUT OFF FUEL. CAN YOU HELP? THANKS JOHN M


... GMC Sierra 3500HD

Rear wiper motor earthing point


You have already solved your problem. Connect the two ground points with good flexible wire and tie it up with plastic ties so that it is out of the way and near a hinge so that there is minimal movement. The original scheme probably relied on conduc ... Ford F

Renault clio 1.2 16v, canister purge valve is clicking when engine is running, when you turn the engine off it keeps on clicking for a few minutes then stops, the engine management light is also on , it says that the fault is the up flow oxygen sensor fault, fitted new sensor still the same,it also said something about a earth fault, I thick there are linked, check out the wiring, I think I have a problem with the earth side with a test light link in to the wring it flashes all the time until th


... Cars & Trucks

My battery light stays on. The windscreen wipers, indicators and brake lights don't work but car runs fine. The alternator and battery comes up pretty much new on the volt metre and my fan belt has loads of wear left on it. Would it be a dirty earth somewhere? If so where are all the earth points on the car? I'm driving a 1997 Peugeot 106 1100cc. Thanks Luke.


The problem with your wipers and brake lights sounds like blown fuses, the battery light indicates low or no charge and will need to be tested for output and that should be 14 volts, if the alternator output voltage is correct there may be a diode s ... Cars & Trucks

I wan't to add fog lights to a VW POLO 6n. I have bought original lamps,grills, an add on wiring loom,correct switch and relay. What I need to know is where I can find the connection point to join the newly acquired add on loom to the main electics. It seems that there should be a femail fitting for a spade type connection somewhere on the main loom.


Ha if fog light were a opation on your car the plug should be there. if not you will have to run new wires. good luck ... Volkswagen Jetta

I have a renault clio 197 cup sport i put a snap on blue point micro scanner on it and it came back with 2 faults p0300 and p0310 egine miss fire and engine miss fire on low feul iwould like to no what these codes are to point me in the right direction to solve the poblem


... Renault Sport

Renault clio clutch biting point very high - 2005 Renault Clio


... 2005 Renault Clio

I have audi A8L 2004 4.2L. The car starts and after 30 sec. main fuel pump relay shuts off and pressure drops to 0 and engine shuts off. I'm auto technician, I checked circuits to main fuel pump relay and signal from ECM to relay is disapering after 30 sec. Car starts fine every time after shut off and every time it shuts off after 30 sec. Tell me what problem could it be or what I should check? Thank you. Sincerely Jerry


Could be an oveheated fuel pump! Extract the pump out from fuel reservoir and test it! ... Audi A8

Im in the process of wiring an air horn to my 2008 dodge caliber se. ive used the existing power feed and earthed the horn via an additional wire to an earth point. the horn works fine whilst the engine isnt running but once started the horn is poor and intermitent. any suggestions


Check your ground and clean it , also check your power source you may have 12v but not enough amps to make it work if you are using the standard horn power trying to run an airhorn motor may not be enough but most likely would be a ground problem ... 2008 Dodge Caliber

To replace the earth on a 1996 lancer the lead goes from battery to the chassis but another lead goes from this earthing point. where does it go


To the engine? ... Mitsubishi Lancer

Earthing fault??? indicators, hazard warning lights, windscreen wipers and drivers side electric window fail to work ; usually after a spell of wet weather I think there may be a loose/corroded common earthing point, if so, where is it?


Could be in the starter circuits or the batterie connectors ... 1986 Renault Sport

No Electricity Car battery is good. Cables are good. Starter will not turn over or click. No lights when you open the door. 0 electricity. Fuses are all good including the battery fuse. Is there a main fuse that controlls everything? I do not have a book for this car so I have no idea if all the fuses are located in the fuse boxes or if there is a main inline fuse somewhere.


Two things I can think of:\015\012\015\0121. The ground strap fromthe engine to the chassis is disconnected, corroded, broken or otherwise not grounding. This would also be true if you had the NEGATIVE battery cable replaced with a "gene ... 1999 Honda Accord

1988 honda civic stalled,code 16,replaced main relay,code now reads 0,car still dont start


... 1988 Honda Civic 2 Door

I need to know the torque settings for bigend bearings, crankshaft main bearings and head bolts on a renault clio 1.5dci 2004. Many thanks


... Renault 181

Renault clio need to connect earth line to spark coil to start


Clio wont start could it be earth strap if so can i put it anywhere else on body to make it easy for me ... Cars & Trucks

How do i turn off the headlights on the E200. I have set the lighting to 0 but the main headlights are still on.


Is it dark when you try this? There should be a sensor in your dash that turns them on in dim lighting. They are almost considered running lights now. Check owners manual for sure. If its wrong consult a dealer. ... 1999 Mercedes-Benz E-Class

Transmission problem 01 Jeep Grand Cherokee limitied. First had code p1762 and replaced the governor pressure sensor and solenoid. Now drives worse shifting in 1st, 2nd, and 3rd mainly shifting from 2nd to 3rd and now has code p1757 saying Governor Pressure Not Equal to Target at 15-20 PSI and Governor Pressure Above 3 PSI In Gear With 0 MPH. Tried disconnecting the battery to reset computuer and still is doing the same thing. Any Solutions.


I had a shifting problem. The car would start in the wrong gear and shift at wrong times. I repaced the governor postion sensor and tranny fluid and the problem has been fixed for several years. Did you replace the tranny fluid? ... 2001 Jeep Grand Cherokee

1990 LEXUS LS400 T-SHIRT GOT CAUGHT BETWEEN TIMING BELT AND CAMSHAFT GEAR(DONT ASK I STILL CANT GET OVER IT)ANYHOW i GOT THE SHIRT OUT BUT WHEN I GO AND PUT THE CRANK AT 0 AND THE ROTOR POINTING AT THE #1 PLUG THE CAMGEARS ARE NOT LINING UP WITH THE MARKS.COULD I SET IT AT TDC AND TAKE THE CAMGEARS OFF AND RESET THEM? IM STUMPED...


Take the timing belt off reset the crank at 0 with # 1 piston at TDC ensure that both cams are up at twelve 'oclock with belt on, when the tension is released and the tensioner is tightened turn the crank atleast 360 degrees and ensure that the timin ... 1990 Lexus LS 400

For the valve adjustment, should it be at "0" or at the timing mark or at the rotor pointing directly at the terminal (I know the last two should be the same)


THE ROTOR, THE TIMING MARK CAN BE 180 DEGREES OUT. ... 1995 Toyota Pickup

The car starts no problem, but then hesitates after severaL MINUTES AND CAR STOPS. MY DAUGHTER HAS ALREADY BEEN DRIVING FOR APPROX 15 MINUTES AND IT JUST SLOWED DOWN TO THE POINT OF STOPPING IN TRAFFIC ON A HIGHWAY IT DOES NOT DO IT EVERYTIME BUT THERE ARE TIMES IT WILL DO IT SEVERAL TIMES A DAY, MY MAIN CONCERN IS SHE PILLS INTO TRAFFIC AND IT HAPPENS, VERY DANGEROUS SITUATION. 2002 CIVIC EX,53,000 MILES


Hondas have an issue with the main relay. Apparently it is a device that is sensitive to temperature. If you check out the other posters for Civic and Accord, you will see quite a few others with similar problems. On the website ... 1997 Honda Civic
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.3925 seconds