Having problems with your 2003 Renault 181 ?

Hi I have a 2002 renault laguna 1.6 and the heater will not work on position 1,2,3 on the dial but will work on position 4, can anyone help me with this problem? Carol.

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Change switch panell assy.... should sort it
Repair Help & Product Troubleshooting for 2003 Renault 181

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi I have a 2002 renault laguna 1.6 and the heater will not work on position 1,2,3 on the dial but will work on position 4, can anyone help me with this problem? Carol.


Change switch panell assy.... should sort it ... 2003 Renault 181

1994 BUICK SKYLARK- MY TURN SIGNALS ARENT WORKING, AND NOW ALL OF A SUDDEN MY LEFT TURN SIGNAL IS FROZEN IN THE ON POSITION....WE ALSO PURCHASED AND ELECTRICAL FLASHER THINKING THAT MIGHT HELP THE TURN SIGNAL PROBLEM....I DONT WANT TO TAKE THESE PARTS TO CAR REPAIR SHOP, THEY WILL GIVE ME A NEW ONE, IF YOU KNOW WHAT I MEAN, I AM WORKING ON BREAST CANCER 2ND TIME AGAIN IN 10 YEARS, SO MY FINANCES ARE VERY LIMITED, CAN ANYONE PLEASE...PLEASE..HELP ME? GOD BLESS! THANKS ERIN


If the turn signal is stuck in the position,then the turn signal switch is bad,now if the turn signal just stays on,and does not blink,and the turn signal lever returns to the neutral position,then it is a bulb that is bad on that side on the car,,fr ... 1994 Buick Skylark

Astra (R-Reg) heater problems...rnHello people, wonder if anyone has a similar problem or is able to help me out with this one?? I have an Astra R-Reg and the heater fan only works from position 3 & 4 and takes forever to warm the car!!! Is there any solution for this and if so how can I remove or replace the needed parts. Thanks in advance for you help Ze


... 2009 Bugatti Veyron 16.4

1996 landrover discovery, works with no problem but when swith on the ac after five minutes the tempreture guage start rising to the red and have to swith off ac, then the needle drops back to normal position. Anyone can help to identify this problem Cheers


Separate electric fans are used for the A/C Check the fans ... 1998 Land Rover Discovery

My MR2 Spider 2002 has a problem with Clutch cable which is in Clutch release Cylinder of the actuator, it is not working 100% which is not making a full Clutch activation, whenever I put the gear in S position the car RPM slow Down little bit and the car engine goes down when I release the stop petal, so far I fill a kick. Can anyone help me with this problem?


... 2002 Toyota MR2 Spyder

2000 buick century headlight problem...we have a century and cant get the low beams to turn on period....the high beams come on just fine and the parking lights come on fine also....everything worked fine then suddenly no low beam headlights ..turn signals work..ect...can anyone that can help me find the answer to this problem ? your help would be appreciated, it's my girlfreinds car and she need's to drive at night..as of now..she cant. please reply s.a.p. if you know what the issue is. than


... 2000 Buick Century

I am having problems with my 2003 Honda Civic windshield wipers. There are 3 speeds..... intermittient, regular and fast. Fast, and regular speeds work well but the intermittent speed is working as the regular speed. The other problem is that when I turn them off the stop anywhere on the windshield except for the position where they should be stopping... out of my view! WHAT do I need to buy ?..... The motor (which I can't imagine), a relay, a switch or is it an electrical problem? Please help!!


... Honda Civic

Please help! I have a 1993 Celica and my brake lights don't work. It's not a fuse problem and we tried a new brake switch that didn't work either. It's also not the bulbs b/c they were replaced as well. The problem started with a trailer connection (fior a UHaul) the previous owner installed that shorted out my tail lights, blinkers and brake lights. The tail lights and blinkers are working again. If anyone has any suggestions (aside from taking it to the dealer b/c that is way out of my budget


Sounds like the wire for your brakelights is broken.Probably close to the trailer connection.Use a testlight and trace it down. ... 1993 Toyota Celica

This is for anyone asking for help. Please tell everything you know. Make, Exact Model, engine size, trans, 2wd, 4wd, 4 door, ect. explain the precise problem you are having, not what you think needs replacing. When do you have the problem?, hot, cold, turning, backing, what speed? is this a sudden problem? has anyone worked on this before? If so what did they replace? why? you cant tell me too much info. or history. I dont have a crystal ball, dont ask for a wiring diagram, or how to change wha


I agree!!!!!! ... 2004 Acura 3.2CL

I had to jump start my 2005 montana SV6. Since then i have had problems with the fan dial,the heat dial wont turn to hot or warm it turns but nothing happens. And the dial that changes the direction of air flow doesn't work.The fan switch stops working when you have to jump start but seems to work again the next day or so.the heat in back is just fine but i cant get the heat to run out roof vents.I have looked at all the fuses 100 times please help me this is our only vehicle that fits my famil


You need to sure that the thermostat settings are set the same on the control \015\012panel for front and rear units. If this its good, them its possible that there pluged heater core in rear or blocked heater hose. Keep in mind th ... 2005 Pontiac Montana SV6

I have a 2000 Cadillac DeVille with a transmission problem. The transmission was working one minute and then stopped. I checked the linkage and it is fine, the fuses are ok and the fluid level is fine. I think it may be electrical as the indicator line that moves to show the position of the gearshift does not indicate any position other than Park. Reverse and drive positions act like they are neutral, Park does lock and keeps the car from rolling. Any help in regard to this problem would be app


... 2000 Cadillac DeVille

Can anyone help. ive got a hilti dx450 that won't fire, ive stripped it down and given it a good clean but still no luck getting it to work. could anyone tell me if there should be some sort of firing pin that should strike the percusssion caps, if so maybe thats the problem but can't seem to see were it should be. any help would be appreciated.


... Cars & Trucks

I have a serious problem which i hope someone can help me with. My 2000 x5 4.4 i bmw battery went dead last night, the problem is i can't open the door manually due to lock not working, also since battery is dead, can't use the key remote. I saw someone hook up a power pack under their x5 bmw by passenger side which then open all the doors. If anyone knows the exact location where i can hook up the power pack beneath the x5 so i can get into my bmw. Your help will be greatly appreciated. Thank y


... 2000 BMW 5 Series

My 98 grand voyager highbeam indicator lamp stays on all the time, both high and low beam headlamps are working ok. also depending which position the dimmer switch is in, the headlights are flashing off and on with the headlight switch in the off position, also the odometer readout flashes off and on also. Need help solving this problem. When all this is flashing, the headlight relays are clicking on and off. HELP Jack


... 1998 Plymouth Grand Voyager

2002 Saturn vue 3.0 AWD over heating problem because. Low fan does not turns on automatically as it is supposed to. The Fan work also the temperature gauge also works.. The problem is that the low fan does not turns on. Anyone help please.


... Cars & Trucks

I have just replaced the heater core in my 1985 Chevy Scotsdale full size 4-wheel drive truck. My problem now is that the blower moter is not working. Can anyone help with troubleshooting this problem. I am pretty sure the blower was working prior to the heater core replacement. I checked the fuse (as noted in my Haynes manual) and it is good.


Since you have the manual, I recommend you check the parts that are easy to check. For example, can you get to the resistor? The resistor is in the middle between the motor and the control panel. If you have a multimeter, you can probably diagnose ... 1985 Chevrolet K1500

My Ford Ranger 3L TDCI 2007 model suddenly cut out on the way back from work yesterday , checked the fuel etc all ok ,then check fuse box under the bonnet and found that one fuse had worked its way out . I replaced with a new fuse and the vehicle started 1 st turn with no problems. I left the vehicle idylling and went to wash up when I returned in a few min the vehicle cut out again , no stutter or warning . Coul anyone help me with this problem or advise me where I should start to look. Thank y


... Cars & Trucks

Wiper problems I had problem with run of my wipers so I bought new wiper relay 911.615.112.00 and 911.615.111.00 . Unfortunately my wipers doesn't work correct still. If the wipers relay are switch on I'm not able to stop wipers in any position of wiper switch. Additional when I switch on the wipers switch in to first position they are going like crazy. I thought that exchanging wiper relays it will help but it's not. If I disconnect all wipers relay then slow and fast run is OK bu


... Cars & Trucks

Check engine light came on, fault is for the Cam shaft position sensor. I changed the sensor. Didn't work. I changed the whole synchronizer assembly. Didn’t work. I checked the wiring, all good continuity (I didn’t use a break out box, just followed wires). I have read about possible problems with the computer or even the timing chain. Has anyone heard of a similar problem and what were some of the solutions? Thanks,


OK, on a 1998 Ford Taurus have a service engine soon light. Scanning it said the Camshaft Sensor circuit was bad. So I replaced the camshaft sensor. Cleared the code and it came back.In the winter time it comes, and in the summer time it ... 1997 Ford Thunderbird LX

1997 chevrolet 1500. Fuel pump is working with good pressure, it have spark and the fuel injectors are working. The problem is engine will crank but it won't start; but if you introduce starting fluid throw the intake the engine will start and it won't turn off until you close the ignition switch (in other words you can drive all day the problem is to start). I change fuel pump, crankshaft position sensor, air flow meter, fuel pressure regulator and all intake gaskets. PLEASE HELP


... 1997 Chevrolet C1500

I need a wiring diagram for a 1983 Dodge power ram 150 4x4. Can anyone help? Motor would crank and run only when the starter is engaged as soon as the key is switched back to the run position from start it looses power and cuts off. Some butcher has been under the dash and hood cutting and splicing, so I figure the best thing is to trace the wires and from one end to the other and fix the butcher's damage. Can anyone help or tell me where I can get a free diagram to solve this problem ? Thank yo


Its your balist resistor you will find it on the firewall,its useally made of white porcelin and has a 2 wire feed ... 1983 Dodge Pickup

I have a problem on my Kenworth 06,dashboard doesn't work when I just start the engine, all lights and gauges won't work.but after running truck for 30 minutes all come to works fine if anyone has an idea of what could be the solution this problem I will appreciated some help.


... Cars & Trucks

I have a 1998 Ford F 150 4.6 , 2 wd with 160,000 miles. I have a problem with no warm air circulating through the cab. I replaced the heater core, thermostat, made sure the blend door was working properly, proper amount of antifreeze and I am still having the same problem with no warm air.... can anyone help me with this problem that may have had the same problem or have any suggestions ??


In a Ford 90's and up this is caused in most every case by a defective air temperature control blend door and the electric actuator that moves the door, the blend door is located deep in the dash between the heater core and the AC core, it mixes or b ... Cars & Trucks

I just recently bought a 2000 Dodge Grand Caravan and the lowlights on it are not working. The high beam lights work, but the lowlights will not come on. I checked the fuses, as well as the relay, and they do not seem to be the problem. We also did the obvious and replaced the bulb. It still does not work. Does anyone have any other possible reasons as to why the low lights do not work? Could it be a faulty switch on my panel? Please Help!!


Yes the swith is the next solution. If you want to be sure,check all the powers & grounds for continuity.Long process & need a wiring diagram to do it. ... 2000 Dodge Grand Caravan

The Climate control dial does not work it seems. The dial to change temp is fine and so is the fan speed dial. But the dial for location doesn't. How do I solve this problem in a cost effective way? Thank you very much for your help. Have a nice day!


Hi, the heater mode is vacuum controlled. With the engine running, listen to the contol panel for a vacuum leak. If no leak there, check the engine compartment. There is a small diameter plastic line that runs from the engine intake manifold throu ... 2005 Ford Explorer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.6669 seconds