Having problems with your 2003 Mazda Mazda6 ?

Driving light how do you replace the driving light in the headlight assembly in the 2003 mazda 6

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

If it's the same as my 2006 there is a seperate bulb in the upper inside corner of the high beam section of the light assembly. From behind..you twist and pull it out. Be careful not to touch the blub as this will greatly shorten the life if the bulb. (oils and dirt from your hands make it heat up alot hotter than normally)
Repair Help & Product Troubleshooting for 2003 Mazda Mazda6

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Driving light how do you replace the driving light in the headlight assembly in the 2003 mazda 6


If it's the same as my 2006 there is a seperate bulb in the upper inside corner of the high beam section of the light assembly. From behind..you twist and pull it out. Be careful not to touch the blub as this will greatly shorten the life if the bulb ... 2003 Mazda Mazda6

How do you remove the headlight assembly on a 05 Pontiac G6 GT to replace headlight bulb? When unlocking car, the bulb works, but when starting or putting car in drive light goes off. Is the bulb the problem or is it something different causing problem?


How do I replace the headlight socket on a 2008 Pontiac G6 GT 4 door sedan ... 2005 Pontiac G6

My driving lights don't work. Meaning when the light switch is in the driving light position neither the front driving lights come on nor the rear. When turning the light switch to the full on position the headlights work but not the tailights. I have replaced the dashboard light switch ($54.00) and I have checked the fuse for the appropriate lights (driving). I noticed that in the fuse location there is no juice to either side of the fuse receptacle. Awhile ago I replaced the brake pedal swi


... 1994 Lincoln Continental

The amber lights on my car will not turn off even when the headlights and car are both off. I saw the lights were on when i left work today. I thought I must have left the parking lights on but that was'nt the case. When I turned my lights on to drive home, I noticed my right headlight was out. When I removed the light to replace it, I saw that it was cracked. I replaced the headlight and they are working fine. However I can not get the amber lights to go off. Also when i turn my hazards on only


A faulty headlamp switch ... 1996 Ford Taurus

I have a 2000 Camaro. My problem is front turn signal/fog light related. First...my fog lights don't come on at all. No biggie but mentioning it due to my second part. With my headlights manually on everything works fine up front. Drive without the headlights on and my parking light/turn signal bulb lights up. Both filaments. The heat from the turn signal filament being constantly on melted the plastic assembly. I have changed them but don't want to always have my headlights on to drive


You can replace the parking light/turn signal bulb with LED lights. The LED draw next to nothing in AMPS and produce no heat at all and last for ever. You can pick up the replacement LED lights for your Camaro at most Auto Parts store like Auto Zone ... 2000 Chevrolet Impala

I have a 1991 Volvo 240s recently I had to replace the circuit board on the left side taillight assembly because the connecting parts for the turn signal were worn out. Upon doing so the turn signal and one of the brake lights worked however the rest of the lights in the assembly stopped. I replaced the fuse and checked all the bulbs so I am really at loss for what to do because the lights on the other side and the headlights do work. What is wrong with the lights on the left side, and how can I


This is most likely caused by a poor ground.\012If you have a multimeter, measure resistance between each socket shell to a clean ground elsewhere; you might have the best luck on hardware inside the trunk on an older car.\012\012If you don't h ... 1991 Volvo 240

Check engine light was on and car running hot when idling and sometimes while driving. Had fuse replaced did not fix problem, then had fan assembly replaced. Check engine light came on again, running hot while idling. When car heats up right fan goes off but will come back on when turn A/C on but A/C not cool when idling. I have two mechanics telling me fan assembly needs replacing again (its just been 3-4 months) and another shop telling me its a computer/circuit problem. What do I do, I really


If the fan goes on with the a/c then the fans relay is bad ... 2003 Chevrolet Impala

My 1999 mazda b2500 headlight actually melted replaced headlight,replaced light switches cut lights on low beam would only work if light switch was on and placed on high beam . help please


... 1999 Chevrolet S-10 Pickup

I have brake light issues. I got pulled over because only the middle brake light worked. I pulled the assemblies and noticed some pretty charred looking sockets so i replaced those. Now I have perfect lighting when headlights are off, but as soon as the headlights come on the lights go haywire. They all work except the drivers side brake light. but if i turn it onto auto lights the driverside tailights dont work at all. I dont think its a ground or wire because they all work at one time.


Multi function contol switch is shot, ... 2000 Jeep Grand Cherokee

I have a 2007 Mazda CX-7. It has been driving just fine (after a timing chain replacement and a turbo replacement in. The last 7 months. Last night (Friday) my check engine light came on. The guy at autozone says it is camshaft sensor. There is no place to get it replaced over the weekend. I ned to drive about 45 minutes away and back this weekend. Is it ok to drive??


Here's what it says Heather,The crankshaft position sensor identifies position of the crankshaft to the ignition control module (ICM), engine control module (ECM) or powertrain control module (PCM) ... 2007 Mazda CX-7 Grand Touring

My tial lights don't work when I turn the headlights on. I have replaced the cuircuit boards for both tail light assemblies and I have replaced all the bulbs. The fuses are good. I am being told I need to replace the tail light relay, but I don't know where it is or if this will fix the problem.


I think whoever told ther was a relay would tell you wher it was if he really knew.i dont htink so. the relay box is under the hood on the fender. you should get at least a test light.or better a volt ohm meter they are not very expensive and follow ... 1999 Chevrolet K1500

I have 98 eddie bauer ford explorer with headlight problems. Headlights work when first starting up and then about ten minutes into drive the dash lights flicker and then headlights go out. If i pull the highbeam back the lights stay on. Another ten minutes the lights start working correctly. Already replaced the multifunction switch on the column.


The headlamp switch will cause the lamps to turn off. The switch heats up and turns the headlamps off. It will cool down and work for about 10 minutes and cut out, ... 1998 Ford Explorer

I was driving and for no reason the headlights stopped working working on my 2000 ford focus wagon. The parking lights light up, rear lights light up but head lights don't. Checked all the fuses, Ok. Replaced the headlight bulbs and still have the same problem.


PROBLEM COULD BE FAULTY DRL MODULE OR FAULTY DIMMER SWITCH. ... Ford Focus

Headlight assembly The headlights on my '95 Eclipse are in need of replacement. I have replacement headlights but have ran into a snag with a single bolt that holds the light in place. I am able to remove all bolts with the exception of the lower most bolt that seats under the headlight. The area is very difficult to get to. Is there an easy or routine way to get to the bolt for removal and intallation. Any advise would be helpful. I am unable to get any direction from a HANES manual and have no


A swivel for the socket may be necessary, sometimes it may take more than one swivel. ... 1995 Mitsubishi Eclipse

I have a 2004 cavalier with 92,000 miles, new to me 7/31/09. around 12/9/09 the service light came on, but only when my headlights are on. noticed the headlights dimmed for a split second before the service light came on. had it checked at o'reilly they said bad battery. replaced battery, no joy. now my ABS light comes on too. when it does i have no ABS but that's fine, i know how to drive in MN in winter. but on christmas both lights were on, as were my high beams. when i switched back to low b


Before you do anything I would check the Ignition Switch. But there should be codes in memory for the ABS and the Service Eng Soon light. ... 2004 Chevrolet Cavalier

1984 aprice classic, Headlights, Tail lights, Interior lights not working (shut off while I was driving) Brake lights, blinkers still working... I checked fuses and replaced headlight switch... Still not working...


Maybe power got cut going to the headlight switch. I think that would be a fusible link coming right off the battery source and going to the switch. Fusible links were used as power distributors before the era of maxi-fuses and power distribution bo ... 1994 Chevrolet Caprice Classic

I have been having some problems with my headlights not running properly. The automatic headlights don't go on automatically anymore and now when I try to turn on the lights manually that doesn't always work either. I have to hold down the bright switch to keep the lights on as I'm driving. As soon as I let go of the brights the lights go off again. Can you tell me what needs replaced?


There is a relay under the hood in the fuse/relay panel called drl, or daytime running lamps, that relay is most likely bad, a good way to tell is switch it with the high beam relay, if they come on you know thats it, if they dont, its the relay for ... 1999 Buick Century

When I left work today, my headlights were working fine. About five minutes before I got home neither headlight was working. All of the rest of my lights are working fine including my hi beams. I just replaced my headlights and they are still not working. I drive a 2005 Honda CRV, what might be the problem? I really need help as I am suppose to make a long drive in 2 days.


Heres a few basic things to take into consideration on the 2005 CR-V. Each headlight uses a separate relay so that cannot be the cause.Each headlight uses a separate ground so that cannot be the cause.Each headlight uses a separate ... 2009 Honda CR-V

One of my driving lights went out after hitting a bump on a dirt road, how do I replace the bulb? It's not the headlight, it's the driving light or fog light.


One of my driving lights went out after hitting a bump on a dirt road, how do I replace the bulb? It's not the headlight, it's the driving light or fog light. ... 2005 Volkswagen Touareg

I would like to replace the headlight assembly of a 2008 Silverado. I've located 3 bolts and removed them but am unable to remove assembly. Is it possible to replace the head light assembly without removing other parts?


There is a little aluminum stick in the assembly holding it in. On the top of the headlight twist the stick and remove it. It will look like a tent stake. Remove this stick and then the head light assembly will almost fall out. ... 2007 Chevrolet Silverado 2500HD

Mazda protege 2000 , it has check engine light on ... when i replace spark plug , valve gasket, intake manifold gasket . the check engine light was gone and car runs good .. however after 5 days of driving about 200 miles ... check engine light come back and it has a lost of power as i drive ... what do you think is the problem ...


... 2000 Mazda Protege

Headlight replacement. My exsisting headlight has a major crack and there is glass floating around in there. Headlamps only last for a few days. I was told by my mechanic to buy a used Headlight and replace it myself. Since then, I've had about four people look at this darn thing. No one can figure out how to get the exsisting light off. The screws look pretty nasty too - seized and damaged. It looks like the grill may also have to come off to access some of the assembly (a major project for us


You should get a tech to do it because it should be aligned after its installed ... 1997 Volkswagen Golf

2004 Chevy Classic / How to replace head light bulb? Using my Chiltons repair manual it says to remove 2 screws on the headlight assembly and pull the assembly out the front. I removed screws but doesn't release the light assembly. What now ?


... 2004 Chevrolet Malibu

I have a 85 blazer k5 and all my lights dont work, but i do have brake lights and i do have turning lights but no headlights or night time driving lights i replaced the light switch, what can i do to


... Chevrolet Blazer

Driver side HID light did not work all othter lights worked. Tried replaceing bulb still di not work. Replaced 2007 cadillac escalade driver side entire headlight assembly and checked fuses. Still do


... 2007 Cadillac Escalade Ext
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.8281 seconds