Having problems with your 2003 Kia Sedona ?

Need to replace front wheel bearings 03 kia sedona

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2003 Kia Sedona

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need to replace front wheel bearings 03 kia sedona


... 2003 Kia Sedona

Replace wheel bearing on driver side front of 2003 kia sedona


... 2003 Kia Sedona

Wheel bearing replacement left front wheel Hello Everyone, I may need to replace the wheel bearing on my right front wheel of my Corolla wagon. How can I know for sure? And how can I find out how to do it? Wheel bearing replacement is not even mentioned in my Toyota Corolla 1996 Haynes Repair Manual.


Diagnosing the bearings can be tricky depending on severity of wear. Typically - drone noise at highway speeds, squeeling, clicking or grinding noises at low speeds that reduce during braking, or pull off the wheel and brake assembly and check the be ... 1996 Toyota Corolla

2003 kia sedona. what size is the nut on the front wheel bearing and is there just one bearing on each side or 2? Do I need a special socket to remove the nut?


The size of socket ur looking for is 32mm & as for bearing i'm sure that its a complete bearing. ... 2003 Kia Sedona

2004 Kias Sedona. I have the replaced the Front Wheel Bearing (Passenger Side) 4 Times in the last 6 months. The last one lasted 2 Days. It was sluggish going uphill, jerking, and then there was a loud "Pop". Immediately, Right Wheel started roaring again and has greatly increased since. What could be causing this problem?


Replace the hub sounds like you have a bad hub, thats why the wheel bearing keep going bad ... 2004 Kia Sedona

Need instruction manual/schematics for replacing 2005 kia rio driver side rear wheel bearing. i've got the wheel/hub/bearing off, not the inside ring to the bearing. i need to know how to replace it .


Clean all the grease if there is any out of the hub, turn the hub over and using a drift and hammer strike the shell from the back edge working around the shell as you go, should not take too much to remove it but you will need a bit more than a tap ... 2003 Kia Rio

How to replace front wheel bearing on 2003 kia sedona


... Cars & Trucks

Front wheel bearing replacement - 2003 Kia Sedona


... 2003 Kia Sedona

I recently had the front left wheel bearing replaced cause it seized up.a month later i started hearing the same noise before it siezed..the mechanic said the front end was sloppy and needed to be replaced.so he replaced the tie rods and two differnt arm assemblys.kept hearing the sound so he warrantyd the first wheel bearing,put in another,and it still is making a metal on metal grinding sound.his next opinion is it could be the axle.i am not sure.i am gonna take it to another mechanic and see


Hi, The one thing that causes repeated failure of the front bearings is being over tightened when they install them. A great number of mechanics try and rush and uses air tools to tighten axles nuts down. This usually over t ... Chevrolet Silverado 1500

Want to replace front wheel bearing on 2002 kia sedona


If you have access to a fly press or press of some kind then tackle this. you might ruin your new bearing trying to force it in by other means .\012I am not trying to put you off. Just advice ... 2002 Kia Sedona

I need to replace the front wheel bearings. Are these off and on? I have a 98 zx2. i am getting an odd sound from the passenger side front wheel. Brakes and tires are fine. Are these bearings difficult for the home mechanic to replace?


These bearing's are press in, you will need to remove the spindle to remove bearing also you will need a press to press out the old bearing and press the new one in.Hope this was very helpful, good luck ... 2001 Ford Escort ZX2

Ford festiva front wheel bearing worn out needs replacing can you provide me with manual to help me replace the front wheel bearing


I do have the manual and there are several on eBay all the time for Festivas, because I check there often for Festiva parts. They are often sold for about $20-$25 for the complete manual. You might want to try that. I have the manuals for Festiva, bu ... 1993 Ford Festiva

How to replace front wheel bearing on 2003 kia sedona


Disassembly\012\012\012\0121.\012\012Remove oil seal from front wheel \012hub.\012\012\012\0122.\012\012Remove front wheel hub assembly with suitable \012tool.\012 ... 2003 Kia Sedona

Replace bearings replacing front wheel bearings need to find a diagram of front end for a 90 toyota pickup 4 wheel drive v6


Try these websites www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get y ... 1990 Toyota Pickup

2003 kia sedona ex front wheel bearing replacement


... 2003 Kia Sedona

How do I replace a front wheel bearing hub assembl in a 2007 toyota tacoma 4 wheel drive?Does the bearing need pressed onto hub and what size socket needed to remove hub?any thing else I might need to know to do this job myself


... 2007 Toyota Tacoma

How can you tell if the front hub assembley needs changed. There is a loud noise that gets louder as you pick up speed. I was told it was the front wheel bearing but there is no wheel bearing just the front hub for replacment parts.


There is a wheel bearing inside the hub as well. They will sell those bearings I've bought them before. Chances are you need to talk to a better parts guy. You can tell if it's a wheel bearing by taking the vehicle up to a speed where the noise is ... 2004 Chevrolet TrailBlazer

How to replace front wheel bearings on 2003 kia spectra


... 2003 Kia Spectra

I need to change the rear wheel bearing assemblies on my 2003 Lincoln Aviator. I have replaced the front already and would like to know if the procedure for the rear is different since the rear wheel bearing assemblies differ from the front. Please help since Chilton Manuals for this vehicle do not exisit.


Yes, the rear is much different...you can get good help on the ford forums, you can downld help guides online at autozone.com ...join up to access their repair guides...its fee and safe...there are other auto pts houses that offer this service.... ... Lincoln Aviator

I need to fix a rear wheel bearing problem on a 2004 lincoln ls. I also have to replace one of the lugs that broke at a tire shop. What parts do I need to buy exactly? Where can I get them from? How do I do the job? And is there a diagram of the area to be worked on. I've done wheel bearings on older other cars and on the front of this car.


You will need a hydraulic press to remove the old bearing and install the new one . also there are adjustable plates for extracting the bearing whick are press fit. not a job for at home ... 2004 Lincoln LS

Need to replace front wheel bearing on my 06 I-280. Is it just a bearing or do I have to replace the whole wheel hub?


Should be hub bearing all new cars have it.remove big nut 32 or 34 mm,deep socket . ... 2006 Isuzu i-280

I am replacing the brake pads on my Kia 2007 Sedona; front and back is neeeded or just front? Took it to Kia dealer and mechanic showed me pads where very thin and needed replacement; all for $400! Heck no. I'll do it myself ??? what brand do you recommend? ceramic is good?


It is hard to tell until inspect front and rear. I would buy front and rear parts to get parts in hand ready. Usually, when change the pad, the rotor (brake disc) needs to be resurfaced, if you see the concentric lines. I used to buy rotors and chang ... 2007 Kia Sedona LX Minivan

I need to replace front wheel bearings and puchased the front hub assembly now i need directions on how to replace the hub assembly


Hi! theres no torque ratio needed in putting the hub. Just as long as the nut of the hub is tightened and the lock pin can be inserted I beieve you're good to go. Some don't have lock holes but instead the nut has a lock that needs to fit the curve o ... 1997 Chevrolet Cavalier

My grand prix passenger said front and rear end was repaired from an accident, now I am having problems with the hub assembly which was not replaced by the repair shop. there is a geat amount of play in the right wheel and they sasid the left wheel is the hub needs to be replaced, howwever this has nothing to do with the accident. the impact on the car caused them to replace wheel, inner and outer tie rods etc. Damage to the bearings of hub would have been damaged


How many miles are on the vehicle? I would change out both of them, and would have changed them out if they were changing out everything else anyways.Thank you,Lee ... 2002 Pontiac Grand Prix

2005 KIA SEDONA WHEEL BEARING REPLACEMENT


... 2005 Kia Sedona
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.6651 seconds