Having problems with your 2003 Ford Focus ?

How do I change the front wheel bearing on 2003 ford focus zx3

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Remove the spindle, remove the hub from bearing, remove lock ring, press old bearing out, press new one in, if old hub is reusable, press into bearing, reinstall spindle.
Repair Help & Product Troubleshooting for 2003 Ford Focus

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I change the front wheel bearing on 2003 ford focus zx3


Remove the spindle, remove the hub from bearing, remove lock ring, press old bearing out, press new one in, if old hub is reusable, press into bearing, reinstall spindle. ... 2003 Ford Focus

Wheel bearing do I need a press to change a front wheel bearing on a 2003 ford focus


A puller should do it. If you sign up at (autozone.com) for free, you'll get access to manuals & pictures in suspension category. ... 2003 Ford Focus

Changing front wheel bearing 2000 ford focus - Focus Ford Cars & Trucks


... Ford Focus

When should front wheel bearings be changed 2008 ford focus


... Cars & Trucks

How to change front wheel bearing ford focus


You can do it yourself just take your time:\015\012To change front wheel bearing.\015\0121. Jack car up support with jack stands\015\0122. take tire off\015\0123. take caliper and brakes off\015\0124. take rotor off ... 2004 Ford Focus

How to change front wheel bearings on 2002 ford focus zx5


These are pressed in wheel bearing assemblies. axles need to be removed out of the spindle and either a special tool to do it on the car needs to be used or the entire spindle removed and carefully pressed in and out. if you so choose to take this ve ... 2000 Ford Focus

How do i change front wheel bearing on a ford focus st2


SECTION 204-01: Front Suspension\015\012\015\0122000 Focus Workshop Manual\015\012\015\012\015\012REMOVAL AND INSTALLATION\015\012\015\012Procedure revision date: 03/18/2003\015\012\015\012\015\012Wheel Bearing\015\012\015\012\015\012Special To ... 2000 Ford Focus

I have a 2001 Ford Focus wagon and when I step on the brake the front end shakes. This has been happening since I had the bearing changed in the back right wheel. If I tap on the brake a couple of times, then they seem to be fine. Any ideas.


Sounds like you need a brake job. I would replace the front pads and front rotors and that should take care of the problem. ... 2001 Ford Focus

Ford focus 2005 change rear wheel bearing. have to change the hub?


... Ford Focus

Ford focus front wheel bearing noise - 2003 Ford Focus


... 2003 Ford Focus

2001 ford focus front wheel bearing torque - 2001 Ford Focus


... 2001 Ford Focus

I have a roaring noise from back of 2001 Ford F150 supercrew I think it might be wheel bearings I have already replaced front wheel bearings but not sure how to change the rear ones any suggestions


That's one that I don't see listed on my online resource. Maybe try alldata.com for more information, but that will cost. ... 2001 Ford F150 Styleside SuperCrew

Front wheel bearing ford focus - 2005 Ford Focus


... 2005 Ford Focus

Fixing a 2003 ford focus front wheel bearings


Remove the hub and spinle ,tie rod end ,axle nut.ball joint,and seperate from strut and then have new bearing pressed in...or rent a bearing press that works with an impact wrench,but they are a little hard to work with...good luck...lee ... 2003 Ford Focus

CHANGE WHEEL FRONT WHEEL BEARING 2006 FORD F150 2 WHEEL DRIVE


... Ford F-150

Trans problem I have a 95 ford thunderbird. I have just changed the fluid in the trans, front wheel bearings and the u joints tryin to figure out where this vibration is common from. When the car hits bout 40 a vibration comes in not crazy bad but bad. Starts to balance out bout 60 to65 and then gets worse from there on our. Not quite sure. When I took the drive shaft out to change the u joints I noticed that the tail shaft had a lot of slop in it is their a bearin back there that I could change


I don't know what you mean that your shaft has a lot of slop. But the driveshaft has to move up and down with varying road conditions. When you took out the driveshaft did you mark it. The driveshaft is balanced and needs to be put back in the same w ... Ford Cars & Trucks

Tyre puncture i am a new driver, i have a ford focus and i;m trying to change the front wheel with a spare one. i managed to remove all four nuts, but the wheel wouldnt come off. is there anything i have to do before trying to remove the wheel? thank you


If it is an alloy wheel ,it may be stuck around the hub where the wheel is placed.sometime there is rust around the hub thus preventing the wheel from coming out.So you have to slightly kick the wheel tyre from behind hardly and it will come out and ... 2005 Ford Focus

How do I change the front off-side wheel bearing on a 2004 Ford Ka Collection


... Ford Ka

How to change the front wheel bearings on a 95 Ford F150 4x4 pickup


... Cars & Trucks

How to change front wheel bearing on mk3 ford mondeo


... Cars & Trucks

How to change left front wheel bearing on 2000 Ford Contour


... 2000 Ford Contour

After replacing the left front wheel bearing on a 2003 ford focus, the abs and traction warning light stay on


The bearings on the wheels has to be installed one way only, the rotor ring is built into the bearing and if installed the wrong way round the sensor cant pick up the wheel speed causing the ligt to be switched on in the cluster. The diagnostic equip ... 2003 Ford Focus

2002 ford focus se front wheel bearing torque specs


... 2002 Ford Focus

Can you change front wheel bearings on 2007 ford sport trac 4 wheel drive


... 2007 Ford Explorer Sport Trac

Change front wheel bearing 2001 ford escape - 2001 Ford Escape


... 2001 Ford Escape
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.8340 seconds