Having problems with your 2003 Dodge Caravan ?

Where is the crank sensor in a 2003 caravan se

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2003 Dodge Caravan

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Rebuilt my 454 engine, installed distributor with rotor at 0 TDC on #1 cylinder. Engine ran fine but ses light was on. Code was P1345-- disagreement between cam sensor and crank sensor. Scanner showed anywhere from 19 to 25 degrees advanced. Rotated dist. shaft. to ****** timing. Wouldn't run. Tried two teeth positions in either direction from original setting. Ever have a sensor go bad. The crank sensor is new, cam (on distributor) is not.


The ignition timing is not adjusted with a timing light or with the engine running, and to set the ignition timing follow these procedures.There is a mark or notch on the distributor housing that the rotor should be pointing to when the e ... 1998 Chevrolet K2500

1995 dodge grand caravan,lot of mileage. rebuilt whole car 4 yrs ago,engine tranny,etc have a 3.3v6. car stutters, backfires, misses etc. have replaced o2 sensor, cam, crank sensor, coolant sensor, throttle pos sensor,swapped ign, coils, map sensor, input, output sensor on tranny. really bucks on hills. had this before but a swap of o2 sensor or another sensor after analysis but im stumped on this. at other times lik toward evening it ran ok ,please help


I would start the engine and let it warm up. Once it is warm spray some WD-40 around the intake manifold gaskets and around all vacuum lines and fitting you can get to. If you hear the engine start to stumble, concentrate the spray on that area until ... Dodge Grand Caravan

No power to coil while cranking a 2.4 liter 1997 dodge caravan. has a new computer,new crank shaft sensor and new cam shaft sensor. new auto shut down relay.new battery ,new plugs and starter.coil checks within parameters.


Then you have a bad ignition switch or bad ECU which controls the power to spark/timing/ignition. Those also contribute to no start/spark situations. I would have those checked and change/replace if neccessary. ... Dodge Caravan

CRANK SENSOR WHERE IS THE CRANK SENSOR LOCATED ON A 2001 DODGE CARAVAN SE


Where isthe camshaft senson on a 2000 dodge grandcaravan 3.0 ... 2002 Dodge Caravan

1995 dodge caravan lots of miles,lots of repairs, engines ,tranny sensors etc but here is my problem and this is not the first time . ive worked on this car so much i forget for what the car hestitates or stumbles , bucks on accleration i have changed crank sensor cam sensor swapped dist coils, fuel regulator ,fuel pressure ok. swapped map sensors to no avail i used to if i remember right put in a new o2 sensor and the trouble went away or was it the input out put sensor. as you can see ive chan


This is a common dodge problem since yo have tried everything else so far. Have you checked your fuel lines you may have grit in the lines and or the fuel tank. The debris may be not large enough to completely stop fuel flow just cut it down. Not eno ... 2004 Hyundai Elantra

I have a 97 dodge caravan 3.3 i have fuel pressure, cranks over swapped relays around new cam and crank sensor, new pcm, new coil pac, the van will sometimes spark once then only crank at the same time the injectors get one pulse then only cranks, i have also checked for a shorted injector and didnt find anything wrong, ignition switch works properly, not sure where else to go.


You have just about replaced everything that would cause a no start situation. Without being able to do any further testing, the only other thing that could cause that is the timing belt, check that, it could be worn, stretched out, and slipping. Goo ... Dodge Caravan

94 Grand Cherokee wont crank. Checked voltage at crankshaft sensor plug and according to chilton it should be 8 volts. Camshaft sensor should also be 8. I have 12 at camshaft sensor and 0 at crankshaft sensor. Does this mean I have a bad PCM?


Did you measure the voltage while the black lead to the multimeter is connected to a known good ground? Is the key in the on position while you were doing the measurement? Remember that the PCM is a very reliable device, and only malfunction if abnor ... Jeep Grand Cherokee

My wife caravan grand 3.8 has a bad idle ,one day it's not firing on 4,6 now 4,6 has fire and 3.5 now don't have fire , i have replace cam sensor, crank sensor, coil pack, wire plugs, idle sensor ,throttle sensor,2 injector's


CHECK THE , PCM AND IT CONNECTIONS . IT COULD BE A SHORT ON THE WIRE HARNESS THAT,S CONNECTED TO THE TCM. HAD THE SAME TROUBLE . ... 2002 Dodge Caravan

Stumbleing ,bucking 1995 dodge caravan 3.3 v6 lots of miles lots of repairs engines, tranny all parts etc . my problem which i have had many times but im gettin tired. it hestitates stumbles bucks especially on hills . usually if i remembered right i changed the o2 sensor which solved the problem or was it the tranny input output sensor it also at times will not start or really have to crank to get it going this time i changed o2 sensor a few weeks ago but i thought that was it not i changed c


Have you tried replacing the fuel filters and lines, you my have a blockage preventing even fuel flow/ I would say try running a fuel line/injector cleaner though it. If this ease sit up a bit try cleaning the injectors with some Gumout. Check intake ... 1995 Dodge Caravan

I have a 92 7.3 and i have an issue where the engine cuts out between 40-45 mph and it still speeds up but the tac hits 0 and then back up to 2k also ive lost power and fuel economy and i have no o2 sensor no camp or crank sensor and no maf but i have put in a new tp or fipl switch and i have a speed control sensor in my hand but im not sure what the issue is please help


My bet is it has to do with either your fuel pump or your injector pump hopefully your fuel pump but if its not giving enuf pressure to your injector pump your truck will run like that ... 1992 Ford F250

I have no spark on my 1997 dodge caravan i have changed the coil, cam sensor checked for volt to the sensors ande coil pack all have there rated volts next i'm going to change the crank sensor to see if that is it ?????????


Yes def change crank sensor that controls the coil on wen to spark... cam sensr usually controls injector pulse.... good luck ... 1997 Dodge Caravan

My wife's 97 Dodge Grand Caravan was running fine and then it just lost power and then quit running. When I tried to restart it, it acted as if it was out of time. I pulled the codes and all that came up was the O2 sensor. Using the process of elimination, I replaced the cam sensor, the crank sensor, the coil pack, and the timing chain and gears. The chain did NOT jump time but since it was a little sloppy and I had the cover off anyhow, I replaced it. When all of this didn't work, I put in


HI...\015\012One of the first step.\015\012Check compression on each of the cylinders.\015\012Before you spend money in other things.\015\012\015\012The ECM. Must be programed with the VIN of your vehicle.\015\012 ... Dodge Caravan

My 1995 Dodge Caravan 3.3v6 has jumped time. The first time in I put new cam and crank grears and new chain. alined crank and cam @6 & 12. Did not know about the color links. Went in the 2nd time and put every thing in order as the repair manual said. When it did fire it sounded like it was off one tooth. Went back in and have check every thing and replaced both cam and crank sensors. Still did bot correct the problem still sounds like it is off time. Is there a special tool to set the position


Pull the spark plug from #1 cylinder. Cut a piece of\015\012straight coat hanger wire about 8" long,(enough so it can't fall into the cyl.)insert the wire into the cylinder.\015\012Have a helper turn the crank until the piston is at the ... 1995 Dodge Caravan

Mine is doing this what is it? have a 2002 dodge caravan with a flex fuel 3.3l. When it is first started it floods out so badly that it almost will not run. you have to hold the rpms at about 3000 just to keep it running. According to a matco determinator scanner it is stuck on 85% ethanol. I have never used ethanol. So far i have replaced the plugs and wires, coolant temp sensor, cam sensor, crank sensor, ignition coils/module, pcm, and tcm. I have even pulled the tranny to inspect the flexpl


... 2002 Dodge Caravan

1997 Dodge caravan crank position sensor


It is located on the bellhousing of the transmission it gets its signal from the flywheel.look where the transmission bolts to the engine. ... 2002 Dodge Caravan

1998 Caravan: where is the crank sensor located on the 98 carava...


The crank sensor is located on the top side of the transmission about 11:oo clock position ... 1998 Dodge Caravan

Where is crank sensor located on 1991 dodge caravan


... 1991 Dodge Caravan

1998 dodge caravan crank shaft or cam shaft sensor??


U have slop in the timing chain with makes a studer in the system ... 1998 Dodge Caravan

2002 dodge caravan will not crank over No com. to PCM changed & disconected crank & cam sensor Changed PCM still the same trouble


... 2002 Dodge Caravan

2000 caravan hard to start will crank easy prev owner put in a salvage fuel pump I put an obd 2 code reader on it and it will read error from the dash I will get code 4,23,55 I have replaced fuel filter crank sensor and will not start will also back fire out throttle body


Timing may be off. ... Cars & Trucks

My 98 dodge caravan would cut off while I was driving. The problem seemed to be the grounding wire that is connected to my positive battery pole. After the wire was regrounded the van will crank up but will stall out when put in gear and trying to drive off. I changed the fuel pump, fuel filter, map sensor and throttle position sensor. My van still stalls out and cuts off when I try to accelerate. What can the problem be?


... 1998 Dodge Caravan

I have a 2008 Saab 93 2,0 turbo cold start problem. It will finally start with full throttle after 2-3 minutes replace the crank sensor and coolant temp sensor


... 2008 Saab 9-5

1999 dodge grand caravan 3.3L flex. Stopped while traveling down highway. Towed to house. Replaced fuel filter,ignition coil,crankshaft sensor, camshaft sensor and finally computer. Then I replaced ignition switch. Still will not crank.


Car Engine Will Not Crank Over\015\012The electrical system of your car has several different voltage \015\012and amperage demand systems. Th ... 1999 Dodge Grand Caravan

2003 Dodge Caravan 3.8 it cranks but does not start, checked and still there is no spark, no fuel, changed crank sensor and still nothing


... Dodge Caravan

How hard is it to install a crank sensor and a cam sensor in a 2003 Dodge Caravan?


Crankshaft Sensor\015\0122.4L 4 cylinder Engine Under the starter (30 minute)\015\0123.3 L 3.8L 6 Cylinder located on the rear of the Tranmission housing above the differentail housing (45 minute)\015\012\015\012Cam ... 2003 Dodge Caravan
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.3877 seconds