Having problems with your 2003 Chevrolet Silverado 1500 ?

Which side is bank 2 on a 2003 chevy. pick up

\015 Is bank 2 on the drivers or pass. side of the truck\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2003 Chevrolet Silverado 1500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Which side is bank 2 on a 2003 chevy. pick up


... 2003 Chevrolet Silverado 1500

I have a 2000 Chevy 3/4 ton 454 4x4 with nv4500 five speed transmission and it is coughing I think on number 2 and number 4 cylinder based on the spark plug and wires I replaced and it makes a tick on that side of the motor(passenger side) a code came on saying it was running lean on bank two replace one oxygen sensor before the cat on bank 2 side and the check engine light wen off but still have the cough. I am clueless on what could be the problem change fuel filter a week ago and the fuel pum


... Cars & Trucks

Chevy s10 yes hi i have a 1992 chevy s10 pick up and when i started my truck and drove it and it warmed up i shut if off to go in the bank and then after i got out of the bank and i start my truck back up i went to leave and my gadges where all like mess up i was going like 20 mph and it said i was going 80 and it said that the truck was to hot and my battery was dead


Alternator is bad . ... 1992 Chevrolet S-10

Possible clutch issue on 1997 Chevy Tahoe - 0 psi on high side


You will have to have a puller for removing it,you can get at auto parts, no very expensive remove the belt remove the nut on front of pulley and use the puller, you dont have to take out the freon. replace and tighten nut to pull new pully in place ... 1997 Chevrolet Tahoe

1996 chevy pick up seat belt onpassenger side is


May have folded when recoiling. You won't really know if it can be fixed until you see whats the matter with it. My advice is remove it pull the belt until it stops examine the belt if it is folded you should be able to correct it. If their is a prob ... 1996 Chevrolet K1500

2004 chevy express van 4.8l when the van is in open loop it runs fine when it goes in closed loop it goes real rich on bank 2 and the bank 2 sensor 2 ox sensor goes to 0,00 the other 3 remain normal coils plugs and wires and ox sensors have benn changed.


... 2004 Chevrolet Express

2001 chevy express van 350 I have problem with long term fuel trim 0% bank 1 and +10 on bank 2 can you help?


... 1999 Chevrolet Camaro

2002 CHEVY TRACKERW/ 2.5LITER MFI DOHC V6 ENGINE. GETTING ERROR CODE P0153 O2 SENSOR CKT SLOW RESPONCE (BANK 2 SENSOR 1). WHICH SIDE IS BANK 2 D/S OR P/S


... Chevrolet Tracker

How do you fix the power locks on your 96 chevy 1500 pick up? neither passager or driver side works. i have tried replacing the driver side swich/button that didnt work.


... 1996 Chevrolet C1500

I have a 1971 Chevy stepside pick up with the drivers side tail light broken off. How do you remove the old on?


If it is bolted to a bracket, just take the nuts lose and it should come off. If the bracket is broke, see if it is bolted to the truck or welded. ... Chevrolet C1500

The valve stems leak where you install freon and also the high side valve leaks. I installed new caps and this seemd to stop the freon leaks. are the stems hard to replace?1998 chevy pick up- 350 engine


No its not. they just screw out ... 1998 Chevrolet C1500

1989 Chevy K2500 350 will not restart after warmed up? I have replaced Heads, reset timing 0 TDC new plugs, coil, cap, button, module and pick up coil. Engine starts cold runs great but will not restart after warmed up!


Tdc is usually set at 8 degrees BTDC for an automatic and 4 BTDC for a manual transmission. This may help. Does the engine run rough at start up being set at 0TDC? ... 1988 Chevrolet K2500

Drivers side wiper blade does not move. it has the cips no bolts. 91 chevy pick up. but you can feel the motor bumbing it if you try to move it with your hand


Pull the blade off the wiper linkage and check the hole. they get worn out.(smooth). Also check the linkage. Most likely its the blade. you can get one at the salvage yard or buy one new at the dealer. ... Chevrolet 1500

Where is the #3 bank 1 oxygen senser located on the exhaust system of my 1999 chevy s10 4x4 4.3 liter v6 pick up?


PO147- 02 heater heater circuit bank1 sensor 3. 1996 camaro 3.8 where is it located ... Chevrolet S 10

How to replace the exterior door handle,both sides,on a 1992 Chevy S10 pick up. Is there an on line illustrated manual I can download or copy? I will need step by step instructions. Illustrated step by step instructions would be better. This will be the first time doing this.


Remove seat belt bolts and pull it out. the rest is just held in with tabs.\015\012 ..or if you want Forget taking the door apart - just remove the two bolts\015\012holding the latch assembly to the door - Pull the latch assembly out\015\ ... 1992 Chevrolet S-10

On a 2003 chevy s10 4.3 v6 which side is the bank one 02 sensor on?


Drivers side = Bank One, Passenger side= Bank two.\015\012\015\012Also sensor one is before catalic converter and sensor two is after catalic converter. ... 2003 Chevrolet S-10

Hi i have a code p161 shown bank 2 sensor 2 is this located on passenger side behind the cat i have a 96 chevy 1500 2wd with a 5.7 eng


Change the sensor. ... 1996 Chevrolet K1500

Can someone show/tell me where is the catalytic converter BANK 2 on the right or on the left side of 2000 chevy silverado 1500, v6, 4.3L ? Thank


Passanger side converter its round canister like on the exhaust coming off the manifold ... 2000 Chevrolet Silverado 1500

Hi i have a code p161 shown bank 2 sensor 2 is this located on passenger side behind the cat i have a 96 chevy 1500 2wd with a 5.7 eng


Bank 2 is passenger side, sensor 2 is Post cat (After) more and likely the sensor is extremly dirty, or failing (Either one requires a replacement, they are not cleanable) ... 1996 Chevrolet K1500

Loose Stearing I have a 2006 Chevy malibu and have returned the car to the dealer for repair they replaced the rack and pinon and when i picked up the car the stearing to the left is still very loose and the right side is tight. the car was purchased used from a dodge dealer with 39,000 miles on it the car has been in the shop for over 3 weeks with the same problem. What shoud i do


Could be needing aligned after all that It does move the toe in and it could have knocked the alignment off if not done properly .. they have to count the turns on the tie rods to put the rack and pinion on .. usually needing alignment afterwards. ju ... 2006 Chevrolet Malibu Maxx

OBD II Code P0441 Incorrect flow detected, was pulled in a 1996 Chevy Monte Carlo. What would the fix be for this code? I ran an O2 sensor test and all banks passed. I then ran an On-board monitor test. Two tests failed: Test 04 data, component ID 32, module $ 10, test value 32770, min limit ----, max limit 32766, staus fail. and test 07 data, component ID 12, module $10, test value 65431, min limit ----, max limit 0, status fail. What do all these values mean? Thanks in advance


Http://www.obd-codes.com/p0441 ... 1996 Chevrolet Monte Carlo

How do you replace the fuel pump on a 1976 chevy 3/4 ton pick up? I believe it is located on the passenger side on the bottom of the engine block


Remove gas cap, pull the two fuel lines off the fuel pump take the two 9/16 bolts out and remove then reinstall same way. pump is on passenger side. ... Chevrolet C3500

HOW TO GET FRONT DRIVER SIDE WINDOW UP TO REPLACE ELECTRIC MOTOR ON 2000 CHEVY SILVERADO PICK-UP


UNSREW THE FEW SCREWS HOLDING THE PANEL ON THE DOOR AND REMOVE PANEL- DONT RUSH CUZ YOU DONT WANT TO DAMAGE ANY CLPS, ONCE YOU REMOVE PANEL( LIFT SLIGHTLY) PULL PLASTIC BACK AND MANUALY REMOVE WINDOW. DO NOT TRY TO ADJUST ELECTRONICALLY WITH YOUR HA ... 2000 Chevrolet Silverado

C 10 1983 chevy step side pick up


... 1983 Chevrolet S-10

1985 chevy monte carlo driver side car hangs have to pick it up to shut how do i fix this


The wording is kinda butchered but I think you are saying that the door is sagging and you need to pick it up to close it.\015\012\015\012there should be heavy copper / bronze sereated bushings that are tapped into the door hinges. there where the do ... 1994 Dodge Caravan
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.8108 seconds