Having problems with your 2003 Chevrolet Impala ?
1999 Buick Century Replace Air Temp Control Blend Dr Actuator
\015 Help a lady out. I am trying to replace this piece b/c air blows cold on passenger side, warm on driver side. Took off the insulator panel (plastic). Took off the knee bolster (metal). Next step online says to disconnect the temp actuator remove and replace. I can't reach it. Is there something else that has to come off first? Pls. help. Dying of heat w/2 young kids!\015
Yes its hard to reach, you must used an extension.
Repair Help & Product Troubleshooting for 2003 Chevrolet Impala
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
1999 Buick Century Replace Air Temp Control Blend Dr Actuator
Yes its hard to reach, you must used an extension. ... 2003 Chevrolet Impala
How to replace blend door actuators on 200 buick lesabre custom with manual air controls
... 2000 Buick LeSabre
2004 ford taurus heater will not blow hot when i turn the temp control i hear nothing, no change in the cold air. when the blend door actuator is working i should be able to hear it right? the a/c works great and all the doors i can hear open and close on the vent selector switch. and last is it hard to get to for replacement?
... Ford Taurus
My 2000 4 runner limited blows cool to lukewarm air from heater. coolant is not low, both heater hoses going into firewall feel even temp with engine running. water temp control cable not working, but can adjust valve manually, doesn't solve problem. do not smell coolant inside cabin or have wet carpet on floorboard. per dealer the blend air door actuator not working. I don't know if blend air door can cause no heat problem? have no clue what is wrong??? would appericiat any help and suggestions
Have you checked your thermostat to make sure it isn't stuck open? ... 2000 Toyota 4Runner
I have a 99 Dodge 3500 Ram Van. The A/C-Heater Fan only ran on High, there was only A/C, and the blend actuator would work for defrost, floor, mix, etc. Now I still only have A/C and the blend actuator stays at Defrost. There is no detent/"feel" in the control knobs between fan speeds or trying to change the blower air direction. Any assistance is appreciated, particularly if I don't have to replace the controls, but if I gotta, so be it.
... 1999 Dodge Ram
The blend door actuator on my 1996 Lincoln Town Car started clicking a few weeks ago and then quit working entirely. I assumed that the actuator had gone bad so I replaced it. I did it without removing the dash, (No fun). Nevertheless, the problem did not go away. There is no air contidioning mode. Turning on the Air conditioning, the vent, the heater, makes no difference, all I get is hot air. The Air conditioning control still seems to be working because the air is diverted to the corre
Before the actual work was done, what were the BCM trouble codes stored in memory? ... Lincoln Town Car
On Ford Escape 2008 Limted V-6-have had two TCCF (Trans.Cooler Condensor Failures- one at 27,000 one at 48000 miles--also have had a Actuator replaced behind Dash-Steering assembly replaced on R/Front(was hearing a Klacking noise-and it is gone so guess the answer to that) Have a heat-temp difference on drivers side compared to the Passenger side--We have read the manual-know proper procedures--Could the Actuator and or the TCCF problems be related to the Air controls-since the Condensor supposa
NO, trans cooler is not part of the heating and air system. ... 2008 Ford Escape
Heat not working on 98 gmc jimmy. Replaced thermostat, checked fluids. Blows air but no heat. Have automatic temp controls and when put on auto nothing at all comes through vents but if put back to manual then cold air blows out, Replaced actuator this summer, could that have messed something up? How can I flush the heater core?
Flushing the heater core is fairly easy just remove the 2 hoses going to the heater core and use a different hose if you have to and use a garden hose to backflush the blockage out..this may take as much as 5-6 times also check for vacumn lines miss ... 1998 GMC Jimmy
Need to know the location of the AC blend door motor on my 1987 Lincoln Town Car, and how to replace it? Is it easy? Also, the same with replacing the Auto Temp Control Sensor. It could be either or? Getting some cool air then I hear this click coming from around the glove box and the air blows warm?
Your blend air door is vacuum controlled. There is a control servo assembly and there is a temperature sensor for the automatic climate control. The sensors fail a lot. you may have to replace the sensor and recalibrate your system. To repl ... 1987 Lincoln Town Car
Air conditioner blows hot air after 30 seconds on drivers side, on start up. Passenger side works fine. Air blows out correct vents per setting on air conditioning. Replaced blend door actuator on drivers side. No change. 2004 gmc Yukon with dual climate control.
I have had this problem. I am not a mechanic...so to correct the issue temporarily, I simply turn off the car and restart. This has worked everytime for me. In extreme cases, I think you can also remove the AC fuse and start the car, which will als ... 2004 GMC Yukon
2007 Chev Silvarado replaced Temperture Control Blend door, Manual AC and Ac will blow cold and then change to hot for no reason. After a while if you continue to turn the temp control knob it will go
... 2007 Chevrolet Silverado 1500 2WD
OK, I've got the same problem I've seen posted everywhere on the net. My a/c blows hot air from the drivers side after a few seconds of cold air. I've tried all the posted tricks, starting/restarting, pulling fuses etc and nothing changed. Now I'm believing I need to replace the blend door actuator, but which one controls the drivers side. The one under the glove box area one the passengers side or the impossible to get to one behind the dash on the drivers side? Help or direction of any kind
Hello. Sorry to have to tell you it is the one that is behind the dash on the driver's side. J. ... Chevrolet Suburban 1500
I have a 1998 Buick Century and recently my temp gauge was spiking close to the red. It never actually overheated and after pulling the vehicle over for a few minutes the thermostat opened up draining my radiator as well as reservoir. Now that I have changed the thermostat the issue has gotten worse. Still a spiking temp gauge along with now the heater blowing cold air. The water pump was replaced September of 2011 and no drainage on passenger floorboard eliminating heater core error. Any ideas
When the thermostat opened where did the coolant drain to? not understanding. did you put the thermostat in upside down blocking the cool will cause heater to blow cold air. if not, could be radiator itself. ... 1998 Buick Century
I have a 2006 X5 3.0i with standard heater controls. When I move the temp to 90 degrees, the air come out luke warm. Before I 1) start taking the dash apart, or 2) Head to the local dealer, is the tabs that held the actuator arms on the air blend doors deep within the dash broke or what? I hope this is not the case, as it was a very expensive repair with the older 5 seriers
... 2005 BMW X5
How to replace blend door actuator 2006 mark lt?I use o get only hot or cold air now only hot. I could never regulate the temp. I bought the actuator and a Haynes manual but can't find ant thing on the subject, PLEASE HELP ME Dusty
Hold on to that actuator. Lincoln products have a longer warranty than most vehicles. We had the same problem with our 2006 LT and it was replaced under warranty. There is a thermal control sensor that is the problem.\015\012\015\012I ... 2006 Lincoln Mark LT
So the air blows hot , would i be best to replace the actuator or the air temp control motor.... which one or both...... for the a/c the blow hot on one side and cold on the other...... Thanks a million
Check the temp-controler, if the system is charged properly, then an acculator is not needed. ... 2003 Chevrolet Impala
How to replace temp control motor on 2000 buick century
... Buick Century
97 Chrysler Concorde high idle speed A 1997 Chrysler Concorde starts fine, but idles at 2000 rpm. The idle increases to 2500 as it warms up. Vacuum is at spec, and no signs of intake leak. We have replaced the coolant temp sensor (previous code), idle air control motor (previous code), one front O2 sensor, EGR valve and control, and MAP sensor (previous code). The previous owner had the PCM replaced with a used unit, with no luck. We have not yet replaced the intake air temp sensor,
Couple things to check out. what is the throttle position sensor readings fully closed (should be .5volts). if it's above the pcm may think the car is not at idle. did you spray sections of vacuum lines and manifold gaskets with brake clean to check ... Chrysler Concorde
2008 silverado k1500 4.8L V8 - this fall i noticed that when I went to use my heat, the blend door or temp control knob was not functioning properly, either it kept blowing cold air or would not get hot, hot. After I got the blend door to change I noticed that My driver side vents are hotter than passenger side. I do not have dual climate control. So I used my verdict scan tool to look at temp control specs and they change like they should. Does any1 know where abouts the temp blend door is l
... Cars & Trucks
2002 pontiac grand prix gt AC only blows hot air compressor full of freon and clutch spinning good temp control actuators working corectly narrow ac tube at firewall very cold thicker ac tube at firewall pretty warm both heater core tubes very hot engine cooling fans come on when they want with or without ac compressor running not sure about the blend doors or how to obtain access SOMEONE HELP ME IM PULLIN MY HAIR OUT
I had same problem 2 years ago. the actuator door tube was snapped in half and i used acquarium tubing to splice together. The tube runs along the passenger front well well inside engine and meets under the battery carriage. I could not tell anyth ... 2002 Jeep Grand Cherokee
How do you replace an air temp control blend door motor on a 98 deville
... 1998 Cadillac DeVille
I have a 2000 Buick Century Custom. Can the pilot lights for the control switches such as fan and temp settings be replaced when they burn out?
The lights are only serviced by GM by replacing the affected switches, so the answer is no. I have heard that some enterprising do it yourselfers have been able to find the tiny incandescent bulbs and replace them, you could try radio shack for the b ... 2000 Buick Century
A family member has a 1987 Buick Century 2.5L. Car would intermittently stall out and restart after sitting for a while. Now it won't start at all and has been in the garage for 2 weeks. They have replaced the Fuel Injector, Power Control Module, Oxygen Sensor, EGR Valve, Ignition Module, Temp. sending unit on the thermostat (?) and the Fuel Pressure Limit Switch and nothing has helped. It is letting too much gas into the engine also. Any ideas? The garage called a week ago and thought they
Try and change out the crankshaft position sencor it has a lot to do with the timeing and fuel i had a 12995 chrysler concorde that did the same thing i switched that out and it ran great i now also have the same buick as your family member hope this ... 1987 Buick Century
Where is the air temp control blend door actuator located
... 1999 Lincoln Navigator
My 99 buick century ac not working. I was told it is full of freon but something is not engaging. The inside control works, the fan blow and air comes out vent. Under the hood the ac is not engaging.the shop that worked on it replaced a fuse and it worked about 2 weeks. They supposedly put a larger fuse the next time and it worked a little while.
... 1999 Buick Century