Having problems with your 2003 Chevrolet Blazer ?

After you fix a leak in the 2003 blazer cooling system, do you have to reset the computer to get it to read the pressure right

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Assuming you are talking about the engine cooling system, no you do not have to reset the computer. The computer does not read the pressure, it reads the coolant temperature.
Repair Help & Product Troubleshooting for 2003 Chevrolet Blazer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

After you fix a leak in the 2003 blazer cooling system, do you have to reset the computer to get it to read the pressure right


Assuming you are talking about the engine cooling system, no you do not have to reset the computer. The computer does not read the pressure, it reads the coolant temperature. ... 2003 Chevrolet Blazer

Reset computer Buick dealer gets a readout from the computer but when taken to e-check, they get no read. Gone through this several times now. E-check says go on line and get info on how to reset the computer. Does this sound like a legit thing to do to get a read at the e-check sation? Jim


... 2005 Buick LaCrosse

My car has no pressure in the cooling system. It appears to be circulating, but no pressure. I had a leak somewhere around the back of the intake manifold, which i apparently fixed with a bottle of sealant i put in with coolant. The car also gets hot if i dont run the heater. In addition to that, when i turn off my heater/AC, you can hear a constant hissing sound right behind the vents in the center of the dash. WTF??


... 1996 Ford Thunderbird LX

(Chest freezer) replaced burned out compressor, filter drier and flushed lines with r11, checked for leak and restriction found none, recharged system with right amount of r404a. Problem low side pressure doesn't pull up to 8 psi, it stays at 20" vacuum and doesn't get cold.


... Cars & Trucks

Replaced burned out compressor, filter drier and flushed lines with r11, checked for leak and restriction found none, recharged system with right amount of r404a. Problem low side pressure doesn't pull up to 8 psi, it stays at 20" vacuum and doesn't get cold.


What year model type vechicle do you have R 12 or R134 system.flush R 12 SYSTEM with R 11 . ... Cars & Trucks

I HAVE 05 SORENTO. A/C WAS BLOWING COLD THEN STOPPED. CHECKED COMPRESSOR FOR POWER AND IT IS NOT GETTING ANY. CHECK PRESSURE ON LOW SIDE AND THE READING WAS 135 PSI. I LEAKED SYSTEM DOWN TO 49 PSI AND STILL NOTHING


You need to put that freon back in the system, if a/c compr not on you will have that reading on your low and high side due to the freon not being compress, start with check the elec. side of it, like fuses, relays and a/c switch. ... 2005 Kia Sorento

(Chest freezer) replaced burned out compressor, filter drier and flushed lines with r11, checked for leak and restriction found none, recharged system with right amount of r404a. Problem, low side pressure doesn't pull up to 8 psi, it stays at 20" vacuum and doesn't get cold.


... Cars & Trucks

I have to reset my computer every time I get gas so that it can read the right amount of gas.


Having a promblem getting starter top bolt out ... 1993 Lincoln Town Car

Break pressure i changed the back read caliber on my 2002 jauguar x-type. but i can not get the brakes to bleed. the front left and the back right have plenty of pressure and are bleeding fine but the front right and back left are not getting pressure and just dripping fluid rather then squirting.


Make sure you are trying to bleed the system in this order (Right rear, Left rear, Right front, Left front). If you are doing this and still not getting pressure, you should check the brake lines going to the rear for leaks. If you find a leak, repla ... 2002 Jaguar X-Type

1997 Nissan Max. Steps to get computer to read again after reset.


The sequence is listed on pg.9-19 and 9-20 of the owners manual ... 1997 Nissan Maxima

I have a honda civic 1400 5 door 1997. which i replaced all the brake seals on , i do not have any leaks in the system and when i bleed the system with the engine off i get good pressure on the pedal. the second i start the engine the brake pedal goes to the floor and i cannot get any pressure on it again until i turn the engine off


Sounds like master cylinder bad, make sure u bench bleed master cylinder before installin ... 1997 Honda Civic

How many miles do i have to drive a 2003 freelander after the trouble codes were reset to get a reading on the evaporator system monitor, thecatalyst monitor and the heated oxygen sensor can be tested on diagnoistic equipment after resetting the trouble codes all i am is getting a incomplete reading on my obd2 test equipment


Well you can drive at least 40 to 60 miles, ... 2003 Land Rover Freelander

Engine code 0456 ( evaportive emission control system leak detected, very small leak ) installed a new OEM gas cap and reset the computer. Worked fine for 1 1/2 week and check engine code came back? Cleand filler tube, reinstalled gas cap reset computer.


It's a leak in your evap system. \015\012Causes: \015\012*Loose or missing fuel cap. \015\012*Evap canister broke, hose cracked or not connected. \015\012*Purge or vent solenoid defective \015\012*Vacuum leak at engine \015\012good luck ... 2003 Chrysler Town & Country

Brake pressure lost all pressure when press on brakes, have to tap the brakes to stop, nothing is leaking when I look, please help? I have the same problem but have checked the brake fluid and it seems to be holding in the system, but I still get no brake pressure. No evidence of it leaking anywhere either. The brakes need to be replaced, I know that...could worn brakes cause a loss of pressure somehow?


Yes, when your brakes are worn the extra heat can boil your brake fluid and put ait and moisture into the system, which will give you no or a soft pedal. you need to replace the worn brake pads and rotors, flush and bleed the brake system- you should ... 1996 Chevrolet Cavalier

The diagnostic computer won't reset on my 1998 Volvo V70 SW. I had work done on the rear main seal, and the mechanics had to disconnect the battery for several days. Now the main computer won't reset. I have driven it for over 200 miles and still reads that the computer is not ready. Any ideas, I really need to get it inspected.


... 1998 Volvo V70

Having trouble with finding the right tire pressure for my 2001 Toyota MR2 Spyder; I just cant seem to get the right pressure . Its too stiff if too full and anything other thsn too full it just grabs every bump,groove,skid-mark on the road and its a constant battle.ive got brand ne Yokohamas on it. this vehicle has two differant sized rims as follows front: Back: ive read so many conflicting reporrts as too a good pressure to start at that i just want some expert advice that i can trust and LOO


If you are running on newer low profile rims and tires,,then the only option is to change to a softer shock absorber.Since the newer low profile tires need to be at full pressure or your handling is going to be dangerous ... Toyota MR2

Is a compression test a conclusive way to check for a leaking head gasket? My 99 honda civic (D16Y7) Is losing coolant and ruining radiator caps from the coolant obviously getting too hot. I did a compression test on each cylinder, as well as a pressure test with each cylinder TDC with 180psi for approximately 1 minute with the engine at running temp. At the same time i had a cooling system pressure tester on with 25psi...there was no loss of pressure in any of the cylenders or cooling system,


Check for milky oilIt may help to have the radiator cleaned and flushed, and a new thermostat installed, the coolant may be going out the overflowNot certain how it ruins radiator caps, they hold about 5psi in the radiatior and let excess ... 1999 Honda Civic

I have reset the computer on my 1997 chevy lumina. I need to get an admissions test and the computer will not read it. How long do I have to drive it before the computer can read again/?


... 1997 Chevrolet Lumina

Cant get the right front brake to pressurize. just spent $670.00 getting new brakes after the ones i had started smoking, then the mechanics could not get the right brakes to function...also the abs warning system is non-functioning.


The front brake not pressurizing my guess would have to be that the brake line is not tight, or there is a brake, kink or some type of blockage in the system that is not allowing the breaking system to pressurize. The ABS warning system not functioni ... 2006 Chevrolet Malibu Maxx

The car won't start every so often. I reset computer with mechanical and wait till next day for car to start. I think the dealership planted a bug in the computer system. The problem began after the dealer had replaced a bad catalytic converter. Since then the car won't start after so many starts. The next day it will start and the check engine light will be on. Again i reset computer by opening the door with the mechanical key. After three times the lite goes out. And then it seems like you get


... 2002 Mercedes-Benz E-Class

On a 2002 saturn l200 with an abs system, do i need to use a scan tool to return the rear displacement cylinder pistons to the home position or the upmost position, the manual i have says it will run them to the top of their travel. I have replaced the master clyinder and front calipers. On the first pump the pedal goes to the floor, then after the second or third pump i get pressure to my pedal. we have bleed the system with a pressure machine and there is no air or leaks are these rear dis


No there is a spcial tool available at auto zone or advance auto. with tool screw the piston back in. make sure piston is in position so pad fits up tight against the piston ... Saturn L-Series

Water leaking on drivers side floor flowing to the rear seat compartment which leaded to flooding the comfort system central control which lies on the floor of a 1999 VW passat v6 after repairing the leak in the drain holes you must remove the computer and the black box to dry. At the same time i could not access the DLC info due to a short in the system from the water--please post this as a must do if water gets inside the drivers compartment


... 1999 Volkswagen Passat

NO spark. I had to replace air manifold gasket collant leak into oil. I properly put the engine back to gether, but know I am not getting a spark to my plugs. I tested the red and black wires coming to the coil and I am readings 12volts on the left side. I check the right side using an ohms meter and I am getting no reading. I tried to trace where thos wires go to but unable to trace to ignition module. please help.


For no spark is power in the big wire going to the dist if so you need a module , coil or both .. ... 1995 Oldsmobile Cutlass Supreme

I have a 1995 Buick Park Avenue that has been sluggish for some time and gets very poor gas mileage. It just so happens that none of the diagnostic computers want to read this car because it is what they call the half and half. It's inbetween the years that they changed from the old system to the new. Anyway I have been told several times to replace the mass air flow sensor. I was just getting ready to do this when these mechanics told me they did test the fuel system and it is telling them


The only thing that would make a fuel pump lose output pressure when you brake is dirt (or water) in the fuel tank - when the fuel gets sloshed around the dirt temporarily clogs the pump admission tube. You should take the tank out and clean it thoro ... Buick Park Avenue

I have a 2003 saturn vue 6 cylinder. my service engine soon light came on and my friend had a diagnostic tool and checked my computer and this code showed up, my friend reset it. it came back on after 12 days. my heater is working good and engine temp is normal. i have noticed that my fuel gage is not working properly..it doesn't go to full when i fill up, but i am still getting good gas mileage 19 mpg. want to know if i should rush out and get this fixed right away or could i just reset it agai


From the looks of it this is a very common problem with the 2002-2003 saturn vue. There was a Technical Service Bulletin from saturn about the problem, which means it happens alot but not quite enough to warrant a recall.You need to repla ... 2003 Saturn VUE
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.3658 seconds