Having problems with your 2002 Toyota Corolla ?

I will like to convert my manul 2005 toyota corolla to automatic. What other than tranny, edal, computer, wiring, pedal and shifter do I need to replace it? Any sensors??

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2002 Toyota Corolla

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I will like to convert my manul 2005 toyota corolla to automatic. What other than tranny, edal, computer, wiring, pedal and shifter do I need to replace it? Any sensors??

... 2002 Toyota Corolla

Before we replaced the transmission we didn't have this problem. We replaced the tranny with a used and that's when it began. I knew that we needed to do some things to the jeep so I did the following, replaced: Crank shaft sensor,fuel pump, distributor, cap, button, wires, plugs, fuel filter, air filter, vacuum hoses, cleaned the intake and throttle body, replaced with used the speed sensor, (did not change out any of the other sensors from the old tranny).Had 2 different computers(diagnostic)

I am sorry,you did not say what the problem was. ... 1992 Jeep Cherokee Briarwood

The MAF sensor was replaced and problem continued. Tried a new sensor and problem continues. The computer checks out ok so I need to know how to replace the wire from the MAF to the computer.

If your sure that the MAS wires are the problem Then the only way to replace them is by tracing them back through the wiring harness and clipping them. Tie new wires to the pigtail where the old wires where cut and reconnect ... Oldsmobile Cutlass Ciera

The O2 Sensor after the cat convertor tore apart at the wiring harness. I was wondering do I need to replace all the sensors (I have 4 on this vehicle, 1996 Chevy C1500 Silverado)? Or can I replace them one by one over time? Also where can I buy another harness that comes from over the tranny and connects tot his one sensor? Thanks.

You can replace them one by one over time. The harness may be purchased from an aftermarket source, but I've never done it that way. If the wiring is torn about with just a few wires being damaged, get the appropriate gauged wire and solder it in to ... 1996 Chevrolet K1500

Where is the 2003 Pontiac Mini Van computer or brain located? My van has the check engine light on. (I got taken to the cleaners & billed almost $1000 and the problem still exists.) The mechanics have replaces 2 sensors; GM has replaced the wiring harness now they say I need a new computer? (A $500 Job.) I'll do it myself get a used one, & if it's just a matter of unplugging the harnesses & plugging the new one in I can do that. ( if I can get to it?)The Van runs rough, stalls & skips backfires

Hi.The main control module is called the ECU, PCM or ECM. The ECM is replaced only after testing the module and finding it faulty. The PCM does not fail very often.Replacing the ECM is no straightforward operation. After repla ... 2001 Pontiac Montana

Radiator Fan for 94 centry does not come on. Engine overheats. I assume temp sensor is faulty. I have hot wired the fan to ensure the fan does work, but without those wires... no luck. I hate to just replace things without some amount of confirmation that that is the problem, but I also needed to know for sure where it is located. I asume there are 2 sensors because the one sending the temp to the dash gauge seems to work ok, just nothing telling the computer to turn on the fan...

The ECM turns on the fan when the coolant sensor reaches a set temp. the fan is also turned on when the AC is on. there is also a fan relay in the circuit. none of these are very expensive. if the fan works when you apply direct voltage, the fan is g ... 1994 Buick Century

Need a wiring diagram for the airbag sensors in the front of a 2006 Chevy Impala computer is saying sensor one is not working so we took sensor two out and replaced sensor one with the one that was in sensor two and we still had same code stating sensor one is not working. Does anyone have any ideals?

... 2006 Chevrolet Impala

I just replaced the clutch to my 2003 tiburon gt v6 and i broke a sensor on the tranny , now i need to lknow what typ of sensor that is .. my sensor is on top to the left and its blue and has a plug for the wiring harness than a bolt under it.. what is the sensor?

I have the 2.0L with a 5-speed. Mine has the Vehicle Speed Sensor in the position you're describing. ... 2003 Hyundai Tiburon

94 s10 pu 4.3l cpi engine drives fine till it warms up then idle goes crazy. new map,iac,cap,rotor,plugs,wires,fuel filter,etc. i believe I'm down to the computer and the 02 sensors. my question is, since the engine light isn't on do/will i need to replace all the 02 sensors? if so is there 3 or 4? i found 3 but haven't gone under close to engine so not sure.

Just 3 sensors . u need to check throttle body bolt make sure tight/no vacuum leaks/plugged pvc/or camshaft lobes worn/leakin head gasket do compression test ... 1994 Chevrolet S-10

I have a 2003 Chevy Avalanche with 164000 miles. I have had the p1125 code come up. I have replaced the accelerator pedal sensor twice. I took it to a dealership and they said they ran an extensive diagnostic on it and it needed a new tachometer module and APS. I replaced both again and after three weeks the problem has come up again. How can I check to see if the two new parts are defective or is the wiring harness is at fault? The problem is intermittent. When I shut off the vehicle for

As if the APS and tachometer both are replaced,but if they are getting short,then its wiring harness fault.But if there is no short checked then its the part causing the problem or parts installation causing the problem.Also new parts getting faulty, ... 2003 Chevrolet Silverado 1500

Need to check the transmission fluid pressure sensor in the tranny. Can it be repaired or does it need to be replaced? The tranny will delay going into R or D when cold. It also sticks in gear "4" when cold. Recently changed fluid and filter and may have bumped sensor when replacing the tranny pan. Are they that sensitive?

Sounds like a fluid flow problem. probably need to change the fluid and filter in the transmission. If the sensor is bad it will have to be replaced. Hopefully it is that simple. If its sticking in gear and delaying when its cold I would prepare ... 2007 Jeep Grand Cherokee Overland

My temperature sensor wires were "chewed" by mice ... the wire right at the top of the sensor is just about to break off so need to replace the wire at a minimum or replace the complete sensor and wiring ....


Replaced clutch in 1999 toyota corolla. When trans dropped, speedometer sensor wire wa not dis connected. Wires stripped from 3 lead female wire connection. need to know wiring color code replacement for 1,2,3 positions on female connector that connects to 3 connection male speedometer sensor. Wiring has red wire with white stripe, red wire with ourple stripe and white wire with green or some other stripe. Help?

Auto parts store has books you can look at for free sorry couldnt help you more ... 1999 Toyota Corolla

I replaced the switch with the switch from another switch from 2005 grand am, both are 2005 i have every thing up plus every thing to shifter and when you turn key everything works but the starter does not engage i have unhook battery for computer to reset the only thing i might not have right is the plug with 3 wires could be off when you turn it just clicks 1 time not the starter but by the fuse box on passenger side . do not know what to do need car bad.help please.

Sounds like your battery is low or you have blown a fuse. which is likely if you changed the ignition cylinder without unhooking the battery first. be that as it may if it's a standard you can push start it. that will charge the battery up. ... 2005 Pontiac Grand Am

No power 85 cavalier type 10 2.0 starts fine idles a little rough at first but smooths out nicely after bout 10-15 seconds but check engine light comes on. drive down the road and have no power. replaced wires, plugs, cap, air filter, oil change, upstream O2 sensor. tranny fluid full, nice and red. thinking it might be fuel filter? maybe vacuum line somewhere. i need help

The exhaust may have a blockage in it....maybe the cat converter....motors don't have power unless they can get rid of the exhaust..... ... 1985 Chevrolet Cavalier

My check engine light comes on every now and then. i had a computer check, and it said the oxygen sensor needs replacing. now when the engine check light comes on, the gear shifter will show an X over the reverse gear but tyhe car will still go backwards without problem. after a couple of startups, the engine check lightdoes not light up.

Sounds like you may be passing moisture to the O2 sensor. #1 make you sure you are using a GOOD grade of Gasoline. You may need to add a bottle or 2 or DRI-gas to you gas tank. A good bottle of LUCAS fuel treatment wouldn't hurt at this point eithe ... 2008 Suzuki Forenza

2001 I30, gas pedal must be held down to set idle from cold start. My mechanic says the ECM and IAC must be replaced. I found a place that will reprogram my ECM and they say that will work but I also will need to replace the Throttle position sensor and Air intake temperature sensor. My mechanic said the sensors are fine and don't need to be replaced. What do I do?

Hi! Used to work on one too and I agree to your second mechanic. ECM may need to be reprogrammed, throttle position sensor, air intake temperature and the MAF (mass air flow) sensor may need to be replaced. The MAF has big contribution on engine perf ... Infiniti I35

I'm getting code po894 for my 09 chevy express van 6.0L. Engine light is on and transmission jerks when going from 1st to 2nd gear, but only when engine warms up a little. Doesn't happen when I first turn on the vehicle. I had the trans fluid and filter replaced. Mechanic shop said that transmission computer needed to be replaced. Checked online and found that it might be possible TPS sensor or TCC solenoid, but nothing on trans computer. Is it possible that computer needs to be replaced or is i

... 2009 Chevrolet Express

I need a diagram of the exhaust system on a 1992 toyota previa, showing the oxygen sensors, I have replaced the sensor with 4 wires, I was told that there was another sensor with two wires, however the two wire sensor only occurs on 1995 models and up, there is supposed to be a 3 wire sensor for the 1992, where is that sensor located and how many wires does it have.... I am going to go to a junk yard to find it and want to make sure that I get the right one....is there any way to test an O2 sens

... 1992 Toyota Previa

I need to replace the Oxygen sensor in my 2001 Passat 4 cyl 1.8T. How many wires are there needed on the sensor? I have seen 4 wire. 2 wire, and even a one wire.

... 2001 Volkswagen Passat

2000 Chevy Silverado 1500, LS 4X4 extended cab. 5.3 vortex, auto tranny. 185000 miles. Recent know situations: Number two knock sensor DTC. Replaced sensor and replaced the wire assembly. Now get number one knock sensor (dummy me didn't change that one too). No other DTC's before or after knock sensor #2 issue or even currently. Easy starting and steady idle. No abnormal noise other than a ticking believed to be coming from a loose exhaust. New muffler installed a while back. Had tranny flushed

CHRCK FOR EXHAUST RESTRICTION ... 2000 Chevrolet Silverado

I have a 1997 monte carlo and the car is always 'dogging' when i accelerate. it takes forever to get the car up to speed. i have a new catalytic converter, a new gas tank. i have also had the fuel injectors replaced, the spark plugs and wires replaced, all the coil packs replaced. the module that the coil packs sit on has been replaced, the crank sensor replaced, the computer replaced, the mass air flow sensor replaced, the throttle position sensor replaced. i have had multiple mechanics look at

Fuel pump ... 1997 Chevrolet Monte Carlo

I have a 95 Taurus sho that was not running right when I bought it. Since I have replaced crank and cam sensors, o2 sensors, knock sensor, wiring harness checked fuel pressure, checked compression, replaced plugs and wires etc. The car will run just fine but when I come to a stop it idled between 1-2 grand back and fourth before just finally stalling. But it starts right back up and usually will idle fine for awhile. Need help!

You did not mention the throttle body or the idle air control valve.The computer controls idle speed by how much air is allowed to enter the intake manifold thru the throttle body.If the idle air control valve is faulty, or there is a vac lea ... Cars & Trucks

1996 cherokee sport 6 cylinder manual trans. looking for a replacement wiring harness for an 02 sensor near my cat. converter.. the harness has 2 connectors on it to my knowlege, both are near converter, and the harness runs above the transmission to the firewall of the engine compartment. any help would be great. my 02 sensor clip fell into my drive shaft while driving so the plug and wires on bothe ends ripped completly off the wires. so i really need a replacement harness or how i find one? t

Likely the quickest way to find one is at a scrapyard. Next and likely only other option is to order one from a dealer. Before installing, check the connections to make sure that wiring attached inside the remaining plug is still connected. ... 1996 Jeep Cherokee Sport

So im still scratching my head... I am going to go ahead an replace my throttle position sensor an clean the throttle body an replace the gasket. But I have a feeling my problem lies with the accelerator pedal positioned sensor or maybe neither an it's the wiring as I had that burning smell after taking the car for a drive an pumping my accelerator pedal ???? Tho I have only come across one person so far with my probs I can't seem to fine any info really in regards to the app sensor just keeps b

Hello\012The\012Engine and Automatic Transmission (not applicable to manual\012transmissions) in this vehicles drive train are fully electronically\012controlled by a computer called the PCM and TCM (Power Train Control\012Mod ... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.3605 seconds