Having problems with your 2002 Oldsmobile Bravada ?

Olds Bravada Fender Help

\015 I have a 2002 Bravada that needs a Right Side Front Fender. Tough to find at a decent price. Does anyone know what else will fit. Maybe Blazer, Trailblazer, yukon? Not sure. Please advise. Thanks Russ\015\[email protected]\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2002 Oldsmobile Bravada

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Olds Bravada Fender Help


... 2002 Oldsmobile Bravada

Replace fender on 2002 olds bravada - Bravada Oldsmobile Cars & Trucks


... Oldsmobile Bravada

I was replacing wires and plugs.....One at a time, moving the wires to the new cap and changing plugs. The RAM Charger is 25 years old. The plugs were rusted to the block. As I loosened the second to last, I fell off the fender and dislodged two wires. I don't know the firing order or where #1 plug wire is on the Dist cap. There's a nipple on the cap, for orientation if you cna help me from there. It was running before and now not (obviously) I got the wires wrong.....Thanks!!


Here is a link to the info u need to rewire the cap and plugs. u don't say engine though so will give both.1st is for 5.9 V8 and then 5.2 V8, the appear to be the same.\015\012\015\012 ... 1984 Dodge Ramcharger

I need a diagram of a fuse box panel for a 98 olds bravada...the fuses were removed and no digram to show where they go back in...help!!!


... 1998 Oldsmobile Bravada

2002 Olds Bravada sunroof won't open or close - fuse replaced didn't help


... 2002 Oldsmobile Bravada

My 2001 Olds Bravada 2wd, non-heated seats has the manual for a 2000 model. The power seats don't work & I can't find a fuse any where. Help please.


... Oldsmobile Bravada

1998 impreza outback, Im having a problem with left head lamp being dim, Changed old beat up plug that powers bulb. Bulb is good, Cleaned ground where wires come up from fender well. Dash high beam indicator seem dimmly lit when high beams are not switched on. Can anyone help me out, Thanks


Replace light switch ... 1998 Subaru Impreza

I HAVE A OLDS BRAVADA 2001, ENGINE LIGHT COMES UP. when using my OBDII shows error P0327,,, Its is dangerous, Do I need to go to the garage right away for repair?.. ?? When erasing the problem code, its cames back in a couples days... please help


Hi,It refers to :-P0327 Knock Sensor 1 Circuit Low Input (Bank I or Single Sensor)Now,On most Vehicles, The knock sensors are located on the side of the engine and can be replaced by you. They are held ... 2001 Oldsmobile Bravada

I own a 2001 Olds Bravada, and the transmission will not shift into 3rd gear. It just acts like it is stuck in neutral. Any help would be appreciated.


... Oldsmobile Bravada

Help My 1998 olds bravada is always blowing hot air out of the vents. This happens even when I have the temp control on the coldest setting,and when the fan is off.


You probably have electronic climate control. Some models have this others have a vacumn operated system. If the vac system the part is about $50-100 aftermarket and easy to do yourself. If elec the part is available dealer only and about $200 last ... 1998 Oldsmobile Bravada

94 olds bravada... Battery has full charge and tested good... starter tested good.... when in vehical nothing comes on ie.. lights turn key nothing help plz....


I would start by checking for a burnt fusible link. ... Oldsmobile Bravada

I hava a 96 olds bravada and am having some ignition problems when i turn on the key no dash lights come on then after 2 or 3 seconds i hear a click an the lights come on the battery is new and all the conections are good the car will just shut off without warning it will start back up and run for a while and shut off again I replced the fuel pump about a month ago and all the sudden this week the ignition problem started is this related to the fuel pump please help thank you steve


NO, This is not the problem related to fuel pump.\015\012Its ignition switch that is faulty. it is a very common issue , many a times if the switch is partly faulty.it causes this problem\015\012\015\012it will cost you about $300. ... 1996 Oldsmobile Bravada

Plain 1986 2.0L 4cyl. My 72year old neighbor took his starter out. I only removed the top bolt, as he couldn't fit his hand there. (I'm a 45 year old ex-female mechanic and have small hands.) He took the old wires off of the solonoid "in the blind." We know where the old wire is for the positive side to be reattached. We cannot find the old ground wire side (O connection) that is attached to what???? The firewall? Carb?, block?, frame? Please help me help this old man that can't afford


On the starter solenoid where the large positive connection is,you should be able to locate a small threaded post,that is where the o connection you refer to goes to. ... Mitsubishi Pickup

2003 s10 I had to change the ignition tumbler/key and the housing with the passlock chip. "the tumbler went out and froze in the housing. So now that I have a new key and chip the security light stays on on the dash no blinking. I've tried ten and 30 minute prociedures but no help. Even hooked up the snap on modis but was only able to reset the codes. it didn't help with the security light. Then I plugged in the old chip out of the old housing and tried reseting. No progress. Please help.


\015\012Turn ON the ignition, with the engine OFF.\015\012Attempt to start the engine, then release the key to ON, vehicle\015\012\015\012will not start.\015\012Observe the SECURITY tel ... Chevrolet S 10

How do you remove the headrest from 1997 olds bravada


... 1997 Oldsmobile Bravada

1991 Olds Bravada 4.3 v6 rough idle and backfiring.


Ok guys, let's fix these things here! \015\012 Just went through this myself, so do the following:\015\012Go to your local parts store and buy a Haynes Repair Manual.\015\012 You need to read the book first, learn how the EC ... 1992 Oldsmobile Bravada

96 old bravada multiple misfires


Check for bad spark plug wires or wires connected to the wrong cylinder. ... 1996 Oldsmobile Bravada

Fuel Pump 2000 Bravada changed but still not working... help!!!!!!


You check the relay?Make a tool out of the relay take the relay apart collapse it.to make full contact and stick it back in,key does the fuel pump come on?If yes keep it like this for 15 minutes if the vehicle stall,the problem is not the fuel pump, ... 2000 Oldsmobile Bravada

1998 Olds Bravada


Your fuel pump is going bad if you have to tap the tank with a hammer to get it to work again ... 1998 Oldsmobile Bravada

I just got done changing a 460 motor out of 1992 F-250. The old motor still ran when i took it out. But can't get the new motor to start. It seems like its not getting a strong enough spark but it is getting one and it has fuel.. I can't figure it out so any help would be appeciated. I think it might be something to do with the TFI-IV ignition system. But everything is off of the old motor and it all work fine before. Need help diagnosing the problem


Is the timing correct. go back to basic number 1 cly TDC check rotor button position add some fuel or starting fluid to prove it is electrical ... Cars & Trucks

1999 old bravada just quit running when going down the street?


Hey , check your ignition cord from the distributor cap to an ignition box. My blew off and caused the same problem. The connection could be corrorated if not blew off. I had to buy all the spark plug wires to get that exact wire ( only cost 20 dolla ... 1999 Oldsmobile Bravada

96 old bravada multiple misfires


On those amung other there is a wire from the module to the crank sensor it might have melted and be shorting out. make sure its not melted between the sensor and the module. they mainly melt after awhile. ... 1996 Oldsmobile Bravada

Change oil 2004 olds bravada


... Oldsmobile Bravada

Replacing front fender of 2000 dodge ram pickup 1500.my replacement fender came as just a fender. my old fender is tack welded to fender. what is my best solution?


... 2000 Dodge Ram 1500 Truck

What is the best way to remove old gasket from a metal surface? I am replacing my transmission shift solenoid on my 2002 Dodge Neon SE 4cyl. automatic and when I removed the old solenoid, a lot of the old gasket is stuck to the metal surface. What is the easiest and best way to remove the old gasket? Please help.


Hi, one of the best things to use is one of those scrapers that you can put a stanley blade into or you can just use a blade on its own as long as you keep it flush with the surface which is a bit difficult without the scraper attatchment. ... Dodge Neon
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.2774 seconds