Having problems with your 2002 Mercury Villager ?

My engine accelerates by itself - 2002 Mercury Villager

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2002 Mercury Villager

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1997 Mercury Villager GS 200000 Miles When The Engine Is Cold And I Press On The Accelerator The Van Goes Very Slow Like It Has No Power But When Engine Gets Warm The Van Works Good Check Engine Is Not On So No Code


Have you checked base fuel pressure with a gauge ?You might also want to look at the engine temp sensor with a scanner. ... Cars & Trucks

Problems accelerating my van (94 mercury villager) runs great when i first start it up but once engine warms up i have problems accelerating and stalling out when coming from a stop or shifting in to reverse


The engine tickover is too slow when the engine is cold its running on cold start, ie:choke,, after it warms up the engine slows down this is what is causing it to stall in gear,, get some one to hold the brakes hard on and with the engine running in ... 1997 Cadillac DeVille

My engine accelerates by itself - 2002 Mercury Villager


... 2002 Mercury Villager

I have a 97 mercury villager mini van, and lately I have been having bad problems with what I'm thinking might be vapor lock, but when it is hot outside, temperature wise or the engine gets over worked, when you try to accelerate, it causes the car to sputter and then stall out until it cools down, any idea's? I've already tried the ignition coil....


It may b a fuel pump not supplying enough pressure, a fuel filter not letting enough gas through, or it could be a vacuum leak. It could be any number of things, actually.\015\012\015\012If you tried the ignition coil and that didn't help ... Mercury Villager

I have a 1992 Mercury Grand Marquis with the 4.6L V8 with roughly 50,000 to 60,000 miles on it and while the engine runes great when it is cold, when the engine warms up, it starts to rattle/knock during acceleration, but only above a very slow acceleration. It sounds as though it is coming from the top-end of the engine. At cruising throttle, and slow acceleration, the engine runs perfect.


First, there are 8 bolts holding the metal Airhorn to the Intake manifold. Underneath this part is a gasket and under the gasket is a groove. The groove can Carbon up and affect the performance of your car. The gasket costs $10 and the job takes a ... 1992 Mercury Grand Marquis

Just had my Mercury Villager 2002 Sport serviced after "Check Engine" Llght" went on. My mechanic indicated that his diagnostic showed 3 Codes. Knock Sensor, O2 Sensor & Unknown. After replacing the Knock & O2 Sensors the "Check Engine" light has gone back on after driving 70miles of so. I have read in several threads that you should never change the Knock Senor for it's a waste of time&Money. You should have all the O2 Sensors changed (Villager has 2 I believe) and the problem could even b


Http://groups.yahoo.com/group/villagerquest/\012\012will will help you. And yes, never replace the knock sensor. A waste of $600.\012 ... 2002 Nissan Quest

I have a 2000 Mercury Villager Mini Van Sport. When I am in park I can rev the engine with no problens, when I put it in gear & push on the gas it spits & sputters & can't hardly get any speed built up. Sometimes it doesn't have any problem & then starts acting up again. Again its a 2000 Mercury villager mini van sport.


Have the fuel pressure checked if it is ok then you most likely have a bad cam or crank sensor.. is the check engine light on? that will help to pinpoint the issue. if no check engine light then most likely its a fuel pump. ... Cars & Trucks

How do i replace a fuel injector on a 98 mercury sable? also, how do i replace the mass air flow sensor? i'm pretty sure it's what i need becuse the check engine light came on, and i got a code. also, when i was driving, the engine didn't accelerate smoothly. it kind of lurched a little and didn't want to accelerate. i don't know where the injector and sensor are located. will i need special tools?


Ok,, look at your engine,, you will see a bar on it with 2 hoses connected on eighter side.. On this bar are 4 rubber plugs connecting to the engine.. unbolt the bar. Then pull it back.. See those 4 plug looking things.. Thats your injectors,, pull t ... 1998 Mercury Sable

I recently purchased a 1999 Bravda AWD w/ the smart trac system. It's been up until about a week ago. From 0-30 mph or so it hesitates while trying to accelerate. Mainly prominent when the engine is cold but gradually gets a tad better after engine seems to warm up. No matter if you slam on the gas and throw the pedal to the floor or a slow acceleration. The issue is rather annoying and from others i have talked with, i have 2 possibilities to diagnose...the fuel pump or the cat. converter. Pl


... 1999 Oldsmobile Bravada

Used Engines for 1998 Mercury Villager - Villager Mercury Cars & Trucks


You can always check ebay.com. You may also want to contact junk yards near you. It definitely isn't too difficult locating used engines. There are also a ton of websites out there that offer in used and rebuilt engines.Thank you,lee ... Mercury Villager

1999 mercury villager engine problems - Villager Mercury Cars & Trucks


... Mercury Villager

Hi..Im driving a Nissan Presea r-11 (1997). the issue im having is sometimes the engine turns off when im in low rpm and turning the steering. Also sometimes it stop accelerating even though im pushing the accelerator to the bottom and drops the RPM to 0 and cat stop moving but engine doesn't switch off. What caan be my problem? (I've been told that it might be air-flow sensor.)


I too be live first thing to check oxygen sensor, possibly fuel filter . Hope this helps some. ... 1996 Nissan 240SX

Diagrahm of 1995 mercury villager 3.0 engine - 1995 Mercury Villager


... 1995 Mercury Villager

Wha happen when the distributor start to fail on 2000 mercury villager ? well when start the engine, it coming on very well but after 15min the engine looks like out of gas and after 6min more engine is off by self. I READY BUY BRAND NEW FUEL PUMP AND INSTALLED BUT ENGINE STIIL DOING THE SAME PROBLEM. So know I am thinking in the distributor and arent sure, thank you.


It may do that. If it was bad, it wouldn't start. You would probably see lack of power, trouble starting. ... 2000 Mercury Villager

Why is there a loss of power on a 1993 mercury villager after engine gets warm


Very old vehicle, and highly likely it needs a new fuel filter and major tune-up (including all new spark plug wires, spark plugs, cap, rotor, and ignition coil). \012Verify proper fuel pressure at the fuel rail, and service fuel pump and fuel p ... 1993 Mercury Villager

1999 mercury villager knocking noise from engine


... 1999 Mercury Villager

I have a 1998 mercury grand marquis and I am getting very little power accelerating. When I try to accelerate quickly I lose all power so I have to slowly accelerate and when I go up hills it will slowly cause me to decrease in speed and if I push on the gas too far it will not have any power going to the engine. I can not reach above 55 going uphill and the only time i can get above 70 is downhill. what could be wrong?


Ok you want to check your back pressure. This sounds like an exhaust blockage. I would bet ont eh Catilitic converter.\015\012 ... 1998 Mercury Grand Marquis

I have a 1998 mercury grand marquis and I am getting very little power accelerating. When I try to accelerate quickly I lose all power so I have to slowly accelerate and when I go up hills it will slowly cause me to decrease in speed and if I push on the gas too far it will not have any power going to the engine. Its running codes PO171 and PO174. Egr valve and DPFE sensor were just fixed. Coils and plugs were just replaced as well. What could be wrong?


... 1998 Mercury Grand Marquis

EGR problem Hi there My 95 mercury villager has engine light on. I come to the shop for computer checking the mechanic said that EGR sensor problem. I go home and took out the EGR valve to clean up, after that,i start engine but it has rough idle and die when i apply the gear the car stop engine so i can not drive the car. Would you like to tell me what should i do an d what happen?


Your EGR is likely leaking at idle, this causes your symptoms, replace it. ... Cars & Trucks

I have a 1985 fleetwood brougham 4100 V8 engine. When i accelerate I have no power from 0 to 35 or 40 mpr. Then runs normal with plenty of power. What could be the cause of this problem? Also can you switch a 4100 engine with a 350 chevy or any other engine that will fit? Any help will be appreciated.


It could be a lack of gas. That is what it sounds like to me. I would recommend changing the fuel filter. Also look at your mechanical fuel pump. Check the psi and if it is above 30 then its fine. Reason i think it is lack of gas is. Your car has a m ... 1985 Cadillac Fleetwood

Engine ideling I have a 1999 mercury cougar 4 cylinder the problem is the engine accelerates without pushing the gas pedal and the the engine idel goes up and down can you please help me with some advices thank you.


Check for a vacuum leak around your intake probably close to the throttle body ... 1999 Mercury Cougar

Check engine i have a 93 mercury villager nautica version and the check engine light goes on and off, when you start the car it sounds fine but when you start accalerating it ont go more than 25km/h and the car has liek a shaky feelings and the engine sound slike its struggling, it goes on for about 10 seconds and then u have to push the pedal to the floor and sometimes it just wont stop n e helpp???


For 93 villagers, check for clugged EGR and PCV valve. 93 does not have the rubber piece that many posting suggested to check for other year models. Both PCV and EGR are hard to get to without proper lift and tools so I recommend to have a mechani ... 1993 Mercury Villager

1997 mercury villager, engine removal?


I have'nt done one myself but a friend tells me it is way easier to come out the bottom of the van.Just undo struts at the top ,remove brake lines undo motor mounts and remove framework bolt and take it out as a unit.Getting it up through to mo looks ... 1997 Mercury Villager

What size engine does a 2000 mercury villager have?


V-6 engine 3.3 liter ... 2000 Mercury Villager

Location of the engine diagnostic connector 1995 village mercury


The diagnostic connector is located on the engine near the starter. However, there are four connectors in that location and without pictures it would be difficult to determine which is the proper one ... 1995 Mercury Villager
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.1956 seconds