Having problems with your 2002 Jaguar S-Type ?

Where do I hook up the diagnostic controller to read codes?

\015 Engine has a miss in it and the engine light has come on and is amber in color.\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

There should be a connection plug under the dash near the steering column to plug your diagnostic tool into. This miss is usually caused by the coil, plug, or plug wire.
Repair Help & Product Troubleshooting for 2002 Jaguar S-Type

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where do I hook up the diagnostic controller to read codes?


There should be a connection plug under the dash near the steering column to plug your diagnostic tool into. This miss is usually caused by the coil, plug, or plug wire. ... 2002 Jaguar S-Type

1994 Chevrolet 2500 Trouble codes. I have a 94 Chevy 2500. I hooked it up to a diagnostic code reader, I got the following codes: 12: Diagnostic made;no distributor signal to electronic control module/fuel cutoff relay circut open or shorted to ground. 32: Barometric pressure (baro) sensor circut failure/ Exhaust gas recirculate (egr) valve diagnostic switch closed during engine start up or open when egr flow requested by ecm / Electronic vaccum regulator valve (evrv) error (evrv controls egr va


Hello! Have you received my comments? The reason I ask is that I'm receiving mail from you but it's blank...saailer ... Chevrolet C2500

1994 Chevrolet 2500 Trouble codes. I have a 94 Chevy 2500, it flashes error 3 across the dummy screen with the truck mileage. I hooked it up to a diagnostic code reader, I got the following codes: 12: Diagnostic made;no distributor signal to electronic control module/fuel cutoff relay circut open or shorted to ground. 32: Barometric pressure (baro) sensor circut failure/ Exhaust gas recirculate (egr) valve diagnostic switch closed during engine start up or open when egr flow requested by ec


DTC 12 - When terminals "A" and "B" have been connected, the ignition switch \015\012turned to the "ON" position with the engine not operating, the MIL \015\012(Service Engine Soon) should flash DTC 12 three times consequently. This\015\012 wil ... Chevrolet C3500

My climate control on my 1989 Cadillac Deville would only work on econ. Mechanic chnaged out my AC system and it wioked fine. Now the diagnostic reads low refrigerant (codes F46 and F47) but mechanic says it is charges. I can clear the error codes and the AUTO climate control works for a few days but then it gies back o to onbly working on ECON. I have cleared it several times and it works again. Mechanic has changed the rekay switch and still same problem. Any ideas?


... 1989 Cadillac Sedan DeVille

My 2009 impala service traction control light continues to come on which initiates the engine light to come on and says " Engine Power Reduced. I had this service earlier this year at the delearship and thought it had been corrected. When i hooked up the obdII it read a code 2187 TPS, and the dealer replaced the throttle body already. The chech engine light never comes on by itself, only when the traction control service light comes on. This problem is very annoying and i look forward to get


... 2006 Chevrolet Impala

I HAVE A 2007 CHEVY COBALT THE CHECK ENGINE LIGHT CAME ON I CHECKED THE COOLANT TEMP GAUGE THE DIGITAL GAUGE READING WAS ONLY SHOWING THREE BROKEN LINES. I CHECKED COOLANT LEVEL WHICH WAS FINE. ENGINE DID NOT OVER HEAT. I NEED TO KNOW IF RADIATOR COOLING FANS ARE CONTROLED BY COMPUTER READING ENGINE TEMP. I ALSO WANT TO KNOW IF TURNING ON THE A/C WILL TURN ON RADIATOR COOLING FANS. ALSO HOW DO I CHECK FOR DIAGNOSTIC TROUBLE CODES


I had this problem with a 2007 Chevy Cobalt. I changed the coolant sensor and even though the check engine light went out I still had a reading of "---" on the coolant gauge. The problem is most likely one of three things: a low coolant level, a bad ... 2007 Chevrolet Cobalt Coupe

I had a diagnostic test done and the results are codes PO607. The definition reads controle module performance Probale Causes 1-Cruise control swithc fault 2-Brake switch fault 3-Open or short circuit condition


My check eng. light will not come on, on the dash ... Toyota Corolla

The vehicle is a 1995 Mercedes c220 - 4 cyl gas. The a/c compressor is not coming on. The self diagnostic system run - I have performed with no fault code coming up. The fuses all are intact and show system voltage through all the fuses inthe main fuse block. My supposing is that possibly the evap temp sender has an issue and is stopping the compressor from coming on. I have also read about controller programing. And imagine that renewing the ETS is the first step in further identifying this pro


Low charge and 4 sensors most likely. Low pressure sensor, High pressure sensor , ac compressor cutout and 2 temp sensors. One outside by blower motor on inside for cabin temp. ... 2001 Mercedes-Benz C-Class

I have a 2006 Nissan Pathfinder while idling stalls, takes a long time to get it started again, but while running it has a smooth idle, runs for a couple minutes then shuts off. It was hooked up to a diagnostic machine, but read no codes, as if nothing is wrong???


... Nissan Cars & Trucks

95 Buick Lesabre, stalling and idle problems either too low,(stalling) or too high. Recently replaced TPS, fuel pump, strainer and filter. Runs great when check engine light is on but stalls or goes to very high idle when check engine light is off. Cruise control only works when check engine light is off but that's when I have the problems. Also, cannot read codes as you get an error when scanner is hooked up. Tried 2 different scanners. Any ideas?


Hi, have you checked the idle air control valve? It's right next to the TPS. Take it out and check the passages for blockage/dirt/gunk. There are some tests you can run on it. Sounds like it may be intermittent. On the OBD connector--are you usi ... Buick LeSabre

Whle driving my 04 diesel honda loses power and the VSA light and engine management light come on . When i turn off the car, it resets and the VSA light disappears but the engine management light stays on. When hooked up to a diagnostic kit it reads error code P2138? Can u help


Hey did you ever figure out what was wrong with your car? Mine is doing the SAME exact thing ... 2004 Honda Accord

I have a 2006 Nissan Pathfinder V6, it stalls while idling and take a long time to get it started again. Once its running, the idle is smooth and will run for maybe 5 min and shuts off. It was hooked up to a diagnostic computer and read no code, as if everything was fine. But this is the 4 time it has stalled in 2 days, sometimes it will start after 6 or 7 cranks, sometimes not at all. Thank You for your help


Sounds like it could be a weak or failing fuel pump.Change fuel filter and see if that helps. ... Cars & Trucks

I just changed the intake manifold gaskets,put everything back together right,marked the distributor while taking out,put back the same way.I fired it up and the Yukon 5.7 has like a rough idle and sort of a hitching under 2500 rpm I hooked a diagnostics tester to it and the code read 1345 and I dont have a guide to identify codes.What do you think???


... GMC Yukon XL

Check engine light on and was reading a p0505 code drove to the store and engine like started blinking got home hooked the code reader and now have another code of p0309 and p1399


Code 505 is a problem with the idle air control valve.Code 309 is noting a cylinder 9 missfire on engines with 10 cylinders which would not include yours. That may be a fluke or not the right number.Code p1399 is brand specific and for Honda ... 1998 Honda Civic

Reading codes We scanned our truck with the computer and it's reading was... P2104: throttle actuator control system forced idle P2110: throttle actuator control system forced limited rpm P0122: throttle pedal sens A CKT low input P0222: throttle pedal position sens/swb CKT low input P0223: throttle pedal position sens/swb ckt high imput I don't really know how to detect what these codes mean exactly. My truck went into failsafe mode. We changed the fuel filter and it ran fine t


Check the wiring to the throttle body, check the supply voltages as well. Check fuses too, it sounds like it received a voltage spike and then lost voltage and is now forcing limited rpm. ... 2005 Ford Expedition

Car problem Diagnostic trouble code using key on/key off method reads code 32 open/short in EGR transducer. pg 25-6 in factory manual. diagnostic trouble code page 21-107 says code 32 which is 2/4 hydraulic pressure switch in transmission. which is correct? Car drives good,shifts ok and gets 17-18 mpg in city driving. engine revs well ans develops full power. idle rpms are high 1100 should abt 800


... Chrysler New Yorker

Code pooo1 fuel volume regulator control curcuit open map sensor reading 99 this is on xtype diesel this reading is with just ingnition on when runnig reading goes up but never below 99 is map sensor faulty.also pecus e code on dash is this related thanks chris.


Hello! The PERCUS...E...Code is an Electronic Control Module (ECM) programming error or failure...The grounding may be at fault...Using an ohm meter set on X10 scale...Read from center of negative battery post to bare metal on chassis and then to eng ... 2003 Jaguar X-Type

The obd system cannot be read, no connection/reading when hooked up to a diagnostic system. one mechanic said his diagnostic system said he needed another cable. Is there a special diagnostic hook up for a 2003 saturn vue?


No there is a wiring problem with your OBDII Link\015\012or it could possibly be the ECM is bad.\015\012 ... 2003 Saturn VUE

01 kia rio has bad rings in the # 3 cyl. i've been just changing the plugs and adding oil as needed but now the same old process happens missing, check engine light, changed all the plugs and wires still missing, still reads a code. plugs are firing (i'm thinking timing belt but the miss is'nt that bad)how can read the code? some cars can be read without a diagnostic pluged up


Rent a scanner, they present more information better that blinking lights. If the engine has a lot of miles, the timing belt is probably ready to fail. The better answer to your problems might be finding a good used engine in a wrecking yard rather t ... 2001 Kia Rio

Need diagnostic codes read on 1994 nissan Pathfinder


You can retrieve the trouble codes from your '94 Nissan Pathfinder right from your home garage, saving yourself both time and money. 1994 Nissan Pathfinders come equipped with an on-board diagnostics 1 computer (OBD 1) that retrieves and stores ... 1994 Nissan Pathfinder

P0300 diagnostic code read on my car today, but didnt specify where it was coming from, the machine that reads the codes didnt feed from my car to the computer


I have a 2000 Oldsmobile Alera that has a diagnostic code p0300 random misfire, runs very bad change- ignition coils- spark plugs and boots for plugs. change catalytic converter, and fuel pressure is 50 to 60 lb. And my car still runs the same, HELP ... 1998 Oldsmobile Cutlass

2003 hummer h2 rear level control problem won't power up pump on its own. Pump tested ok and level system reads normal no current codes after ecm restt. Codes set CO 711 and CO 713 both level control curcuit problems


... Hummer H2

Will a faulty MAP Sensor on a 1998 Jeep Grand Cherokee cause problems with the Idle Air Control System? I am getting a P0505 diagnostic code and have changed the Idle Air Control Motor. Still receiving the P0505 code and have cleaned the Intake Maniford and trouble shot the electrical connections between the ECU and the IAC and have not found any problems.


YOU HAVE INTAKE VACUUM LEAK AT THROTTLE BODY OR PCM HAS FAILED.NOT CONTROLLING IDLE SPEED CONTROL CIRCUIT. ... 1998 Jeep Grand Cherokee

Po135, po141, po720, po721 po722 codes for 1999 Ford Econoline E250. Changed REAR OUTPUT SHAFT SPEED CONTROL SENSOR, OUTPUT SPEED SENSOR, SOLENOID TRANSMISSION, FUEL FILTER. Cannot figure out if the codes are tied together. Drove with scanner on data mode, the output speed was reading too low, would go to zero while driving. Been to transmission shop, replaced controller. Speedo does not function after the replacement.


... Ford E-250

The esp/bas light came on and has stayed on in my 2008 Jeep compass. My mechanic used a computer diagnostic tool and said the machine cannot read the Jeep codes. Why aren't these codes available to independent mechanics. I now have to take the vehicle to the dealer and pay 130 dollars for them to do the diagnostic.


It is the law that proprietary information on engine management systems and monitors is the right of the manufacturer exclusively for three years after manufacture. Tool companies took the manufacturers to court years ago to get them to release this ... 2008 Jeep Compass
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.8894 seconds