Having problems with your 2002 Honda Accord ?

I repaced the sending unit and the a new gauge i

\015 I repaced the sending unit and the a new gauge i stiil have problem not reading the gas\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Check the grounds to the guage and sender this is the #1 problem in automotive electrical problems
Repair Help & Product Troubleshooting for 2002 Honda Accord

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I repaced the sending unit and the a new gauge i

Check the grounds to the guage and sender this is the #1 problem in automotive electrical problems ... 2002 Honda Accord

1982 elcamino I have teplaced fuel sending unit 0-90 it matched the original perfect I checked the ohms to be sure. ground wire is well grouned to the frame. I thought old sending unit was the problems so i put it back togher same problem gauge goes to empty with the key on.then I ordered a new gauge put it on same problem . Are the gauges set for only 0-90 like a sending unit? some tanks are 17-22 gallon.

No they are all the same normally ,i would check for a feed to the gauge first and if it has a feed then check at the tank ,it could have a broken wire somewhere or a corroded connection under the carpet somewhere ... Chevrolet El Camino

I have a 1964 mustang with a six cyl. all gauges dont work. put in a new oil pressure sending unit, has a new fuel tank with sending unit,new temp. sending unit wires are all hooked up. I need help finding the problem

There is a voltage regulator on the back of the instrument cluster printed circuit board. Chances are this has burned out if no gauges work. You'll need to remove the instrument cluster to get to it. ... 1965 Ford Mustang

Fuel gauge registers empty with a full tank of gas on my 2001 chevy S10 Blazer, we replaced the fuel pump, sending unit. The new pump and sending unit came with a new wiring plug. We made sure we wired it correctly. All the other gauges work, checked fuses. We are not sure what to check next???? any Ideas?????

... 2001 Chevrolet Blazer

I have a 95 impala ss that has a new oil sending unit and a new fuelpump plus sending unit in the tank...now my first start takes a while to start but after it does it starts ok until it sets for a while. I notice my oil pressure gauge moving up as It turns over but it want start until it comes up so what do I do now?

... Chevrolet Impala

Put a manual gauge on my 1997 to read oil pressure, will get down to 10#, but not the zero it was showing on the dash gauge. what is the next option, new oil pump or perhaps a new electric gauge where the sending unit was. replaced them twice, but still showed no pressure at idle.

You can try a new oil pump, but in my 30 plus years 99 out of 100 your bearings are gone! you would have to pull the oil pan to do oil pump so i would pull 2 or3 main crank caps and check bearings if badly scrached or copper spots showing through ali ... 1997 Jeep Wrangler

I have a 1989 Chevrolett C3500. The fuel gauge started acting up, when the truck was full of fuel it would only read 1/4 of a tank and empty would read empty. I put the truck in the shop with a local mechanic for a bad fuel pump and told him to fix the fuel gauge as well. He installed a new fuel pump and sending unit. Now the fuel guage read full when the truck it full of fuel and 3/4 when the truck is totally out of fuel. The mechanic says there is nothing wrong with the guage or the new s

I would presume that the fuel sender unit is still at fault. Is it possible that this particular sender unit can be installed the wrong way around? The only style sender units have to be fitted at a particular angle.Your mechanic should check t ... Cars & Trucks

Put in new fuel pump and sending unit. but my gas gauge doesnt always work. sometimes is does and sometimes it doesnt

If it worked for a short period of time after doing the pump/sending unit the check the connections going to the pump/sending unit they would have been moved around doing the pump ... Cars & Trucks

1991 F150: my temp gauge max out put new sending unit in did ...

... 1991 Ford F150

Trying to hook up aftermarket fuel gauge but no power from new fuel pump sending unit any advice on this

... 1997 Chevrolet Blazer

My 1970 f250 is having a problem with its fuel gauge. I first assumed it was the pump and replaced it. But the gauge is only accurate if it is full or empty. That was the problem that it had before the new sending unit. So it will be accurate as soon as if fill up the truck, but no matter how much I drive it, the gauge will remain in the position as when it was filled. So not sure if it is the gauge or what.

... Ford Cars & Trucks

The temp gauge does not indicate any temp info. The gauge tests good on start up when the gauges all illuminate. I put an new temp sensor and thermostat in the truck but it still dosen't indicate a reading. Is there a separate temp sending unit on this truck or does the gauge get it's info off the temp sensor ECM info?

Did you replace the sending unit on the drivers side head between the number 1 and 3 spark plugs? That is the one for the gauge ... 1991 GMC S-15 Jimmy

Gmc sierra oil sending unit is new but the oil pressure gauge is high

... 2005 GMC Sierra

New fuel pump and sending unit. now gas gauge

If the gas gauge worked before i would just double check the connections to the fuel pump and make sure they are tight. ... 1990 Ford Tempo

1996 ford ranger fuel gauge stays on full . I had a new sending unit put in but did not fix the problem. Could the cluster panel need replaced? the lights by the fuel gauge and the lights by the battery gauge are not working also

Sounds like a short, check the wiring harness ... Ford Ranger

My gas gauge started working sporadically ,so i replaced the sending unit in the tank with a new one but the gauge still isn't working and yes the ground wire is on clean metal, also the other gauges are working, any help would be appreciated.

Check the injector ... GMC Sierra 1500


... 2006 GMC Envoy

1993 gmc suburban showing low oil pressure on gauge. at idle engine warmed up shows in the first red dash lines. tried new sending unit. gauge goes all the way to the right. no effect when plugged in or unplugged. even with old sensor. installed a temporary gauge. when warm shows 30 psi at idle

... 1993 GMC Suburban

1996 bonneyville,no gas gauge,new gas tank,new sending unit,new fuel pump,took car in they said it was the computer


'04 Land Rover Discovery-started out running hot-mechanic rebuilt upper end of motor(rebuilt heads,new head gaskets). Still ran hot-then he replaced thermostat. Still ran hot -radiator was cked-gases getting into radiator. Mechanic decided was a cracked head. Put a new head on it. After 50/60 miles ran hot again. Car gauge says "running hot" mechanic hooked up to computer which said was not running hot. Put in a new temperature sending unit -car still runs hot. Motor is a V8 4.6L 278CID. Pl

... 2004 Land Rover Discovery

97 s10 pickup 4.3 sending unit. purple to gauge black/white wire? my black/white wire has 5v at conector sending unit does your sending unit get volts. my ohms are correct on sending unit. nothing on gauge empty. when i shut the key off from on gauge goes to 1/4 tank. even when sending unit not connected goes to 1/4 with truck key out.can i test my cluster some how for my fuel gauge

Hello,\015\012It is ok for your gauge to go to 1/4 when off. It is even some what normal. The gauge is going to its neutral position. Keep in mind it is also comon for the sending unit to fail in this year / make of vehicle.\015\012 ... 1997 Chevrolet S-10 Pickup

Oil pressure I have good oil pressure but once it warms up the gauge clicks clicks clicks fluctuating, then it bottoms out. Engine still sounds strong, with maybe a little tapping when oil pressure is bottomed out. replaced sending unit, hooked external gauge and it is showing low to no oil pressure, had it in 2 shops, one couldnt figure it out other just wants to replace with a new engine at a cost of 6000.00 plus. two shade trees told me to change oil pump, a third says to check the pan for a

The oil pump pickup could have come off the oil pump, but u could fell it inside the pan through the drain plug, that is possible, but not very likely, try installing an aftermarket high volume oil pump, most ar ... 2003 Ford Ranger Regular Cab

My 1989 Ford Ranger 2.3L 2wd has a problem in the oil pressure area. The pressure gauge at idle says normal but when accelerating it goes past Low. I replaced the pressure sending unit and it didnt change the way the gauge works. The oil is brand new and the engine isnt making any noises like it has low pressure. What can I do?

I would take the sender out and install a temporary manual gauge (we use a manual SW gauge connected to a 3' length of 1/4" high pressure hose). If the oil pressure is normal on the manual gauge then about the only thing left is the gauge itself. ... Ford Ranger

I put a new sending unit in ti and a new wiring and pump but the gauge still ain't reading like it is suppost to

The guage itself may be bad, how do you know it is good? Can you check the resistance with an ohm meter, resistance should read on the high side. ... Ford F-150

Fuel gauge does not work replaced fuel pump and sending unit with new one and the gauge does not work still

Check this info for a better diagnostic and calibration: 93ZJ Service Manual / Secc 8E Instrument Cluster and Gauges I hope t ... 1993 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.5187 seconds