Having problems with your 2002 GMC Envoy ?

2003 gmc envoy, 4x4 problem

\015 Hi,\015\012\015\012the problem that i have with the car is when i tried to switch from rear wheel drive to all wheel drive, it felt like the front wheels were heavy when making turns. it got so heavy that broke the right side front axle. What can be wrong? thank you.\015\012\015\012Diogo\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Sounds like the wheel speed senser is not working properly when you are in all wheel drive the computer uses the brakes to keep the all wheels rolling at the same speed for good traction if one speed senser is reading that right side front wheel was going faster than the others it would activated that brake via the antilock brake system
Repair Help & Product Troubleshooting for 2002 GMC Envoy

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Transmission problems "GMC Envoy XL: 2003 gmc envoy xl 4x4 ...was driving and car" -- because it falls within my area of expertise. I just need a few more details about your situation and I will get to work! sitting beside road now


Do you have a question ? ... 2003 GMC Envoy

03 gmc envoy with 5.3 140000 miles. Oil pressure reading fluxuates between 0 and 40. When problem first started pressure read 80. When vehicle was new it stayed at midpoint (40) vehicle has plenty of oil. if you rev engine or increase rpms it goes to 0 and stayes there. let off and it jumps around like it did when started (0 to 40). No engine pecks while running. Display indicates low oil pressure and stop engine. orange light (check gages) comes on when at 0. any ideas. Service engine has not c


There may be a loose wire or the gauge or sending unit may be going bad. The first thing I would do is to hook up a temporary oil pressure gauge, not using the old one at all. With this watch gauge while driving and see what readings you get. If the ... 2003 GMC Envoy Xl

2002 GMC envoy SLT 4x4, tccm, switch problem


About 45% of all transmission problems are due to a defective battery, its components and the charging system. Make sure you have the correct battery in the vehicle and inspect all items relating to the charging system and the battery. The vehicle sh ... GMC Envoy

2003 gmc envoy 4x4 problems. 4200 vortec engine. my front diff doesnt seem to be


... 2003 GMC Envoy

2003 gmc envoy 4x4 problems. 4200 vortec engine. my front diff doesnt seem to be working


... 2003 GMC Envoy

2003 gmc envoy, 4x4 problem


Sounds like the wheel speed senser is not working properly when you are in all wheel drive the computer uses the brakes to keep the all wheels rolling at the same speed for good traction if one speed senser is reading that right side front wheel was ... 2002 GMC Envoy

I have a 1990 GMC Z71 4X4 with a 350 TBI 217K my problem that I cannot figure out is after giving the truck new plugs, wires, cap, rotor, coil, TPS and vac. line, O2, Map sensor and vac. line, air cleaner gasket, fuel filter--NO EGR on motor.. The truck just doesn't want to go once it hits second and will burp through the TBI leaving the truck with very little power getting to speed. Had timing check by a local and said it was off 3- degrees, returned it back to 0, and truck ran worse. I can hea


Yes use a cable comalong. as for you motor can you hear the vavles rattling with that many miles ur heads may be getting bad if the vavles don't open enough i could see it not running right ... 1990 GMC C1500

My 1999 GMC Jimmy 4X4 does not engage when I put the button on HI 4X4 or Low 4X4. What is the problem' When I engage the 4X4. Then where should I go to fix the problem. Thank you


You might have an actuator out, some of those have a shifter, but a solenoid still has to be actuated ... 1999 GMC Jimmy

Problems with gmc envoy


... 2003 GMC Envoy

I have a 1995 gmc jimmy 4x4 4.3l and I am having problems with the 4x4 .ok here's what my problem is When ever I switch in 4 lo or 4 hi The 4 hi don't seem to engage And the 4 lo engages and the engine light comes on all the while the wheels start turning with brakes applied I can feel the rear tires spinning and when I drive in 4 lo it feels like it sputtering can anyone tell me what's wrong The actuator underneath the battery is working fine and still good is it the transmission going out?


The actuator under the battery runs the engagement of the front Diff .If 4 - wheel low is working and high is not then that is a linkage adjustment problem at the transfer case or a internal problem with in the transfer case not the transmission . T ... Cars & Trucks

2002 gmc envoy radio problems - 2002 GMC Envoy


... 2002 GMC Envoy

Ac clutch problem for 2002 GMC Envoy - 2002 GMC Envoy


... 2002 GMC Envoy

2005 gmc envoy 4x4 not workin - 2002 GMC Envoy


... 2002 GMC Envoy

Rpm gauge on gmc envoy 2004 problems - 2004 GMC Envoy


... 2004 GMC Envoy

2002 GMC Envoy overheating problems - 2002 GMC Envoy


Check antifreeze ... 2002 GMC Envoy

4x4 problems I drive a 2003 gmc yukon. I have problem with the 4x4


... 2003 GMC Yukon

Common problem of 2005 gmc envoy xl 4.2 - 2005 GMC Envoy


... 2005 GMC Envoy

Transmission problem I just bought a 2009 GMC Envoy with 48 miles on it....still has 10 day plates. When I press on the gas after being at a stop, the truck will not shift into first year. The dealership says there is no problem with the transmission and the computer says there are no problems. They did take it for a ride and the problem did happen to them but they still say they do not know what the issue is....it's been a week. What is wrong with this piece of junk.


The governor in the transmission nedds to be removed and cleaned,there is a piece of trash ,that is really small,lodged in the governor valve.The governor controls the gear selection for the speed of the vehicle. ... 2009 GMC Acadia

Transfer case problems on a 2000 GMC Sonoma 4x4 sls 5-speed manual tranny -- 4.3 litres engine. 3-way switch. History -- over the past 4 years in winter, wouldn't switch into 4high setting for 4x4. Drove for a bit and then when warmed up or moving switched back and forth normally. Last winter ago, switched into 4 high ( 4x4) and terrible sounding gear noises resulted when stepping on gas. Down hill at a coast no noise ( only under load ). Jacking up vehicle and running all 4 tires ( 4x4 ) rev


Since the noise appears only at load it means that the bearing supporting the front shaft is pretty much destroyed. There is no noise when there's no load because the few remaining ball from the bearing are still doing what they can to keep the shaft ... GMC Sonoma

2006 GMC Envoy has 2 problems. I thought the alternator was going bad because of some battery problems. Pulled it out and had it tested. Nothing wrong with it. The biggest problem is a loud whine when I accelerate. Could it be another pulley? When I was working it I noticed the smell of fuel. When I started it there was a small amount of fuel spraying above the alternator. What could it be?


The whine could be a pulley, start the engine, raise the hood, and then rev the engine to see if you can duplicate the noise. It could be a weak belt, or a bad bearing in either the alternator, or a pulley when the engine is under a load. Check your ... 2006 GMC Envoy

97 gmc suburban, no start, has spark and fuel. no codes. scanner shows no problem, except cam ******=0 knock ******=0 and spark ******=0 doesnt show inj. pw. leaning towards pcm??any help would be great


... 1997 GMC Suburban

Hi,,, i have an envoy gmc xuv 2004 ,, all the sudden i got hestitations in the engine,, first i thought it is a fuel problem,,i changed the fuel filter and the air filter but the problem still there, it happens when i press hard on the gas ,,if i adjust the gaz pedal on a certain speed i dont feel it ,,what should i do????? what do u think might be an electrical problem caused by the coils , or spark plugs,, thank you and your help will be greatly apperciatted,,,,,,,,,


I had a problem with my 2004 envoy where it would not go when pressing on gas. It seemed as though I were tring to pull a heavy trailer behind me but I wasnt. I found out that my catalytic conveter was cloged up. I replaced it and all is good now. ... 2004 GMC Envoy

I have an 1994 GMC sierra 1500 4x4 and it has a lever to shift it into 4x4 hi or lo or 2 hi. I can shift it into any position but my front tires do not turn only the back ones! what could be the problem?? pleas help me cause I live in an area where I regularly have to use the 4x4 and I have been getting stuck in many places.


The front axel control solinoid is not working, it's on the right front side of the front axel, it most likely the cause [ commom problem]. it's easy enough to replace, it just unscrews from houseing. good luck. ... 1994 GMC Sierra

2003 GMC Sonoma ZR2. I just bought this vehicle and have been reading forums about common problems. I had the faulty transfer case vacuum swith and put a new one in today. I blew the line out form the 4x4 actuator under the battery tray, the HVAC line up by the brake master cylinder and the vent tube. They all had some fluid in them. I haven't had any problems with my HVAC. Should I do anything else to prevent future problems or leave it alone?


... 2003 GMC Sonoma Extended Cab

4x4 Problems I have a 99 GMC Jimmy with push button 4x4. Placing the car in nutral followed by pressing the button it doesn't flash like it used to just lights up the next setup 4x4 hi. You can hear the transfer case locking in but front tires don't move. The transfer case is getting vaccuum. Drive shaft going to front axle does spin. The Vaccuum actuator under the battery tray is working normal no cuts or anything. Also cable from vaccuum line is not broken. Did check to make sure the actuator


Sorry lost here ,never seen one but if transmission shaft is turning to front diff then the problem is their,could be anyting from a sheared diff pinion to a broken planet wheel or possible evan a snapped half shaft or the spline on the end of the ha ... 1999 GMC Jimmy
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.9621 seconds