Having problems with your 2002 GMC Envoy ?

How to change the wiring harness in a 2002 envoy headlight housing

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2002 GMC Envoy

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to change the wiring harness in a 2002 envoy headlight housing


... 2002 GMC Envoy

Headlight harness passenger headlight dim replaced 9006 bulb did not change still dim noticed to bare wire in loom cut out bare wire section and rewire still dim passenger side only does any one have any suggestions right now i fear my only choice is rewiring


... 2000 GMC Jimmy

I have a 93 toyota camry xle v6,i am taking the motor out so i can replace transmission,i am stuck on how to take off the wiring harness under the intake or throttle body?Do I have to take throttlebody housing off before I can get to the wiring harness?also if I was just changing sparkplugs on that side,how would you get to it?


Yes you do have to take the throttle body off to get to the injector wiring. The plugs on the back side are very hard to get to. You have to take loose the back motor mounts and tilt the engine forward. ... 1993 Toyota Camry V6

Saturn Outlook 2009. How to change a low beam headlight wiring harness.


... Saturn Cars & Trucks

Appears like the small wire headlight holding bracket came off of the plastic housing that holds the bulb in place. This occurred when changing the bulb. I can push it back on but not sure if this will shake loose after a while? Is this now damaged or can I possibly apoxy it back on, or maybe even screw it to the housing unit....or ? Seems like the bulb has been replaced often and is worn. Thanks Bill


You should be able to epoxy that piece back on, just make sure there isn't a opening into the housing as this will let water in and will burn out the bulb contuinally. That's what seems to been happening as you noticed alot of activity on that light ... Hyundai Sonata

I have a 06 town & country with a four pin wiring harness. Our pop-up camper has a 7 pin round plug. I used an adapter to connect them but it caused a blown fuse; was told by shop that would have to change wiring harness for van or camper. I am planning on changing the van's wiring harness to 7 pin round. Would appreciate any advice as perhaps link to harness that is known to be compatible with 06 t&c.


I'm assuming your pop up is big enough to have electric brakes, thus the 7 pin connector. If it doesn't, you can use an adapter (probably like you have) provided the 4 pin was wired correct in first place, but if not, figuring out what's what, should ... 2006 Chrysler Town & Country

While attempting to change stereo on my volvo 940 turbo I cut wire harness now headlights wont come on


Ok that problem is where u cut the wires on the rdaio harness u cut is a dimmer wire for your lights on the radio need to figure out which if u have a autozone or advanced parts store they have a radio wire harnes kit has all color code and wire colo ... 2007 Avanti Convertible

I have a 2006 Grand Cherokee with a auto trans. I have a leak on the right side of the bell housing above the pan. It appears to be from the wire harness seal. My question is how do I change this seal?


U replace the plug adaper it comes with the seal. If u have a NAG trans u have to take it to the dealer to adjust the fluid level. The plug is held in by a 7mm bolt use a 1/4 inch rachet with a small extension never remove the plug hot u will damage ... 2006 Jeep Grand Cherokee

1997 pontiac sunfire, i have a 2 pin connector loose, but i dont know where it goes. it is on the passenger side close to headlight, all lights work. it is a black and yellow wire taped in the harness that holds the connection that goes to the radiator. having trouble with the cooling fan not coming on, checked fan motor, changed the coolant temp. sensor, havnt driven it yet, was wondering it that could have anything to do with the fan


There is a yellow and black wire in the wiring diagram that is for the low coolant sensor in the overflow tank. Your model may not use this sensor. ... 1997 Pontiac Sunfire

2006 Envoy XL low beam headlights will not come on at all. Went to Auto Zone and change the bulbs...still will not come on. Two weeks ago Pep Boys put in a new ignition stating the original one had sign of burning coil wire. Since then there is a little beep when I turn off ignition and now my low beam headlamps don't work. HELP


... 1996 Dodge Intrepid

How do i change the headlight wire harness in 2000 ford escort


... Cars & Trucks

How do i change the wire harness for the headlight


Welcome to FixYa.com\012Buy the repair kit for the head light at the dealer and cut one wire at a time and splice one at a time to not crimp the wrong wire. Yes you will need a wire crimper.\012\012Thank you for using FixYa.com, ... 2005 Mitsubishi Endeavor

How to change the headlight wire harness on a 07 pontiac g6


... 2007 Pontiac G6

I changed the whole exhaust system-including 02 sensors,now my kia will sometimes buck and stall,when it stalls it wont start,just crank.i changed the cam & crank sensors,ecm,fuel filter,coils,spark plugs and wires. i also went through wireing and cleaned connectors and grounds. also now (sense changing exhaust)if i run all electical thing-headlights,ac,radio,wipers,etc...,my headlights dim,wipers move slow and radio goes off. im at a loss,this shouldnt have happened by changing exhaust. please


It sounds like you covered many of things..\015\012\015\012The engine's main ground..\015\012There is a open metal braided wire that runs from the engine to the chassy/frame.. They can fail and still look ok,, and need ... 1999 Kia Sportage

My wiring harness to the headlight switch has melted and now the connections for the headlight wire does not stay connected very well causing the headlights to turn off periodically. How do I fix the


... 1995 Dodge Dakota

I was driving my 86 2.8 fiero a couple of months back my oil line broke the wiring harness that travels to ecm caught fire i towed it back to my place changed the oil line repaired burnt wires one at a time changed the oil when i started it i noticed the exhaust sounded louder and it only had half the power it use to so i changed plugs,wires,cap,rotar,when i tested it code 42 showed up electronic spark timing also changed ignition module,and pcm still runs the same if anyone can give ideas i app


It almost sounds as if the cpu in the car was damaged do you have a lotus tester i doupt this is the problem put check your fuses also ... 1986 Pontiac Fiero

My 91 chevy 2500 4x4 will not change gears we had the tranny rebuilt and still will not change I was told that the wiring harness was bad and that I need to run a hot wire in order to make it change gears, I was told it is electronic shift? What wire do you hook on to in order for it to have fire I need a wiring diagram


... 1991 Chevrolet Silverado 2500

Hello, well on my passenger side, my low beam headlight is out, i tryed looking at the wires and fuses but it all looks fine....well the thing is while back my old harness for the low beam was burnt and cracked so i cut it and replaced it, while trying to take it out i think i pulled to hard on the harness wires, could this be an issue of whats going on with me headlight low beam?


Check the connection between the new harness and the old wires for good contact. If you have a multi meter, you can check to see if you are getting voltage, as you wiggle the wires. you can also use an inexpensive 12volt test light to do this. Also d ... 2000 Buick Century

Change Dodge Ram tail lights from 2005 to new 2008. The wiring harness to change from the 05 to the updated 08 are different. Is there a adapting wire harness from dodge for this?


I just got a pair of 2008 tail light lens for my 2002 Dodge Ram 1500. If you look under the rear there is a connector that runs up to the tail light. This is a small harness. I believe that all you need to do is purchase the 2008 tail light harness. ... 2005 Dodge Ram

Installed LED Halo Projector headlights in my 05 Impala but encountered an issue. The front left and right turn signals fo not work. All other lights work. When using the turn signal the indicator and rear turn signals blink really fast. The bulbs do work. Wiring- the power cable that runs fro, the hi/low beam is connected and linked into the cars headlight connector (power cable- yellow wire) the turn signals have a harness that connects to the stock harness coming from the car. Any clues,


... 2005 Chevrolet Impala

How do you unplug the headlight retractor motor wiring harness on a 1995 miata?


... Mazda MX-5 Miata

How do you unplug the headlight retractor motor wiring harness on a 1995 miata?


... Mazda MX-5 Miata

Hi Colin! I had to change the tail light circuit board and the wiring harness on my 94 jetta. Now I need to know how the wires fit back into the harness. There's 2 harnesses: one holds 4 wires and


... Cars & Trucks

I just installed a Sony cd deck into a new 2009 hyundai accent. I spliced the harness onto the built in harness supplied with the car. I cant get the stereo to power up unless the headlights are turned on. I used the wire color code from an online site that seemed to make sense. basically red to red, black to black but I did not ground to frame. I just used the black wi re from the harness. I did not confuse the red and black speaker wires with the power and ground wires.


You should never us the information that you find on line. Every so often about twice a year car manufactures change the wiring a bit. Due to changes in the system , problems with supilier issues ect. What you should have done was purchased a Metra c ... 2009 Hyundai Accent

I need the wiring schematics for the range sensor/neutral safety switch, for a 2003 ford windstar. my brother cut the original harness plug off & replaced it with a different one that has different colored wires, i was having a connection problem & me not knowing he had changed it with a different color code wire plug i disconnected all the wire to fix the connection, when i was going to put it back together i came to find out that the vehicle harness & the plug had different colored wires & now


... Ford Windstar
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.7106 seconds