Having problems with your 2002 Chrysler Town & Country ?

2002 chrysler town and country won't crank

\015 Van won't crank. Thought it was starter and removed and brought to advance and they said it was good. Battery and starter relay is good. I jumped neutral safety switch and still nothing. Also everything inside works. I'm stuck\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2002 Chrysler Town & Country

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 96 chrysler town and country 3.8. engine will crank, wont fire. about a year ago I replaced the feul pump and filter, I know its getting gas. replaced the coil pack and the crank shaft possition sensor. getting the 5 volt marker voltage on the plug for the coil pack but nothing else on the other 3. turn the key on and the check engine light does come on. checked for codes on the OD. gave me code 999. cant find a record of code 999. located the ASD Relay under the hood and swapped


... Chrysler Town and Country

My 2003 chrysler town and country wont crank


... 2003 Chrysler Town & Country

2003 dodge minivan cranks but wont start - 2003 Chrysler Town & Country


... 2003 Chrysler Town & Country

1997 chrysler town & country was cutting out,died,now wont start


You need to put a scanner on it and see what code comes up.\015\012my guess would be the crank sensor which is very common . ... 1997 Chrysler Town & Country

TOWN AND COUNTRY SLIDING DOOR WONT UNLOCK - 2006 Chrysler Town & Country


... 2006 Chrysler Town & Country

2000 town and country wont cold start - 2000 Chrysler Town & Country


Assuming the check engine light is not on, I would check the fuel pressure with a gauge before and after startup.Could be a fuel pump relay or the pump, among other things. ... 2000 Chrysler Town & Country

Wheren is crank sensor 2004 town and country - 2004 Chrysler Town & Country


... 2004 Chrysler Town & Country

Remove crank pulley 2002 town and country - 2002 Chrysler Town & Country


... 2002 Chrysler Town & Country

2003 3.3l chrysler town and country wont start


... Chrysler Cars & Trucks

Chrysler town and country 2005 dvd player wont


... 2005 Chrysler Town & Country

I have a 2005 chrysler town and country and my drivers power seat wont recline backwards, it will go forwards and all other buttons work but it wont go back and i need it to soon.


... Cars & Trucks

Starting problem I have a 1999 Chrysler town & country 96,000 one owner miles, will crank 3 times, shut off immediately, the 4th time it won't do anything. Let it set for a while, it will crank up and go on.I have tried about everthing, been in dealer 4 times, they can't fine the problem. Any help will be appreciated.


My van is doing exactly the same thing. It will crank, then cut right off, after I try 3 times it doesn't do anything. After that it may not start for a couple of days, but if I leave it alone after the first or second try it may start back in an hou ... 1999 Chrysler Town & Country

1996 chrysler t&c 3.3 will not crank - 1996 Chrysler Town & Country


If only clicks then yuou need a starter ... 1996 Chrysler Town & Country

My 93 chrysler town and country ran out of gas i added 3 gallons of gas still wont start turns over but wont start?


Add another two or three. your fuel pump sits in a module which has a valve on it to let gas in, but as the car gets older that valve needs more weight to open and let gas in. this module is about 12" high, so if you fill the tank you will definitely ... Cars & Trucks

There are dvds stuck in my 2006 chrysler town and country multi disc dvd changer and the dvd screen wont turn on, is the reason the screen wont turn on because there are discs stuck in there?


... 2008 Chrysler Town & Country

My 2001 chrysler van wont go in reverse - 2001 Chrysler Town & Country


... 2001 Chrysler Town & Country

Describe your 1999 Chrysler Town & Country Problem-Won't start up all the time, takes me 7-9 cranks for it to start. sometimes it starts with no problem at all. Someone told me my battery was too small for the size of the vehicle. Starter was replaced 3000 miles ago. Battery sounds like its dying after repeated cranks to get it started sometimes. Three hours later I start it right up.


Does it not start hot? if so it sounds like a crank sensor ... 1999 Chrysler Town & Country

I have a Chrysler Town and Country which shuts off completely while driving. The last time was a 70 MPH and I had to very carefully make my way to the right land and then to the shoulder of the road. The speedometer read "0" and the gas gage read "0". After pulling over the care started right up. This is a dangerous situation. It has been in the dealership three times and checked completely with no results. The first time it happened at city speeds.


Your ignition lock is the most common issue, its the thing you stick your key in. it could be a wire thats shorting out or the whole lock cylender is worn so it could be sending "kill engine signals" at the wrong times, either or, this should be a pr ... 2007 Chrysler Town & Country LX New Cars

MY CHRYSLER 2002 TOWN AND COUNTRY VANS ENGINE BROKE DOWN SO I GOT ANOTHER ENGINE PUT IN 3.3 V6 AND ALSO HAD TO CHANGE THE IGNITION KEY CYLINDER AS THE KEY WAS LOST NOW THE ENGINE WILL NOT CRANK THE IGNITION LIGHTS COME ON SO DOES THE COMPUTER RED LIGHT I GOT A LOCK SMITH TO LOOK AT IT HE TRIED TO PROGRAM THE COMPUTER AND MAKE A COMPUTERIZED KEY BUT IT STILL WOULD NOT WORK BNO SOLUTION THE MECHANIC WHO PUT THE KEY IN SAYS THE ENGINE DID INITIALLY CRANK SO WHAT DO I DO


Sorry its a dealer only job ,the key has a chip in it and without this chip then your just wasting money ,The immobilisor software is encrypted so only a dealer can programme it ,even on a ten year old vehicle so whilst it is in the dealer get the tw ... 2000 Chrysler Town & Country

Transmission i found a transmission from a chrysler t c 97 and is exactly the same........i just try to make it work.......it fits pretty good........but it wont get start ............just started at the very begining for a few seconds........and then nothing happen.................my email is [email protected] and im from el salvador.......thanks....the starter sounds to work pretty good.......and my chrysler is a town and country 99 lxi v6 3.8....


Make sure the shift linkage is in park or neutral, you might just need to adjust the linkage! ... 1999 Chrysler Town & Country

Have a town and country 94 3.8 it wont start. Acts like a lean condition. Pops by the intake. I crank it it turns but it wont stay running. new O2, checked TPS good. what else should I check?


VACUUM LEAK AT FUEL INJECTORS OR VACUUM LEAK AT INTAKE MANIFOLD OR STICKING INTAKE VALVES. ... 2000 Chrysler Town & Country

2002 chrysler town and country wont leave limp mode


Try getting a new shift solenoid for it. i had the same problem on my 2002 chrysler town and country and my plymouth breeze which is also a dodge product. it is very simple to do and doesnt take all that long. the part will probably run you about 150 ... 2002 Chrysler Town & Country

2003 chrysler town van and country won't crank


... Cars & Trucks

1996 chrysler town and country wont start


... 1996 Chrysler Town & Country

1996 chrysler town and country,wont start


... 1998 Chrysler Town & Country
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.2059 seconds