Having problems with your 2002 Chevrolet TrailBlazer ?

Need to fill Front differential

\015 How do I fill Front Differential?\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

If you look on the back of your front diff, you will see two plugs, one located on the bottom (for draining only) and one mid way up for adding. Good luck!
This answer is great for my front differential. so how do i do the same, to nthe rear differential? i hope we are both referring to maint on a 04 kawaski prarie 650 4x4 atv. thaanxxxx!!!!
Repair Help & Product Troubleshooting for 2002 Chevrolet TrailBlazer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need to fill Front differential


If you look on the back of your front diff, you will see two plugs, one located on the bottom (for draining only) and one mid way up for adding. Good luck! ... 2002 Chevrolet TrailBlazer

I need to change the front cover on my front differential for a chevy 2500 4x4 8 bolt hub, have a another front differential from similar truck, but cannot figure out how to get the gears out of it, how does one do that?


You have to pull out the front axles to get the gears out of the differential ... 1990 Chevrolet K2500

Ford ranger front differential diagram --- I need to replace the PTO shaft and front bearing/seal and need a schematic diagram


... 2001 Ford Ranger Regular Cab

HI I HAVE A 2001 CHEVY S10 4X4 4.3L. I NEED TO KNOW HOW TO GET THE FRONT DIFFERENTIAL ACTUATOR CABLE OUT OF THE FRONT DIFFERENTIAL. I CANT SEEM TO FIND A RELEASE FOR THE CABLE AND I DONT WANT TO PULL TO HARD AND BREAK IT. PLEASE HELP.


... 1989 Chevrolet S-10 Blazer

I need a front differential, how much labor is involved? I have a 98 jeep cherokee, and need a front differntial, about how much labor will be involved in replacing this?


You can usually locate a good used differential for between $150 and $250. New units are very expensive. It isn't a terribly difficult job if you have a half-way decent set of tools and some time. It takes about a full day to do the job on the ground ... 1998 Jeep Grand Cherokee

Jeep Wrangler 1998 straight drive has difficult times going into reverse gear. I don't drive it every day,usually towing it behind my RV. It seems better when I drive it more,but is still difficult to do.Transmission shop checked it without removing engine and thought it was due to iinactivity.Jeep dealership flushed standard shift transmission and filled with new fluid.Also flushed front differential,transfer case,rear differential and filled fluid. Still the problem persists. .


If this is a 5 speed manual transmission...all you need to do before putting your jeep into reverese is puting it into first gear and then shifting it to reverse to avoid any grinding or problems shifting into reverse...this isn't a problem just a po ... 1998 Jeep Wrangler

How to change front differential oil on 1999 ford explorer eddie bauer, I apply gas and get up to about 40mph let off gas and I here a gear noise only upon deceleration. The vehicle has 150,000 miles and I believe never had dif fluids changed or transfer case. It sounds like noise coming from front of vehicle, front dif or transfer case. The front dif is tightly packed into the front end and I cannot even see a fill hole to try and **** out the fluids and of course there is no drain plug and tak


... 1999 Ford Explorer

I have a 1991 Lincoln Contenental and replaced the rear struts with conversion springs. The front still has the air suspension. The guy that replaced the rear struts unplugged the actuotor so no air is going to the front. I just need to locate the actuator to see if it will fill the front struts again.


It is on the strut along side the air spring you should be able to see the air line going to it and the connector. off white color ... 1991 Lincoln Continental

I get an intermittent knocking sound from the front undercarriage area of my 2005 Yukon Denali. The dealer has replaced the left front hub assembly and rebuilt the front differential but the same knocking sound occurred again today. It only lasts for about 30-45 seconds but it's quite loud and unnerving. I need help on this. Thanks.


You would have thought that the dealer would have see some thing, but what it sounds like is that one of the brake pads is loose in the caliper mounts.\015\012\015\012if you remove the wheel and take a screwdriver and slide it into the ba ... 2005 GMC Yukon Denali

I am having problems with my 2000 Mercury Mountaineer front differential. I removed the front drive shaft to see if I could just resort to having rear wheel drive, but that was not the case. My front wheel will not move at all because of the damaged shown which is what I figure out. Need opinion or expertise to enlightened me on my options that I believe I do know already, but seek a second opinion. Thanks to whom ever may respond!!


... Cars & Trucks

Need to know where the fill plug is for the rear differential


Generally if it's not on the rear cover, you will find it on the front of the center section (a 1/2" square plug, either male or female) ... 1996 Chevrolet C/K 2500

I need to remove the pinion shaft from the spider gears in the front differential on a 2004 dodge ram 1500


... 2004 Dodge Ram 1500

Need infor for Oldsmobile Bravada 300 SUV R&R front differential


This is a HUGE job that will require mechanical skills and a goo repair manual. This question can not be answered in it's entirety in this post. ... 2000 Oldsmobile Bravada

Need diagram and specs for front differential on a 2003 denali


... 2003 GMC Yukon Denali

How to fill the front differential fluid Hummer H3


... 2006 Hummer H3

Need to remove inner front axle from differential to put new cv joint on


... Dodge Ram 1500

How much will it cost to replace my front differential in my 2002 subaru outback sport wagon? Can i just replace my differential or will i need to replace the whole transmission? Eliza


... 2007 Subaru Impreza Outback Sport Wagon

I need to replace to front differential on my 2004 chevrolet k1500.what all do I need to know?


It is a fairly simple procedure. remove the axle flange bolts. driveshaft,electrical plug and 4 bolts holding diff to frame. ... 2004 Chevrolet Silverado 1500 Crew Cab

I was told I need to replace my front differential on my Lincoln Aviator. The seal was missing and all fluid came out and how pin is damage and it needs replacing and is costing me 900 dolars.


Hi, Sorry to hear of the problem you have.If all the fluid did indeed leak out, and the Lincoln has full time all wheel drive, and the vehicle was driven with the front differential dry , the sad news is the bearings will have been scored ... 2003 Lincoln Aviator

I need to remove the front axle out of the differential on a 2003 Dodge Ram 1500? What is the best way to pull it out. I already have the half shaft taken off I just cant get the solid axle out of the differential. Its on the driver side.


When removing the front axle i believe that you must open the front differential cover and inside the dana you will see a small 8mm bolt located on the spider gear center it holds the pin bar in place and the pin bar holds both the upper and lower ge ... 2004 Dodge Ram 1500

The side wall of my transmission has come loose. I think it missing a bolt on the right side if you are looking at it from the front. My wife ran over something, and it bent it a little bit. I have some JB Weld and was going to fill the gap when I noticed that a bolt looked to be missing what I need is a diagram so that I can see what size bolt I need. It is a 1994 Honda Civic SI. It is a manual transmission


Remove one of your tranny bolts, Use it to match one at a automotive store. ... 1994 Honda Civic

I need to know what kind of differential fluid is used in a front 4 wheel drive differential in a 2006 ford explorer V8


Check your owners manual under fluids and capacity ... 2006 Ford Explorer

I need to replace the starter solenoid contacts on my 1993 Toyota pickup. The starter is located above the front differential on the right side and the space is very tight and I don't see how I can get my hands into the available space or even see the end of the starter motor to remove the end cap to get at the plunger. The parts man at the Toyota dealership gave me a diagram which showed how to get into the starter motor to replace the contacts. Does the vehicle need to be raised on jack stan


Starter removal is not fun the first time, or the second time, but the third time it's a cinch. \015\012\015\012When you pull the start out you really ought to change the fuel filter while you're in there. There's one bolt holding on the ... 1993 Toyota Pickup

I removed the 4wd actuator on my 1997 1500 gmc located on the front differential and pressed the 4wd hi button in the cab. The actuator traveled out. I then pushed the device inside the differential housing and wiggled the driveshaft until the spring loaded device moved inward an inch or so. I then pressed the 2 wd button and the actuator retracted. I put the actuator back in and pressed the 4 wd hi button but still no 4 wd. Need help.


... GMC Sierra 1500

I can't get the front differential out of my 1995 S-10 pickup. It is free from all other parts (axles, u-joint, frame, etc), but I cannot get it to drop. Do I need to lift the engine to create the space needed? I'm stuck and have exhausted every idea. Please comment, I'm at wits end.


Yes you need to lift the engine a bit to get that front differential out, the best way is to take the center bolts out for the motor mounts (i'm pretty sure its set up that way) if its not, just un-bolt the mounts lift the engine with a jack and a bl ... Chevrolet S 10
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.0242 seconds