Having problems with your 2002 Chevrolet Tracker ?

2002 chevy tracker idle air control valve - 2002 Chevrolet Tracker

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2002 Chevrolet Tracker

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2002 chevy tracker idle air control valve - 2002 Chevrolet Tracker

... 2002 Chevrolet Tracker

Our 2003 Chevy Tracker stalls after 20 minutes whether it is in Idle or not. I have cleaned the Idle Control Valve and replaced the fuel pump. No code is coming up and no lights on the dash come up prior to the stall. From what I understand I should be getting a P340 or P341(?) for the Cam Position Sensor. My son poured water on the Idle Control Valve and it started up immediately. Makes no sense. What is your opinon.

... 2003 Chevrolet Tracker

I have a chevy silverado - 5.7 engine. It runs rough, wont idle and most time dies unless i pop it in neutral, shakes and sputters when i accelerate and not much power. I have replaced the air filter, gas filter, ERG valve, ERG relay, spark plugs, wires, rotor, cap, PCV valve and hose going from PCV to intake and vacuum hoses on intake. I have tested the throttle position sensor and idle air control valve and appear good according to the service manual. Any other ideas?

Fuel Pressure/Pump?Injectors?Fuel Pressure Regulator?Are there any codes/check engine light?Ignition coil? Just off the top of my head. ... 1995 Chevrolet K1500

I cleaned my air intake with an air intake cleaner. I put everything back together except the tube coming from my mass air flow unit to my right side valve cover and put about 100 miles on it. It now is idled up very high. My truck is a 98 chevy z71 with a 5.7 Did i harm my idle air control?

When you put the tube back on does it still idle high? it seems like you have a vacuum leak somewhere ... 1998 Chevrolet C1500

I have a 1990 chevy corsica lt 6cyl 3.1 multi port fi dis ignition. the problem is it starts and idles fine, but when i push the gas it dies. before i changed some parts it wouldnt even start. ive changed the crankshft sensor,coolant temp. sensor,fuel filter,o2 sensor,pcv valve,map sensor,throttle position sensor,idle air control valve, i cleaned out the egr valve with throttle body cleaner, been told maybe a bad egr valve ,but thats expensive to replace ,if not problem.also maybe a bad speed se

You can manually test the egr valve by pushing up from underneath it and seeing if the spring loaded valve moves and re seats itself. If no, it's bad. ... Chevrolet Cars & Trucks

I have a chevy 350 that runs good but wont idle. i replaced the idle air control valve and the pcv valve and still nothing

Sounds like the vehicle needs timed and or a tune up including plugs and wires be sure to gap them correctly or just by a set that is pre gaped. ... 1993 Chevrolet K1500

1989 Chevy Silverado, 5.3L engine, 4 Speed Automatic. I have a run problem, the idle is to low and it surges at times and dies. I cannot adjust the timing as everytime I try it goes wild. The EGR valve, Idle Air Valve, Ignition Control Module, spark plugs, plug wires, coil,TBI rebuilt,Knock sensor, O2 sensor have all been replaced. I'm not getting any codes. When I start it I have to play with the throttle to keep it running. Sometimes its running rich enough that it smokes and other times it do

Check the tps sensor ... Chevrolet Silverado 1500

1995 chevy k1500 4.3 5 speed 150,000 stumbles at idle and while driving slow, and even at higher speed while maintaining my speed it will go erratic and smokes black. Have changed map sensor and ignition control module, plugs and wires just about a week ago, egr about a year ago, idle air control valve about a month ago. Injectors are spraying good, fuel pump is working. Im told to clean the egr passages which i did not do when i changed the egr a year ago. haven't done that yet, but gut say

... 1995 Chevrolet K1500

Pops back through the intake when it is cold runs better when warm replaced complete distribitor,cap rotor,plugs,wires,ign coil, ign control module,throttle position sensor,idle air control valve, egr valve,oxygen sensor,fuel pressure regulator kit,fuel injectors,don;t know what else to do 1992 k 1500 chevrolet tbi 5.7 with 5 speed

This problem can be caused by defective spark plug wires that are cross firing due to voltage leaking to a nearby plug wire as well as a flat camshaft lobe. ... 1992 Chevrolet K1500

Idle air control valve 2005 Chevrolet Equinox

... 2005 Chevrolet Equinox

How do i remove the idle air control valve from my 2004 chevy classic 2.2L engine

... 2005 Chevrolet Malibu

My 1997 honda cr-v has had a problem with idle air control valve for a long time.the code is 14-1 idle air control valve-circuit failure.i replaced the idle switch yet the the light still comes on and the vehicle stalls in the morning before it behaves normally.two auto electricians have suggested replacing the ics in the computer since its not sending the correct voltage to the idle air control valve.is this helpful or just another non-working theory?

Check your mas air flow sensor. if that don't work check your throttle position sensor.hope that helps.. ... 1995 Volkswagen Jetta

I have a 1997 chevy maulibu 3.1 and I just had to replace my tps sensor and my idle air control valve. Still idles around 1300-1500. When we hooked it up it says that my throttle is open 15% and it should be zero. Any suggestions?

Make sure return spring is still good.Make sure the throttle is closing all the way, could have binding or improperly adjusted linkage. ... Cars & Trucks

I have a chevy full size blazer with a 350 engine and it has a high idle i replaced the idle air control valve and still no change

... 1989 Chevrolet K1500

1998 Chevy Venture van started fine this morning, idled for about 15-20 minutes while I cleaned off snow, shut it off to go back in house and now will not start. Acts like fuel pump...not getting gas but looking online was hoping its the idling Air Control valve

The idle air control valve will not create a no start, it just won't idle after starting, and these valves seldom fail, and when they do they stick open so u end up with a high idle speed, you should hear the fuel pump ... Chevrolet Venture

We have a 1993 Chevy C1500 with a 5.7 that is dumping fuel at idle. We've put new injectors in it, new map sensor, O2 sensor, air control sensor, temp. sensor, new computer & chip, EGR sensor, Pickup in distributer, new distributer wires, new cam, lifters, timing chain & gears, fuel pump,& top end of throttle body. We've taken it to Sands Chevrolet & Gateway Chevrolet and nobody can find the problem. New crate motor from dealership has only 85,000 miles on it and transmission.

Something is creating alot of air to pass over the 02 sensor.\015\012\015\012\015\012Low compression\015\012Big vacuum leak.\015\012Weak ignition\015\012IAC stuck a little open.\015\012TPS that is saying your ... 1993 Chevrolet C1500


Check the fuel pressure as it can be the problem of fuel not reaching the engine properly may be clogged up fuel pressure.as you have ruled out all the possibilities for this problem.so all parts needs to be checked with meter for proper voltage.fro ... Nissan Maxima

In my 2000 Saturn SL1 I am experiencing very high idle (2000 rpm warm - higher cold). I have cleaned the throttle body and the idle air control valve with no improvement. What next, replace the idle air control valve? Any other suggestions? Thanks, Sandy R

You could try replacing the idle air control valve but I would obtain one from a local salvage yard, its cheaper and you are not certain if thats the problem, another thing i would check is your intake manifold gasket where it meets the cylinder head ... 2000 Saturn SL

My 1990 Honda Prelude idle goes up and down,I replaced the idle air control valve with a new one my cooling system is full and it is still going up and down I'm stumped,everyone said idle air control valve it has to be something else,anyone have an idea. By the way it is a 2.0 si mpfi double overhead cam thanks Mike Smith

... Honda Prelude

Had a rough idle and the engine dies while driving. Got a code P0505 Idle air control system malfunction. Replaced the pcv valve and the idle air control valve but it is still doing the same thing, check engine light is also back on.

Does yurs have the idle air control motor if so look into that ... 1999 Dodge Durango

I have a 98 dodge Dakota 4x4 auto 5.2. Air idle controle valve was loud all the time and wound load up on fuel n die and also rpms wont go past 2000. So I changed both o2 sensors. Now air valve is not loud at idle most of the time. But still won't rev up. When I try to rev it up it bogs down n smokes alittle n some soot sometimes comes out. Fuel presser is 45 psi @idal new o2s new air temp water temp new tps used map used air valve. Please help

Here's a link on what may be wrong.Here's how to ... Cars & Trucks

Transmission Problem This only happens when it is pouring down rain. I have a 95 chevy S10 4.3 Vortec automatic 4l60E tranny. My truck will run fine until I run into water where it splashes up, but not enough to get into my engine bay. The engine will have no problem shifting to 1st but then it will rev and not go into second. Once it dries up I don't have a problem. Within the last two years I have replaced the fuel pump, the air idle control valve, gave it a complete tune-up (plugs, wires, cap

Its flood a tranny sensor causing a circuit fault, rain water conducts electricity. Locate this/these sensors and coat them with a sealing agent, your local auto parts store will have the stuff you need. No water, no short.\015\012\015\ ... 1995 Chevrolet S-10 CA Edition

I have a 1999 Chevy Malibu (6 cylinder, automatic, 3100 SFI) and I changed the Idle Air Control valve (IAC). The part I ordered off the internet had a shorter pintle than the part that was originally on the vehicle. I changed it anyway and now the car won't start at all. I later decided to switch back to the original part, swapped o-rings with the new one, and the car still won't start. I need to know what went wrong!

Hi,\015\012\015\012If the engine will not crank at all you must have disturbed the connections to the starter solenoid when you were working on the car.\015\012\015\012Either this or you have a flat battery. Check with a multi ... 1999 Chevrolet Malibu

2000 Chevy Impala 3.8L any idea if I can prelace the idle air control valve o-ring?

... 2000 Chevrolet Impala

What are the steps to replacing the idle air control valve? i have the idle air control valve and the gasket.dont want to pay a mechanic an hours worth of labor if i am able to do it myself.thanks

I'm already faced this problem and got my solution from here. Hope it \012will help you to solve yours too. Here is the link for your Solution " bit.ly/fixyablog-post17762 " (Copy this link on your browser and read the instructi ... 2000 Mazda Protege
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.3170 seconds