Having problems with your 2001 Toyota Tacoma ?

Replace alternator belt on 2000 Tacoma pick-up

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2001 Toyota Tacoma

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replace alternator belt on 2000 Tacoma pick-up


... 2001 Toyota Tacoma

How to replace the alternator belt in 1999 toyota tacoma


... Cars & Trucks

1998 Toyota Tacoma, need to change belts, alternator belt broke, is there anything I need to know special on how to loosen each belt for removal and replacement


... 1998 Toyota Tacoma

Have been alternator has size...? only sine I put can into garage to rectify small leak from power steering pipe - new clip required. Authorised alternator & belt to be replaced, now they have advised of water leak, could be water pump or worse case cylinder head..? Please advise as car was running fine before it went in. It is a Rover 200 1.4si 1999 model (T reg)not on your list below. I have just picked a Renault to get me through.


Water pump,it would show when the mechanic puts altenator on as it would no doubt drip on him ... 2000 Renault 181

How to replace the alternator belt on 2002 toyota tacoma


... 2002 Toyota Tacoma

Replacing alternator belts on a 1987 Dodge Ram pick up


... 1987 Dodge Ram Wagon B150

My 1998 Caravan has a bad squeek in the belt system. Have replaced tensioner pully twice, replaced idler pully and bearings, replaced cerpentine belt twice, replaced alternator twice, went back to original alternator. Used belt dressing on original belt, made it 1000x worse. It has 123,000 miles. Sounds like multiple squeeks now.


Without the belt do all the pulleys turn easy. Power steering, water pump, alternator, and tensioner pulley. There is probably only one way the belt will stay on but make sure you have the smooth side to the smooth pulley and the grooved side to the ... 1998 Dodge Caravan

Serpentine belt replacement of a 2006 tacoma 4,0


... 2006 Toyota Tacoma

We're trying to replace the alternator on a 1996 Chevy S10 pick up and are having trouble getting the belt reattached. Any hints on how to do so?


... Cars & Trucks

How do you replace an alternator belt on a 99 toyota tacoma prerunner v-6.


... 1999 Toyota Tacoma PreRunner

Gutless Subie So I just picked up a '93 Subaru Legacy a couple days ago for real cheap, and I'm probably beginning to find out why. It only has about 170k miles and just had the alternator, starter and timing belt replaced. For the most part, it runs and drives solid, but I've noticed every now and then within the first 5 minutes of driving it has some serious power issues. I can press the gas, but it barely goes faster than an idle. I almost got smeared off the road this morning on my way to wo


Look for a loose, cracked, or worn distributor cap. Hope this helps. ... 1993 Subaru Legacy

Replacing alternator belt on 1984 Toyota pick-up


... Toyota Cars & Trucks

Alternator belt replacement of 1989 Toyota pickup truck . there are 2 belts to get past before we can replace the alternator belt. How is best to remove first two belts.


Start with the power steering belt it takes a 12 mm socket for the bolt in the power steering . also loosen the bolt on the power steering pump pulley. remove the radiator lower fan shroud. It just clips in. pull the power steering belt around the ... 1989 Toyota Pickup SR5

Alternator belt I just replaced alternator..Need to replace alt. belt but there is a different belt in way and cant figure out how to remove that one...i sure could use diagrams or real pictures for both belts...Help????


The other belt has a tensioner and is located under the ac compressor. It takes a 8mm bolt to loosen it. ... 1998 Nissan Sentra

Belts squealing About 4 weeks ago the alternator belt failed, causing the alternator to stop, the battery was weak and would not run the electric radiator fans, so the motor started running hot and blew the radiator. I had the car towed in, and the mechanic replaced the radiator and the belt to the alternator, now the new belt broke less than a month later, I took the alternator off and had it tested, I thought maybe the alternator was not spinning like it should, but the alternator checked out


The bearing in the tensioner may be toast. ... 2000 Mazda Protege

Tring to install an alternator belt on a 1988 VW cabriolet. In order to install the alternator belt i have to remove the starter belt, which is on the outside pully. The alternator belt is on the inside pully and cannot slip over the outside starter belt without removing the starter belt first. My problem is finding all of the bolts on the starter in order to losen it and remove the starter belt. Ive replace several starters on american cars before, but never on a VW. Any suggestions you have wi


The air conditioning compressor is driven by the crank and that drives tha alternator. you have to take off all the belts in order to change the alternator belt. ... 1998 Volkswagen Jetta

My 2001 alero has been making a whining pitch somewhere near the serpentine belt. I have had the belt the tension rod, alternator, and water pump pulley replaced . It is still making the same noise. I took it to the local college on town ( got too expensive to keep going to a mechanic) the class and instructor were gone and I was supposed to get my car back that day. It looked like all it needed was the the belt put on as the water pump pulley and alternator had been replaced. Well it sounds hor


... Cars & Trucks

Alternator squeal, down 4mpg. 07 tundra with 110000 miles dropped a valve and took engine out. replaced engine with a 08 with 5000 miles . now I get considerably less fuel mileage and the alternator belt squeals on start up, replaced belt checked tension. does not squeal if alternator unplugged or if I turn ignition key to on for 15 sec before starting. this is a 5.7 L engine


... 2007 Toyota Tundra

I replaced my alternator belt and put it on too tight and the belt was not turning. I dorve it for a while until the warning light came on. When i got home the battery was dead. When i boosted it shorted and blew the 100amp fuse. I cleaned all the connections for battery, starter, alternator. My ground from the battery is on tight and does not look damaged and the same with the other wires running to the alternator. I replaced the fuse and started it with my charged battery. It ran but smoke w


... Toyota Tercel

I had the alternator, alternator belt replaced on my 2001 Mazda and now it is chewing up the belt. I have replaced it three more times. what seems to be the problem? It looks like the alternator pulley is not aligned properly. The idler pulley spins freely by hand. any suggestions would be appreciated.


The alternator needs to be spaced in or out until the pulley is in line with the rest of your pulley's. They may have dropped or lost spacers when they changed it. You can use washers to do this or make slight bends to the mounting brackets if necess ... 2001 Mazda Protege

Is replacing an alternator belt the same as replacing the alternator


Are you sure you need to replace it. You can test the alternator by starting the engine and measure the voltage on the battery. If it's at least 13.6 volts, (the minimum for properly charging the battery), then the alternator is probably ok.\012H ... Cars & Trucks

One of the three drive belts on my 1986 corolla (4a-c engine) is frayed and needs replacing. The belt loops around the idler pulley, air conditioner? and crank. Can I just cut this belt out and not use my air conditioning? Or if it needs to be replaced, which pulleys/ alternator bolts do I adjust to loosen, remove, and replace the belt properly. I have to remove the main drive belt to remove the one that is frayed. Thanks for any help you can give


To replace the belt you need to see what size socket the tensioner has on the inside. with a ratchet attached put the socket on the inside bolt and push in the rotation to move the spring down taking the tension off of the belt. Pull the belt off a ... 1986 Toyota Corolla 2 Door

I own a 2003 Elantra. When my car is cold the belts squel loudly and the steering is hard till it warms up. The other part is that the belt keeps breaking that is around the alternator. I am not a mechanic but I am pretty sure there is something wrong with either the way the belt is installed or the alignment of the belt or maybe the alternator itself. The pulley on the alternator turns freely. I have to replace the belt a third time in three months.


Power steering pump? ... 2001 Hyundai Elantra

87 Mazda B2600 4x4, My power steering belt broke today, and popped my alternator belt off. I replaced to broken belt and remounted the other. I drove 10 miles to my house and my alternator belt broke,


... Mazda Cars & Trucks

I have a 1997 Toyota Corolla, it sounds as if the belts are slipping and I'd like to replace them myself. From doing some research it seems that there are 3 belts: alternator belt, power steering belt and A/C belt. Does this mean that there is no serpentine belt? Also, do you think that this job is difficult? How expensive are the belts (I plan on changing the alternator belt and power steering belt only). Thanks


Well if your sure that it really is the belts the job isnt too hard. Refer to your owners manual for a clear view on how to replace them. I feel that every car owner should own a car manual for the car that they own cause they really do come in handy ... 1997 Toyota Corolla
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.9714 seconds