Having problems with your 2001 Oldsmobile Alero ?

How do I replace cruise control switches on 2001 Oldsmobile Alero

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2001 Oldsmobile Alero

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I replace cruise control switches on 2001 Oldsmobile Alero

... 2001 Oldsmobile Alero

Cruise control not working suddenly. I had the brake light switch replaced a few weeks ago because the gear was stuck in park. Sometime after this the cruise stopped working, but I can't really say it was immediately after because I didn't notice. I had the mechanic who replaced the switch check it again to make sure the wires were hooked up and he said it was. The cruise light does not come on within the pushbutton switch nor does the cruise control engage with the wheel controls. The

The speed sensor is going bad. Check and replace this part first. If it still does not come on after you replace the speed sensor then you will need to replace the cruise control module ... Honda Pilot

Oldsmobile Alero Olds Alero Dash Lights,Fog Lights, cruise control lights, a/c and rear exterior lights went out. Recently had brakes repaired by Firestone and did not take it back yet!!!!! Then I took it to Gooodyear and they said it was some type of switch for a/c that would cost over $400.00. Checked fuses none blown.

Found out what it was relay switches. (Fuses) ... 2003 Oldsmobile Alero

How do i replace the cruise control on/off switch on my 1999 alero


I have a 2001 Deville DTS and the cruise control switch will not stay engaged. Is it difficult to replace this switch on the steering wheel? Is this a switch I can replace myself or does the airbag come into play when replacing this switch? Thanks!

I am not sure but I think that is a vacuum controlled system, check the vacuum lines to the regulator. ... 2001 Cadillac DeVille

My cruise control keeps cutting off. If I keep my foot on the gas pedal it stays engaged. If I pump the brake pedal repeatly the cruise control works for a while. I purchased a cruise/brake cutoff switch, the upper one. I am having problem getting to it to replace it. And suggestions and proper removal and replacement.

There is a switch\015\012\015\012NOTE: If the cutoff switch does not contact the pedal\015\012arm, it will be necessary to slightly bend the switch\015\012mounting bracket (use a pair of pliers) until contact is\015\012made. The crusie control module ... 2005 Ford Freestyle

Trying to disconnect cruise control ford f350 1999 v-10.right now the truck will not start. tested fuel-has good pressure.tested with gauge. tested spark-it is weak(yellow spark instead of strong blue) on three plugs.tested with spark tester. no computer codes-had one for the neutral safety switch,replaced that.tested with code reader. have a new battery-alternator was bad and replaced battery and alternator.tested with meter. the tip on the cruise control lever is broken off,with wires t

Well all you have to do is remove the fuse for it.. Its located in the fuse panel under the hood.. the panel has a diagram on it,, its located under the fuse panel cover.. this will direct you to the cruse control fuse which is the one u want to remo ... Ford F-350

MY 1989 Honda Accord had cruise control until it stopped working. I checked the Fuse. Its good, I replaced the control switch on the steering wheel. Didn't fix the problem. Then replaced the power button that turns the Cruise "On & Off" and lights up "green" & is located down by your left knee of the lower dash area. Whats the next thing to try?

Look for the obvious. Check for the cable that goes to the throttle to see if it came off or broke. Also look for any leaks in the vacuum system. A small leak will cause it not to work. The unit may be engaging but with one of these problems, it j ... 1989 Honda Accord 4 Door

The rubber button covers on my 96 ford explorer cruise control swithes have dry rotted. I purchased a motorcraft replacement SW5919. It has a harness attached to both switches. I just need the switches but I can't figure out how to unplug the harness. I don't have the expertise to pull the whole steering wheel. To replace the switches I need to disconnect the battery and take two bolts out of the column for the air bag then just unscrew the swithces and replace. So what is the secret method to r

You will need a small screw driver to gently disconnect the switches from the harness. They are clipped on.Locate the clip side of connector and pry off gently.Good luck. ... 1996 Ford Explorer

I have 98 Saturn sl2. The cruise control works intermittently. I set the cruise and it will engage for about 20 to 30 seconds before disengaging. Sometimes it won't engage at all unless I repeatedly hit the set button. I have replaced the cruise control module and it still does this. When it is working during the 30 seconds, I hit the break and the cruise disengages. Same when I press the clutch in, the cruise disengages. So, I disconnected the clutch switch and it still does this. I ha

... 1993 Saturn SL2

2004 Buick Rendezvous - Heater/AC fan switch shorting out. I had issues with the switch working on only 2 speeds. I then replaced the resistor block. I then got all speeds except 2. The AC Light came on with #2 but blower not working. Also, the AC and other 'directional' switch didn't work either only worked for a 10-30 seconds. I then pulled the dash and found the switch burnt on a couple of pins. I replaced the switch and control head BUT now the fuse keeps blowing the moment of going from 0 t

... Buick Rendezvous

04 jeep grand cherokee, cruise control inoperative. "cruise" light comes on momentarily, but goes off before speed can be set. Recently replaced brake switch, but brake lights are working properly. May be related, but don't see how. Can't find a fuse for cruise or speed control.

... 2004 Jeep Grand Cherokee

1992 1ton toyota PU has no brake lights, the fuse is good and was replaced, the bulbs are new and replaced and the brake light switch was replaced twice, so now I am stuck and my wife wants to take the truck/ motorhome to the local Toyota dealer and get the problem resolved! Please, I went to the pay as you go websites and the final response was to run a wire from the switch to the tail lights but they were forgetting the cruise control so that was not the solution to my problem. Any help beyo

I could be totally wrong but under the dash and above the pedal is there a switch for the brake pedal? it is adjustable is it not? ... 1988 Toyota Pickup

Instructions for replacing cruise control switch

... 2001 Ford F250 Super Duty Super Cab

Brake lights on 2000 Civic EX w/ cruise control do not work when brake pedal is pressed. I had the same problem 2 years ago and the brake light switch was replaced. Where do I locate the brake light switch? Is it easy to replace if I do it myself?

The break lite switch is located behind the break pedal and it probably doesn't replaced it is probably just stuck. Its fairly easy to get to . ... 2000 Honda Civic

The cruise control on my 2000 mercury sable quit working, the controls on the steering wheel seem to be o.k. plus the switch activated by the brake was replaced but still no cruise, what next

... 2000 Mercury Sable

Need to replace the cruise control panel under steering wheel without doing any damage, and as easily as possible, and also need to replace the window and door lock panel on driver side, bought pantiac used outside mirror adjusment switch missing and driver side window switch not working.

... 2004 Pontiac Grand Am

Need a replacement for a cruise control brake disconnect switch for 2004 Grand Marquis. I have shorted the old switch and CC engages fine. Can't find a replacement part though.

Remember the Crown Vic is a sister car. Try Carparts.com for salvaged auto parts. They are a Nationwide Salvage association which offers to your door shipping and a choice of "found" parts at different prices. Searching for your part is free. ... 2004 Mercury Grand Marquis

Replace hazard switch on 03 oldsmobile alero - 2003 Oldsmobile Alero

... 2003 Oldsmobile Alero

99 suburban,rear brake lights and turn signals work intermittently. Tail lights are fine on both sides. I have replaced bulbs and the circuit panel on the rear to no avail. I think it may be the turn signal switch itself. I also lose the cruise control whenever i hit a bump, like crossing a bridge, also. Could the ground be the cause of this? Another point of issue that may not be related directly is that my horn fuse blows whenever it is replaced and the driver side door jamb switch works inter

Blinker switch can go bad everything runs through the switch ... 1999 Chevrolet Suburban

The cruise control on my 2002 BA Fairmont will not turn on. I have replaced the switch on the steering wheel and did not fix the problem. There is power at the steering wheel control switch. What do you think I should check for?

... Ford Fairmont

2003 Chevrolet Suburban 1500 cruise control and brake lights not working. I replaced the brake light switch and the check engine light went out, howevr the cruise control and brake lights still won't work.

How many switches on teh brake pedal ,bet their is more than one ... 2003 Chevrolet Suburban 1500

Cruise Control The cruise control wont engage. It has worked properly for many years. I checked all the fuses and they are ok. The speedometer and trip computer seem fine so I suspect the speed sensor is good. Should I replace the brake pedal switch? The brake lights are fine but I have no other ideas.

Are you sure there has not been a recall on your cruise control? There was a recall on mine and it was a fifteen minute fix. ... 2000 Ford Expedition

How to replace cruise control switch on 2008 Aspen

... 2008 Chrysler Aspen

I have a 2004 Ford F350 cab & chassis & the cruise control does not work. When you switch it on I get no light. I performed the KOEO test on the steering wheel switches & everything was good until I activated the set/accel switch & nothing happened after that which told me that the switch was bad so I replace it with a new one & got the same results which now tell me the original switch was good & that there is a problem further down the line. The clock spring is good as I have a horn & no air b

... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4749 seconds