Having problems with your 2001 Nissan Sentra ?

What must be removed to change a 2001 nissan sentra starter

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Undue the battery ground and move away from the battery.Take the battery wire off the starter and the small selnoid wire,then remove the bolts holding the starter to the engine and it will fall into your hands.
Repair Help & Product Troubleshooting for 2001 Nissan Sentra

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What must be removed to change a 2001 nissan sentra starter


Undue the battery ground and move away from the battery.Take the battery wire off the starter and the small selnoid wire,then remove the bolts holding the starter to the engine and it will fall into your hands. ... 2001 Nissan Sentra

How to remove starter on 2003 nissan sentra - 2003 Nissan Sentra


... 2003 Nissan Sentra

How to change a 1995 Nissan Sentra's Starter - Sentra Nissan Cars & Trucks


... Nissan Sentra

How do i remove and install a starter on a 1999 nissan sentra


... 1999 Nissan Sentra

I'm driving a 1998 nissan sentra. I got it new and have driven about 60000 miles and has about 85000 now. In this time I had to replace 2 water pumps. At $300 for repair. I will try to replace it if needed again. There are 5 bolts holding it on, and a pulley to remove to reach the pump. No removal of hoses is required. Maybe you can tell me what else must be removed, or give some tips on procedure. Thanks Don Cole


... 1998 Nissan Sentra

How to remove the starter on a 97 Nissan Sentra GXE


YOU NEED A HAYNES REPAIR.IT HAS PHOTOS TO SHOW YOU HOW TO REMOVE STARTER. ... 1997 Nissan Sentra

After changing the starter and alternator and installed a new ignition switch my 1997 Nissan p/u started up fine. Drove it around town, stopped, turned off the engine and it started again right away. Drove it home, parked and turned off the engine then started it up again. No problem. However, the very next day the truck wouldn't start; not even a click. Installed a new battery still won't start. Removed the starter and got a new one and still won't start; not even a click. Checked the fuse box


Replace the starter wire going to the battery ... 1997 Nissan Pickup

How to change starter in 2001 sentra - 2001 Nissan Sentra


... 2001 Nissan Sentra

Starter removal and install 1999 nissan sentra


... 1999 Nissan Sentra

Labor hours to change starter on 1995 Nissan Sentra


... Nissan Cars & Trucks

Hi, 2006 Nissan Sentra, The car won't start, I can hear the pump as I turn the ignition on, as I try to start the car is turning over okay so no starter problem and battery strength is okay. I had removed one of the ignition coils to test looks like I am not getting spark. Ignition coil fuse is 15amp is okay. Any other simple things to check ? I am about to take it to the dealer Thanks Justo


I have an 06 sentra as well with a similar problem. Just pop the gear shifter into neutral and then turn the ignition. The car should start. It always works for me. ... 2007 Nissan Sentra 2.0 SL Sedan

Wont start changed starter just goes click - 1995 Nissan Sentra


STARTER IS BOUND AGAINST FLY WHEEL OR WHIRE IS LOOS ... 1995 Nissan Sentra

Nissan sentra 2004 overheating, fan and radiator has been changed and also removed is thermostats. What could that be?


Check to see if the radiator fan switch if working properly. ... 2004 Nissan Sentra

How do I remove the starter on my 2006 nissan sentra?


... 2006 Nissan Sentra

How do i remove the starter on a 1999 nissan sentra


... 1999 Nissan Sentra

Removing the starter from a 2000 nissan sentra gxe


... 2001 Nissan Sentra

How do you remove the ac/heater control on a 2006 Nissan Sentra? Does it pull out or are there screws behind the side panels?Thank you for previous info. It is a one piece unit that must be replaced noy serviced


... 2006 Nissan Sentra

I need to adjust the headlights on my 1996 Nissan Sentra. There are no screws around the front of the headlight to make the adjustments so there must be another way but I don't have an owners manual. I did change the bulbs but need to adjust them. Thank you for any assistance you can provide.


Look at the back of your headlight assembly. There should be two (about 2.5") rods there which can be turned with a small wrench-those are the adjusters for the headlight. ... 1996 Nissan Sentra

How to change a starter on a 2004 nissan sentra 1.8 liter


Early to wear the starter out as most of the older cars went to the junk yard with th orginal starter! But I bet you may have starting problems.. Does it click under the hood when you tur the key? Have you tried to start in neutral? Have you take ... 2004 Nissan Sentra

2003 honda accord dx remove the starter and hot wire it to see if the drive gear of the starter extend and spin. i found out it dont extend or spin just click, click. it sound like being installed in the car. is this means the starter is bad that is why the car will not start. we change the battery twice. first change the new battery was bad. second battery still wont start. then i tried another battery fron another car and still wont start. prior to this work, i remove the starter and have it c


If you removed the starter, and placed battery voltage to the starter, and it clicked just like it did when installed, then the starter needs to be replaced. When you had it tested and they said it was good, did you verify this claim? ... Honda Accord

I have a 1997 nissan sentra that wi have a 1997 nissan sentra that wont pass emisions fuil system lean bank1 p0171 code so i changed the maf sensior,fuil pressure reg, pcv valve, and all four fuil injectors, now the car has no power at all it hardly move now with pedle to the floor it wont go can any body help me please. ont pass emisions fuil system lean bank1 p0171 code so i changed the maf sensior,fuil pressure reg, pcv valve, and all four fuil injectors, now the car has no power at all it


Have you checked your fuel pressure at the fuel rail? The problem could be a clogged fuel filter, pinched fuel line, or under-performing fuel pump (either faulty part, or not receiving enough voltage).The only other thing I can think of t ... 1997 Nissan Sentra

Truck died at light found out electric control modual was bad changed it then it acted as if the starter was weak and wouldnt trurn the engine over,so i bought a new starter no change still would'nt turn over so i pulled the access cover for the flywheel and used a flywheel turner to turn the flywheel (i also removed all the belts) and only moved it about 1/2 inch so i removed the oil pan and don't see anything brock or loose under the engine.what do i check or do next?


It would be much easier to turn the engine by using a socket and a breakover on the crankshaft pulley bolt. I understand why you thought you needed to turn the engine. If you remove the spark plugs it will turn real easy bec ... GMC G1500

Replace starter on 2005 nissan sentra


\015\012Remove or disconnect the following:\015\012\015\012\015\012\015\012\015\012Negative battery cable\015\012 \015\012\015\012Air inlet tube\015\012 \015\012\015\012Har ... 2005 Nissan Sentra

Hi, hope you can help me on this, I got a 1967 mustang, I recently change the fmx tranny for a c4, but I remove the c4 from a mustang II with the small bellhousing (141 tooth), now the problem I have its that the starter hits the oil pan, so I need a smaller starter. I got a mini starter, second hand, from a friend, but It didnt work. So my options are: 1- Get a mini starter that works (If you know anyone, will appreciate the info) 2- Modifying the oil pan 3- Changing the bellhousing, but will h


MODIFY THE OIL PAN.CHEEPER.EASYER TO DO.ANY WELDING SHOP CAN PIT IT FOR YOU . ... 1966 Ford Mustang

Vehicle has a bad starter. There is a cover over the starter that must be removed. How complicated is it to remove and replace starter?


It's not too hard to replace. Disconnect the positive battery cable from the battery. Remove the 3 10mm bolts holding on the cover. There should be 2 14 or 15mm bolts going up thru the starter, into the block. Disconnect the wiring going to the start ... 1995 Buick LeSabre
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.1409 seconds