Having problems with your 2001 Jeep Grand Cherokee ?

2001 jeep grand cherokee 4.0l fuel pump control relay does not have a ground

\015 How does fuel pump relay control get its ground?\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2001 Jeep Grand Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2001 jeep grand cherokee 4.0l fuel pump control relay does not have a ground


... 2001 Jeep Grand Cherokee

1996 Jeep grand cherokee wont start im not getting spark from the coil and it has no power at the injectors every thing is pointing to the auto shutdown relay but i replaced it and still nothing the relay is getting power and ground if it is the power train control mod can it be tested or repaired or did i not check everything. I would go for a short drive about a mile i would turn it off and it wouldn't start but if i waited a couple of hours it would start again it did it a couple of times. i


Crankshaft position sensor is probally your problem ... 1996 Jeep Grand Cherokee

1997 jeep grand cherokee dies like clock work..., dies once or twice after 10-20 min.of running when decreasing from highway speed to 10 miles an hour, or at highway speed it hic-ups like the key is turned off & on for a split second...after both symptoms it runs fine for the rest of the trip. replaced distributor, plugs, wires, fuel pump relay,air idle control sensor, crankcase sensor. also when it dies theres a smell of gasas if its flooded, 205,000 miles


Have you had the computer checked ... 1997 Jeep Grand Cherokee

2000 Jeep Grand cherokee Laredo wont start. Engine turn over . No noise from fuel pump with ignition on. Replaced fuel pump and filter.Turn ignition on- pump did not run.Jumped the fuel pump at the pump relay.Pump worked and pressurized fuel rail. Still no start. Checked OSD relay and fuel pump relays and fuses-all good. I noticed that the fuel guages were malfunctioning. Battery guage hardly moves.Battery full . The anti theft light stays on as I tried to start engine.


Sounds alot the the pcm it controls the fuel pump and ign system but the anti theft would keep it from starting because the key has a transponder in it programmed for that vehicle and that would kill all ign if triggered ... 2000 Jeep Grand Cherokee

1998 cherokee sport. Fuel pump wont turn on. was driving vehicle, the guages dropped out and vechile shut down. Tested the relay and its fine. Jumped the relay to get the pump running and it turned on. The relay doesnt see to switch on when the ignition is turned on. The ground between the powertrain control module check out ok, and I have 12volts to the relay. Any ideas???


... 1998 Jeep Cherokee

Hi, I have a 1995 Jeep Grand Cherokee 6 cylinder, 2wd. I need to replace the A/C Fan relay switch but I don't know where the relay is. Can anyone help me to locate the relay switch? The issue my Cherokee is having is, when I shut off the engine the fan will not shut off. So the battery will die. Also I can no longer can control the fan-a/c on the console. It just runs loud and blows air out as though the fan is on high.


Under hood in high voltage fuse box ... 1995 Jeep Grand Cherokee

98 grand cherokee turns over will not start. fuel pump will not run. instruments do not work. info console no info other than compass & ext. temp. all volts present at relays. can jump power to fuel pump at relay, pump runs but still will not start. dont think injectors are opening or ignition firing. Control module ?


If asd relay circuit is okay then the computer is most likely at fault, assuming that the theft deterrent system is not activated. i just repaired this same problem2 days ago ... 1998 Jeep Grand Cherokee

1993 Jeep Grand Cherokee will start then immediately die. I've replaced the Crankshaft sensor, ignition coil, fuel filter, battery, new plugs and wires, new cap and rotor, tried swapping the fuel pump relay with the auto shutdown relay and installed a new ECU computer. Before installing a new computer the jeep would crank but not start. After installing the new computer the car started right up. I then attached the vacuum hoses to the air cleaner assembly and now it won't keep running. Any ideas


This sounds like a imobiliser problem,sit in the car,lock the doors on the key fob then open them on the key fob,you have about 2 minutes to start the car or it will activate the imobiliser.had the same trouble. ... 1993 Jeep Grand Cherokee

Fuel Pump doesnt Run!..Maybe A Relay,Where is the Fuel pump Relay on a 1993 Jeep Grand Cherokee 6 cyl?


Its in the power distribution box under the hood,fuel pump is probably out ... 1993 Jeep Grand Cherokee

2000 jeep grand cherokee 4.0 auto getting a code p1388 asd relay is loosing ground from what i found what grounds this relay


Releys are grounded every where try checking the motor and the body grounds \015\012\015\012\015\012if all else fails run a new ground 1 to the frame and 1 to the body as likely it has a bad body ground ... 2000 Jeep Grand Cherokee

I have a 1994 jeep grand cherokee 4.0 6cyl that died.replaced fuel pump still not running.the feul pump relay coloses but the auto matic shut down relay doesnt.when i jump the asd reley it starts.pease help?


... 1994 Jeep Grand Cherokee

Fuel pump relay on a 2004 jeep grand charkee - 1996 Jeep Grand Cherokee


... 1996 Jeep Grand Cherokee

I have a 1995 Jeep Grand Cherokee Limited ,when I go to start it, the relay starts clicking and the fuel pump starts pumping after about 15- 20 minutes of leaving the key on. Also the security light comes on. After the fuelpump pumps up pressure the security light will go out, then when I go to start it the RPM gauge and the injectors go wacky. The RPM gauge continues to jump all over until I turn the key off, at the same time the RPM gauge is going all over the injectors are pumping gas, the en


Certainly sounds like a bad fuel pump regulator. You have a 95 so the regulator isn't part of the fuel pump (on 96 and newer its all one assembly.) You don't have a fuel pressure tester by any chance do you? That would be a great tool in this situati ... 1995 Jeep Grand Cherokee

My 1995 jeep grand cherokee died while driving,found that computer was bad,replaced,all was well for a day or so,now died again with exact symptoms,was told that a bad sensor may be taking out computer.Crank sensor is new,hear fuel pump relay and ASD relay clicking with KOEO,if I unplug MAP clicking stops but still no start,could MAP take out computer or is it somewhere else.Battery voltage is present at both relays mentioned above,any thoughts?


... 1995 Jeep Grand Cherokee

I have a 2003 Jeep Grand Cherokee 6 cyl. I am getting fault codes P0351,P0352 and P0353 which is defined as #1,#2 and#3 ignition coil circuit and code P0505 JEEP Idle Control System Malfunction and code P1495 JEEP EVAP Leak Detection Pump Solenoid Circuit Condition. The problem I'm having is at times the engine will bog down and lose all power and sometimes just completly quits. I can stop the vechicle and turn the key switch off and start the engine and it will run just fine. I have replac


I would check Cam Position Sensor as is directly related with ignition. Power loss is due to the ECU going on "limp mode" to prevent further damage.I hope this helps! ... 2003 Jeep Grand Cherokee

I have a 1995 Jeep Grand Cherokee. I get voltage at the coil leads only for a second when cranking engine. Car has factory security system. Could this cause a block of voltage at engine control module? Or, is engine control module defective? Relay at fuse panel for coil works fine. Any suggestions?


Try changing the crank shaft senor around the bell housing on the driver side ... 1995 Jeep Grand Cherokee

1995 jeep grand cherokee electrical problem. checked wires to starter. theyre good. the battery is grounded good. have voltage to fuse panel. i was checking continuity by hooking a wire to the negative terminal and checking the switch plug on the back of the heater control panel. had continuity. then i switched to positive terminal. i had continuity. this' to me means there is a short somewhere, but it is affecting the window and lock controls also. is there an easy way to trace a short. thanks,


It depends on how you were checking continuity.\015\012If you are using an ohmmeter (which is only $3 at Harbor Freight), then the question is what resistance reading do you get?\015\012The positive is continuous with the ground, through ... Jeep Grand Cherokee

I have a '98 Jeep Cherokee 4wd, 4.0 ltr, 5 sp man. trans. I am gettin NO fuel pressure. The fuel pump relay works. When I jump the brown wire leaving the relay to ground it gets pressure and fires up. WHAT could be causing this?


Have u checked the fuel filter ... Jeep Cherokee

I have a 94 jeep grand cherokee. i repleced the power steering pump, and the pully with it. afterward the jeep keeps eating belts and over heating. i replaced the thermostat. on the way home it over heated and cut off, but there was no fluid running out. as soon as it cooled some i was able to start it and get on the road. please help!!! I'm wondering if its got anything to do with some kind of relay swicth?


If it keeps eating belts I would look at how the pulley is installed, if it is pushed on too far it will have resistance and be misaligned with the other pulleys thus causing the engine to labour all the time. also have a good look at the rest of the ... 2003 Jeep Grand Cherokee

I have a 1993 Jeep Grand Cherokee Laredo. I love the jeep. I have 380,000 original miles on her and never had any problems. BUT.. When I go to start it now all it does is turn over. Will not start. If I leave the key in the on position for a while ( it varies from a few seconds to a few minutes), I can hear what sounds like a relay click a few times and then the Check Engine light appears and goes away and after the noise... it will start and run like nothing is wrong. Got a new fuel pump ($200.


If the check engine light comes on then there must be a trouble code stored in the PCM memory. What is the code when you turn the key on,off,on ,off... then leave it on....count the engine light blinks. (Don't start the engine during the ... 1993 Jeep Grand Cherokee

I have a 97 jeep grand cherokee with a 5.2 start then dies 2 sec later the relay is clicking so i tried swithing the relay still same problem and still clicks i think it may be a fuel pump ?


Your fuel filter could be plugged so only small amounts 2 seconds worth get through if ti been 3 - 5 year since it was changed now would be good. ... 1994 Jeep Grand Cherokee

The cooling fan (radiator area) in my 2000 Jeep Grand Cherokee is not working. I believe that the control relay has failed. I'm don't know where the relay is located - under the hood. Can you help? NRL 6/3/09


Located under the passenger side headlight. ... 2000 Jeep Grand Cherokee

I just bought this 95 jeep grand cherokee and he told me a relay that controls the everything in the center counsel is bad. so there is no power to the radio, ac,fan controls or anything.


Change the relay inside under the glove box, that should solve the problem. ... 1994 Jeep Grand Cherokee

I HAVE 95 JEEP GRAND CHEROKEE. AFTER DRIVING CAR FOR SHORT DISTANCE WILL NOT START. LET SET COUPLE HOURS IT WILL START. MAY GO 5OR 6 DAYS NO PROBLEM THEN AGAIN WILL NOT START. HAD TWO GUY CHECK IT wE HAVE REPLACED 1.COIL IN DISTRIBUTOR 2.AUTO SHUT DOWN RELAY. 3CRANK SENSOR. 4.IGNITION COIL. 5.DISTRIUTOR CAP. 6. WIRES& PLUGS WHEN CAR IS RUNNING FUEL PUMPS PRESSURE IS CONSTANCE AT 42 LBS. COULD THIS BE PROBLEM, SEEMS THAT ONCE CAR STARTS PUMP COULD BE WORKING FINE, ON RESTART CAR CRAN


Had similar problem with 96 Jeep 4.0L engine. Tracked it down to the connector for the distributor pickup. Spliced in another connector and hasn't stalled since. Also, have you had any codes? Easy way to check on Chrysler products: turn key on, off, ... 1995 Jeep Grand Cherokee

94 Jeep Grand Cherokee is hard to start. If I turn the key on and wait several minutes till I hear the fuel pump kick on, then it'll start right up.I have replaced the fuel pump, fuel pressure regulator, crankshaft position sensor, automatic idle control valve, throttle position sensor, distributor cap and rotor.What else should I check?


Has any one soled this yet???????? Because I have the the same prob. but mine is only when it is could out blow 65 it will start but I have to keep my foot on the gas like a carb with no choke ... 1994 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.7172 seconds