Having problems with your 2001 Jeep Grand Cherokee ?

2004 jeep tailgate latch failure - 2001 Jeep Grand Cherokee

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2001 Jeep Grand Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2004 jeep tailgate latch failure - 2001 Jeep Grand Cherokee


... 2001 Jeep Grand Cherokee

Two problems. Problem 1: hood will not latch closed. Not matter how hard i try. even tried jumpingin up and sitting on it. it wont latch closed. Problem 2: there is a connector nossel thing at the back of the engine with a cable or hose hooking up to it coming from the right side just behind the air fliter. what is it. the cable has broken off and is no longer connected. I have a 95 jeep grand cherokee laredo


First, with the hood latch. Check to make sure the pull cable is free. Next, try working the latch by hand, using some wd40 or other solvent to free it up. If you have not totally damaged it by sitting on it, likely you will get it to work. If not, ... 1995 Jeep Grand Cherokee

95 Jeep Grand Cherokee Tailgate Latch


Many thanks, nascar2fever!\015\012\015\012I had the same problem and of course started by trying to pry open the tailgate (gently). The problem was solved by undoing the top of the plastic panel on the inside of the tailgate until I could ... 1997 Jeep Cherokee

Shock size ok so i go to the auto parts store and tell them i need shocks. tey ask if its a 0 inch lift, 1 , 2 , 3, upcounty ect ect. i got this car used im 95% sure its stock suspension. i have a 98 jeep grand cherokee limited. could someone tell me what size is right


They are talking about the lift it has, if it's stock, you need a 0 lift shock. ... 1998 Jeep Cherokee

Rear tailgate latch wont move - 1995 Jeep Grand Cherokee


Can you tell me what happened that made it not move, ie.. were you trying to unlock it, or all of the sudden was it just like that or what? ... 1995 Jeep Grand Cherokee

96 jeep Grand Cherokee tailgate will not open


This is kind of tricky. OK let's start, you have to crawl into the rear\015\012hatch area from the inside of the car. You'll have to pull the rear\015\012panel off the hatch, a screwdriver between the panel and hatch near the\015\012window will work. ... 1996 Jeep Grand Cherokee

Can't get the tailgate open on my 1998 Jeep Grand Cherokee


I had the same problem. I was able to get the back window open. \015\012I took the the 4 screws off that are on top of the inside of the door (where the tailgate window latch is).\015\012Got a metal coat hanger. straightened it and made ... 1998 Jeep Grand Cherokee

Where is bank 1 on jeep grand Cherokee? - 2003 Jeep Grand Cherokee


... 2003 Jeep Grand Cherokee

I have a 97 jeep grand cherokee larado with a 91 grand cherokee motor in it, my oil pressure will go from 40 to 0 every now and again when i come to a stop any solutions?


Gauge or sensor could be bad and could be oil pump going bad....hope this info helps and if so please leave rating on this post and good luck. ... 1991 Jeep Cherokee Briarwood

Will a 4.0 engine out of 91 jeep cherokee work in a 1993 Jeep Grand Cherokee. I have 2 yes and 1 NO so far.


Yes, may be sensor or two different maybe even more but the block is the same. ... 1993 Jeep Grand Cherokee

Hood latch 2000 grand cherokee - 2000 Jeep Grand Cherokee


... 2000 Jeep Grand Cherokee

2004 jeep cherokee bank 1 and bank 2 lean - 2004 Jeep Grand Cherokee


... 2004 Jeep Grand Cherokee

I HAVE A 1999 JEEP GRAND CHEROKEE, 112,000 MILES. JUST FOUND OUT BALL BEARINGS NEED REPLACING. THE MECHANIC SAID WOULD COST $1,600- $1,700 TO FIX AND THAT THE RODS OR CRANK MAY NEED REPLACING BUT HE WILL NOT KNOW UNTIL HE GETS "IN THERE" IS THIS TRUE? CAN A JEEP DEALER TELL WITH JUST CHANGING THE BALL BEARINGS AND /OR SHOULD I EVEN BOTHER GETTING THIS FIXED? (PLEASE DON'T SAY TOO BAD I DID NOT GO FOR CASH FOR CLUNKERS!!) LTW


The front bearings on a Jeep should have lasted longer but, there you go. When he disassembles the front end to replace them he should check the steering linkage and suspension since they are weaker than the bearings and even more prone to give out. ... 1999 Jeep Cherokee

(1)I am replacing a 1995 Jeep Grand Cherokee Laredo(not Limited)Power steering pump (AC - 6 cycl.). I wnet to the junk yard and got one off a '93 I believe. I got the old one off and ready to install


Check with the junkyard where you got the pump...you may need to change the pump bracket with the pump, or use a different pump. You don't have a separate tensioner the pump is on a slide mount and is the tensioner (why the parts guy is a parts ... 1995 Jeep Grand Cherokee

Jeep Grand Cherokee, EVIC message "trans - line 1"


... 2005 Jeep Grand Cherokee

2004 jeep grand cherokee with dead battery, got a new 1 and now it wont crank and the gauges and radio doesnt work.....fuses maybe???


You probably blew a fuse.\015\012Look under the hood for the fuse box and check the BIG fuses. ... 2004 Jeep Grand Cherokee

Help! Just purchased a used 2004 Jeep Grand Cherokee and the speedometer jumps from 0-70. Had it checked at 3 shops, 2 of which were Jeep dealers, and none of them can figure out what's wrong. I haven't had my Jeep for 34 days and I just want it back :( Any suggestions?


Did anyone check for a binding or defective drive cable? ... Cars & Trucks

I have a 2003 Jeep Grand Cherokee 6 cyl. I am getting fault codes P0351,P0352 and P0353 which is defined as #1,#2 and#3 ignition coil circuit and code P0505 JEEP Idle Control System Malfunction and code P1495 JEEP EVAP Leak Detection Pump Solenoid Circuit Condition. The problem I'm having is at times the engine will bog down and lose all power and sometimes just completly quits. I can stop the vechicle and turn the key switch off and start the engine and it will run just fine. I have replac


I would check Cam Position Sensor as is directly related with ignition. Power loss is due to the ECU going on "limp mode" to prevent further damage.I hope this helps! ... 2003 Jeep Grand Cherokee

I have a 2000 jeep grand cherokee 4.7 liter 4x4. the problem i am having is that when i turn the jeep on and it is idling the oil pressure is at about 40 lbs. however as soon as i touch the accelerator the pressure will drop to 0 until i let off the accelerator and then it will return to normal. it only does this after the engine gets cold or the first start of the day. the outside temperature seems to affect this some what because i used to be able to let the jeep warm up for 10-15 minutes when


... 2000 Jeep Grand Cherokee

My friend has A Grand Cherokee Laredo 1994, 4 liters. His Jeep start and run well. He goes in town and when it is time to re-start his Jeep...the motor turns but does'nt start. If my friend wait 4 to 5 hours to re-start his Jeep...Vroummm! Everything his fine and he's able to come back home! He already change twice his gas pump and the problem still remain. Where could be the cause of this failure? Thanks! Alex


Next time it don't start I would check to see if it has spark. If it don't have spark there is 3 components i would check #1 Crank sensor #2 cam sensor or pickup coil #3 coil I have a feeling one of these items could be your problem. Good luck ... 1994 Jeep Grand Cherokee

Slow battery drainage on 97 Jeep Grand Cherokee


Let's see if we can get this thing solved. First disconnect the battery\015\012positive cable, then connect a test light between the battery positive\015\012terminal and the cable you removed. If there is something draining the\015\012battery, the te ... 1997 Jeep Grand Cherokee

Battery Drainage on a 1997 Jeep Grand Cherokee


Hi,I think the solution that cbuss20 is the propper way to do this,but it would not hert to change that tail-light lamp as it showed up as a falt,some times they can still work but still be falty.best of luck. ... 1997 Jeep Grand Cherokee

How do I get more info? I need to know if there's somewhere I can get a picture of this area? What tools do I need to get into the area? do I remove the star shaped thingies on the metal plate near the latch? What size spring do I need? Where would I get it-- hardware store? dealer? If dealer, what's the part number?? thanks. Gale This is about a Jeep Grand cherokee, 1998 with a broken latch for the lift gate. I already got the answer that I need to replace the spring, but no info on what siz


Hi gale\015\012im joel\015\012\015\012let me just jump into this one really quick.\015\012\015\012the best thing to do is to not get any parts for your car from the hardware store.\015\012to replace the handle. ... Jeep Grand Cherokee

Cooling system i buy a new jeep grand cherokee laredo 2002 .i have this jeep about 1 month and i have problems with the cooling system i buy many diferents parts and the problem its not resolve i buy the sensor ,thermostat,motor fan new.. how i cant resolve my problem ?please some people explain me


All the parts that you mentioned are the correct parts that you need to check if there's a problem with the cooling system in your jeep. It's just that you missed to check two (2) things: 1. Freon2. LeakIf there's a leak ... 2002 Jeep Grand Cherokee

1998 Jeep Grand Cherokee Laredo 4.0 6cyl, when i crank my jeep after about 1 or 2 min it will start idling very rough and the exhaust smells very rich. Seems like the motor is starving for air but there's no vacuum leaks. I have already replaced the idle air control sensor, fuel pump, fuel regulator, plugs, plug wires and air filter. Its not throwing any codes and even though the check engine light doesn't come on Ive still check it numerous times. Has anyone else experienced this or know wh


Have you checked the coolant temp sensor. They also have something called a MAP(manifold absolute pressure) sensor that could be causing this issue. This sensor will have a 4 pin connector and 1 vacuum line going to it. Should be on the firewall, jus ... 1998 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.9013 seconds