Having problems with your 2001 Hyundai Accent ?

Where is the plug in for the diagnostic machine on the 2001 accent

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2001 Hyundai Accent

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Diesel Fiat Punto 1.3 multi jet 2003. I cant start the car it keeps turning over and over and will not start. Ive had the pump and injectors checked, changed the starter motor, had new glow plugs. The car has been put on diagnostic machine, when the car is being tuned over its showing an intermitent fault showing the RPM signal is jumping to 0 to 300. i have changed camshaft and crackshaft censor. Please can someone help me ive spent a fortune?


First I would check to make sure you have the proper fuel pressure at the pump - you should have 2 pumps - one that delivers from the tank, and a high pressure pump for the injectors. Make sure that both are delivering properly - you may need to prim ... 2006 Fiat X1/9

Where is the plug in for the diagnostic machine on the 2001 accent


... 2001 Hyundai Accent

I have a Renault 1.9 DCI, glow plug light came on diagnostics machine showed glow plug problem. Replaced glow plugs not the problem, then noticed the fuel supply pipes above the injectors were damaged replaced them light went off and all running well until a few days ago again glow plug light came on, and put car on a diagnostics machine shows error by Air flow meter, replaced the air flow meter but still the light is on and poor Acceleration. But someone has advised me to have a look at the exh


Hi the air flow meter measure air flow to intake therefor it could be meter or 1st thing to check being in africa ? remove the air filter and check the underside of the element as this iswhere dust etc is collected and prevented entering the ... 2003 Renault 181

I replaced the motor in march '09 without any problems and the rebuilt engine has probably 10 or 15 K miles but the car suddenly started running rough so we took it to the nearest auto parts (auto zone) and hooked it up to obd 2 diagnostics machine and trouble code PO302 came up stating it was a cylinder 2 misfire so i changed the plugs and wires but, upon changing the plugs i noticed that the #3 plug was black as if it had been spray painted and knew the fuel in that cylinder was not burning pr


Check the compression in each cylinder. # 2 especially should be over 110 pounds. If you have any less than that you may not have enough to fire that cylinder. Also check the gap on your spark plugs. Too wide of a gap may cause this same problem. ... 2001 Pontiac Sunfire

1995 accent loses power when hot, the car seams like it does not burn the fuel well or as a restriction, changed fuel filter, plugs & plug wires still does it My mecanic cant't fin a place to plug in the computer for further diagnostic (the check engine light is not on)


ECT sensor ... Hyundai Accent

Deisel heater plugs dashlight comes on flashing at the same time all revs are lost but engine will still tick over. to remedy you just have to switch off, restart and away it goes !!! until the next time!!! have had it on diagnostics, but no problem found. but cant hook it up to machine when its happening,as it always happens when your on the road..cant sus the link between heater plugs and revs


Change the air flow meter.Heater plug light flashes to tell you you have a problem.Switching the car into limp mode. ... 2000 Ford Focus

My 2004 Tahoe LT was put on a diagnostic machine and did not give any codes. The tech said that there was no power coming from my diagnostic plug.


I'm thinking Marcos is on the right track. In todays world with all the gadgets such as phones and GPS's, they tend to get plugged into the cigarette lighter. These cigarette lighter circuits are not able to handle the amps our gadgets put out which ... 2004 Chevrolet Tahoe

My car is a 2002 Pontiac Grand Am w/ the 2.2 ecotech motor in it . When I tried to star the car it was hard starting and once it did start ,it ran very rough and didn't have too much power . I had a friend plug it in to a hand held diagnostic machine and it read multiple cylider misfire . I know i just put new plugs in it and I checked all the connections and all was fine . The ecotech has that piece on the top of the motor the provides the spark ,is that the problem or is it something else ????


Most likely that piece on top of the motor is the problem. I believe it is called the control module. It is the little piece where the electric sensor plugs into ... Pontiac Grand Am

Car won't go over 30mph, running sluggish, motor shakes. has new sparke plugs, plug wires, and fuel filter. comprehsion test was good, and when hooked up to a diagnostics machine it just reads "misfire" help????


My car would get stuck in 2nd gear and not go faster then 30 to 45. I found out it is the output sensor on the transmission might check that out and see if it helps. \015\012\015\012I have another problem that i can not figure out. My car ... 1997 Pontiac Sunfire

It has come on three times in the last week. Each time, I take it to my VW certified mechanic. He runs the diagnostic machine. It returns a error code on a glow plug, but when he checks the glow plug, it is functioning normally. So he resets the computer. It drives fine for a few days without the MIL lighting up, but then it lights up again. I'm getting tired of this ritual.


Replace the glow plug as they get older they carode and will short under different condtions and may be shoing low voltage, and when it sets a code for the check enginge light three times the light comes on Just replace it, if it goes out it could da ... 2003 Volkswagen Jetta TDI

MISFIRE ON CYLINDER 5. I have changed plugs, wires, coil pack, fuel injector, and ECU unit. I have had two compression tests and it was put on a diagnostic machine. Everyone is scratching their heads as to the cause. The vehicle is a 1997 Chrysler Concorde LXI. If this was a random misfire I might think it was timing. When on the disgnostic machine it said misfire on 5 the technician told me it was probaby the fuel injector. I replaced it. I took it back and told them that was not th


Same problem. 94 LHS 3.5L engine. Noticeable rythmic misfire at idle. Looks like cyl 5. When I pull the injector connector off of cyl 5 the idle rythm does not change. It does if i pull the inj connector off of any other cylinder. Spark OK. Injector ... Chrysler Concorde

What does code: PO128 mean? I plugged it into the diagnostic machine, and that's the code that popped up.


A code P0128 may mean that one or more of the following has happened:\015\012\015\012Low engine coolant level\015\012 Leaking or stuck open thermostat\015\012Faulty c ... 2007 Chevrolet Silverado 2500HD

Im buying a 1986 bmw 325e and it has a check engine light im familiar with locations and diagnostics of obd 1 and 2 vehicles but im not sure how and where to pull codes off of this vehicle is there a plug under the hood somewhere? and is the vehicle considered obd 0?


You can get hte codes from this BMW by turning the ignition key to the run position and then press the accelerator pedal to the floor 5 times, it will enter the diagnostic mode, count the flashes just like obd 1. Hope this helps, let me know ... 1986 BMW 3 Series

When driving hard or trying to go over 70 mph, car goes into limp mode! A light comes on dash stating take to dealer, also the glow plug light keeps flashing and have loss of power! My car is a 2005 '55 reg passat sport 2.0 diesel. Checked on diagnostic machine with light still on and no fault showing! Any help would be appreciated. Thanks


Check it in eobd as well as vw specific what scanner did you use to check for the fault code ? because when that light comes on it has logged a code,it could be anything from a brake light switch to the vains sticking in the turbo ... 2006 Volkswagen Passat

Got a mitsubishi colt 1.5 turbo with engine management light on. plugged into diagnostic machine and it is bringing up fault code 1970p. but no one knows what this code is??


... 2006 Mitsubishi Colt

Where is the computer plug for diagnostic machine please I have taken it to several dealers and garages and no one seems to be able to find it


Underneath steering column, might have a cover over it says diagnostic, black cover about 2" long ... 1996 Chevrolet Astro

My Nissan Primera P12 2003 model 2,0 CVT (Automatic) troubles me. This beacause the engine stops VERY often! This especially when I drive toward a cross or a roundabout. I step off the gaspedal and the engine turning (rpm)falls to way below 300 - 400 rpm... The garage is not giving me any advice. I had the car for some hours in a "testdock" docked to a diagnostic machine, but the garage could'nt find any faults, and could'nt help me to solve this problem... Do anyone have any advice?


Try o put oil in the fuel tank ... Nissan Altima

I just bought a 1995 Grand Jeep Cherokee Limited V-8 - check engiine light comes on after driving awhile. I wanted to know how do you perform the diagnostic so I can check the code. A friend has the machine but was not sure where to plug into the car to check.


The plug should be located in the wiring harness on the drivers side under the hood. If you cant find it there look under the dash on the drivers side. There is also a on/off sequence in which you can make the check engine light actually flash out ... Jeep Grand Cherokee

My 2002 hyundia accent is loosing coolant. I have replaced the radiator cap, when it would not start i had it towed and checked and they said with the coolant being low it flooded the engine and i had to have the spark plugs replaced. They did a diagnostic - nothing. They did a pressure test on thr radiator and said they found no leaks. My engine light goes on and off and the radiator resivore keeps overfilling so i have to keep putting fluid in. I got this car from a ford dealer 5 months ago. H


I would change the thermostat. ... 2002 Hyundai Accent

96 accent has not been starting ( no spark ) for 6 months off and on. cranks fine, can hear fuel pump, checked regulator...all great.Will start again if it sits for a few minutes ( not flooding ) This time, will not start although tried often ( battery/spark plugs fine ). 0 other issues at all with this vehicle.


Fuel pump relay ... Hyundai Accent

Hi I have a ford mondeo mk3 tdci... It ll run fine until I give it any more than half throttle when the management light comes on and it goes into limp mode. If i stop the engine and re-start it runs fine again. I ve had it plugged into three diagnostic machines but they all report different faults from temperature sender to some vacuum valve somewhere. Please could anyone help ?????? has anyone had similar problems??? Thanks kevin.


... 2002 Ford Taurus

2002 chevrolet trailblazer sounds like its reving high and check engine light is on now i went to have a computer diagnostic and the machine that they plug in for the diagnosis won't power up


... 2002 Chevrolet TrailBlazer

I have a 1998 Chrysler Sebring it sputters like it wants to cut off from a stand still, i put it on a diagnostic machine it said the egr valve was bad, replaced it still sputters,changed spark plugs still same, i hearing that the oxygen sensor down by the catallic converter might be bad or even the catallic converter might be bad or stopped up, pls help


Check first the Idle air control valve and  pcv valve, it may need a little cleaning.  If that does not work check the engine's timing. ... 1998 Chrysler Sebring

My check engine light has been on and the diagnostic machine says it's not firing on the 1st cylinder. I replaced the plugs, wires, cap and rotor and it's still not going off. The next step I'm told is the fuel injector and I'm wondering if there's an online resource for me to do this myself?


You can take a ohm meter and test resistances on injectors specs are 10.8-13.2 ohms also check plugs condition for black or white salt/ash or yellowish that help to tell what the cylinder is doing. if it is black you have weak spark and dumping fuel ... 1999 Jeep Cherokee

AN AUTO TECH USING A DIAGNOSTIC MACHINE GOT A CODE PO442, FOR A SMALL EVAP EMMISSION CONTROL SYSTEM LEAK AROUND 11.26.08 ON MY 2003 HYUNDAI ACCENT. WHAT KIND OF COST CAN I EXPECT TO REPAIR THIS?


This DTC (P0442) depends on what caused the code to set. Most times it's simply a loose fuel cap or the O-ring on the fuel cap is damaged OR dirt got between the O-ring and the mating surface of the fuel filler tube. There are numerous possible cau ... 2003 Hyundai Accent
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.3424 seconds