Having problems with your 2001 Ford Focus ?

The car die as I was getting off the highway and

\015 The car died as I was getting off the highway and would not start back. I replaced the fuel filter and spark plugs. It won't start its like it's not getting enough fuel will not turn over.\015 Posted / edited by AnonymousUser on : 18-12-2017

Answers :

What Needs to be done is First Check The
\015\012\015\012\015\012\015\012\015\012\015\012Inertia Fuel Shutoff Switch
\015\012Located Behind the Driver side (KICK Panel) Witch is @ your LEFT Ankle When sitting in a Driving Position. If it"s ( OUT ) Push it and then Cycle In
\015\012Ign. Switch on & Off 3-6 times then Start Engine.
\015\012\015\012\015\012 '\015\012var HIGHmap142725841 = ''\015\012\015\012// --> \015\012\015\012 \015\012
\015\012 Second IF Shutoff Switch Is NOT The CURE Then Next Procedure to Perform is a FUEL
\015\012 PRESSURE Test 40 PIS and up Is Geed . IF you DONT have
\015\012 Pressure tester, Being Very CAREFULL Diing it But you Can remove Test point Cap and With key
\015\012 on Depress the Shcreder Valve / with Eye Protection and in A Well Ventalated Area When you
\015\012 Press the Valve You should get a HEAVY Pressure Blast of Fuel from the Valve,(If it Tricles) then
\015\012 This a very good indication that The FUEL PUMP IS FAULTY. From What You have Discribed the
\015\012 Fuel Pump IS SUSPECT.
\015\012
\015\012SPECIAL TOOL(S)

REMOVAL
\015\012
    \015\012
  1. Remove Fuel Tank
  2. \015\012
  3. Disconnect the fuel supply line from the fuel pump module.
  4. \015\012
  5. Hold the fuel pump connector. \015\012
  6. Disconnect the fuel supply line from the fuel pump module

  7. \015\012
  8. Using the special tool, remove the locking ring. CAUTION: Make sure the float or arm are not damaged while removing the fuel pump module.
  9. \015\012
  10. Remove the fuel pump module
  11. \015\012
  12. Rotate the module counterclockwise. \015\012
  13. Lift the module from the fuel tank.
\015\012INSTALLATION

NOTE: Install a new fuel pump module seal and make sure it is seated correctly on the fuel tank prior to tightening the locking ring.
\015\012
    \015\012
  1. To install, reverse the removal procedure. \015\012
  2. Carry out an evaporative emission system leak test. See: Emission Control Systems\\Evaporative Emissions System\\Testing and Inspection
\015\012\015\012
\015\012REMOVAL

WARNING: DO NOT SMOKE OR CARRY LIGHTED TOBACCO OR OPEN FLAME OF ANY TYPE WHEN WORKING ON OR NEAR ANY FUEL RELATED COMPONENTS. HIGHLY FLAMMABLE VAPORS ARE ALWAYS PRESENT AND MAY IGNITE. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.

\015\012
    \015\012
  1. Release the fuel system pressure. \015\012
  2. Drain the fuel tank.
  3. \015\012
  4. Detach the exhaust pipe from the rear hanger insulator.Detach the exhaust pipe from the hanger insulator
  5. \015\012
  6. Detach the center muffler from the exhaust insulator
  7. \015\012
      \015\012
    1. Disconnect the exhaust pipe.
    \015\012
      \015\012
    1. Remove the nuts. \015\012
    2. Detach the exhaust pipe from the two insulators
    3. \015\012
    4. Secure the exhaust pipe in a suitable position.
    5. \015\012
        \015\012
      1. Remove the heat shield.\015\012 \015\012
      \015\012
    6. \015\012
        \015\012
      1. Disconnect the fuel tank vent pipes and filler pipe. CAUTION: When removing the fuel tank vent and filler pipes, do not use any sharp edge tools to lever off the pipes. Failure to follow this instruction may result in damage to the filler pipes. NOTE: Make a note of the position of the retaining clamp and clip to make sure that it is positioned in exactly the same position when installed.
      2. \015\012
          \015\012
        1. Disconnect the fuel line quick release coupling.
        \015\012
      3. \015\012\015\012 \015\012
        \015\012
          \015\012
        1. Disconnect the evaporative emission pipe.\015\012 \015\012
        2. \015\012
        3. Place a suitable high-lift jack under her fuel tank. CAUTION: When supporting the fuel tank, use a suitable packing material to prevent damage to the underside of the fuel lank.\015\012 \015\012
        4. \015\012
        5. Remove the fuel tank support strap bolt

        6. \015\012
        7. Partially lower the fuel tank. CAUTION: When lowering the fuel tank, make sure that excessive strain is not placed on the fuel lines and electrical connectors.
        8. \015\012
        9. Disconnect the rollover valve hose.
        \015\012\015\012 \015\012
        \015\012
          \015\012
        1. Disconnect the rollover valve hose.
        \015\012\015\012 \015\012
        \015\012
          \015\012
        1. Disconnect the fuel pump electrical connector.
        \015\012\015\012 \015\012
        \015\012
          \015\012
        1. Disconnect the fuel tank pressure sensor electrical connector. \015\012
        2. Remove the fuel tank.
        \015\012INSTALLATION

        CAUTION: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury.

        \015\012 \015\012
        \015\012
          \015\012
        1. To install, reverse the removal procedure. NOTE: The fuel filler and vent pipe retaining clamp and clip must be installed in the same position as removed. \015\012
        2. Carry out an evaporative emission system leak test. See: Emission Control Systems\\Evaporative Emissions System\\Testing and Inspection
        \015\012\015\012
Check fuel and gauge first then fuel reset button under dash and fuel pump
Repair Help & Product Troubleshooting for 2001 Ford Focus

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0131 seconds