Having problems with your 2001 Ford Crown Victoria ?

2001 Crown Vic quit running, replaced fuel pump, but only have 5 volts coming to pump

\015 Car quit running. when I tried t restart it sputtered like running out of fuel. Replaced the fuel filter and fuel pump. Still des not work. Only have 5 volts at pump.\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

You need to check the reset switch on the inertia relay FIRST, it is designed to cut off the fuel pump or pumps (dual tank trucks) in case of inpact, the can be triped by slaming the car door or trunk , common problem with fords, it will be located behind one of the kick panels in most cases, it is a small black box with a button on it to reset simply push in the button, you operators manual should give you the location
What is the voltage at the fuel pump relay ?
Repair Help & Product Troubleshooting for 2001 Ford Crown Victoria

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2001 Crown Vic quit running, replaced fuel pump, but only have 5 volts coming to pump

You need to check the reset switch on the inertia relay FIRST, it is designed to cut off the fuel pump or pumps (dual tank trucks) in case of inpact, the can be triped by slaming the car door or trunk , common problem with fords, it will be located ... 2001 Ford Crown Victoria

99 crown vic police intersepter car will not run over 20 mph change coil packes and fuel injecters then fuel filter still didnt run right so then i change the cats and mufflers still nothing the only thing i can come up with is the ecm is bad or the fuel pump is going out so any thing i missed

Those cars are good for clogged catalytic converters . start the car and place a peice of paper over each tail pipe and see how much exhaust comes out. do not leave to paper there for long it will burn ... Ford Crown Victoria

Where is the or is there a reset button for the fuel pump on a 1989 bmw 325i. i have no power to the fuel pump. Is there 12v going to the pump? son was driving down the road and the car just quit. Remover the pump and tested the wires to the pump and cant get no volts. Have volts going to the fuel sending unit.

Fuse? relay, check those in that order. ... Cars & Trucks

On my 1994 plymouth voyager the 3 wire harness to fuel pump (blue wire) doesn't have 12 volts; should it? fuel pump quit then worked once when hot-wired with 12 volts. fuse and relay is good.

The wire should not be hot until the relay is triggered. The relay does not get triggered until the ignition key is turned on. It will run for 3-5 seconds or until the system pressure it at max. ... 1999 Plymouth Grand Voyager

I have a 1989 Ford Crown Vic, the gas tank got a hole in it so I swaped it out with one from my 1991 crown vic. The problem i'm getting now is my 89's tank had the fuel sender and pump in different holes, and my 91's tank has them in the same. The wire colors were the same so i hooked them up according to color and the pump works great but the fuel guage is not reading correctly. Is there a way to make it read write? or do i have to fix my old one and put it back in?

Put the old sending unit back in the newer tank ... Ford Crown Victoria

I have a 93 ford crown vic an its not gettin fuel the pump not coming on an its not fireing from the coils i replace the relays all of them an the crank&cam sensors an im not gettin power from the crank sensor what do i need to do an i checked all the fuses


05 crown vic no check engine light .does not come on with key on. there is no spark and no fuel pump power

... 2005 Ford Crown Victoria

Engine quits due to lack of fuel. If I spray fuel directly into the throttle body car will start and run for a minute or two and then die again. I've replaced the fuel filter and checked fuel pump pressure which runs at 50 psi. I do notice that the pump runs for a second or two after the engine quits. The MIL is not coming on to show any trouble codes. What should I look at now? The vehicle is a 2002 Hyundai accent GSI with the 1.6 L engine.

Reset the alarn/immobiliser......... ... 2002 Hyundai Accent

I have a 2005 kia spectra 2.0L and fuel pump doesnt work.The fuel pump relay is good.I unplugged the fuel pump and checked each wire on the plug end separately 1black 1 red 1 blue 1 black with a blue dash using the black for ground and also chassis ground and get 12 volts on the red and no voltage on any of the other 3 wires with the key off or on (no change on any wire when key is turned on).The fuel pump quit working after the car hit a concrete curb that bent the front rim and blew out both d

... 2005 Kia Spectra 2.0

How do you check voltage on the fuel pump on a 2001 Chevy Silverado, was driving engine stalled but regained power drove three more miles and it quit running, I have spark but no fuel. Trying to check out fuel pump but only 5 volts on wiring plug at pump, checked fuse its good. Dont know how to check the relay or what voltage should be at the pump.

Hello Dennis.When you are checking fuel pump voltage on your pickup when you turn on the key the voltage is only applied to the pump for a couple of seconds unless you go to cranking position.There are 4 wires leading to the fuel pump on ... 2001 Chevrolet Silverado 1500

I have a 1986 Ford LTD Crown Victoria Station Wagon. 302 Fuel Injection. When I turn the key on I use to here a the Fuel Pump come on and then a few seconds later after the pressure buildups up it stops. Now I hear the Pump Constantly running. I also hear a hissing noise coming from the Throttle Body near the firewall. My car will not start. The only way to get it started is to spray starting fluid into the Throttle Body. After starting, the cars runs rough. When I put the car in drive and push

You may also check your fuel pressure module...it is located behind your throttle body, near the firewall. I was able to isolate a vacume leak in that same area with the same symtoms before starting the car, although mine runs an idle ok, it hesitate ... 1986 Ford LTD

Where does the power come from to power the fuel pump in my 1997 chevy tahoe? how many volts should the wire to the fuel pump have? and where does that power come from ?

When crusing at any speed, the rpms go up and down about 150 rpms without any increase to my speed. ... 1997 Chevrolet Tahoe

Starter quit working so we pushed started it drove it now the fuel pump isnt working and my dash lights are not coming on however if you play with the starter the dash lights come on and the fuel pump kicks on

May be a short in the power wire to the starter ... 1997 Honda Civic

Have a 1987 nissan d21 pickup with 2.4l engine. truck will start and run for 1 to 2 seconds then quits. If i shut the key off and wait till the fuel pump relay kicks out maybe 30 seconds then turn the key on and let the fuel pump build thill it cuts out,truck will start and run for 1 to 2 seconds. If I just try to start it right away again it will not even fire although I can hear the fuel pump run. It comes up with codes 21 and 43

The signal from the distributor to the coil and injectors are off and on,not constant.Replace the distributor to fix the problem. ... Nissan Pickup

My trailblazer started running bad and quit, then it would not start cranked and cranked. it sat for a day then turned the key heared the fuel pump come on the it started ran good for five minutes then cut if off and it will not start back cant hear fuel pump. put new fuel pump and relay in still doing the same thing

Hello! Which engine is installed in the vehicle; 4.2L or 5.3L?...Guru.............Saailer ... 2003 Chevrolet Trailblazer Ext

Vehical shut off going down road,will start idles then quits,fuel pump does not seem to be working no fuel pressure at fuel rail,scan tool comes up with fuel pump module not connected.

I don't know what engine you have, but some had a fuel conditioning module located close to the filter and pump. Go to the autozone website at autozone.com and register your truck. It's free and will give you access to an online repair manual for you ... 2004 Ford F150

2003 chevy 2500 6.0 replaced the fuel pump and it ran long enough to pull it in the shop now it wont run all I have at the furl pump is 5 volts replaced the relay and still no fuel pump can anyone think of what else tell the pump to come on.

Replace the secondary fuel pump relay. ... 2003 Chevrolet Suburban

I am having troublw with my car not starting. i have just installed a used engine from a junk yard and it will not fir up. engine will turn over but will not start. i have put a new fuel pump in and i have tested it bt running a wire directly to it and a 12 volt battery and it did operate. i also tried hooking it up to car power the way it is suppose to be hooked up and the pump would not work. i took the fuel line off the engine and started car to see if fuel would come out and no fuel came out

It can be faulty fuel pump relay.\015\012 the fuel pump relay would go out or a circuit feeding through that same fuel pump relay will be shorted and prevent the relay from working. As a temporary fix and to see if this is the problem, you can ... Volkswagen Passat

97 Malibu cranks but wont start Theft light is not on. If you keep trying (15 to 20 min)eventually it will run as long as the RPMs stay above 1000. Fuel pump won't come on unless I jump across the relay, or it catches one of those magic running moments. Gas gauge doesnt come off of empty unless it decides to run. I probed the voltage on the ICC relay Normal 12 volts on the #30 pin but only 7.9 volts on the #85 pin and 2.3 volts on the # 86 (computer switch pin) Throttle position sensor voltage s

... 2005 Chevrolet Malibu

Fuel pump inop on 2002 mitsubishi lancer ozzy edition non turbo 5spd. I checked fuse #8 and 10 both are good. No power coming from fuel pump relay2 at bulk head connector . I have disconnected connector at fuse box and applied 12 volts to red wire and pump runs and starts car, so one can assume the problem lies ahead of the connector. When car is in start position I can feel relay 2 click as if it turned on. I cant get to the wiring at the back of the fuse box to verify voltage right behind rela

... 2002 Mitsubishi Lancer

2006 crown vic; the fuel pump, will not kick. changed fuel pump, all fuses and relays. i can ground the pump and make it run all the time. but it will not kick on and off.

From your description, sounds like your pump wants an external pressure regulator - and that the pump is designed to be "always on'. Follow the ground lead back to its source - I suspect that you will find a bad connection (rust or broken). You can ... 2006 Ford Crown Victoria

Where is the fuel pump relay for a 1995 crown vic

... 1988 Ford Crown Victoria

Where is the fuel pump relay for a 1995 crown vic

... Ford Crown Victoria

Truck will start when i ground the fuel pump 2 the frame of the truck 05 ford f150 i changed fuel pump so its new as soon as i take off my ground wire it quits. where is the ground wire coming from and where is it grounded 2?

Ground is controlled by your computer, check your fuel pump relay ... Ford F-150

What would cause my 96 gt to crank but not start?? i get no fuel pressure under the hood nor do i get 12 volts to the pump, i have changed the fuel pump and the CCRM (the box inside the right front fender) and still nothing... it quit starting after having a battery charger hooked up, thinkin this had something to do with it, any suggestions??

This sounds like a fuel pump relay.Since it cranks,that means everything input to the PCM is good.These are start relay,start solenoid,starter,ignition switch and brake safety switch.The direct output are the fuel pump relay and a relay called an aut ... 1996 Ford Mustang
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.6871 seconds